Ford Ranger / B-Series :: Speedometer Bouncing - ABS Light On W/ RABS DTC 9 - Fix?
Last night the speedometer started acting up, would fluctuate when the truck went over bumps and completely cut out on moderate right turns. Looked underneath as well as one can in the dark and couldn't find anything loose.
This morning I searched on here and the VSS came up numerous times as a common failure. $15 and about a half hour later I had it installed, and while I was under there I took a better look at the other connectors to double check harness connections for tightness and cleanliness. It all looked good, so I went ignition on... and the light came back. Tried clearing it by keeping the diag connector unplugged while switching ignition off, but no go. Took it for a quick spin around the parking lot, and the speedo was completely dead.
Hit up my factory ETM, found all the relevant connectors and set up a wiggle test of the VSS circuit with the DVOM on audible continuity check. Found one of the wires had chafed against the body right by the under-cab harness connector and worn almost completely through. Cut out the bad bit, soldered and heat-shrunk a patch in, and took it for a spin. Voila! No more ABS light and a working speedometer.
Also fixed the fuel gauge sending unit wire which was in the same connector grouping and chafed (but not yet broken) in a similar manner.
Ford Ranger / B-Series :: 1993 XLT - Leak Is Coming From Brake Line Or RABS Module
I have a 93 Ranger xlt and after checking wheel cylinders and calipers first I have found a leak that is coming from the brake line or maybe the RABS module. The leak is up along the inside of the frame and I can't get in there because of the gas tank. Has to change line or RABS in that area and am I correct in thinking the gas tank has to come out to do anything in there.
Also, in the manual it says to plug the line as soon as you remove it(at wheel cylinders etc) so the fluid does not leak out of the RABS because it can't be bled without an expensive piece of equipment. I am pretty sure it probably emptied due to the leak location.
Ford - Ranger :: 1994 - Coolant System Thumping Loudly?
I had my 94 Ford Ranger recently repaired, new water pump and coolant. Seems to run okay, but after 10 minute drive, the coolant system loudly thumps and visibly pulses as if there is steam or huge bubbles in the hoses. They are timed irregularly, but about once every 2 seconds and they quickly go away after a minute after shutting off the engin. Water temp is showing normal on the idiot gauge.
View 2 RepliesF Series :: 2004 - Thumping Noise While Braking
I have a 2004 Heritage Model F150 4x4 Manual Transmission V6
It started to make a thumping noise a while back when the brakes were applied hard, sounded like from the front end. I figured it was a warped rotor and/or bad pads or bad caliper bolts, the thumping and pulse seemed like that was what it was.
The front end was a mess. I ended up changing just about everything. CV axles both sides, one piece bearing/hubs, upper control arms, bushings, ball joints, tie rod ends, sway bar links, rotors, pads, calipers, hardware, maybe more things.
It all needed done, so no big deal, however the thumping while breaking is still there, it is getting worse and sounding more metallic. You can feel it in the steering wheel and under your feet. The drive shafts are very, very rusted, but seem to have no play in the u joints. I changed the back rotors, calipers, hardware and emergency brake parts and hardware a couple of years ago, they seem good. Taking it out of gear or pushing in the clutch or not pushing in the clutch seems to make no difference. You can go fast and let off the gas, no noise, you can aggressively downshift, no noise. Hit the brakes and you get a nice thump, thump, thump, like I said now it sounds even slightly metallic and getting worse.
I figure if nothing else before long something bad is going to happen and I will know what it is.
Ford Ranger / B-Series :: Thumping Noise From Under The Hood
Driving home from work (a 30 minute hwy cruise) I had to stop for a traffic light. As was sitting there I hear a thumping noise from under the hood, otherwise it was running the same as always. Got it home and I didn't hear it anymore, looked under the hood while idling, seen nothing, shut it off. top rad hose had a slight amount of pressure, started it and it quickly built pressure and felt a rhythmic thumping in hose and it got fricking hot quickly. I figure either a head gasket or cracked head.
I just recently did an aggressive cooling system flush using Prestone heavy duty cooling system flush (can only get this at a dealer) because the previous own neglected it, and it blew a head gasket, tons of rust inside when I did it. I'm gonna borrow a tester to check for exhaust gas in the cooling system and what did it end up being? The guy I bought it from (the previous owners mechanic) put 1 or 2 head gaskets on it.
