Ford Ranger / B-Series :: 1994 - Rear Brake Lock Up?

Under mild-heavy braking, the rear brakes on my ranger lock up... EVERYTIME. Not just when its wet, or humid. Everytime I hit the brakes hard they lock. I think I'm getting little, to no pressure to the front brakes either. Could it be just a Proportioning valve?

Truck is a 94' 4.0l V6, RCLB, Auto, 4X4.

View 6 Replies

Ford Ranger / B-Series :: Brake System Bleeding With Rear ABS

It is a 1994 Ranger XLT, Regular cab, two wheel drive, manual transmission and I think it has rear ABS. A front brake line blew which drain the master cylinder. Also a couple of pieces of brake line at the rear had to be replace along with the rear wheel cylinders. After installing the new brake system components we were trying to bleed the system. After reading the repair manual I had it said that vehicles with rear ABS you are to bleed the ABS module before bleeding the rest of the system. There is a module where the book described it (driver's side inside the frame rail) with brake line running to it. I am assuming this is the rear ABS module? I didn't see anything that looked like a bleeder on the module. Where to look? Also when I open the bleeders on the rear wheel cylinder no brake fluid came out.

View 14 Replies

Ford Ranger / B-Series :: 1988 - Rusted Rear Brake Lines

I am going to fail State safety inspection due to a problem with my brakes. Months ago when I was trying to get it through emissions testing the mechanics looked under the truck to see where the brakes were leaking. All they told me was the rear lines are rusted through and need replacing.

From my reading I believe the lines are 3/16" line and I think they go around the back of the fuel tank and up the frame rail. Correct?

My questions are, what length line do I need (I am not a hard-line expert, but I will try). I want to order some ss line so it won't rust through again. Is the system made of small sections threaded together? Or is it one long section? And what else would I need/want to replace along the way?

View 14 Replies

Ford Ranger / B-Series :: 1990 - Rear Brakes Locked Up When Hit The Brake Pedal Hard

I have a 1990 4x4 ford Ranger, the little truck was purchased in early 2008 as a work truck but has ended up becoming my main vehicle, it has been a good truck for the most part but know I am having some brake issues, well have been having for some time but they seem to come and go. Usually it happens when I have to hit the brakes hard, the rear brakes lock up, I replaced the master cylinder months ago and thought that fixed it, then a month later it happened again. The last time it happened was friday, the time before that was in march 09'.

I have searched this online and found numerous try this but the original poster never comes back to say if the problem is fixed or what fixed it. My ABS light DOES NOT come on when this happens, it does function properly, it illuminates when the key is turned on then goes off. My parking brake no longer works either but I think that is from me "driving thru" the locked up rear brakes. I plan on replacign both drums and shoes within the next week but would like an option to repair the locking up issue.

View 14 Replies

Ford Ranger / B-Series :: 1996 - Clutch Pedal Locks When Hot

I've had my truck a few years now but for 2 it was basically parked. When I started trying to use it again I am having issues with the clutch now. When it is cold everything is fine, but on hot days or after I have been driving for a while It will lock the pedal up and will not let me dis-engage the clutch at all. Sometimes when it does eventually let the pedal down it will go to the floor and stay there for a few seconds until it slaps back up and engages slamming the truck into gear.

I have yet to try much. I'm not good at working on anything other than stereos in cars but I am willing to try. My thought is some water got into the system and is boiling in the lines but I am not sure. Places to start? I really need my truck going and the couple places I've taken it dont even want to try it seems like.

View 2 Replies

Passat (B5) :: 1999 - Electric Door Locks On Left Side Won't Work Intermittently?

The electric door locks on the left side of my '99 Passat sometime don't work. The left rear works 90% of the time, but sometimes it doesn't lock. All I have to do to get it to work is unlock all the doors with and then hit lock and that cures it every time, and I have been living with that for 3+ years. The driver door lock sometimes decides to not lock or unlock at times. Normally it starts working on it's own when it feels like it, but again, it works 90% of the time. What the likely cause should be and how to go about getting it fixed?

View 1 Replies

Ford Ranger / B-Series :: 1992 - Both Power Door Locks Won't Working?

So I've got this 1992 Ranger extended cab with power door locks and neither side is working. It has power windows too and they work fine. I checked the 30amp fuse under the hood for the power door locks and it's good and checked it with a test light and it's good. What's most likely the cause that both sides don't work? Is there a way to troubleshoot with a test light to trace down the problem as a bad switch or actuator?

View 10 Replies

Ford Ranger / B-Series :: 1996 - One Of Tire Locks Up When Coming To A Stop

I have the problem that my 1996 ranger 4x4 has a break problem. When it comes to a stop it feels like one of the tires locks up, feel wired. Ihad the problem before i changed the front breakpads and it still continues. Air in the lines? ABS module?

View 6 Replies

Ford Ranger / B-Series :: 1999 - Power Door Locks Installation?

I'm finally bringing my 99 regular cab to Texas next month and I'm putting together my first list of upgrades to do it. On the top of that list is a remote start system. I am considering installing power door locks so I can install a nicer RS system. It would allow me double my starting distance and take strain off my already bad back since I won't have to lean across the cab to let people in.

View 2 Replies

Ford Ranger / B-Series :: 1991 4WD Manual Tranny Locks Up After Going Forward A Few Feet

My 4x4 4WD Ranger has a 5 speed manual tranny that locks up after going forward a few feet. It can back up all day long but locks up going forward. some god awful noises (grinding, clunking, etc) come out of that gearbox. the 4wd is electrically operated. the ? is , can this tranny be rebuilt with a kit? I'm having great difficulty finding a replacement. Are bronco II's compatible? Engine is 2.9L V6. On disassembly I found 2 meshing gears with broken teeth.

