Dodge - Stratus :: 1996 - Fuse 20 For Fuel Pump And Ignition Keeps Blowing
I have a '96 Dodge Stratus that keeps blowing fuse #20, which is for the fuel pump and the ignition. How to isolate the problem? This happens as soon as the key is turned on. The car has 140,000 miles and runs excellent otherwise.
View 3 RepliesFord Ranger / B-Series :: 1997 - Spit / Sputtered And Died - Fuel Pump Fuse Blown
I drove my truck 2 times the day it stopped running. The 3rd time I tried to leave it started moved about 2 ft, spit and sputtered and died. It had blown the fuel pump fuse. I changed it and checked the fuel shut -off in the cab, passenger side. It was not tripped. Tried to start it and as soon as I turned the key it blew the fuse again. I changed the fuse again and this time I changed the fuel relay and the switch in the cab. Turned the key and it blew the fuse right away. Went to AutoZone because they are close to the house described what it was doing to them and they said sounds like a short in the fuel pump.
I purchased a new pump put it in turned key blew the fuse, pump just clicked...I found this site and my son noticed a thread where it said wires under the cab are good for wearing through and grounding out. I looked and it did wear through one wire coating. We taped it up, put extra cover over it and now it does not blow any fuses. Fuel pump still just clicked. Took fuel pump back for an exchange.....same thing. Turns over but fuel pump will not pump fuel. What am I missing?......
Ford Ranger / B-Series :: 2.3L - PCM Fuse Keeps Blowing
Description: It will crank over forever but not start. New timing belt water pump, etc, so it is not timing. tried different fuel pump relay. no luck. new fuse no luck. The radio fuse also shorts and blows when I change it. Headlight does not come on, but the cabin "ding ding ding" sound plays. Marker, turning, reverse, and brake lights work.
CHECK ENGINE LIGHT does not come on during key turn. I may know what caused it or it may not. Before all of this happened, my audio system fuse under the hood blow. It blew again after I installed a new fuse (immediately).
One day, the wires on a portable cigarette light pump snapped and the two wires had been touch. I noticed the truck stalled several times when letting off the gas and coming to a rolling stop. The fuel pump relay makes a click noise when I turn the key
Ford F-150 - 1997-2003 :: Fuel Pump Fuse Keeps Blowing
I have a 2000 F150 with @175K miles. Replaced the clutch about a year ago, replaced the front calipers a few weeks ago, due to the right front locking up on my way home from work. Since then, when I try to start, it blows the fuel pump fuse. (#10)...
View 2 RepliesFord Wiring/Electrical :: Fuel Pump Keeps Blowing A Fuse
I have a 1994 Ford Ranger king cab 4x4 with a three inch lift kit on it . My problem is the fuse is blowing that goes to the fuel pump . It started out blowing the fuse now and then when it was raining . Well I thought it mite be the fuel pump going bad but after I put the new pump in the truck it lasted about a week and started blowing fuses again . I put another fuse in and it go a few days and blow it . Last week on a 100 mile tripe I got almost there and it burned a fuse on the highway . I tried to put another fuse in and it would blow it as soon as I tried to start the truck . Burned five fuses right then . So I had it towed to mothers house and put another fuse in and it cranked up . I looked at the wiring that was not wrapped in that plastic cover stuff and have not found anything yet ...
View 14 RepliesFord Ranger / B-Series :: 2000 - Fuse Keeps Blowing On
2000 Model, The fuse keeps blowing on this. I thought it was the cruise control fuse because the cruise kept not working and when I replaced fuse it would work. Only for a little though, then I looked at manual and it says the fuse is for the brake position switch. I am presuming this is just like the old days and that is the brake light switch under the dash. They use to have two wires now there is like five. Anyways I do not see any bare wires or anything that would blow a fuse, is it common for these switches to go out or what??
View 13 RepliesFord Ranger / B-Series :: 1991 2WD - EEC Fuse Keeps Blowing
My dad's 1991 Ford ranger 3.0 2wd just died on him when he was driving home and I checked to see if the truck had a spark and it did not so I replaced the ignition control module, then ignition coil, then distributor and rotor cap(plug) and I put new plugs and wires on it a few months back too. I also checked to make sure that the timing chain was working as well (while I had the distributor cap off). Then I realized that the EEC maxi fuse was blown. I then found a fourm that said it might be the relay so I replaced the EEC and the fuel pump relays while I had them both out. Every time I put a new 30 amp fuse in the EEC slot and turn the key to start it the fuse blows and the truck won't start. What might be wrong?
View 1 RepliesFord Ranger / B-Series :: Fuse 41 Keeps Blowing - Wiring Diagram?
Fuse #41 keeps blowing...scan tool says o2 sensor heater circuit malfunction. Problem is that when the o2 sensors are unplugged it keeps blowing fuse the second I hit the key. Where this short would be? I can't find a wiring diagram anywhere. ( I'm new to this forum and I'm sure there is a sticky somewhere..
