Ford Super Duty (1999-2016) :: 2010 F450 - Drive Train Shudder At 40 Mph

I have a 2010 f-450 with 87K miles. 6.4 engine, auto trans, 4wd, and 4.11 rear. All seems fine in the earlier gears....in the later gears...at around 40mph...there's a very noticable shudder...enough to cause you to slow it down...since the shudder shakes the truck...then at about 35mph...it stops. repeat the speeds...shudder repeats.

Trans fluid is clear and all vehicle fluids and filters have been changed during the 4000 miles I have owned the truck....with the correct fluids, filters, and additives. There's also what sounds like a coasting whirling noise in the torque converter area while in neutral....which may or may not be related.

The last time all was normal...a bang .....as if I ran over a cinder block (which I did not) occurred...leading me to believe a bolt or part sheared. There is no metal in the magnetic drain plug of the tranny filter.

There are no codes indicated other than ODBC drive cycle incomplete. I do not see any obvious damage on any of the universal joints...

View 14 Replies

Ford Super Duty (1999-2016) :: 2013 F250 - Drive Train Shutter Upon Takeoff

Having trouble with a shutter upon take off in there drive train. It only happens when I am going straight. It does not do it when I am turning or anything. I just bought the truck used sat. It has around 18000 miles on it. I haven't had a chance to put a load on it yet to see if it does it then.

View 14 Replies

Ford Super Duty (1999-2016) :: 2006 F250 V10 - Drive Train Disengaged While Towing The Trailer

I have a 2006 f250 superduty crew cab longbed with the v10 gas motor. it has 201000 miles on it and towed great up until last month. I was towing a 5000lb trailer down the interstate at around 68mph,suddenly it was like the drive train disengaged and the motor had nothing left, check engine light on but no overheat condition or lack of oil pressure. we put a new fuel filter and pump on and maf, took trailer out again and same problem, pulled to the side and turned off, immediately restarted and ran fine. It has a cat not cleaning code in it now!

View 14 Replies

Ford Super Duty (1999-2016) :: V10 - Clattering Sound Coming From The Rear

My 99 super duty v-10 has 227,000 miles. It was a former UHaul unit but seems in good shape considering the abuse it's probably had! I recently started hearing a clattering sound coming from the rear.

Not just turning but in straight line. Very loud even at 2-3 mph, more pronounced in deceleration. I can best describe it as someone shaking a metal pail with about a half dozen lug nuts in it.

Previous threads point at the limited slip. I called the Uhaul after sales desk and he right away said put some friction modifier in and do figure. Eights in the parking lot. I did and The sound is still there.

One poster said the factory LS is garbage and not worth rebuilding. They mentioned the TruTrac as a good replacement and I guess I'll investigate that further.

View 13 Replies

Ford Super Duty (1999-2016) :: Crunching / Clunking Noise Coming From Passenger Front Suspension

2012 truck, started making a noise today. I cannot tell what it is, but seems to be coming from the passenger front suspension, its a crunching/light clunking sound, happens when going over bumps, when the truck pitches one way or the other turning, and coming to a stop....

Truck has 6k miles, I did a quick visual inspection this afternoon, didn't notice much, but the sway bar endlink looked a bit odd though, not sure if normal, its gota little bend too it and seems to just contact the vac line mounted behind it, seemed unusual...

Maybe its its just one of the crappy rancho branded shocks is junk?

View 6 Replies

Ford Super Duty (1999-2016) :: 2002 F250 - Rattling Noise Coming From Front Suspension When Going Over Small Bumps

2002 F-250 7.3 4x4 ...

I have a rattling noise coming from the front suspension (both sides) when going over small bumps. Most people point to ball joints, but I find my case odd because I just replaced

Upper/Lower ball joints
Track bar
Tie rod ends
Shocks
Front U joints
Drag link

I did not touch the leaf springs or the sway bar, except to grease the links, which otherwise looked good.

View 3 Replies

Ford Super Duty (1999-2016) :: 2003 F250 - Front Hubcaps Backing Off Slightly

I've been noticing that one of my front hubcaps has been backing off slightly. I tap it back on and it's good for a while. But lately I'm noticing that I have to tap it back on more often. I took it off today, thinking that I might need a new one. The part number on the inside is IC34-IA096-AB. It's on my 2003 Ford F250 4x4.