View 5 Replies

Ford Ranger / B-Series :: 2002 - Door Locks Attempting To Activate When Turning The Ignition Key?

Having problems with their door locks attempting to activate when turning the ignition key? If so, how can I correct it or make repairs.

View 3 Replies

Prius (2010-12) :: Brake Locks Up With Indicator When Stopped Intermittently?

This has happened twice now, about a month ago and then again today.

I was stopped at a light with my foot on the brake. There is a clunk noise, then the indicator light comes on.

The first time I tried to go, and the car stayed put. I hit the parking button, then went back into gear, no problem.

The second time I just put it in park and then back to gear. No problem.

View 19 Replies

Ford Ranger / B-Series :: 1995 - No Power Windows / Door Locks - Wipers Work When Buzzer Dinging?

Just picked up the truck 1995 Ranger XLT. 3L...5spd...4x4...no power windows or door locks. The key buzzer only buzzes for a few seconds, if you move the ignition it buzzes for a few seconds each time its moved. The wipers only work when the buzzer is dinging. Also..the wipers when turned off stay in the up position. I replaced the ignition key mechanism and the on off wiper relay. What am i missing in this weird scenario??

View 1 Replies

Ford Ranger / B-Series :: 2000 - No Start Intermittently?

I have a 2000 Ranger 4.0L with intermittent no start. Have spark, fuel pressure is 55psi, temp sensors are reading correctly. When there is a no start condition I can pop the scharder valve, relieve the pressure on the fuel rail and it will start.

View 3 Replies

Ford Ranger / B-Series :: 1997 - Won't Start Intermittently?

1997 2.3 Ranger w/ 160,000 mi. Every few months it won't start, sometimes after just having been running fine. Symptoms:

-the dash lights will be dim or off completely
-the chime will be softer than normal
-the headlights will not work, or be dim
-the starter will sometimes briefly click, sometimes crank once, sometimes do nothing
-the emergency flashers will sometimes click much faster than normal
-if during one of these "episodes" it does start, the battery light will sometimes flutter on and off, and the meter will flutter a little higher than normal. The next time I stop it, it typically will have the same problem.
-it will typically start if i get it jumped

My battery, starter, plugs and wires are all fairly new. On occasion, when it is having this problem, and I am trying like crazy to start it, if when I turn the headlights on and they are no longer dim, it starts right up and runs fine.

View 7 Replies

Accent LC (2000-05) :: Left Front Brake Locks Up

I have a 2001 Accent GL 1.6l automatic non ABS (original owner) with no real issues until last month when the left front brake started locking up. Sometimes within a mile sometimes after ten. The brakes go from normal pressure to hard as a rock unable to move the brake pedal even when I bleed off the booster. I've researched every site then proceeded with the following work.

Changed the front pads, rotors, calipers, rubber lines plus the back brake cylinders, rubber lines and master cylinder then bleed the system using a power bleeder... all to no avail. As a last resort I replaced the booster, still no change.

I've checked the brake pedal and the booster pushrod adjustment. Eventually took it to my mechanic. After two days he told me he was stumped as well.

The only thing left is the rear brake proportioning valves on the left side of the brake cylinder. Can't figure out how they would be causing the left front brake to lock up if indeed that is the problem.

There are no kinks in the lines, no air in the lines, bleed almost a gallon of brake fluid through the entire system and still zip... Frustration and anger has left me for despair and total confusion and a 700+ dollar hole in my pocket.

View 5 Replies

Ford Ranger / B-Series :: 1994 B2300 ECU Relay Intermittently Does Not Come On

Ok I have 94 B2300 and about every 3rd or 4th start the ECU relay will not come on / energize which the the fuel pump relay doesn't come on either to prime the fuel system... so no start! It's very intermittent and sometimes the only way I can get the truck started is by pulling out the ECU relay and plugging it back in even sometimes that doesn't work too. Is it a bad relay or bad base the relay plugs into or is the ECU/computer going bad or is there wiring messed up in my ignition switch? Is there a known problem like this with these trucks?

View 7 Replies

Ford Ranger / B-Series :: 1996 - Odometer Work Intermittently?

I have a 96 ford ranger 4cyl 5 spd. I've only had it for a month or so, but I've noticed on cold mornings my odometer won't work. The trip or the total mileage. I can hear the odometer cable clicking. Once the cab gets warmed up it'll start working. It's only happened twice, at about 50 degrees or lower, so I can only imagine what'll happen once winter kicks in. Where to go from here? I was thinking maybe it needs to be re-lubed or something...

View 9 Replies

Ford Ranger / B-Series :: 1996 - 3rd Cylinder Misfire Intermittently

I figured something out on my ranger that has been bugging me for a while it was a third cly misfire so I changed the plugs and it went away for a while.the po told me he had just changed the plug wires so i didn't mess with those and it was an intermittent misfire so i changed the brain box because it was 15.00 at pull and save and it had been all updated boy did it run smooth for a while then the misfire came back. So I decided to check the 3rd cylinder plug wires and found out the one that is hard to change on the drivers side was badly rusted so i borrowed one off my windstar it was a little longer but boy does it run smoother and it doesn't die all the time and chug chug all the time now i just need to change the battery. i have already changed the clutch and the tranny twice i took one out of an 88 and it fit just fine by the way the engine is a 2.3 8 plug engine with over 230,000miles on it my next project is a timing belt and a heater core won't that be fun and yes i smell the antifreeze inside and don't like the stop leak like the last person put in.

View 2 Replies