Camry :: Idler Pulley Replacement On Serpentine Belt Tensioner
2002 Camry 4 cyl. Can the idler pulley alone be replaced on the serpentine belt tensioner? I noticed a very slight side to side play when I had the belt off. No noise from it. When I looked at rock auto, they sell the whole bracket with the pulley.
View 2 RepliesLexus RX 2004-09 :: Chirping Noise Coming From Belt Tensioner Or Idler Pulley
So from reading around a lot, it seems like the chirping is from the belt tensioner or idler pulley. That said, I've not been able to find anything definitive. I tried to do the water bottle squirt test (from Gates' youtube video) and either I did it wrong or the chirp did not go away implying the issue is not the belt. While I was looking in, I could see the tensioner shaking some.
If my tensioner should not be moving, do I just need the pulley or the pulley and the mount?
- Pulley [URL] ....
- Pulley and mount [URL] ....
Also, if the above items will fix the chirp, which brand would be best?
2007 RX 350, 113K.
Chirping gets worse as it heats up. Seems to happen independent of ambient temperature. Purchased a year ago so unsure of the history of part changes.
Ford Ranger / B-Series :: 2000 - Power Steering Pulley Wobbles Slightly / Belt Squeaking
I purchased a new 2000 mazda b4000 2 weeks ago and the belt was squeaking and I knew I had to change the water pump so I replaced it and the squeaking didn't went away... I thought maybe my idler pulley bearing was worn out cause I could see it wobble back and fourth when the engine was running... Replaced it, still squeaking! Change my belt still squeaking! look further turns out my power steering pulley wobbles slightly. I'm thinking about trying a gator back belt and see if the squeaking goes away. Could it be dangerous to run the truck as it with a slight misalignment in the power steering pulley? or it'll be a must replacement asap?
View 3 RepliesFord Ranger / B-Series :: Installing Timing Belt?
I've tried every variation of installing the timing belt on my '91 2.3L Ranger, still not in. The belt seems as if it's too short but I've been told that it "barely" fits, no kidding! I've pulled the crank balancer/timing trigger off and put it back on three or four times already. What's the trick? Everytime I get it close I'm off a tooth or more. Just frustrated, tired of hitching a ride to work.
View 14 RepliesFord Ranger / B-Series :: 1998 - Belt Started To Squeak
I have a 1998 ranger 4.0 and about a year after getting it the belt started to squeak so far if have replaced the belt, replaced the tensioner, and cleaned and wire brushed all the pulleys to remove glazing. And it still squeaks and its annoying and kinda embarrassing...
View 4 RepliesFord Ranger / B-Series :: 1996 - When To Change The Timing Belt On A 2.3L
What is the recommended interval for the timing belt change? I have a '96 B2300 with ~85K on it and he original timing belt. I wanted to change the serpentine belt and my mechanic said he'll take a look at the timing belt. It's not cracked or anything but he says that after 8 years it should be changed.
View 14 RepliesFord F-150 - 1997-2003 :: Noisy Serpentine Belt - Crank Pulley Squeak?
Been trying to isolate my noisy serpentine belt. Had the belt off and spun everything, only thing I found that made any noise was the alternator. It had a nice churp like a bearing was on its way out in it. So I replaced that figuring my squeak was going to go away. No such luck. Listening to it again while it was idling, I crawled underneath. Almost seems like the churping noise is coming from the Crank Pulley. Is there a bearing on this pulley that goes bad?
View 13 RepliesFord - Taurus :: Serpentine Belt Squeak Due To Contamination / Timing Cover Leak
My serp belt squeaks due to contamination due to timing cover leak. I removed belt and cleaned it with mild degreaser solution and it was quiet for 1 day. If I had 100% water in cooling system, would any more leakage cause a belt squeak? I am putting off fixing timing cover gasket since it is a 5hr job. Coolant is @ 90% water concentration now.
Taurus 3.0 Vulcan motor.
Honda - Pilot :: Timing Belt Frayed Broke Due To Idle Tension Pulley Failure
I am working with Honda dealership management because I had my timing belt changed at 102,000 miles and 25,000 miles later The belt broke and frayed while driving in heavy traffic at night on freeway leaving me stranded in the median luckily instead of in the middle of the freeway. Honda dealership stating that the idle tension pulley caused the fraying of the belt not due to poor workmanship by their mechanics. I am asking dealership to consider assisting in payment because the day the belt went out, the car had been serviced for a oil change.
When I was called to be notified the job was complete I asked the service rep questions about the oil transmission and told him there was a noise in the engine could they check it or did they check it which she replied no that I would have to make another appointment for that. So even if I would've made appointment the next day the damage was already done because that night is when the belt broke Is this part of Hondas responsibility is it reasonable for them to take part responsibility. Also if the idol tension pulley had been changed at the same time of the belt, it would've saved my engine. So this is all my responsibility not theirs?