I pulled the opposite cover and tried it on the side I'm having trouble with and noticed the same thing. Upon further inspection, I noticed that the chrome plated trim piece that covers the steel rim has tabs that should be flat to the rim. I'm referring to the area where the trim piece ends, near the lug nuts. On the one that I'm not having trouble with, it's flush/flat all around. But on the one I'm having trouble with, some of the ends are not flush to the rim. That is why the hubcap is not seating in those areas. I can see the gap and I can also push down on that section. It's almost as if that trim piece is separating from the rim? I tried using a punch and giving it a couple of whacks with a hammer, but it doesn't press it back to being flush with the rim.

Why would the end of that trim piece that covers the whole wheel lift up on the ends? Is there a way to get it to sit flat?

View 14 Replies

Ford Super Duty (1999-2016) :: 2004 - Front End Noise When Hit Bumps Or Backing Out Or Entering A Driveway

I have 2004 Super Duty with a noise in the front end when I hit bumps or backing out or entering a driveway with a lip. I don't feel anything in the steering wheel but I feel it on the floor board with my feet? Where to begin?

View 3 Replies

Ford Super Duty (1999-2016) :: 2006 - Clattering / Rattling Sound When Let Off Gas

I have a 2006 Ford F250 super duty kingcab 6.0 with 6 speed manual transmission. It just started making a clattering sound when i let off the gas in 1, 2, 3 gear but not in 4, OD, in Neutral with or without clutch engaged or at idle. U joints and carrier bearing are good. I took it to a mechanic and he said it was the throw out bearing but the sound goes away when clutch is engaged?

View 7 Replies

Ford Super Duty (1999-2016) :: 2003 F250 - Ticking Noise Coming From Underneath

I have a 2003 F250 4wd with a 5.4 and 6 spd and 175,000 miles. Yesterday I came out to start it and noticed it had a ticking noise coming from underneath. According to the stock gauge it had normal oil pressure and the oil looked nice and clean and was full. I checked it while running and was able to verify that it is coming from the bottom oil pan/bell housing area. Before anybody says exhaust leak, I just put on JBA headers a few months ago and verified it wasn't an exhaust leak. I was assuming it was a rod bearing so I figured I would let it get to operating temp and see what happens. Once it started getting warm it started getting quiet and finally it just stopped once it hit full operating temp. Took it for a drive and found that it does it when in gear no matter what but stops when I put it in neutral and let out on the clutch. it makes the noise in neutral with clutch pushed in, but stops as soon as you let it out.

View 5 Replies

Prius (2010-12) :: Clattering Noise Coming From Suspension

Since new my Prius V has had a metallic clattering sound that comes from underneath the car. This can be replicated when driving over lane divider dots on a quiet street with the windows down. To investigate, I put the car on ramps and looked around; I was almost certain the sound was coming from a thin aluminum heat shield that is just behind the engine. Tapping this shield made a similar sound to what I heard coming from under the car while driving over bumps and such. The shield is poorly attached with those "fun" push pin fasteners that seem to be liberally deployed all over the undercarriage. I decided to re-attach the shield with a judicious circular application of silicone under each of the holes in the shield and let it dry. The clattering sound I heard previously when tapping the shield was gone. Out for a test drive and still there!

I just had the first service done, and of course the tech couldn't hear it on his test drive. Unfortunately I was pressed for time, so I wasn't able to take a test drive with the tech. I will drive the tech around next time and demonstrate it.

View 19 Replies

Golf/GTI VI :: Suspension Noise When Backing Out Of Garage And Down The Drive Way In Reverse

I have what sounds like a spring noise or a slight rub of a newly installed coilover set. The thing is it only happens when backing out of the garage and down the drive way in reverse, I'm not able to recreate it when moving forward. I've notice that it happens on all four. It is a very subtle sound/feel but it is there. I have about a one inch drop when backing out this when it occurs and yesterday I noticed it also happens when I go over the small lines that divide the driveway concrete slabs, but only when in reverse. Besides this the car rides and feels great with no other problems.

