Ford Excursion :: 2001 - Tranny Fuse Blowing - Electrical Malfunction - Wiring Diagram?
I posted earlier about the tranny in my 01 Ex v10 having a transmission problem. The show looked at it and found the O2 sensor had shorted out and in some way sending the truck in to limp home causing the tranny fuse to blow????
Any way they fixed it or so they said and I drove it for a few hours and it did fine. The next morning I drove it and it blew the fuse. (under hood box I belive #19) I took it back to the shop and they beat and banged on it....got it wet etc. and can not get it to do it again. I know whe have an electrical issue but what all runs off of the fuse that controlls the tranny?
Is there any online wiring diagrams of excursions or superduty drive trains? Where all to look for the problem?
Passat (B7) :: AC Started Blowing Hot Air - Wiring Diagram For Sensor / Fuse Panel
My wife's 2013 Passat started blowing hot air. I checked the fuses and they are ok. I looked at the sensor switch for the AC on the passenger side of the engine compartment and it looks like the wire caught on something and frayed/cut through. I don't see where it went through to fix. Finding info on this car is a slight challenge. The owners manual doesn't even have a map of the fuse panels.
View 3 RepliesFord Ranger / B-Series :: 2003 3.0 2WD Auto - Fuel Pump Wiring Diagram?
I'm working on a truck for a friend's mother and all of the tests that I've done point to the fuel pump. However, to make sure the pump is getting voltage past the large connector block under the cab, I would like to do a pin-out test before I pull the tank (or the bed). The pump will not run/prime in KOEO test, the relay is good, as are all of the fuses and the inertia switch.
Looking for a wiring diagram handy for this purpose? I've look all over this forum and searched quite extensively and I haven't found one for this year. Since it isn't my truck, I don't feel like purchasing a manual. I'm working on a 2003 3.0 2WD Auto.
If a wiring diagram isn't available, what colors are the wires going to the fuel pump? That way I can at least test the ground and the positive.
Ford Ranger / B-Series :: 1999 - 4 Wheel Drive Quit Working - Wiring Diagram?
My son has a 99 ranger and the 4 wheel drive quit working. Traced it to the front hubs not getting vacuum. If I jump around the vacuum solenoid(not sure if that's what it's called), the 4 wheel drive works. Looking for a wiring diagram that shows how this is supposed to work electrically?
View 5 RepliesFord Ranger / B-Series :: 2.3L - PCM Fuse Keeps Blowing
Description: It will crank over forever but not start. New timing belt water pump, etc, so it is not timing. tried different fuel pump relay. no luck. new fuse no luck. The radio fuse also shorts and blows when I change it. Headlight does not come on, but the cabin "ding ding ding" sound plays. Marker, turning, reverse, and brake lights work.
CHECK ENGINE LIGHT does not come on during key turn. I may know what caused it or it may not. Before all of this happened, my audio system fuse under the hood blow. It blew again after I installed a new fuse (immediately).
One day, the wires on a portable cigarette light pump snapped and the two wires had been touch. I noticed the truck stalled several times when letting off the gas and coming to a rolling stop. The fuel pump relay makes a click noise when I turn the key
Ford Ranger / B-Series :: 2000 - Fuse Keeps Blowing On
2000 Model, The fuse keeps blowing on this. I thought it was the cruise control fuse because the cruise kept not working and when I replaced fuse it would work. Only for a little though, then I looked at manual and it says the fuse is for the brake position switch. I am presuming this is just like the old days and that is the brake light switch under the dash. They use to have two wires now there is like five. Anyways I do not see any bare wires or anything that would blow a fuse, is it common for these switches to go out or what??
View 13 RepliesFord Ranger / B-Series :: 1991 2WD - EEC Fuse Keeps Blowing
My dad's 1991 Ford ranger 3.0 2wd just died on him when he was driving home and I checked to see if the truck had a spark and it did not so I replaced the ignition control module, then ignition coil, then distributor and rotor cap(plug) and I put new plugs and wires on it a few months back too. I also checked to make sure that the timing chain was working as well (while I had the distributor cap off). Then I realized that the EEC maxi fuse was blown. I then found a fourm that said it might be the relay so I replaced the EEC and the fuel pump relays while I had them both out. Every time I put a new 30 amp fuse in the EEC slot and turn the key to start it the fuse blows and the truck won't start. What might be wrong?
View 1 RepliesFord Ranger / B-Series :: Reverse Lights Fuse 26 Blowing
Since last summer my truck keeps blowing fuse 26 and then I have no reverse lights. If I replace the fust its ok for a bit but blows again the same day sometime. The book says its the fuse for revers and overdrive. The overdrive button on the tree shifter stops working too but the truck does not seem to be revving any higher so I think the overdrive itself is fine. I can't find the short but its got to be shorting somewhere...