Ford Ranger / B-Series :: 1998 - Loud Thumping Noise From Dash
Ok I have a 1998 Ford Ranger XLT 4.0L automatic 4X4 with A/C my problem is i just had the timing chain,water pump, thermostat, upper and lower hoses, and front crank seal replaced. I got it back and right away noticed a thumping noise at idle only... My gauge was always steady at the same spot it had always been. but the thumping was loud when idling. Now the sound seems to have moved farther towards the engine instead of the dash and tonight when i popped the hood noticed the top hose was collapsed and i could feel no pressure. the thumping noise seems to be coming from the area of the thermostat. I have no oil in the coolant and no coolant in my oil! I tried to get the air bubble or pocket out if thats what is the problem by running the engine till hot with the radiator cap off but it made just a huge mess. it did seem to push a huge air pocket out but still does the loud thumping. This all started the day i got it back from the mechanic so I am assuming its an air pocket. I planned on changing the thermostat tomorrow.
View 14 RepliesJeep - Grandcherokee :: 1994 - Thumping Sound Coming From Drivetrain
When I drive over 55 i have a shaking through the car after driving for a while if you put it in reverse it feels like it is binding up and when you put it in park you can hear a thumping sound coming from the drive train i have replaced both cv shafts in the front (they were bad) and the passenger side hub. I am going to replace the ball joints with after market ones because it pulls to the right and the stock ones do not have a camfer adjustment is the binding a differential problem or a transfer case problem also if while the engine is off if you shift to neutral you can feel it release the tension on the drive train.
View 2 RepliesFord F-150 (2009-2014) :: Sloshing Scraping Thumping Sound Coming From Fuel Tank Under Hard Braking
Hearing a sloshing scraping thumping sound coming from their 36 gallon tank under hard braking accelerating? It's loudest when the tank is between 200 and 150 miles to empty, I checked the spare tire and its tight, haven't had a chance to crawl under and look around yet though, I think something inside came loose. 2013 XLT.
View 2 RepliesCivic - Honda :: 1999 - Rhythmic Thumping / Grinding Sound While Braking
I get a rhythmic thumping sound from my right front wheel when braking. The sound gets slower as the car slows, and when very slow sounds more like a grind than a thump. I can feel the vibration through the brake pedal. I've had this problem before, and had my wheel bearings replaced -- fixed the problem, but after about a year the sound came back. Just had the car inspected and brakes are in good shape (at least those parts checked out by the state inspection). Could it just be that I need to get the wheel assembly tightened up? (It's a '99 Honda Civic with about 145K on it, if that matters)....
View 11 RepliesJeep - Grandcherokee :: 2006 - While Braking Extremely Long Thumping Sound With Shaking?
I own a Jeep Grand Cherokee 2006 V8 4.7 with 133,000 miles. This week I went to a Quick Service Oil Change , after receiving an oil change they informed me I needed a Differential Fluid Change , that I "should have " had one at my last visit and couldn't wait any longer. After receiving the two , I left and not even fifteen minutes later , I attempted to use my breaks approaching the end of the highway.
Instantly the car started making an extremely long banging / thumping sounds along with the a lot of shaking and the car proceed to dead right there. I got it towed home , the company is supposed to send some one to come do a once over. What it could be? As sad as it sounds, I have a feeling they will do a look over and claim they don't know what is wrong or that it isn't there fault in any way.
Ford Ranger / B-Series :: 1994 - Jerking Below 3k RPM?
My 94 ranger, 3.0 v6 began to sputter and jerk about a month ago. It does this when ever give more then lite throttle up until about 3000 rpm. I have replaced plugs, wires, coil and cleaned the air flow sensor. I feel like this has worked a little but the problem is still definitely present. When I hit 3k rpm if feels lie the truck begins to run correctly and almost like it had a power ban much like a dirtbike, but again it's just the truck running correct.. And above 3k rpm it runs great... and every so often the problem will completely disappear for 5 minutes or so, then come right back.
View 1 RepliesFord Ranger / B-Series :: 1994 - Mpg Dropped - Fix?
I have a 94 2wd 4.0 auto 3.08 rear end it has 195,000 im gettin 15 city 18 hwy I used to pull 24+ hwy I changed plugs and wires no change? It has the 4.0 tick but its always had it....