View 2 Replies

Ford Super Duty (1999-2016) :: 2014 F250 - Squeak Coming From Drive Shaft Area

I have a 2014 4WD Super Duty. It has a squeak that is coming from the drive shaft area. I had someone listen to it as I drove slowly next to them. It is a repetitive: squeak squeak squeak squeak squeak. Not loud. The frequency increases as speed increases. I could believe it may be a U joint based on the frequency, but seems hard to believe with a new truck. I heard this sound when I first got it, but the sound was so slight that I thought it was just some sound associated with a newer engine. But now it is becoming a bit louder.

View 4 Replies

Ford Super Duty (1999-2016) :: 2003 - Front End Vibrates - Steering Or Suspension?

2003 F250 4x4 5.4L with 35" off-road tires.

My problem is my front end started vibrating and got worst over the last 2 months. I noticed my front tires were wearing very oddly. Not the way they would if it were out of alignment. I checked the ball joints and the tie rods and all seem tight. There is no play in the ball joints or tie rods. Now I have noticed that I have play in what I think is coming from my steering gear box. I can wiggle the steering wheel and can hear it rocking but it's not from the gear box down. Could that be the problem or am I missing something. Also when turning out of a Parking lot that has a good angle to it I do hear a pop quite often but have not been able to locate where it's coming from other than it's in the front end somewhere. I just rotated the tires so now the front tires are smooth and worn evenly but I still have vibration just not near as much. It's hard to see in the pics but there's like lips on the end of the tread. The ones that were on the back are smooth and not worn like these.

View 13 Replies

Ford Super Duty (1999-2016) :: Grind Feeling Through Gas Pedal And Noise From Front Right Suspension

I have a new 2016 F250, few months old, loving life. I noticed a weird noise/feeling when I am making turns while going over a bumps. There is a left hand turn on my way home that I take every day at approx 15 mph. There is a dip in the road and I can feel a weird grind kinda feeling through the gas pedal and a noise from the front right suspension. Being a brand new truck, I'm not sure what the deal is, or if I'm just overly critical.

View 4 Replies

Ford Super Duty (1999-2016) :: 2001 - Replaced Hub Bearing / Noise From Suspension Area?

I have a 2001 f250 v-10 4wd with 117,000 miles. I just replaced drivers side front hub bearing assy and not sure if it's the new bearing or what but now I keep hearing this crazy noise from suspension area. It has had bangs and pops for a while now. It almost sounds like abs motor going off but louder. Does it going slow fast or whatever. Brakes on or off. Trucks ball joints were done about two months ago and new shocks, trac bar replaced this summer only thing not done was tie rod ends and all bushings. Brakes are good new rotors and pads this summer also. It's like taking two inflated balloons and rub them together real fast. It may be the timken bearing maybe bad from get go.

View 14 Replies

Ford Super Duty (1999-2016) :: 2003 F250 - 4 Wheel Drive Is Not Working

Love my 03 lariat Super Duty, King Ranch. Just found out 4 wheel drive is not working. Checked fuses, next going to look at the vacuum system, make sure its working. New to the Diesels but going to work at it and learn at the same time. 2003 F-250 4x4 ....

View 5 Replies

Ford Super Duty (1999-2016) :: Grinding Noise Constant In 2 Wheel Drive

I have a 2001 F350 with a7.3 power stroke, 6 speed manual with manual t case and hubs. I have a bad grinding noise when in 2 wheel drive. Similar sound as if you are trying to shift t case into 4 wheel drive too slowly. The grinding is constant in 2 wheel drive, but if I shift it into 4 wheel drive, the noise completely goes away. I have been driving around in 4 wheel drive (T case only, manual hubs not locked) for the past 2 days. If I shift back into 2 wheel drive, a constant terrible grinding noise returns. What could be wrong, and why it goes away in 4 wheel drive?????

View 3 Replies

Ford Super Duty (1999-2016) :: Turn Off Alarm When Backing Up With Boat And Trailer?

2016 F-250 Lariat Crew Cab.. How do I turn off the back-up alarm when backing up with my boat and trailer?

View 10 Replies