Ford Super Duty (1999-2016) :: Transmission Will Not Go Into Forward Gears
I have a 1999 F-250 4X4 7.3 lit Diesel engine. My problem is my transmission will go into reverse great no problem but it won't go forward. I have no problem rebuilding the transmission if that's what it needs, I just want to make sure there isn't a electrical issue from the PCM first?
View 14 RepliesFord Super Duty (1999-2016) :: 2005 - No Gears / Transmission Dropped Into Neutral
I was driving on the highway last night when it was like somebody dropped my transmission into neutral. I was cruising at 50mph slight hill. There was no noise or any thing. Now I have nothing.
It's a 2005 f350 4x4 automatic
I can only assume I'll be needing a new transmission but I am hopeful of a small problem...
Ford Super Duty (1999-2016) :: Transmission Rattle At Low RPM Especially In Lower Gears Under Load
This is an early 99 f250 powerstroke 6spd manual 4wd, is it common or normal to hear a lot of transmission rattle at low rpm especially in lower gears under a load. Starting off from a dead stop it sounds awful until about 1500 rpm where it clears up (or load is reduced). I'm hoping it's just the power pulses going through splined shafts, gears, etc.
210k on the truck, just changed every fluid in it.
I've been a honda owner and mechanic for all of my driving years where shifting at 8500 rpm is common and now I'm having a hard time learning what this thing likes, rpm ranges to avoid, ect; even shifting I find difficult. At least you can heel toe with the pedal arrangement...
Ford Super Duty (1999-2016) :: 2000 F250 - Tachometer Needle Will Not Always Move The Way It Supposed To
Just had a question about my 00 F250 7.3. I recently have noticed that my tachometer needle will not always move the way its supposed to. Sometimes it will sit at zero until I drive it for a min then all of a sudden pops up to where its supposed to be. I also noticed today that while i was driving it just dropped to zero for a second or two then back up to where it was supposed to be again.
When it does this there is no drivability issues with it or idle issues what so ever. Which is strange to me and I cannot seem to put my finger on what could be causing the issue. As I have searched online for a while to no avail as most of the other issues include drivability and idle issues. Also not that it matters but I have recently replace the cps sensor with a new one OEM of course but i don't think that has anything to do with this problem.
Ford Super Duty (1999-2016) :: 2001 7.3L F350 - Transmission Starts Shifting Hard And Grinding Gears
My buddy's 2001 7.3L F350 has had 3 transmissions. Rebuilt and used. Once the new trans is in he goes like 15 miles and then is starts shifting hard and grinding gears. What this could be?
View 8 RepliesFord Super Duty (1999-2016) :: Transmission Bucking When Coming To A Stop
I have a 2000 ford f350 7.3l with a auto transmission(4r100) and I have had problems with it . It started a while back when the transmission is cold like in the morning when I put it in drive it acts like when you don't push the cluch in on a standard when coming to a stop kind like it's bucking and this only happens when it's cold when it's nice and warmed it's fine so I changed the whole transmission and put a billet torque converter and I'm still having the same problem can it be a sensor or something electrical ?
View 7 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Shifting Late In All Gears / OD Indicator On Shifter Blinks From That Point Forward
My 2000 SD 7.3 has developed a quirk. For some reason the trans has decided to shift late in all gears. This only happens once, then resumes shifting normally. However the OD indicator on the shifter blinks from that point forward. Once the engine is shut down and restarted. The sequence starts again. Late shift, through the gears, once, then shifts normally with light blinking. Fluids are up and clean.
