Chrysler - LeBaron :: 1994 GTC Won't Shift Out Of First And No Working Speedometer
Thought this would be a fairly straight forward fix of making sure that the transmission fluid was full with no air in it, as well as a few other things to try.
Well, I've run out of things I can reliably try right now. Replaced the output sensor on the transmission, filled the transmission fluid with the proper type, read error outputs. (boy was that odd, you have to turn the key three times in a certain way and it blinks codes out at you)
The error readouts point to an Oxygen sensor, and the speed sensor. The oxygen sensor I could care less about at the moment, as I can't really reliably drive the car in first gear. Once it shifts, then I'll fix that, otherwise its wasted money as I won't be driving anyways.
None of my local mechanics have a machine to read or program this thing by the way, so that is kind of out of the question.
Toyota - Corolla :: 1994 - Speedometer Just Stopped Working?
My 1994 Toyota Corolla's speedometer just stopped working while I was driving this morning. Does this mean that there could be something worse going on than just my speedometer?
View 4 RepliesFord Ranger / B-Series :: ABS Light And Speedometer Not Working
I have the infamous ABS light & speedo not working on my 2000 Ranger. I replaced the ABS Speed sensor on the rear diff as has been suggested on many posts, but it didn't solve the problem. Did I get a bad part or is there something else I should go after?
View 7 RepliesFord Ranger / B-Series :: 1998 - Speedometer Not Working
so heres whats happening. My 98 ranger speedometer has not been working since I owned it (I am the second owner who got it from a grandpa) and I've replaced the vss sensor two times, got a new connector and gave that a try and still nothing. Yes I've looked for cracks in the wire or any exposed copper, I've looked through many forums and cant figure it out. At first before replacing the vss, my abs and check engine light weren't lit up until i put a new vss sensor on that i got from o'reillys, so then i got another one thinking it was just a bad sensor and still no luck. another thing is when its cold in the morning and i get in my pickup to go to work it will start working once i go over 30 and fluctuate between that and 20 but if i don't accelerate it will not bounce all over the place.
View 4 RepliesFord Ranger / B-Series :: 1990 2WD - Speedometer Stopped Working
I have '90 Ford Ranger 2wd standard cab long bed. A few days ago the speedo stopped working. What is the more likely cause? The gauge itself or a relay/cable. And if it is the cable/relay are they hard to remove & replace.
View 1 RepliesFord - Ranger :: ABS Light Came On / Speedometer Quit Working And Trans Not Shifting Right
Recently the ABS light came on (truck does not have ABS), also speedometer quit working and trans was not shifting right. After a few minutes the problem went away.
View 4 RepliesFord Ranger / B-Series :: 1994 - Turn Signals Stopped Working - No Flashing / Blinking
I noticed that my turn signals stopped working. I replaced the flasher. Now the turn signals work but the signal indicators in the dash don't light up. Also, the hazard lights don't work either. No flashing, no blinking when I turn on my hazards. I've seen many variations while searching? 1994 B3000 2x4 extra cab.....
View 14 RepliesFord - Explorer :: 1994 - Inconsistent Speedometer / Indicate Several MPH Too High
Most of the time, my speedometer needle is steady and in the right spot. But once in a while, it will indicate several mph too high, along with some slight fluctuation. The tach and the GPS speed remain steady. What would cause this? I would think that a worn component would cause it to indicate low or bounce around all the time. Also, where would I get a speedo drive gear with a different number of teeth, since I have 31-in. tires? I look on parts store websites and don't see any drive gears. 1994 Explorer..
View 2 RepliesAccord :: Changing Whole Speedometer Cluster 1994 Honda?
How difficult is changing the whole speedometer cluster on a 94 honda accord? Mine has been messed up since i got the car. It stays on 20mph when I turn on the car.
View 6 RepliesHonda - Accord :: 1994 - Speedometer Works But Mileage Readings Quit
I have a 1994 Honda Accord DX 5 speed. As it was turning to 208,000 the odometer froze up. This was in mid April. The speedometer still works but the 2 mileage readings quit. About a week later it began to work for 9 miles, then froze up again. I called 3 mechanics. They said it was the speedometer cluster & that he would need to put a search out for the part because it was a rare part for my car. That was 2 weeks ago. Last week my odometer began working as though nothing happened and has been fine. If and when I ever hear back about the part what should I do? Go ahead and get it fixed or just say "If it ain't broke don't fix it?"
View 2 RepliesFord Ranger / B-Series :: 2000 - ABS Light Stays On / No Speedometer
I have a 2000 ford ranger 4.0L v6. My problem is the abs light stays on and the speedometer won't work till i hit about 35-40mph.
View 14 RepliesFord Ranger / B-Series :: Speedometer Bouncing - ABS Light On W/ RABS DTC 9 - Fix?
