Ford Ranger / B-Series :: 1988 V6 Won't Start After Fuel Pump Replacement
I have a 1988 Ranger 2.9 V6 that sits most of the time. The fuel pump quit working so I removed the bed and replaced the pump in the tank and the inline filter near the engine. I did not replace the inline high pressure pump because it still made a humming sound so I assumed it is working. Now when I turn the switch on I hear both pumps working but the truck will not start. It seems like it wants to fire or fires for just a second but just wont completely start. Is the system supposed to be primed and if so how?. I suspect a fuel problem but I dont know how to check pressure or check to see if fuel is getting to the engine. What to do next?
View 6 RepliesVenture :: 1999 Chevy Will Not Start - Can Hear The Fuel Pump When Turn The Key
Got done with replacing head gaskets and intake gaskets, Van started fine and I backed it out of the garage. Left it running and put down ramps and drove up on them so I could get under and connect the exhaust. Got that done and then got back in it and all it will do is crank and it will not start now. It also has a new cam shaft sensor( wire broke on old one). I can hear the fuel pump when I turn the key. It is like now there is no fire to start it. What could be wrong? What do I check? What causes it to fire? If something was connected wrong, would it have still started and then wont do anything but crank? Got dark on me and started raining so I say tomorrow is another day. I feel it is something simple.
View 4 RepliesFord Ranger / B-Series :: 1999 - Fuel Pump Won't Turn On At Start Up?
My 1999 4.0L v6 Ranger (auto trans) is having some issues. Recently the fuel pump won't turn on as normal when I turn my key. I have to turn the ignition on and off 10-20 times before I hear the pump kick on and I can start it. I already checked the relay and fuel pump shut-off switch. Neither was the bad.
View 10 RepliesGeo :: 1995 Won't Start - Cannot Hear Fuel Pump Whirring
Geo won't start. It has a new battery and air filter. Just replaced the fuel pump and fuel filter. I don't hear the fuel pump "whirring" when I put the key in the ignition (to on position). All the dashboard lights come on when the car is in on position.
I suspect the relay or the fuse, but having trouble finding the correct one of each. What does the relay look like? i.e. part number? What is the spec for the fuse? 20amp 30 amp? This has been a great car.
Golf IV / Jetta IV :: 2005 1.8t AWP Cranks But No Start - Cannot Hear Fuel Pump Priming
2005 1.8t gti wont start. The other day I was driving on the highway when a thin plastic type wrapping got caught in my serpentine belt. The car immediately died and I hit the gas and nothing and with no power steering i pulled over to the side.
Timing belt was done with water pump and tensioners
Spark plugs and coils are brand new
What fuel line to disconnect to test if the fuel pump works? Like I said in the title I cant hear the fuel pump priming. The engine was running 100% before this 2 techs saw it and the vw dealer i workrd at looked it over.
Ford - Explorer :: 1995 - Can't Hear The Fuel Pump?
I'm working on one of our fleet vehicles here, a 1995 Explorer. about 2 months back, it stalled out. Got it back to the shop and turned the key on .... I couldn't hear the fuel pump. I replaced the fuel pump and the fuel pump relay. Vehicle started right up and seemed to run O.K. About 2 weeks ago, it stalled out again, same symptoms, acts like it runs out of gas and can't hear fuel pump.So, I have been playing with it and find that it starts up great in the cool mornings. In the afternoon when the temps are hotter, it won't start (can't hear fuel pump). The following morning when temps are cool, it will start right up and can hear the fuel pump. I almost wrote this one off as a defective fuel pump, but I'm not sure on this one.
View 7 RepliesFord Ranger / B-Series :: 1995 Will Not Start - Fuel Pump Going Out
My 1995 ford ranger with a 3.0 will not start. It acted like the fuel pump was going out so I replaced it. I also replaced cmp sensor and the camshaft synchronizer due to old cmp sensor broke and messed up the synchronizer. My truck is getting fuel and spark but still will not start. Where do i go next?
View 4 RepliesCelica :: 90 Fuel Pump - Can Hear Buzz But No Pressure
I've followed steps 2-6 from this image
I don't feel any pressure in the hose from the fuel filter. I can hear a buzz (guessing its from the fuel pump) but no pressure.
I've checked both fuses, the efi main relay, and swapped out the circuit opening relay with a known good one and all checked out good. Only thing left is the fuel pump or the writing and electrical connectors.
Car has pretty much took a dump one morning and has almost no power. I can't find anything else wrong with this car besides this. Is the fuel pump the problem even though I can hear the pump?
Ford Ranger / B-Series :: 2000 - Just Turned Over But Would Not Start - No Fuel Pump Noise
My daughter's boyfriend just bought a 2000 ranger with a 2.5. We just put a flexplate in it and it wouldn't start. Just turned over. Listened for the fuel pump and no noise. After a few minutes, it worked. He drove it home last night and said that it didn't want to work first try but worked with the second try. He drove it to church, 40 miles, and it sit for around two hours and wouldn't start, no matter how many tries.
We tried changing the relays around with no luck. We went and eat lunch and back to the truck with a rubber hammer. Then it starts on the second try without using the hammer. We got under it and cleaned the connections up and put some bulb grease on them. I couldn't get the one apart right on top of the pump itself, I was afraid of breaking it. It's been doing fine since we left the church before we cleaned the connections.
Accent MC (2006-11) :: 2007 - Code P0343 / Car Not Starting Cannot Hear Fuel Pump
It was acting rough and was a little loud. Like a low deep loud, the engine light came on. I tried to start it, it would crank but no start.