View 7 RepliesFord Ranger / B-Series :: 1994 - Got Codes 218 And 998?
Working on a friends 94 ranger, 2.3 L with codes 218 and 998. Chiltons manual does not even show this code. Code is for Loss of Ignition Diagnostic Monitor (IDM)/left side. What exactly is this? Can't find anything that explains the IDM.
998 means a hard fault.
Ford Ranger / B-Series :: 1994 - Low To No Heat
1994 ranger 3.0 .. New: water pump, htr. hoses, radiator, thermostat, pulled & flushed htr. core. (2 year time frame) ....
View 5 RepliesFord Ranger / B-Series :: 1994 - Won't Start After Warm Up?
I have a 1994 Ford Ranger 4.0L 4x4, 130,000. I love this truck but about a year ago it started not starting after it warmed up short distances in the summertime? It start right up on cold crank...Runs smooth idles like a champ...but if i shut it off..wont start for 20 to 40 min??? It doesn't happen in the winter months??? So I changed the fuel pump, filter, relays. I feel like it has something to do with the Ignition Control Module. Would that come up in a code?
View 13 RepliesFord Ranger / B-Series :: 1994 - Hesitates Under Acceleration
Having a slight issue with my ranger. So I bought this truck out of a junkyard about a month ago, its a 94 4x4 with a 4.0 and a five speed. When I bought the truck the motor was blown so a few weeks ago i replaced it with a 4.0 from an aerostar van I had laying around. Right after I changed it the truck was running good with no issues, until a few days ago going to work the truck started hesitating going up a hill. Now the truck does it all the time, sitting at idle the truck runs smooth as silk, at half throttle it does it the worst but when you mash the peddle to the floor it clears up and runs good.
So far I've replaced the plugs, wires, coil pack, mass air sensor, throttle position sensor, and the fuel pressure regulator to try and fix it but nothing has worked. I've checked the fuel pressure it has 30 at idle and 40 with the vacuum hose pulled off of the regulator, I even taped the gauge to the windshield and went for a ride and there was no drop in pressure when it started acting up. a few other things i have done were plugged all the vacuum ports to rule out a leak, reset the computer and checked for codes. the only code that came up was 522. So I think my next step is going to be buy new oxygen sensors ? But my question is wouldn't the check engine light come on if it was an oxygen sensor ?
Ford Ranger / B-Series :: 1994 - Battery Keeps Running Down
Got a problem with the '94 Ranger. Something keeps draining the battery. For reference, the truck is an XL, manual 4x4, 4.0L, 5-speed. I've been trying to keep driving it so I could try and diagnose the issue. At first, as long as I cranked it every day, it stayed charged up, but now it has gotten worse. It will run down in an hour or two. I know figuring this kind of problem out is tough, but I thought maybe some others of you may have experience in this area that might benefit me.
Based on a gut feeling, my first idea was that there was something going on inside the AC compressor. So, I disconnected the compressor, but that wasn't it. My plan at the moment is to replace the wiring harness between the battery and the starter. The current harness is pieced together (not my doing), and whether it fixes this problem or not, it needs to be done. Another thing I've thought about is the ignition switch. It acts "funny" to me, but it has never really given any trouble.
My son needs to take this vehicle back to college with him in a couple weeks, and I need to get it figured out.
Ford Ranger / B-Series :: 1994 4.0 Sometimes Will Crank And Not Start
94 Ranger, 4.0, Automatic, 280k miles. Normally starts and always runs fine. Sometimes will crank and not start. Fuel pump replaced Feb. 2015 and again Dec. 2016. Have had it towed 3 times. Always starts when it gets to the mechanic. Sort of reminds me of vapor lock on the old cars with carbs, because if it sits long enough after not starting, it will start, no problem. Never died out or even coughed when running and plenty of power. When I take off the gas cap, it sucks in air like a whale. Twice I did that and it will not start right away, but if it sits for an hour or so, it starts no problem. Just bought a new gas cap 10 minutes ago and looked in a Haynes manual and a " gas tank vapor valve assembly" is mentioned. I don't want to change parts just to see what happens. Mechanics say there are no codes shown.
View 1 RepliesFord Ranger / B-Series :: 1994 - Headlights On At All Time / Won't Come Off
The headlights on my ford ranger 1994 won't come off. All fuses are good and wondering the next step?
View 9 Replies