Ford Ranger / B-Series :: Truck Rattles When Going Up Hills
My truck rattles when going up hills. The higher the rpm,the more it rattles. It sounds like a heat shield shaking. Also, when I accelearate on a flat road, I hear this very light knocking sound.
Motor has 190 000 km and is due for an oil change. Spark plugs and plug wires have been replaced. Engine sounds good when I rev it. No abnormal sounds. So, what would be my issue? Carbon build up?
Ford F-150 - 1997-2003 :: Hesitates / Surges When Climbing Hills
03 supercrew 5.4. I've been having problems climbing hills. I'm on a trip and the truck surged fron do then to drive and stopped. Let it sit for 30 mins or so and it was good. Drove another 500 miles ans started again going up some hills. The first time it was 110 out and the 2nd it was 90. I'm pretty sure it's a cop but of course no cel. It does not seem to of over heated either. Can the cops overheat? Do you recommend a diagnostic, will this show up if no cel has show?
View 5 RepliesFord Ranger / B-Series :: Speedometer Dial Started Climbing When Driving On Highway - Erratic Readings
On my '91 last week I was driving on the highway about 60-65 when all of a sudden the speedo dial started climbing to 70-75-80-85 and past. The odometer seems to be working ok? Still when I drive it still operates in the same manner. It never bounces around or falls back. The needle is sort of stable such if I maintain a speed the speedo will maintain even though it's incorrect. There is a slight wavering of the needle meaning it's not as stable as it use to be. With the odometer working I was wondering and don't know. Does the cable drive the needle or is it electrically controlled? I'm thinking of grabbing another instrument cluster it that is the problem, I'd like to know more about it and understand how it works so I don't just throw parts at it until it's fixed.
View 1 RepliesFord - Explorer :: 2000 - Tranny Shifts Fine - Power Loss When Climbing Hills
I have a 2000 Ford Explorer with 188,000 miles on it. I bought it used with 110K miles and put a new tranny in at that time. Now, I am having problems. I don't know if it's the tranny or the engine. It looses power when climbing hills. It takes off really slow with no power and finally gets up to speed it switches gears the whole time smoothly but the engine just can't take a load.
The check engine light came on and put out 10 codes:
P1451 EVAP Control System Canister Vent
P1747 Electronic Solenoid A-Short Circuit
P0743-Torque Converter Clutch Circuit Electrical
P0750-Shift Solenoid "A"
P0755-Shift Solenoid "B"
P0760-Shift Solenoid "C"
P0765-Shift Solenoid "D"
P0135-O2 Sensor Heater Circuit
P0155-O2 Sensor Heater Circuit
P1409-EGR Vacuum Regulator Circuit Malfunction
Those are the codes and I don't know how one has anything to do with the other. I checked the dip stick on the tranny and it's clean. Juicy red and not shavings.
Hyundai - Elantra :: 1997 - Emits Blue Smoke From Exhuast While Climbing Hills
1997 Hyundai Lantra LS 1.8 5-speed. I live in a really flat area, but we're surrounded by hills and mountains. Whenever I have to go into the mountains I start to get blue smoke from the exhaust after a few minutes of climbing. The longer or steeper the hill, the more smoke I get. Obviously I'm burning oil, but I'm not sure what would cause the problem only when the engine is being taxed.
View 10 RepliesMazda - Mazda5 :: 2007 - Runs Rough - Diminished Power For Climbing Hills
Our 07 Mazda5 (80k) once in a while will start and run very roughly, and pressing the gas to the floor only gets it to 3,000 rpms.It has diminished power for climbing hills when this occurs. Everytime this happens if we shut the car off and let it sit (between 10 minutes - a couple hours) it starts and runs like a top. We have added drygas 2 of the times, but the last time it happened was on the same tank of gas that we added the drygas to. Check engine light comes on, but will go off after a day or so.
View 5 RepliesSubaru - Outback :: 2002 - Engine Temp Increasing When Climbing Steep Hills
I am having an engine temp issue when climbing steep hills. The gauge goes from normal to the red line but not into the red. The VDC OFF light is on but the CEL is not one. Once I reach the top of the hill the engine begins to cool off and returns to normal. Yesterday I had the radiator flushed and the thermostat changed. Am I looking at a water pump or head gaskets?
View 5 RepliesGasoline - Hyundai - Elantra - Transmissions - Clutches :: 2002 - Losing Power When Climbing Hills
Our 2002 Hyundai Elantra is having issues. It shifts fine, no need to double-clutch. It stays in gear. Doesn't grind or anything crazy like that. It does seem like it isn't getting power to the drivetrain, and is having trouble climbing hills. This all came on very suddenly. Hubby thinks it's the clutch -- I think it may be the bushings. Though now, I'm wondering if it's something else? Since it's not having trouble shifting, should we be looking at the fuel system? Sensors? Engine seals?
View 10 RepliesNissan - Frontier :: 2002 - Temp Needle Near Danger Zone While Climbing Hills At 40mph / 2500 Rpm
I have a 2002 Nissan Frontier with a non supercharged 3.3L v6. The truck is a crew cab, long bed and 4x4. I have had this truck since I bought it used in 2004 with 26k miles. The truck now has 196k miles and I have done a little modifying to make it a bit more off road capable.
