Ford Super Duty (1999-2016) :: 2000 F250 - Front Suspension Noise - Loud Knock As If Left Shock Is Bottoming Out
I have a noise with my new (2.6k miles) 2000 Diesel F250 Crew Cab. When I make low speed, right turns while crossing any type of depression in the road I hear a loud knock as if the left shock is bottoming out. There's an intersection near my house with runoff depressions across the road, I almost always hear the noise when making that turn. I've occasionally heard it coming from the right side when making a left turn.
View 14 RepliesFord Super Duty (1999-2016) :: V10 Knock / Misfire When Accelerating Under 2000 RPM
My V10 was knocking when accelerating under 2000 rpm; rain and moisture made the problem worse. I discovered that the 2-part wiper cowl under the windshield allowed water to leak into the engine compartment and onto the throttle body, which then dripped onto the left side of the engine. This caused the spark plugs to rust and the 3 back ignition coils (coil on plug) on the driver's side to crack and fail. This caused a horrible misfire/knock that was worst under 2000 rpm especially in high gear and when the environment was wet. I fixed the misfire and cowling leak. Has not returned. I caulked the cowl and changed all my spark plugs and ignition coils.
View 3 RepliesFord Super Duty (1999-2016) :: 2006 F250 - Phaser Knock At Idle In Gear
Ok I bought this truck with a bad engine 5.4 3v had rod knocking. I rebuilt engine got it all back together and in truck. I did replace cam phasers and solenoids. After driving 20 mins or so it would start the phaser knock at idle in gear so I put a oil pressure gauge on it and cold had 55 psi after running 10 mins or so had 15 psi at idle then would drop to abought 9 psi. I am thinking I got bad cam bearings or something for some reason don't know why. I did it but I took oil cap off where you pour in the oil. Had to force it off it was pulling that much vaccum ones cap was off oil pressure jumped up to 25 psi. What could be causing this.
View 2 RepliesFord Super Duty (1999-2016) :: 2003 F250 4x4 - Misfires On Cylinder 1 / 3 / 6 And 7 - Knock P0325
2003 F-250 SD 4x4 w/5.4L engine and 4R100 trans (pic in sig) . Truck has 280K on it with about 40K on a partial rebuild on the top end.
Took the truck out offroading and got about 4" from the top of the 33" tire in water (not mud.. water) . Someone with 6' tractor tore through the puddle.....
Well the truck survived through it ... albeit dirty as all hell and developed some issues soon thereafter. Codes for misfires on cyl 1,3,6,7, general ignition coil, etc etc etc
Power washed the underbody , washed the mud off the engine bay (yeah... with water but given it was caked with mud and water to fill the plug wells... no additional harm) .
Replaced all 8 COP and 4 plugs ( easier ones to reach), oil change, oil filter, new paper cone filter. checked most all the harness connections and cleaned with alcohol also. Reset the PCM/ECU and drove the truck for about 100miles and finally just after putting a full tank of gas (92 Octane) I throw a P0325...
The engine runs very clean, no hesitation, smooth idle, smooth acceleration on both light and hard acceleration. Just the damn code. Is it the gas I just topped off? After 100+ miles with new COP and plugs it threw nothing until this and runs great. Dont hear any knock/ping/detonation by ear and feels silky smooth at idle.
I really dont want to have to tear the intake off to replace bank 1 knock...
Ford Super Duty (1999-2016) :: 2003 F250 - Doors Squeaking
I posted a reply her a couple of weeks ago on how I fixed my '03 SD's squeaky doors. I went to AutoZone and bought 32 feet of 5/8 inch self-adhesive rubber (not foam) weatherstripping and mounted it around the outside edges of both doors, starting at the top. Presto - squeaks are gone, there are no more drafts and road noise is reduced a little. (I may remove the stripping I put on the side edges of the doors because I think the culprit is actually the rigid polyethylene bumper strip they've mounted on the upper door jam).