DTC codes: P1451, P0743. P0750. P0760. P0765. P1747. P0135. P1409. P0755. P0155
Ford Ranger / B-Series :: Reverse Lights Fuse 26 Blowing
Since last summer my truck keeps blowing fuse 26 and then I have no reverse lights. If I replace the fust its ok for a bit but blows again the same day sometime. The book says its the fuse for revers and overdrive. The overdrive button on the tree shifter stops working too but the truck does not seem to be revving any higher so I think the overdrive itself is fine. I can't find the short but its got to be shorting somewhere...
View 14 RepliesFord Ranger / B-Series :: 1992 - EEC Relay 30 Amp Fuse Keeps Blowing?
I recently got a ranger from my buddy and it keeps blowing the EEC fuse in the engine compartment. We have replaced the EEC relay and the EEC power relay. As soon as you turn the key it is blowing the fuse.
View 1 RepliesFord Ranger / B-Series :: 1986 - Brake Light Fuse Keeps Blowing
I've got an 86 ranger sport and I'm having trouble with the lights. The turn signals work, and ALL 4 bulbs in the back are new. The brake light fuse keeps blowing, and the fuse for the tail lights is good but they won't come on at all. I was told there was a direct short somewhere, does that sound about right? And is there a common place where they tend to short out?
View 2 RepliesFord Ranger / B-Series :: Fuse 11 In Battery Junction Box Under Hood Keeps Blowing
fuse #11 in the battery junction box under hood keeps blowing, the last time I put a fuse in it blew immediately, key was off and lights off. Fuse is for parking lights, dash light and I/P(whatever that is) and switch illumination lights. I have to start following all wires to find bad spot. May just put in piece of metal and watch for smoke...
View 3 RepliesGolf IV R32 :: Fuel Pump Fuse Keeps Blowing
My R32's Fuel Pump Fuse keeps blowing. This started after driving my car in a bad rainstorm. I think water may have gotten in the door which could be causing the short, but I am not sure. This car has two fuel pumps as it's been modified. I know for a fact the main fuel pump works as it did prime after replacing the fuse (then letting the car sit over night then opening the door). Right after the fuel pump primed though, the fuse blew. I decided to replace the fuse and start the car. The car started and ran for maybe a second or two before the fuse blew. I took a look at this thread in regards to the fuel pump not working as I thought the fuel pump was dead till today. I was wondering what are the possible problems that could be causing the fuse to blow? Could it be the relay? Could it be the switch in the door shorting? Also, where would I find the relay? I know it's under the dash, but is it under the panel on the passenger side or driver side?
View 1 RepliesFord Super Duty (1999-2016) :: 2006 F250 5.4L - Fuel Pump Fuse Keeps Blowing
The fuel pump fuse keeps blowing intermittently. I would assume it's a wire grounding out somewhere but I can't seem to find one yet. I do have a faulty purge solenoid on the canister but I don't think that would cause this. The reset switch doesn't seem to be tripped either.
View 3 RepliesGrand AM :: 1993 Pontiac - Fuel Pump Fuse Keeps Blowing
Ok so I just bought this car, 1993 pontiac grand am se, from a neighbor. When I test drove it, the back seat was all unscrewed so I thought no biggie and it drove really nice for being a 1993. Ended up buying the car. I get the car home, husband puts seats back together and we go to leave for town and the fuel pump fuse blew. Put a new one in, go to start the car, fuse blows again! Tow the car home. Husband checks the wires to make sure there is no faulty wires. Has to reground the ground wire. Car then starts. Go to drive down my driveway and the dang fuse blew again! Mind you there is a new fuel pump in the car so we know this isn't what is wrong with it.
View 4 RepliesPlymouth :: Fuel Pump Fuse Keeps Blowing When Neon Turns Over
When I changed the alternator on my 2000 plymouth neon, I crossed the wires for the plug. Now the fuel pump fuse keeps blowing, when it turns over, which isn't often. I turn the key and nothing happens.
View 2 RepliesFord Ranger / B-Series :: No Power To Fuel Pump
The fuse and relay have been tested. There actually is 5 volts at the fuel pump. The truck was running OK when the clutch went out. It wouldn't start after the clutch was replaced. The inertia switch is OK. I don't know where to look now....
View 14 RepliesFord Ranger / B-Series :: 1999 - New Fuel Pump Still Wants To Die?
Anyway just got a new fuel pump put in my 99 3.0 Ranger and now after it's warmed up from a few miles it starts to choke and almost die. No CEL comes on and I just put new Motorcraft plugs in and still the same thing. I read something about maybe cleaning EGR.?
View 13 RepliesFord Ranger / B-Series :: 1996 - Fuel Leak / Dripping On Ground
I was adding some fuel from a can to my Ranger last evening and I noticed gas was dripping on the ground. I traced it to, as best as I can tell, where the inlet pipe meets the tank.
Cannot see up there at all so not sure how it is attached. How I might be able to repair it without dropping the whole tank. Some kind of goop I can reach up there with and lather on to try and curb the leak?