Ford - Explorer :: 1996 - Rear Differential Was Leaky / Loud Whine Noise In Rear
Well i picked up a 96 4x4 with the 4.0 a few weeks ago and been fixing stuff weekly that i find wrong. One thing i noticed was the rear diff was leaky but couldn't get the fill plug out so left if for now. Last night my wife was on interstate and it just started making a loud noise so she pulls over calls me. I get there and drive it and it makes a woowoowoo noise and it got louder as speed increased. She was 3 miles from the exit so i drove it about 15-20 to get it off interstate than another 2 miles to her sisters. We let it sit for a few hours and found a flatbed to haul it home, and when we finally got home i drove it off the flat bed and now it was making a loud clunky noise. Parked it in drive till today. Cracked open the rear and no fluid came out.
Inspecting all the gears looked good no metal in bottom so i went and got a new rear cover and 3 qt. of fluid. Put it back together and the woowoowoo was still there but seemed to slowly go away as i drove it around the block. So what else could be going on here or do i need to drive it and warm up the fluid so it circulates? I also noticed a sheeee sound like metal on metal when braking but i changed all 4 rotors and both pads last week but i noticed the brakes in the rear that look like drum brakes was bare but i assume that is only for the ebrake so didn't bother changing them yet. Could those be hitting the inside of the rotor and making the metal to metal noise?
Ford Ranger / B-Series :: 1996 - Growling Noise From Differential?
I have been hauling a lot of garbage with my 96 ranger this last week. The differential has been making a little more than usual noise like growling, but it has always been smooth, now all of a sudden it shakes like a tire out of balance up to about 55 then it is like a switch is thrown and everything quiets down and the shaking goes away, until i get around 55. I haven't climbed under the truck yet just checked the tires and grabbed the drive line they are all ok,i don't see any leaks so it is a head scratcher. Hopefully it will be something easy, but it hardly ever is.
View 7 RepliesFord Ranger / B-Series :: Vibrating Rear Axle / Metal Chunks In Differential
The rear axle in my dads 1998 ford ranger has been vibrating for quite a while so I pulled the cover today and found that the fluid was full of metal shavings, it was glittering. I also found this metal chunk in the differential so my mechanical experience tells me this is not a good thing. I am taking it apart tomorrow any tips or do's or don't? Also, what this metal chunk is and what that knurled up end is??
Door tag told me it was a 7.5 open 4:10 axle.
Ford Ranger / B-Series :: 1996 - Squeaky Rear Wheels
I am working on a 96 ranger 2wd the front brakes were shot or nearly so,about 1/8 in left and cracked. Changed them this morning at 5am because that is the cool of the day (104 today) everything up front works fine but the howling and nails across the chalk board from the back was still there. Took it to my freindly les schwab and they told me it needed axle seals on one side and the noise is from the gear lube on the shoes. they wanted 800 bucks to fix everything, went and bought new shoes,new seals,gear oil,and gasket for rear end cover it is an easy half hour job. As I was driving home tonight from the parts store the noise stopped so now i am worried either it was a rock stuck between the drum and backing plate or something broke. everything sounds and works fine....
View 2 RepliesFord Ranger / B-Series :: 1996 - No Running Lights On The Rear End
I have a 1996 ford ranger and i have no tail lights i have license plate lights, brake lights, Hazard and turn signals. But no running lights on the rear end. Where the grounds are for this circuit and if some one has a schematic for this ranger...
View 9 RepliesFord Ranger / B-Series :: 1996 XLT - Rear End Shakes When Driving Down The Road
My problem is wih my 1996 Ford Ranger XLT 6Cyl. 4.0L 2WD Recntly it started shaking violently in the rear as I drive down the road any road. Mainly slow to about 50MPH or slower, it just starts to shake really hard and then it stops then out of the blue it will do it again I thought it might be the back Drums maybe the shoes came apart and were catching but they are fine everything looks fine, could it be the gearbox on the axle? I don't know...
View 5 RepliesFord F-150 (2004-2008) :: Whine Coming From Rear Differential
I got a new to me truck. It's a 2004 F150 Lariat 4x4 with the 5.4L. It's got a whine that I believe is coming from the rear differential. I'm going to change the fluid. My axle code is 26 which I believe is 3.73 non-limited slip. My owners manual says to use 75w-90 but I've seen a lot of posts on here that say to use 75w-140. Which is right or better? Also, is my rear differential the 9.75"?
View 14 RepliesFord Ranger / B-Series :: 1999 - Squeaking Front Wheel Bearings
4x4 1999 Ranger ... They are a squeaking and driving me crazy. How hard are they to do, do they need a press or can they be done at home?
View 7 RepliesGolf IV R32 :: Rear Differential Whine?
So I have the dreaded rear diff whine, which started about a month (1000 miles) ago. I've read a bunch of the past posts, but still can't find a solution other than a) live with it, or b) spend $3500 for a whole new diff. (95k miles - no warranty) It seems the general consensus is that the problem stems from a loosened pinion nut. Is there no way to just tighten the nut? Or if I do will the whine continue because the gears are now worn? BTW I just had all the diff and tranny fluids changed. Made no difference.
View 14 RepliesFord Ranger / B-Series :: Adding Oil In Front Differential?
Thought I would try and fill up the front. Diff well not as easy as the rear diff. They make a special hose or some thing. To put in the bottle so u can get some Gear oil in ?
View 3 RepliesFord Ranger / B-Series :: 1986 - How To Disable Front Differential
My front diff is busted, and I mean bad.. I can barely even run the truck 5mph, and it's very loud. The diff casing is even busted. I want to just disable it to drive in 2wd. What's the easiest way to do it? It won't disable using the push button control.