View 4 RepliesFord Super Duty (1999-2016) :: Transmission In Neutral When Continue From A Stop Sign
I have a 99 f350 V10 gas dually dumper. Today while driving I stopped at a stop sign. When I went to continue the transmission seemed to be in neutral, then it caught and I drove through the intersection. It 2-3 seconds later disengaged again. I pulled over. When I attempted to put it in park it grinded. (Bad enough I just turned off the key). I checked the fluid. It was close to full and red. While in park I restarted. Truck started fine. I shifted into drive and nothing. It was like it was in neutral still. I attempted to put in park again and more grinding. Also while in park it does not hold the truck from rolling. After getting towed home I checked the tranny fluid again and it was still looking ok. I drained the transfer case also. The fluid in there was near black an appeared to have a metallic look. Does this problem seem to be just my tc or tranny issues also?
View 8 RepliesFord Super Duty (1999-2016) :: E4OD Transmission - Truck Will Not Downshift When Come To A Stop
97 f350 5.8L E4OD Transmission. This truck will not downshift when you come to a stop. You must manually shift it all the way through and then it does fine. What is causing this issue? It will kick down into passing gear. What is wrong?
View 4 RepliesFord Super Duty (1999-2016) :: Transmission Malfunction - While Coming To Stop Bucking In Cold - Sensor?
I have a 2000 ford f350 7.3l with a auto transmission(4r100) and I have had problems with it . It started a while back when the transmission is cold like in the morning when I put it in drive it acts like when you don't push the cluch in on a standard when coming to a stop kind like it's bucking and this only happens when it's cold when it's nice and warmed it's fine so I changed the whole transmission and put a billet torque converter and I'm still having the same problem can it be a sensor or something electrical ?
View 14 RepliesFord Super Duty (1999-2016) :: F250 Transmission Noise When Towing On Incline From A Complete Stop
2016 F250 6.7L 4x4
I getting some tranny noise when towing on incline from a complete stop. When I slowly press the gas pedal I hear grinding noise. If i press the gas more my truck starts to move and the noise goes away. It doesnt happen all the time. This started right after my 1000 miles recommended break in before towing per ford manual.
My truck now has 2800 miles and the grinding noise occurs intermediately regular driving. Mostly on steep incline or decline. I haven't taken it to the dealer yet because I cant recreate the issue all the time.
Ford Super Duty (1999-2016) :: 2000 F250 Triton V10 - Brakes Won't Stop Squeaking
I've replaced the brakes that weren't in that bad of shape anyways and even replaced one of the rotors as it was under federal regulations. I've even put the brake squeak goop on the back of the pads and it keeps squeaking and squeaking and it's driving me insane. Am i missing something here? I don't here any other super duty's squeaking on the road.
View 1 RepliesFord Super Duty (1999-2016) :: 2000 F250 V10 Shakes Up Until Second Gear When Takeoff From A Complete Stop
I have a 2000 f250 superduty gas v10 6.8L . I bought this truck about 4 months ago. Now when I take off from a complete stop the truck shakes up until second gear, shifts fine all the way up until the last gear it looses power "loosing power" i mean i can put my foot into the pedal and it takes forever to climb speed meanwhile the RPM'S never skyrocket like it the transmission was slipping if anything a couple times the RPM's dropped are stayed the same then as i take my foot off of the pedal once i have my desired speed sometimes not always the truck will give me a little jerk Also Just the other day I was driving on the highway and decide to put her on cruise control at about 70mph, I set the cruise control and the RPM gauge was just over 2,000 and the tach was fluctuating up and down about 1/16 of an inch. I been reading alot of forums and what I got out of them is it maybe pointing me to a misfire maybe the coil packs? Plugs?It's not something major like a transmission rebuilt.
View 6 RepliesFord Super Duty (1999-2016) :: 2000 F250 Transmission Is Starting To Slip Occasionally
I have a new to me 2000 F250 7.3 diesel with automatic. Truck has 185K miles and tranny is starting to slip occasionally. Do these trucks come with a OEM tranny cooler or do I need to add or upgrade the OEM one. Someone also told that there is something called "bulletproofing" the tranny on these trucks. BTW, what would be a reasonable cost to have a two wheel drive auto tranny done on my truck?
