Ford :: Ranger Edge 2002 Won't Start Sometimes - Fire Up Then Shuts Down

For the past year, my 2002 Ranger Edge runs fine, but the last few months after running errands, the truck will fire up and then seems like fuel is gone and the truck shuts off. When I try to restart the truck, it just cranks over and over. If I wait a few minutes, it will fire up again. It never shuts down while driving the vehicle, only at start up. I can hear the hum of the fuel pump and no indicator lights on the dash, etc.... It has 83,000 miles on it. I've taken it to a few different repair shops, including the dealer and they can't repeat the problem or tell me what's wrong. I've replaced the IAC, mass flow air sensor, replaced the plugs, plug wires, coil pack, alternator, fuel filter and am still having the problem.

View 2 Replies

Ford Ranger / B-Series :: New Starter / Turns Over But Won't Fire

So my sister has a 2000 Ranger 2.5L. I put in a new starter today for her today, and the second I re attach the battery terminal it turns over but wont fire.?

View 4 Replies

Ford Ranger / B-Series :: 2001 Edge Really Rough At Start Up / Stalls On Hard Acceleration

2001 Ranger Edge 3.0. Like the title says, when I start my ranger it idles really rough. If I give it gas it shudders like it's gonna die. After about 2-3 minutes it smooths out. If I'm on the interstate and down shift to pass someone, while accelerating it feels like I have a misfire (no CEL given) not all the time though. I've changed plugs and wires and it stopped doing it so I thought I had it but, it continued a few days later. Then I changed the fuel filter and it stopped again for a few days. Well it's back again. I'm thinking it's the fuel pump but I wanted to check here before I take my truck bed off. I also checked for vac leaks and I'm all good there.

View 1 Replies

Ford Ranger / B-Series :: 1991 - Turns Over But Will Not Start

My 1991 ranger with a 4.0 turns over but will not start. It acted like it ran out of gas put again seems to do ok then it did same thing it sat over night then would not start so I thought I would put some gas in the intake so it starts ran real rough but smoothed after a few minutes ran fine after that next morning same thing no start did same put gas in intake at first no start just turned over didn't even try let it sit for awhile then tried again it fires up ran rough but ran now I get nothing just turns over pulled codes 22and 122 replaced both had ignition mod checked its good new coil pack no change so at this point i hear fuel pump kick on fuel getting to fuel bar but seems a bit week on pressure going to get pressure gauge and see what it says but in the meantime I am loosing my mind...

View 9 Replies

Ford Ranger / B-Series :: 1994 - Turns Over Fine But Won't Start

My son's Ranger wouldn't start today, turns over fine, added gas to make sure it wasn't out still no hit.

Other than fuel pump (he said he couldn't hear it) what things should he check? I'll check back in the morning.

1994 Ranger 2.3 4 Speed ....

View 3 Replies

Ford Ranger / B-Series :: 1992 - Turns But Will Not Start / No Spark

My Ranger was running great when suddenly on the highway it just died. I towed it to local nationally known brake/ muffler shop where a good friend is the manager. He narrowed it down (guessed in my opinion) to no spark and no fuel. He thinks it could be the crank sensor, the fuel pump or the ignition module. Is there any way to pinpoint the problem without replacing parts? It will sometimes start and run for about 2 seconds before shutting off. It will not repeat this unless it sits for a day or two. I am not sure if there are different 2.3 engines available but mine is fuel injection and has two sets of spark plugs and wires.

View 9 Replies

Ford Ranger / B-Series :: Mazda B2300 Turns Over But Doesn't Start

Mazda B2300 2.3L 1995 model... About a week ago I ran my B2300 out of gas (or so I was convinced I was out of gas) because the engine quit running. After adding gas was unable to start it back up. It turns over but doesn't start.

Here's what we did to try and fix it:

1.) Replaced Fuel Filter
2.) Check the fuel pressure, and it was at 35 psi when the key was on
3.) Replaced all 8 spark plugs (4 cylinder truck btw)
4.) Checked spark of all 8 coil pack slots and 1st and 3rd slots (exhaust side) were not sparking. After replacing coil pack we received spark but truck still didn't start.

We're speculating on the possibility of it being the PCM (ECC).

View 2 Replies

Ford Ranger / B-Series :: 1996 - Turns Over But Just Doesn't Want To Fully Start Up

So I just finished redoing my head gasket. Everything is hooked back up the way it was prior to the tear down. I'm getting spark, fuel, compression, timing was set correctly according to Haynes, turns over but just doesn't want to fully start up.

View 3 Replies

Ford Ranger / B-Series :: 2001 - Turns Over Great But Will Not Start After New Plugs And Wires

2001 Ford Ranger 4.0 - 250k miles had the original plugs and wires ....

First things first - I changed them one at a time and confirmed the truck started and ran after each one was changed. I changed all the plugs on the drivers side with no issue. 4,5,6 ... Then I changed plug 3, rear passenger side plug closet to the firewall.