Ford Excursion :: Idler Pulley To The Right Of Alternator On V10
My Ex is missing the label showing the serpentine belt routing diagram. I pulled one off the Autozone website for V10 with AC. It showed that there are 2 idler pulleys (one on the left and right side of the alternator). It also has the tensioner pulley.
I only have a tensioner on the left side of the alternator. The one on the right is missing. There appears to be a threaded hole where a pulley should go. Since I bought this used, I thought the previous owner took it off.
I used the bolt from the old tensioner pulley I replaced for the hardware and put a new pulley on.
I also looked at other V10s on used car lots and none of them had the pulley to the right of the alternator. Should there be one there?
Ford F-150 - 1997-2003 :: Replacing Idler Pulley?
An idler pulley on my 2002 F-150 seized and snapped the serpentine belt. The pulley is below and to the left of the belt tensioner. The pulley doesn't have a bolt but a hole that looks like an allen wrench would fit it. I couldn't find an allen wrench to fit it. Called AutoZone and they have a pulley removal tool in three sizes. What size wrench would fit the idler pulley? I want to make sure I get the correct size tool so as not to screw up the pulley when I start pulling on it.
View 2 RepliesFord F-150 (2004-2008) :: Whining Noise - Idler Pulley Going Bad?
I noticed my engine whine more than it usual since the last few days. So, I took it to the dealership and have them check. They said that it is the idler pulley going bad. Just want to see some info on diagnosis.
View 6 RepliesFord F-150 (2004-2008) :: Top Right Idler Pulley Bolt Broken
Doing some charity work on a '04 5.4. Noticed top right idler pulley was sitting on a 45* angle, figured it was shot and decided to replace it. The bolt broke. Borrowed an Easy Out. Short version, I have a very messed up bolt hole. Tried drilling and tapping but couldn't get it to bite and was scared to go bigger. I don't know if the threaded part pulley actually mounts can be replaced and if so how to go about it. Not sure how much deeper I can drill if it can't be replaced? At a standstill.
View 1 RepliesGolf IV / Jetta IV :: Timing Belt Squeak Only Seems To Occur When In Motion And Let Off The Accelerator?
2.0 Jetta with AEG engine.
I've been plagued by a belt squeak for several months now that only seems to occur when I'm in motion and let off the accelerator. I'm thinking it's the timing belt so I took the top cover off to have a look. What I found is the belt is a bit off center on the top sprocket, although it doesn't look frayed and isn't hanging off the edge.
I found that the tensioner seems to wiggle slightly when I try moving it by hand. It doesn't look like it wobbles when the car is running, but I've never been able to see in the engine compartment when the squeak occurs. The belt also appears to have some shine on a line down the center. Pictures attached.
FWIW, I checked for play in pulleys on the aux belt and found none. What's everyone's opinion on the tensioner and the condition of the belt? The belt has 52,000 miles on it.
Ford F-150 (2004-2008) :: Whining Noise From Engine - Idler Pulley?
I noticed my engine whine more than it usual since the last few days. So, I took it to the dealership and have them check. They said that it is the idler pulley going bad.
View 4 RepliesFord 6.0L Power Stroke Diesel :: Idler Pulley Bearing Part Numbers
I need to replace the bearing on my Idler pulleys, both smooth and grooved. I also want to replace the bearing on the tensioner pulley. What are the part numbers and the best place to order them from?
View 10 RepliesFord 6.0L Power Stroke Diesel :: Doing Idler And Tensioner Pulley Bearings - Fan Shroud Removal?
Looking for how to's out there on how to get all of the fan shrouding removed? I am trying to do my idler and tensioner pulley bearings and those shrouds really make it tough.
View 6 RepliesSanta FE SM (2001-06) :: Idler Tensioner Pulley Seized
I have a 2003 Santa Fe 2.4. Couple days ago my idler tensioner pulley or whatever its called seized up and took the belt out with it. I got a pulley that resembles it from Autozone mind you that it was the only parts store that had one in stock even Hyundai didnt have the part. The only difference is the hole size for the bolt is about 1/4 inch bigger then the stock pulley. Is there any chance I can get a spacer and make up for the difference?
View 6 RepliesSonata NF (2006-10) :: Idler Pulley Bearing Has Become Quite Noisy
The idler pulley bearing of my 3.3l Sonata NF has become quite noisy, as though it is running dry. Does this necessitate a complete pulley replacement or can it be disassembled and the bearing repacked (or if necessary replaced). I am becoming concerned that the bearing may fail altogether soon.
View 11 Replies