View 14 RepliesFord Ranger / B-Series :: 1992 - EEC Relay 30 Amp Fuse Keeps Blowing?
I recently got a ranger from my buddy and it keeps blowing the EEC fuse in the engine compartment. We have replaced the EEC relay and the EEC power relay. As soon as you turn the key it is blowing the fuse.
View 1 RepliesFord Ranger / B-Series :: 1996 - Fuel Pump Fuse Blowing
My 1996 Ford Ranger's Fuel Pump- Fuse keeps on blowing... (Fuel pump is new)... We need to find where the short is coming from!
View 2 RepliesFord Ranger / B-Series :: 1986 - Brake Light Fuse Keeps Blowing
I've got an 86 ranger sport and I'm having trouble with the lights. The turn signals work, and ALL 4 bulbs in the back are new. The brake light fuse keeps blowing, and the fuse for the tail lights is good but they won't come on at all. I was told there was a direct short somewhere, does that sound about right? And is there a common place where they tend to short out?
View 2 RepliesFord Ranger / B-Series :: Fuse 11 In Battery Junction Box Under Hood Keeps Blowing
fuse #11 in the battery junction box under hood keeps blowing, the last time I put a fuse in it blew immediately, key was off and lights off. Fuse is for parking lights, dash light and I/P(whatever that is) and switch illumination lights. I have to start following all wires to find bad spot. May just put in piece of metal and watch for smoke...
View 3 RepliesFord Excursion :: Wiring Diagram For Trailer Wires From Fuse To Plug
My park lamp circuit is dead. I have tested with a multi-meter and there IS power at the fuse. However, no power at the plug. I have pulled the bumper and found the plug for both the rear taillights (the park lamp circuit WORKS in the taillights) and the trailer wires. Confirmed it is dead there as well.
Both bundles go into the frame rail at the fuel tank, but I not sure which is which where it comes out at the firewall. A web search did not reveal a diagram and the Ford repair CD I have does not list Excursion diagrams.
Ford Wiring/Electrical :: Overdrive Fuse Keeps Blowing
Overdrive fuse keeps blowing. Drive one and 2 shifts fine. 3 and overdrive don't work. Had transmission checked it is fine. Repair shop says it is electrical.
View 1 RepliesFord Wiring/Electrical :: Fuel Pump Keeps Blowing A Fuse
I have a 1994 Ford Ranger king cab 4x4 with a three inch lift kit on it . My problem is the fuse is blowing that goes to the fuel pump . It started out blowing the fuse now and then when it was raining . Well I thought it mite be the fuel pump going bad but after I put the new pump in the truck it lasted about a week and started blowing fuses again . I put another fuse in and it go a few days and blow it . Last week on a 100 mile tripe I got almost there and it burned a fuse on the highway . I tried to put another fuse in and it would blow it as soon as I tried to start the truck . Burned five fuses right then . So I had it towed to mothers house and put another fuse in and it cranked up . I looked at the wiring that was not wrapped in that plastic cover stuff and have not found anything yet ...
View 14 RepliesFord Wiring/Electrical :: Running Light Fuse 17 Keeps Blowing
2006 F-250 SD... I Keep popping the 15A #17 fuse under certain conditions - Driving forward
1. Start with good fuse.
2. Start engine, while in park, turn on parking light...4.8A on circuit. No problems.
3. Put into reverse and drive. down the block around the corner and back up to the house... No problem. 4.8A on circuit.
Put the shifter into drive and - POP - the fuse goes. I never see a jump in the current. 1-5 seconds until fuse goes. While conducting testing, I have had the fuse blow when shifting from reverse to park. Looking at the wiring diagrams, I don't see a common wire that would cause a short when shifting. What I should try next?
Ford Ranger / B-Series :: Vacuum Hose Diagram?
Where I might be able to find a vacuum hose routing diagram for a 2.9? I have searched high and low but with no luck.
View 14 RepliesFord Wiring/Electrical :: 2005 - AC Clutch 4x4 Solenoid Fuse Blowing
My 2005 4.6L 4x4 screw is blowing the 10amp a/c clutch, 4x4 solenoid fuse whenever i turn the a/c on, at times whenever I turn the defrost on. the fuse does not blow when i turn the key to power (no engine start) but when engine is running fuse will trip. I disconnected elect. Connection at compressor and fuse still blows, also seems like no power or life from compressor.
View 3 RepliesFord Ranger / B-Series :: 1997 - Speedo / Cluster Diagram?
I have a 97 ranger 2.3L (manual transmission) and want to change the cluster to one with a tach... I have a 2000 cluster but I would like to compare the actual wiring between the two (1997/2000)... I have looked in the Ranger technical area of these forums and also did a search for "dash cluster wiring" and found no info...
View 4 Replies