Ford Super Duty (1999-2016) :: 2000 F250 - Cruise Control Not Working
2000 F250 Super Duty cruise control not working. I looked through a lot of threads on this subject and cannot pin point my problem. Cruise control was working, had to slow down wile approaching a town, back on the highway and now it won't turn on.
Looked at the brake pressure switch, it was till good but was the old type but had the recall harness on it. Bought a new one and replaced it anyways. Still nothing. All my brake lights work, I also did the Cruise control diagnostic and it passes everything. No lights on my dash are on, speedometer works, horn works.
The only thing I did not check is the Vehicle speed sensor. Even though my speedometer works and my ABS light is not on, can this still be the problem? If so how do you test it? Do I just remove it and test continuity?
Ford Super Duty (1999-2016) :: 2000 F250 - Door Locks Stopped Working
My door locks stopped working new battery in fob, I can hear them trying to work. 2000 f250 crew cab .....
View 3 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Parking Lights Not Working After Electrical Work
2000 F-250 Super Duty
I was replacing my headlights, which required me to splice in their lights to my parking lights, and I seem to have shutdown ALL my parking lights. I did a test after twisting my wires together and everything worked fine. Then I soldered and heat shrunk them and somewhere during that process I lost all the parking lights.
I checked the 8th fuse as per the manual (for Parking Lamps) with a multimeter and it checked out just fine.
Figured it was the time to ask the experts on here where I should go from here. Are there some other fuses I could be missing, or maybe some else I could do?
Solved: Bad fuse in the #8 slot in the Power Distribution Box (under the hood, near Cab, driver's side)...
Ford Super Duty (1999-2016) :: 2000 F250 - 4x4 Quit Working / Front Wheels Don't Even Turn
I have a 2000 f250 with auto/manual locking hubs and today the 4x4 quit working. The light comes on the dash and the drive shaft and u joints turn but the front wheels don't turn even when its locked in. I assume its the hubs? And when I am going down the highway about 75 the front starts making a hellacious noise but stops if I slow down is this connected?
View 11 RepliesFord Super Duty (1999-2016) :: 2002 F250 V10 - 4x4 Not Working
2002 F250 SD 4x4 crew cab, v10. 4x4 not working. Replaced switch on dash, not the problem. Some of told me it was the vacuum control module. Not sure where to start.
View 4 RepliesFord Super Duty (1999-2016) :: F250 V10 - Over Drive Not Working?
1999, F250, SD, v10, Auto, 4x4.
My light on the overdrive is not coming on and the overdrive does not seem to be working. I had a new transmission installed a few weeks back. Wasn't working prior to this.
Ford Super Duty (1999-2016) :: 2000 F250 Will Not Start
I have a 2000 f 250 that will not start... I have replaced many parts all electronic sensorsm the past week i have spent in the neighborhood of 1800.00 on this truck. Cps, icp, idm, ebps, fuel filter, new oil, hpop level good, gpr, all new need starting........
View 4 RepliesFord Super Duty (1999-2016) :: 2008 F250 4X4 Not Working All The Time
I have a 2008 Ford F250 with 6.4. Having alot of problems with the 4X4. Went to put the truck in 4 wheel drive one day and noticed the light on the dash never came on to engage 4X4. Of course we had a big snow storm coming and I didn't have 4 wheel drive. I drove the truck across town and decided to just try 4x4 again and it worked that time. I got the light on the dash and could hear the transfer case shift motor engage. Came out a little later and tried it and it wasn't working again. Took truck to shop where they replaced transfer case shift motor with a remaned motor from oriellys.
4x4 worked for a few weeks then just started doing the same thing again. We thought maybe that motor had problems also so had it replaced too. Truck is still doing the same stuff. Sometimes it works sometimes it doesn't. Figured out that if its not working and I leave it in 4x4 and unhook power to shift motor then plug it back in it will engage 4x4. I've seen some post on here but sounds like everyone i've seen their motor just stops and doesn't work at all.
Ford Super Duty (1999-2016) :: F250 V10 - Fuel Gauge Not Working
1999 F250 V10 gas. I changed out the fuel pump, and now the gauge doesn't work. Checked all fuses - they're good. Is there any possibility that I could have accidentally pinned the float under the pickup sock, or got it hung somewhere? Is this a common occurrence? Don't really want to drop the tank again - but looks like I will have to in order to check/fix.....
