Ford Super Duty (1999-2016) :: 2003 F250 4x4 - Left Rear Caliper Sticking After Replacing
Two weeks ago did a road trip to NH from RI and i heard a slight dragging only at low speed (10-15mph) in my left rear tire. figured the caliber was dragging a little, it was. Before arriving in NH the brake light came on. Long story short i get back to RI and the left side noise gets worse and starts to lock up. I finally replace the rotor which was warped, pads, and caliper which was bad.
Was driving it same day and still here the same dragging and screeching noise and the brake light is still on. On my way home the left side locked up at low speed without hitting breaks and slid the truck, mid you all parts are new on that side. I am not sure what it could be at this point something in side the axle?
Ford Super Duty (1999-2016) :: 2001 F250 - Rear End Slip / Bump When Initially Starting From A Dead Stop
I am experiencing what feels like a "bump in the rear" when initially starting from a dead stop. It feels like a car behind me tapped the bumper or that the truck "hunkers down" first, then moves. Tranny seems fine also. Once moving, there is no problem whatsoever. There atre no noises, leaks, or other symptoms. Also, when coming to a stop, it feels the same way just before the truck completely stops. If I drift forward a little, then apply the accelerator, it does not "slip" or hunker down.
Took it to the dealer and they claim that they can't find anything wrong and may just be the suspension releasing? The truck does this whether loaded or not?
2001 F250 CC Lariat SB 7.3
Ford Super Duty (1999-2016) :: 2008 F250 - Left Rear Brakes Hanging Up
Took truck out for a ride and stopped for gas. I smelled Brakes and upon inspection found the left rear brake pads were not releasing. Any take on what could be holding it? 2008 F-250.
View 10 RepliesFord Super Duty (1999-2016) :: F350 - Left Front Rotor Rubbing On Caliper Bracket
1999 F350 4x4 dually. Replacing brakes front and back. Rotors, Pads, and hoses. On the left front put rotor back on and torqued down hub nuts on rotor. Then caliper mounting bracket wouldn't fit back between mounting bracket and rotor. Loosened the hub nuts on rotor, and fit mounting bracket in place. Then torqued down the hub nuts again, and rotor rubs on mounting bracket and rotor/hub won't turn.
View 2 RepliesFord Super Duty (1999-2016) :: F250 - Brake Caliper Won't Release
My 1999 F250 right rear brake caliper will not release. I replaced the caliper, caliper mounting hardware, pads, rotor, emergency brake pads, and I bled the system. For some reason the right rear remains activated when my foot is not on the brake pedal. The other three wheels appear to be functioning normal.
View 6 RepliesFord Super Duty (1999-2016) :: Left Front Caliper Is Not Squeezing Hard Enough To Stop The Truck Evenly
Having a problem with calipers again/still seems like always. Replaced all calipers twice in 86K miles on a 2000 f250 crew 4x4 because of stuck calipers. Replaced brake hoses and all hard lines in the rear about 2 years ago. My problem now is the left front caliper is not squeezing hard enough to stop the truck evenly. (pulls to the right) The rotor had some rust from sitting and after driving a for a while the rust is not completely gone as you would expect. Replaced caliper bled a couple of times. Caliper looks to be getting pressure enough to bleed and can see it move when brakes applied when engine not running. I don't have experience with Proportioning Valves but do you think that is the problem and how do I fix it?
View 8 RepliesFord Super Duty (1999-2016) :: Rear Brake Caliper Locked Up?
About a year ago, I had my right rear brake caliper lock up on my F350 dually. The shop said it can happen and replaced both rear calipers. Last week I started to hear something from the rear and within less than a a few days, before I could get to a shop the noise increased and when I looked the rotor had been gouged on the right rear.
I cannot see the left rear rotor to compare as the wheels don't line up on that side to see through. So my question is this. Could it be the caliper failure was a symptom and not the cause. Maybe a proportion valve or something that could affect the pressure on that one wheel.
Ford Super Duty (1999-2016) :: 2000 F250 - Front Passenger Side Caliper Keeps Locking Up
I have a 2000 f250 4x4 with 4 wheel abs. The front passenger side caliper keeps locking up while I'm driving and won't release and when I hit the brakes it pulls hard to the drivers side. I have put two calipers on the passengers side and put new brake lines on.
View 8 RepliesFord Super Duty (1999-2016) :: 2001 F250 - Easier Way To Fill Rear End?
Is there an easier way to fill the rear end on my '01 f250? I have a gadget with a valve on it with a length of tubing that you put on the bottle, but you still have to snake the bottle up through the chassis.
View 14 RepliesFord Super Duty (1999-2016) :: 2001 F250 - New Rear Bumper Conversion?
Ok I have a 2001 f250 SD with 7.3 and my rear bumper is dented and badly and warped. The steel frame mounting part of it is straight and fine. I found a "kit" on eBay that has just the end caps and plastic top cap for a 2008+ style trucks. Would those caps and plastic fit on my frame mounted section (what the actual name for the part that the chrome bumper actually screws into that mounts it to frame) ?