Last night the speedometer started acting up, would fluctuate when the truck went over bumps and completely cut out on moderate right turns. Looked underneath as well as one can in the dark and couldn't find anything loose.
This morning I searched on here and the VSS came up numerous times as a common failure. $15 and about a half hour later I had it installed, and while I was under there I took a better look at the other connectors to double check harness connections for tightness and cleanliness. It all looked good, so I went ignition on... and the light came back. Tried clearing it by keeping the diag connector unplugged while switching ignition off, but no go. Took it for a quick spin around the parking lot, and the speedo was completely dead.
Hit up my factory ETM, found all the relevant connectors and set up a wiggle test of the VSS circuit with the DVOM on audible continuity check. Found one of the wires had chafed against the body right by the under-cab harness connector and worn almost completely through. Cut out the bad bit, soldered and heat-shrunk a patch in, and took it for a spin. Voila! No more ABS light and a working speedometer.
Also fixed the fuel gauge sending unit wire which was in the same connector grouping and chafed (but not yet broken) in a similar manner.
Ford Ranger / B-Series :: Speedometer Will Reverse Despite Of Increasing Speed When Gets Over 75 MPH
1999 (built late 1998) Ranger 2.5 stick 2wd single cab. If I get much over 75 MPH the speedometer will reverse direction despite increasing speed. If I then let off the throttle completely, the speedo will jump right back up and indicate the correct speed. Continued operation without letting off the throttle to let the speedo recover will trip the ABS fault light, probably due to the erratic signal.
Disconnecting RABS module has no effect on symptoms. Speed sensor in the rear axle has been replaced already (by me) and the new unit ohm'd out good. Wiring between GEM and sensor checks out as well, good continuity (< 1 ohm) and no shorts to chassis ground. I wish I had an o'scope to take a look at the waveform, but I don't at the moment. It is on my future tool purchase list.
Ford - Ranger :: 1994 - Very Low Power
Pickup developed low power issue (won't go over 35 unless downhill) suddenly, I'm told. Already had other issues. Replaced the engine with a used one, replaced the MAF sensor, and replace the ECM. Took care of all issues except low power. In neutral RPMs top at 3000. New fuel and air filters, distributor cap & rotor, plug wires. Runs smooth, idles fine, just no power.
View 5 RepliesFord Ranger / B-Series :: 1994 - Jerking Below 3k RPM?
My 94 ranger, 3.0 v6 began to sputter and jerk about a month ago. It does this when ever give more then lite throttle up until about 3000 rpm. I have replaced plugs, wires, coil and cleaned the air flow sensor. I feel like this has worked a little but the problem is still definitely present. When I hit 3k rpm if feels lie the truck begins to run correctly and almost like it had a power ban much like a dirtbike, but again it's just the truck running correct.. And above 3k rpm it runs great... and every so often the problem will completely disappear for 5 minutes or so, then come right back.
View 1 RepliesFord Ranger / B-Series :: 1994 - Mpg Dropped - Fix?
I have a 94 2wd 4.0 auto 3.08 rear end it has 195,000 im gettin 15 city 18 hwy I used to pull 24+ hwy I changed plugs and wires no change? It has the 4.0 tick but its always had it....
View 7 RepliesFord Ranger / B-Series :: 1994 - Got Codes 218 And 998?
Working on a friends 94 ranger, 2.3 L with codes 218 and 998. Chiltons manual does not even show this code. Code is for Loss of Ignition Diagnostic Monitor (IDM)/left side. What exactly is this? Can't find anything that explains the IDM.
998 means a hard fault.
Ford Ranger / B-Series :: 1994 - Low To No Heat
1994 ranger 3.0 .. New: water pump, htr. hoses, radiator, thermostat, pulled & flushed htr. core. (2 year time frame) ....
View 5 RepliesFord - Ranger :: 2000 - Speedometer Quit / Jump When Brake Pedal Pressed?
I have a 2000 Ford Ranger, 5spd with 3.0 v6. The speedometer will jump around or quit about half the time whenever you push the brake pedal or use the turn signals. I've cleaned all the grounds I can find including taking the battery cables off the clamps and cleaning them, and I had to clean all the fuses (inside box and outside box) because most of them were corroded. It still does it. Occasionally, I'll hear a buzzing/crackling noise like electricity arcing when I use the brakes or the turn signals which sounds like it's coming from the left side of the dashboard.
I took off panels and the fuse box, but I don't see any sign of arcing. Also, the noise only occurs when the truck is actually moving, never when it's sitting still. Also, the engine has a slight flutter at an idle. I hooked up a computer, and the O2 sensors were erratically jumping between rich and lean, so I replaced all of them. It says Insufficient EGR flow detected, so I did put a new EGR valve on and cleared the codes, but it still reads the same. And lastly, the computer refuses to finish either of its diagnostic tests. I've tried the Koeo and the koer tests, and neither will complete.