View 3 RepliesFord Super Duty (1999-2016) :: 2004 F250 6.0 - After 10 Minutes A/C Not Working?
My A/C has been working fine up til the end of last season and getting worse now. It comes on and blows really cold, then after a bit a electrical connection gets hot and looses contact somewhere. I can turn it off for about 5 miles then turn it back on, May last the rest of the day, may only last 10 min, then turn it back off, wait 10 min, turn on, does great! I thought it might be a dampener door,, but does the same whether in defrost, regular A/C, or max, so I think it has got to be a electrical connection getting hot and loose.
2004. F250 FX4. 198,000 miles,,,, runs great,,, just a little hot driving!!!
Ford Super Duty (1999-2016) :: 2001 F250 - Cruise Not Working
I have a 2001 F250 with 7.3.... We swapped the auto for a zf6 manual.... We left the auto's shift position sensor tied to the frame and left in neutral. I did install a pcm from a manual transmission pickup. Also have the clutch position switch hooked up. I have an Edge Evolution CTS2 reprogrammer, and on the display the gear indication always shows P. I suspect that is why my cruise doesn't work. For interests sake, I tried manually adjusting the shift position sensor through all gears, and the reverse lights come on when in reverse but the Edge's display always shows P. My question is with a manual transmission, how does the pcm know that it is in gear? The only sensor that I am aware of is the reverse sensor on the zf6.
View 2 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Airbag Light Came On?
my 00 f250 has the air bag light on all the time. it does not flash it just stays solid. it was like this when i bought the truck @3 months ago. also the passenger air bag switch does not light up when you use it. is this causing my airbag light to stay on?
View 9 RepliesFord Super Duty (1999-2016) :: 2000 F250 - AC Just Blows Hot Air When Turned On
I just bought the truck and the ac was working and now out of nowhere when you turn it on it just blows hot air so I just assumed it was out of free on so I bought an ac pro but that did nothing.
View 5 RepliesFord Super Duty (1999-2016) :: 2000 F250 Miss Only At Idle
I have a 2000 F-250 V10 that misses (cylinder 10) at the idle, once you give it gas it runs correctly again. I am at a loss. I have replaced the plug, tried moving coils from one cylinder to another to see if it shifts the miss, and it has new injectors. What this could be?
View 9 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Brakes Getting Soft
So a few week back I noticed my brakes were getting soft. Soft meaning that when braking for any distance, I would hear a kind of "pressure release, squeaking" sound coming from the pedal, and the pedal would sometimes go to the floor and the ABS would kick in. Let me tell ya, its a pretty crappy feeling when your brakes aren't doing what their supposed to! So, I replaced the pads all the way around, replaced the master cylinder (bench primed). I took it out for a drive, and it did the same thing. So thinking maybe the fluid is bad, I flushed new fluid through the lines. Took it for a drive, and it felt good right away, the pedal firmed up a bit, and then it did did it again.
Just so I give as much info as possible, the rotors are looking pretty rough and going to be replaced soon.
So, my question[s] are; What is the next step in identifying the problem? Is there a chance the new master cylinder is bad? Could worn rotors cause the caliper to max out and not apply enough pressure? Even though the calipers seemed fine while replacing the pads, could one or more be bad? If so, how do I know?
Ford Super Duty (1999-2016) :: 2000 F250 5.4 - No Compression On Cylinders
I have a 2000 ford f250 5.4 2v that's been having a shaking at idle and no power what so ever. I tried diagnosing it myself and came up with nothing. I finally decided to take it to the dealer and they are telling me that the right side has no compression on 3 cylinders. They want almost 7000 for a new engine. I was wondering if it was possible to get away with just putting a new head on the right side?
View 13 RepliesFord Super Duty (1999-2016) :: 2000 F250 - No Air From Dash Vents
I have a f250 with 6.8l engine. I can get air thru the defrost and to the floor, but no air thru the dash vents on me. I have traced all vacuum lines and they seem fine.
View 1 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Knocking And Smoking
Does it need a diesel fuel injector?
View 2 RepliesFord Super Duty (1999-2016) :: F250 - Cruise Control Working Intermittently
1999 F250.. What would cause my cruise control to work sometimes and not others. it may work today and not tomorrow.
View 2 Replies