View 1 RepliesFord Super Duty (1999-2016) :: Replaced 5th Time Rear Brake Caliper And Slider?
one of my f350 super duties has had the right rear brake caliper and slider replaced 4 times in less than a year. it has just gone for the fourth time today. i called ford who, after a long phone call, said it could be the metering valve. i have looked everywhere for this valve.....no luck. so i called them back and he said it was part of the HCU. after a few minutes, he finally told me it was also called the ABS module.
my question is..........can i just replace this metering valve or do i have to replace the whole unit?
Ford Super Duty (1999-2016) :: 2001 F250 - Rear End Differential Fluid Change
I have a quick question. I am gonna change the fluid in my 01 f250 rear end. it has 410 gears and a limited slip diff. if i use full synthetic gear oil do i have to add the limited slip additive or just the 75w-140 full synthetic gear oil.
View 14 RepliesFord Super Duty (1999-2016) :: 2001 F250 - Rear Pinion Bearing Replacement
I am working on my Dads 01 super duty with a 5.4, automatic, and the pinion bearing has seized up due to a lack of fluid from a rusted out rear diff cover. The tag on the diff cover had a 10.5 stamped on it and has 12 bolts. Is this known as a ford 10.5"
I have changed gears and pinion bearings in a Dana 70 before is this the same process? What are part numbers for a new pinion bearing and seal? Gears are in fine shape.
Ford Super Duty (1999-2016) :: F250 V10 Starting Sporadically
I am looking at purchasing a 1999 f250 Crew Cab Long bed with the V10. It has 120,000 miles on it and has been very well taken care of and maintained. The current owner says that over the last couple of weeks it has started to start sporadically. The first time it did it was after a 30 minute drive. Parked the truck outside his garage and a hour later when he went to pull it in the garage, it wouldn't start. He called a mechanic friend that told him to trip the inertia switch.
Pressed the switch, it clicked, and then the truck fired right up. Since then it has done it twice more but now instead of tripping the inertia switch he turns the key on and off 10 times and then it starts right up. What this would be? I would normally think fuel pump since cycling the key on and off would be building pressure in the system if the pump was just starting to die but the inertia switch being tripped has me confused.
The owner thinks or was told that quickly turning the key off and on is resetting the computer and after turning the key 8 times the locks lock and unlock and the lights flash once. Is this what it is doing? I thought turning the key on and off in multiple succession let you manually read the codes...
Ford Super Duty (1999-2016) :: 2003 F250 Cranking But Not Starting
My 2003 F-250 (gas V8) will always start right up when it is cold. However, once it has warmed up, it often will not start. Cranks fine, but not even wanting to start (like someone pulled all the plug wires) and has left me stranded until I wait for 3+ hours for it to cool back down. Doesn't trip the check engine light, but seems to be due to the engine being hot. What this could be?
View 7 RepliesFord Super Duty (1999-2016) :: F250 Won't Start Without Starting Fluid
My 1999 F-250 wont start unless I use a squirt of fluid but once started it will run fine could this be my cam sensor or do I have an injector problem.
View 4 RepliesFord Super Duty (1999-2016) :: F250 - Hard To Turn Left
I have a 1999 f250 sd with the 7.3. I'm not sure what is going on with my pickup. When I turn to the right i can turn with one finger, but when I turn left i have to put some muscle into it. Power steering fluid is full. I raised the front end and it turns both ways easy. My ball joints feel fine, there is no tire shake when i have it off the ground. My tie rods feel fine also, nice and tight. I was thinking about replacing the steering sector to see if thats the issue but wanted to get a second opinion first.
View 2 RepliesFord Super Duty (1999-2016) :: F250 V10 Cranked Fine But No Hint Of Starting
1999 F250 SD V10 I recently replaced the in-tank fuel pump and filter. I operated the truck briefly after and everything was normal. I parked it with about 1/4 tank of new fuel and put it on a battery tender. It was parked in a garage on level ground in temperate weather(Southern Calif.). Two months later I tried to start it and it acted like it did when the fuel pump was bad. Cranked fine but no hint of starting. Could it be the fuel lines have become full of air and need purging through Schrader valve ? I haven't begun to troubleshoot but what to check other than pushing the fuel relay reset button.
View 5 RepliesFord Super Duty (1999-2016) :: 1985 F250 Diesel Cranks But Not Starting Up
My diesel truck is stuck at work. It cranks but it's not starting up. When I turn the key, the glow plug light takes a lot longer than usual to turn off. When I try to start the truck, it cranks fine and I get a lot of white smoke coming out the exhaust pipe. I've had this truck less than a year and I know very little about Diesel engines. I at least need to get it running long enough to get home. The parking lot at work is really busy pretty much 24/7 and towing it out of there would get pretty dicey.
View 5 Replies