Truck will not start, turns over great, but will not start. I have confirmed I am getting spark. No clue what could have changed, I just pulled out the old plug and wire put in a new one and it wouldn't start.

My father-in-law said if you have spark check fuel. I recall seeing a post about someone breaking a cable for the coil pack but i have checked and i see nothing broken.

View 7 Replies

Ford Ranger / B-Series :: 2001 Edge 4.0 5 Speed Auto - Noise While Accelerating

MY 2001 Edge 4.0 5 speed auto has a noise while accelerating. It happens only when truck is first run and disappears after warming up after a few miles. It just turned 1500 miles. Can't figure out if it is from trans or possibly a speedo cable. It goes to the dealer next week.

View 6 Replies

Ford F-150 - 1997-2003 :: 2002 - Turns Over Fast But Won't Fire

All of a sudden wouldn't start Saturday morning. Turns over fast. No fire. Waited a while and tried again and it started and ran fine. It did it again Saturday afternoon, so I changed the fuel filter. Gas from filter was very dirty. Still did it after filter change, so I replaced the fuel pump relay. Still did it twice on Sunday. Once it starts, it runs perfectly. Drove it 200 miles without a problem until I killed it. Then it wouldn't start.

View 9 Replies

Ford Ranger / B-Series :: 1998 - No Spark / Cranks But Does Not Fire

My father in law has a 98 4wd, 4.0L that cranks but doesn't fire. We pulled a plug to check for spark....no spark. Possibly coil pack, or crank position sensor?

View 5 Replies

Ford Ranger / B-Series :: 1995 - Cranks Just Fine But Won't Fire

I have a 1995 ranger with a 4.0 it cranks just fine wont fire has alot of fuel spark it will crank and crack then it stop and acts like it is going to fire up and stops cranking... This thing has 253k on it...

View 4 Replies

Ford Ranger / B-Series :: 2002 - No Start When Shut Off

I have a 02 ranger..3.0 standard trans 4x4.... Started running crappy, cleared up and when shut off, now wont start... Good spark and good gas pressure... Seems to want to try, but just doesn't go. No codes or pending codes.

View 8 Replies

Ford Ranger / B-Series :: 2005 Has Spark And Injector Pulse But Will Not Fire

I have a 2005 ford ranger, 4.0 auto, 4x4, 60psi fuel presser, has spark and injector pulse, will try to start if you hold the throttle a little over 3/4 the way down, but will not fire on starting fluid.

View 3 Replies

Ford Ranger / B-Series :: 2004 - Cranks But Does Not Fire At All After A/C And New Battery Install

I just finished putting in aftermarket A/C in the 2004 Ranger my dad gave my son. It's a 2.3L, STD transmission. It was running GREAT before the project started. I installed new battery as part of the project. When I started it back up it ran for 2 or 3 seconds then died. I now cranks, but does not fire at all.

I have tried one of the key reprogramming sequences (turn key to "ON" 8 times) with no success. Would it crank at all if it were a key security issue? Is there anything I need to reset anywhere else, like in the air intake system?

It's either not getting spark or not getting air. The fact that it ran for a couple of seconds has me confused. Would it run at ALL if there was a key security problem?
I had to remove and reinstall the air filter housing and ducting. Is there anything else I need to do to with the air intake system?

View 3 Replies

Ford Ranger / B-Series :: 2002 Truck Won't Start At All Even After New Starter

I have a 2002 Ford Ranger, and it wont start at all. Ive replaced the starter, had the battery checked. Not the battery, took starter out, had it checked too, its not the starter either. Someone said it maybe a fuse? This is totally frustrating, and I need to get it figured and fixed asap. Its been going on for weeks., I had it fixed and then it just stopped. It wont even take a jump anymore.

View 4 Replies

Ford Ranger / B-Series :: 2004 - Changed Push Rods Now Car Cranks But Won't Fire Up

2004 ford ranger 3.0 ... So here it goes I am pretty mechanically incline for the most part i would say until this last week i got a rod knock. So i replaced all my push rods put everything back together and now my car cranks but just wont start up where did i go wrong. I cant afford to get another truck i just want my baby back up and running ...

View 14 Replies

Ford F-150 - 1997-2003 :: 1998 4.6L - After Rebuild Turns Over But No Start - No Fire?

1998 F150 with 4.6L Windsor SOHC. I just completely rebuilt the engine including pistons, rings, timing chains (timing is good; compression @ 180 psi), 2 new coils, wires, plugs etc. and there's no fire at the plugs when I crank it. It turns over good but doesn't start. The fuel pump comes on and there's fuel up to the injectors. Before I disassembled the engine, it still ran good except for one piston. The 2 new coils, wires, plugs were replace before I rebuilt it. I was very thorough when re-installing the electrical etc... and triple checked it all after the engine not firing. Fuses are good. I know it's hard to trouble shoot without seeing the truck? The battery has been disconnected for months as I started a long time ago. Computer maybe?

View 6 Replies