View 2 RepliesFord Super Duty (1999-2016) :: F250 Extended Cab Back Doors Stopped Opening
1999 F250 extended cab back doors won't open. The passenger side stopped opening right after I purchased it a few months back (168K miles). I removed the door panels and reached my hand in feeling around. I know the latch releases are activated by cables but cannot figure out how they work. While feeling and pulling on the cables one became dislodged from its holder. The driver's side stopped opening yesterday . Do the cables stretch, break, or what? Or are the holders the issue? Is there an illustration that shows how the cables are run and connected?
View 14 RepliesFord Super Duty (1999-2016) :: 2005 F250 - Cam Phaser Knock / Timing Chain Slap On Start Up And Noisy Lifter
I have 05 F250 SD with 150k on it. The engine has the typical cam phaser knock, timing chain slap on start up and occasionally have a noisy lifter. As long as I use fresh 20-40 oil the engine symptoms are less and the engine runs strong. The motor also doesn't leak or burn oil and the plugs were change out about 20k ago.
The truck is still good and is prefect for my needs so to me it's seems worth fixing the needed repairs. What I would like to figure out how far should I take the motor... just have the chains, guides and phasers replaced or buy a rebuilt motor and swap it? I'm thinking just doing the phases and etc would be 1/2 the cost but may not last as long as rebuilt motor. But realistically I might only put 5-7k miles are year on it anyways.
Ford Super Duty (1999-2016) :: 2012 F250 - Sticky Residue Along Button Of Doors And Around Hinges
I bought a 2012 F250 6.2L 4wd recently, truck came from Canada, Noticed a sticky residue along button of doors, around hinges, inside front and side edges of hood, some of the goo is in the A/C coil, doesn't have much odor, maybe oil, comes off with degreaser, doesn't look like it came from engine as that is clean, could this be something they spray on the roads up there? Doesn't seem to harm anything just messy if you rub up against it?
View 8 RepliesFord Super Duty (1999-2016) :: 2000 - Rattle Around 2k Rpm Range
2000 super duty v10 with 92,000 miles. Getting that common rattle around 2k rpm range that goes away if I give it gas or let off. I originally thought it was the inspection plate on the transmission so I removed it and went for a drive to verify. The sound is still present so the only thing I can think of is the catalytic converter is worn out??
View 10 RepliesFord Super Duty (1999-2016) :: 2005 F250 - Timing Chain Rattle?
I have an 05 5.4 f250 that had a stuck injector. I changed plugs before I realized it was injector. After that the truck had a terrible rattling noise. I ended up changing timing tensioners and guides (guide was broken). Started it up and have the same noise, like timing chain is loose.
What I think happened is gas got into oil when injector was stuck. I had key on to pull codes. Then it lost oil pressure?
Could this cause can phases to go bad? Also can I just install lockouts or do I need to replace phasers as well?
Not sure if there's anything else I should check
Ford Super Duty (1999-2016) :: 2000 F350 - Front End Rattle?
I recently purchased a 2000 F350 4wd, it's mainly used for plowing my driveway, and hauling larger items. I can truly say I love this truck. When I got it, it was in pretty rough shape, but slowly I've been bringing it back to life.
However, I have this loud front end rattling sound I can't seem to locate. Quick background the truck is 4wd with a v10 in it, and it has 215k miles on it, poorly maintained, so everything is suspect. Only new parts are all new brakes and new u-joints everywhere.
So back to the noise, it's most noticeable whenever I hit a small bump or dip at lower speeds, but the noise is still there at higher mph as well. It's loud and literally sounds like the whole front end will fall off, its a definite rattle, doesn't seem to be from one side or the other, best I can describe is in front of the firewall at it sounds like something is very loose.
But when I crawl underneath the truck, I don't see anything loose, the shocks, look OK, the sway bar links seem to be connected. IDK what else to look for, 4wd works fine and doesn't seem to alter the noise any when engaged.