I have done all the work to the truck myself, until last fall when I finally broke down and took it to a dealer, who was not able to find my problem, but I will get to that...First of all, the truck has steel bumpers, a winch, a tool box, onboard air system and large tires, all of which make the little 3.3L work hard. However, for three years since I quit making modifications, the truck ran perfectly cool and the temp needle never once went above the normal operating position, even through thick sand at the beach, mountain trails and towing heavy trailers, until last summer.
Late last summer, on 90+ degree days, I noticed the temp needle would start riding above normal when I had the AC on. It didnt matter if I was on the highway, the city streets or idling in the driveway. When I turned off the AC the needle went back to normal. This started happening occasionally at first (once every 2 weeks) then towards fall it started happening more frequently, almost every 90 degree day. Soon after I noticed the problem, it would happen even with the AC off, but not get quite so hot.
After a few weeks of this, I started chasing the problem. I replaced the radiator cap, the thermostat (tested the old one and tested the new one before installing,) I took the radiator to a rad shop and had it boiled and flow tested, I replaced both coolant temp sensors, and then finally the water pump. When none of those repairs made a difference I built new radiator fan shrouds and that made no difference. At this point I was starting to get discouraged so I borrowed a scan tool from a friend and drove around for a few weeks with it plugged in. I was reading live temperature readings of the coolant and verified that the gauge was working correctly.
The truck ran about 200 degrees with the AC off most of the time, then, when I turned the AC on, no matter if I was sitting in park or driving on the highway, the temp would steadily climb until it got to 222 degrees and I would shut off the truck, at that point the needle was near the danger zone and according to several nissan dealership, the highest normal operating temp is 204, but it should stay around 195. At 205 degrees, the needle would start to move above the normal position, so the gauge seems to be fine. As summer turned into fall, the truck started running cooler as the days began to drop into the 70's. I finally got fed up with chasing my tail and took the truck to a dealer with my main concern being a blown head gasket or cracked head.
The dealership inspected the head and tested the coolant for hydrocarbons and said that the head and gasket are not the issue. They advised that the only other thing it could be is my fan clutch. After that dealership visit, the days were cool so I drove the truck all winter without changing the fan clutch. Then, 2 weeks ago, on a 70 degree day, I hooked up my truck to an empty trailer (maybe 1000lbs) and towed it 15 miles. When towing up hill with the AC on, the temp needle started moving. I immediately went to napa and replaced my fan clutch. Confident that was the issue, I drove the truck to the mountains for a camping trip last weekend. While climbing the hills at 40mph and about 2500 rpm, the temp needle climbed to the near danger zone.
Ford Super Duty (1999-2016) :: AC Switching Modes On Its Own
2006 F250 gas King Ranch. My AC wants to switch modes on its on. I can have it on vents & it will go to defrost then back to vents every few minutes. Any clues? Air is cold.
View 4 RepliesFord Ranger / B-Series :: CEL On After Oil Change?
I just changed my Oil, added a FRAM filter and bought some good Quakerstate High Mileage and my truck runs good. However, I noticed that my Check Oil light is constantly on. I also recently changed my Oil Sender, and I wonder if that has got something to do with it.
View 3 RepliesFord Ranger / B-Series :: Transmission Is Going Out
I have a 1994 2.3l 4cylinder xlt ford ranger regular cab Manuel transmission. My transmission is going out. I found an 04 ford ranger Manuel transmission off a v6 will this be compatible? And if not what years will be?
View 2 RepliesFord Ranger / B-Series :: Shaking Really Bad When Get To 35 MPH
I have a 1994 ford ranger 4x4 that I just put on and 35's and when I get to 35 mph it shakes really bad. What the problem is. Have been told that I need a steering stabilizer.
View 9 RepliesFord Ranger / B-Series :: AC Cycles Off And On
I need to change the AC relay. What is the location of the relay.
View 6 RepliesFord Ranger / B-Series :: Throttle With A/C On?
I have a weird issue. When I'm running AC on my 2.3l ranger sometimes the idle wont go down but rather hold its current RPMs till i either turn the AC off or place the truck back in gear. What that could be?
View 6 RepliesFord Ranger / B-Series :: 3.0 VS 4.0 Engine?
Opinions welcomed...thinking of taking a gamble on an '04 with 248k miles on it.....not sure what engine is in it.
View 14 RepliesFord Ranger / B-Series :: One Hub Locked In 4X4
Hello. I never did this before but could you lock one hub in 2wd and leave the other unlocked. Also can you leave one hub locked while in 4wd? I was thinking if you have one hub locked would all the power would go to that wheel? Or will this do damage?
Thanks
Ford Ranger / B-Series :: 2wd To 4wd Conversion
I fit explorer rear axle to my 2wd ranger. But now I have fromt x-member with front suspension and front drive axle from explorer. Can I fit all this stuff to my ranger?
View 2 RepliesFord Ranger / B-Series :: 1997 - Possible 4.0 To 5.0 Conversion?
I recently purchased a 1997 Ford Ranger with a blown 4.0 with a 5 speed , I have a 5.0 with a Carb and 5 speed out of a 80s mustang . Is it possible to use this in the 97 Ranger , I understand I need a different fuel pump but motor mount wise I was hoping it would fit.
View 2 Replies