Can I just remove all the locking stuff in the front wheels, so there's nothing for the axles to grab on, and manually turn the solenoid at the transfer case to shut off the front wheel axle?
Ford Ranger / B-Series :: 2007 - Traction Lock Differential Making Noises
My 2007 3.0L XLT 2WD Ranger with 7.5" traction-lock differential started making expensive noises last weekend coming from the rear end. Shop has not yet opened up the differential because the initial though was just do a swap.
Turns out that 7.5" LS is hard to find, plenty of open diffs available. So I suggested that I'd rather swap in an 8.8" LS rear end anyway but turns out that these are also hard to find. Was a LS rear end option just not very common? or do these get scooped up just as fast as they become available?
Ford Transmission :: 1993 E150 - Differential Bearings Replacement?
The differential is howling like crazy on my 1993 E150 5.0 van, it has over 200k miles on it so I'm assuming the bearings need to be replaced! Before I tackle this major project is there any special tools I need or a special procedure I should use?
View 2 RepliesFord Ranger / B-Series :: Electrical Noise Or Grind / Whine
I have a 2001 Ford Ranger XLT 2.3L RWD AUTO.
I've never had this problem but now I can hear what appears to be a electrical noise or grind/whine. This just started happening on Monday. Prior to that I've never heard nor seen my speedometer bounce like this.
I've read that it's the rear diff ABS sensor possibly going bad. So I should have a new one tomorrow via amazon. I have also read that it's possibly the battery? I know the previous owner said he replaced the battery but this was at LEAST 2 years ago. So I know there is a solid 24 months on the battery now, since I've owned the truck...
I've also read that it might be the speedo? These actually go bad? Makes me wonder because of the noise you can hear towards the end like a whine noise. I have noticed that the battery gauge looks a little lower than before... normally it would be at around the MIDDLE of the battery icon and as you can see in the pic it's not now... however, the truck starts up perfectly fine, no hesitation at all or trouble, or having to do it multiple times.. so that makes me wonder is it really the battery?
I have projector HIDS and LEDS inside and have had them for at least a year now, I've noticed today pulling in the garage that the right hid was not flickering on and off persay but the beam wasn't steady like it was.. it was kinda dimming a little along with the interior cabin LEDS.... Battery? Alternator? I'm truely at a loss.
I've also heard there are sensors on the transmission that dictate the speed to the speedometer, problem is I don't know which ones to get.. I don't mind replacing all of them as long as this STOPS.
I did change my rotors and pads, and calipers. This was friday and this didn't happen. I will note that my ABS light is not on nor is it flickering so it makes me wonder as well if that sensor in the rear is bad? I didn't see any bare wires everything is taped and loomed, so I don't think anyone cut the wires back there that I could see at all...
Attached the picture of the battery gauge. And link to the video that I took with my phone...
Ford ranger gauge bounce - YouTube .....
Subaru - Outback :: 1996 - No AWD Suddenly / Leak In Rear Differential
I have a 96 outback which all of a sudden has no awd. The rear differential looks as though it has leaked some. I don't know if it has a bad axle, or if this loss of fluid is the culprit..... Where to start?
View 4 RepliesFord Ranger / B-Series :: 1996 XLT - ABS Not Communicating
My 96 ranger had lost a brake pad coming out of the mountains. I replaced the rotor but the ABS light came on as well as the check engine within a week. Several issues the clock spring was bad, replaced. The cam position Sensor was bad, replaced. I had this at a shop in a small town. While I was there they ran diagnostics.
At first the ABS module was sending data and gave them some info. Suddenly there was no more data stored in the module. They ordered a new ABS module installed it and replaced the LF sensor cable. Both sensors were cleaned prior to this.
The new abs module required a trip to ford to reprogram. At the shop they still could not get the light out. I took the truck home to my ford dealer and they said bad abs. Got a new (rebuilt Mfg discontinued) Installed and ford said this was bad with a code c1102. 4 w 4wd installed needs 4 w 2wd. ordered a new abs. Ford said same code again and the tech said that the ABS is not communicating through the obdii port.
My thoughts are the reader they used at the small shop was defective and either shorted out something or blew a fusible link. I am told this is 4 wheel abs with the rear sensors are on the pumpkin but after looking at the diagrams I do not see a RABS fuse. I have tested all fuses, and the shop replaced several relays. The pcm and ABS diodes check ok. Perplexed.
Ford 7.3L Power Stroke (1999-2003) :: Whine Coming From Front Wheel Bearings?
I have some whine coming from my front wheel bearings so I'm going to replace them both. I'm not sure if this had been done on my truck before, but I'm thinking so since I have Moog greaseable ball joints.
Truck has 250k miles on it. I'm going to check the pads, rotors and slide pins. Anything else that might need work? I'm sure the half shaft could use a once over, but I don't keep my hubs locked so they don't turn much in regular driving.
Ford Ranger / B-Series :: 1996 - Ignition Coil B Went Bad?
My engine has 2 ignition coils, and b went bad, but which one is b. ?
View 9 RepliesFord Ranger / B-Series :: 1996 - Won't Start And Crank Even?
I have a 1996 Mazda B2300 & I heard that it is similar to the Ford Ranger.
Well the thing won't crank or start.
This is what I have done so far. I wanted to put a RPM meter on it. I followed YouTube videos on how to do it. I cut the Tan wire w. the yellow stripes & try to connect the wire to thr RPM meter. Then it won't start soo idk what to do. I also took put the PCM too. (I was looking for the wire) Now be honest, I talked to a mechanic, he said thag I might have blown my PCM or Blown another fuse. But when i put the key in to crank, it won't start ot click at all. The lights come on & it wants to start but won't start.
Then my mechanic tried to start it by the... Idk what it is called but you can start it & it wont evet start. It will crank like crazy but will not start at all.