Truck recently passed inspection, and no mention of anything being loose or worn was mentioned. I'm kinda at a loss, but the sound is so loud and noticeable I feel like it should be obvious as to whats loose underneath.
Ford Super Duty (1999-2016) :: F250 - Door Corner Rattle At Highway Speeds
My factory-ordered 2016 F250 CC SB 6.2L 4X4 3.73 is about 6 weeks old. Driver and passenger side door rattle noise (in upper back corner) at highway speeds (65-75 mph) has gotten progressively worse over those 6 weeks. See attached video.
Trying to determine if this is caused by:
Door seals: the temperature here in Iowa has dropped from a few weeks in the 90's to the now in the mid-60's.
Could the temperature change have caused the seals to change shape/structure and result in the rattle/noise?
The exterior seal between the front and back doors (attached to front of the back door): mine seems a little loose on top, but nothing that would cause this kind of noise.
Ford Super Duty (1999-2016) :: 2015 F250 - Driver Side Door Rattle?
Have a 15 250 diesel and my drivers side door has a rattle in it. Seems to be coming from around the area were the mirror buttons are. Removed that little panel and applied some silicone around the edges and seemed to work for a bit then back to noise. Seems to go away when cab heats up good or warm outside.
View 5 RepliesFord Super Duty (1999-2016) :: 2012 F350 - Interior Lights Not Coming On When Doors Opened
I have a 2012 F350 and the interior lights and cargo light do not turn on when I open my doors. The maps lights work if I manually turn them on. Why this happens and how to correct this issue?
View 2 RepliesFord Super Duty (1999-2016) :: 2000 F350 - Factory Key Fob To Lock And Unlock The Doors While Running?
Ok, it's cold out... is there a way that I can use my factory key fob to lock and unlock the doors with the truck running? 2000 F350.
View 10 RepliesFord Super Duty (1999-2016) :: 2003 F250 V10 - Heat Shield Rattle That Sounds Like Exhaust Leak During Loaded Acceleration
I recently purchased this truck and have towed a couple of times with it. It has 98,000 miles and I do not know if the automatic transmission fluid has been changed. Should I have it flushed or drop the pan and change it? I have a lift so doing the change is no problem, although it might be worth it to pay a transmission shop to do it.
Also, I hear what appears to be like a heat shield rattle or something that sounds kinda like an exhaust leak during loaded acceleration. What to look for to locate the noise? One last question, the air bag light is on sometimes then off sometimes. Any known air bag light issues? I love the truck, hate the gas mileage!
Ford Super Duty (1999-2016) :: 2010 F250 Not Coming Out Of 4wd
I just bought a 2010 F250 with a 5.4. It is my 16 year old's 1st truck. He is pretty excited. Really nice truck that drives like a 2016. Anyway, it goes into 4wd fine and works fine. The hubs lock in. Everything works fine until you turn the switch to take it out of 4wd. The only thing that will take it out of 4wd is to back up and then turn the truck off and back on. Then it is fine. Both steps have to be done. I know the backing up part is normal, but what about turning the ignition switch on and off?
View 3 RepliesFord Super Duty (1999-2016) :: 2000 F250 Will Not Start
I have a 2000 f 250 that will not start... I have replaced many parts all electronic sensorsm the past week i have spent in the neighborhood of 1800.00 on this truck. Cps, icp, idm, ebps, fuel filter, new oil, hpop level good, gpr, all new need starting........
View 4 RepliesFord Super Duty (1999-2016) :: 2000 F250 - 4x4 Not Working
2000 f250 7.3. Today I tried using the 4x4 and no light or anything. Here is what i have tried so far. Swapped the relays and also swapped them with the towing relays with no change. Not getting any voltage to the t-case shift motor at the selector switch testing between pins 2 and 3 there is 4.3 volts with switch in 2wd 2.4 volts at 4 high and 1.09 volts at 4 low. Where to go from here? it worked fine 3 days ago.
View 2 Replies