View 7 RepliesFord Super Duty (1999-2016) :: 2000 - Transmission Fluid Leaking From Cooler Line
So my 2000 f350 is leaking transmission fluid from the cooler line. It goes to the rear of the transmission, but where does it go to from there?
View 5 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Manual Transmission Noise When First Started
I am new to being an F250 owner. Just recently purchased a 2000 F250 SD 4x4 with the 5.4 and a 5 speed trans. Got a pretty good deal on it, because I knew some work had to be put into it, and do plan on dropping the trans. Currently, if the truck has been sitting for a little bit, not cool, but not running for a little bit, when I start it, whether it is in gear or in neutral, there is a noise coming from what seems to be the clutch area.
After a couple minutes of driving, this noise goes away and all sounds as it should. A little bit of researching turned up the possibility of the throw out bearing being bad, however, I found other posts online that doubt this. Another symptom that I assume is connected is that if I go to put it in reverse at 0mph from neutral, it grinds.
In order to go into reverse, I have to press in the clutch, put it in first, then put it in reverse, at which point it goes in no problem. I had already planned on replacing the clutch because it seems to me that would be the logical choice as to where the problem originates, so no issue there. But perhaps I'm wrong??
Ford Super Duty (1999-2016) :: 2000 F350 - Transmission Shifts Fine With Disabled O/D?
And if I have to sift through one more "My O/D light is blinking."
I have a 2000 F350 7.3 4x4 SRW CC with several issues but right now I'd like to address the one plaguing my transmission. If I crank the truck and take off it will not shift out of first gear, well it might but it'll take a while, be at high rpms, and a hard shift, throwing the 1-2 shift error code. Now if I disable O/D with the button on the shifter and take off it shifts through all gears fine. I can drive it normally and if I hit the highway, when I'm up to speed I can enable O/D, it shifts into O/D and I can keep on trucking. When I stop I disable O/D and take off normally again. After about 10 minutes of driving and several start/stops even with O/D disabled it will eventually throw the 1-2 shift error code and give me a harder shift into 2nd and I guess enters its limp mode but is still drivable. This appears to be the only code dealing with the transmission.
Due to the fact that it shifts fine with O/D disabled, doesn't skip any gears, and I can manually shift it through 1-2-D I'm guessing it's not the mechanical diode I've heard so much about but an electrical issue. Before I bought this truck it had been abused, at one point the front driveshaft came loose and ripped the wiring harness going to the TRS in half. They soldered it back together but it still looks a little rough. I figure this is a good place to start. What readings I should get at the TRS? Sensor side and plug side. I have the AE enhanced ford bundle and a good DVM. If the TRS can't cause an issue like this where do I go from here, shift solenoid?
TLDR Version
2000 F350 7.3 4x4 SRW CC
Won't shift out of first with O/D enabled.
Shifts fine with O/D disabled.
Can manually shift through all gears.
Eventually throws 1-2 shift error code.
TRS/TRS Harness has been damaged in the past.
Appears to be an electrical issue with the transmission.
Can the TRS cause an issue like this?
How do I test the TRS/Harness?
If not the TRS what could it be, shift solenoid?
Ford Super Duty (1999-2016) :: Automatic Transmission Swap 2000 F250 To 2003 Model?
I have a 2003 f250 4x4 with a 5.4 motor the automatic trans is shot. I can get a replacement trans from 2000 f250 4x4 with the v10 motor. I tried my best to research it bell housing supposed to be the same so it should fit. But I'm not sure what they changed in those years internally or electronically.
View 2 RepliesFord Super Duty (1999-2016) :: F450 - 4.30 Or 4.88 Gears?
I have a 1999 F450 that was bought new as a cab and chassis. The truck belonged to my dad who passed away two years ago and now I have it. I am wondering if it has 4.30 or 4.88 gears. The rear end is huge! It has an aluminum cover with cooling fins on it, not sure if they both had that or not. I looked online and I think it said all cab and chassis had 4.88?
View 10 Replies