Code came up P0340 (Cam sensor) So i replaced it, reseted and scanned again, now it says P0343 To much input sensor 1 bank 1. When i turn the key over to "ON" I don't hear the fuel pump, is this normal?
I don't understand what to do I am so lost, I am ready to do the timing. Is there something cutting my fuel pump out or is it done? Do i do the timing, or replace the pump ...
Oldsmobile - Bravada :: Cranks Good / Can Hear The Fuel Pump But It Doesn't Fire Up
Sometimes my Bravada won't start. It cranks good (new battery) and I can hear the fuel pump , but it doesn't fire up. I just got it back from the repair shop.?
View 4 RepliesFord Ranger / B-Series :: 1993 - Check Engine Light Comes On And Truck Will Not Start / Fuel Pump Runs Non-stop
Sometimes the check engine light comes on and truck will not start,the fuel pump runs non-stop.. when check engine light goes off,the fuel pump runs for a few seconds and stops,truck will start.... driving down the road check engine light will come on and truck runs bad....
View 2 RepliesFord Ranger / B-Series :: 1988 - Headlights Won't Turn On At All?
I have a 1988 ford ranger and my headlights won't turn on all my fuses are fine but no headlights! All the other lights work fine blinkers, parking, brake ,and tail lights! What do I need to look for????
View 14 RepliesFord Ranger / B-Series :: 1988 - Turn Signals Not Working
I have an 88 ranger with the 2.9l. The headlights work and the markers do to. The brights don't though. and also none of the turn signals work, the brake lights work though but i don't think the reverse do, I can't see them. Do the turn signals and brights share a fuse on there own? How to diagnose it or what it may be?
View 9 RepliesBuick - Regal :: 1996 3.8 Won't Start / Can't Hear The Pump Running - No Spark
I have a 96 buick regal thats been giving me problems for over a year now. it from time to time acted like it was out of gas even though it might have a half a tank. Turns over fine but won't start after it sits for a couple of days then it starts fine. Last summer my son replaced the fuel pump after doing a pressure test and getting a low reading. No more problems until jan then it started doing it again. Well about 3 months ago it wouldn't start so I had my wife turn the key on and I stuck my ear in the fuel fill tube and I could not hear the fuel pump.
I checked the fuel pump relay by putting my finger on top of it and I can feel it click when the key is turned on. Also the air relay next to it is the same so I switched them no change so I replaced the fuel pump again and also the sending unit so every thing in the tank is new. Car still won't start can't hear the pump running and i checked for spark no spark now. My other son has been saying he thinks its the ecm so I just put a reflashed used ecm in. Did the security relearn procedure still nothing. whats next? Somebody told me check the cam and crank sensors and wiring. I also replaced all the ignition coils last summer.
Lumina :: 1996 / 3.1 - Turn Key Wait 2 Minutes For Fuel Pump Then Start?
I have a 1996 Lumina 3.1. For the last few years, every now and then I would turn on the key, all electrical systems, lights, windows, radio, etc. would work but it wouldn't turn over. If I waited about 4 minutes it would start perfectly and it wouldn't happen again for up to a month. Last week it did it and after I waited and tried it again it turned over once then everything went dead. A mechanic (friend) installed a new battery and it started. He took it to his shop and installed a new computer. Everything read fine, but now when you turn on the key it will turn over fine but not start. Leave the key on and wait about 2 minutes till you hear the fuel pump start and the engine will start fine. If you stop for a few minutes it will start but if you stop for more than 5 or 10 minutes you have to wait for the fuel pump to come on again.
View 7 RepliesFord Ranger / B-Series :: 1988 - Won't Start - No Spark
Any way to tell if the ECU is faulty? I hooked my analyzer up to my friends 1988 Ford ranger 2.3L and it wouldn't even detect that the ignition switch was on. He was driving it the other day and is shut off on him while he was making a turn and it wouldn't start back up. We have rebuilt the distributor by replacing the pick-up, rotor button and cap, and we had the ignition module tested and found it was good. We have also replaced the coil. When the ignition is turned to the on position, the fuel pump comes on and never cycles off.
View 8 RepliesFord Ranger / B-Series :: 1988 XLT V6 Won't Start Just Crank
I have tried about everything i know about cars on this truck!! It ran great when I got it until a head gasket got blown so I tore into it and replaced them both torqued heads to specs. Made sure valves wasn't to tight. Distributor is in correct spot timing is correct had ignition module tested good!!! Coil tested good replaced both fuel pumps and put new tank and sending unit in the truck b/c it needed it new fuel filter replaced return line firing order is correct 1 4 2 5 3 6 it is getting fire it will crank and crank sometimes act like it is going to start then not also I can get it to run for about 3 sec on 3 or 2 cylinders it seems to have plenty of compression as well!! only thing really I can think of that could be wrong is computer? Also one last detail tried pull starting it as well still wouldn't go.... V6 2.9L...
View 9 RepliesDodge - Ram :: 1996 - Intermittent Fuel Pump Malfunction - Have To Turn Ignition Several Times To Start
Intermittent fuel pump problems in '96 Dodge ram resulted in new fuel pump 50,000 miles ago. Happened again 100 miles ago, so another new fuel pump. Now to start car must turn the ignition on several times before going to the start position. It appears the latest new pump may have defective one way check valve, so the pressure is depleting after turn off. Any favorite brand of fuel pump for the Dodge "pump in the gas tank" arrangement? Or solutions such as installing an external pump to do the work of pumping the fuel?
View 1 Replies