Ford 7.3L Power Stroke (1999-2003) :: 2002 F350 - Outside Temperature Gauge Reading Wrong
I have an 02 f350 7.3 power stroke...Yesterday I noticed the outside temp was reading wrong,it was jumping from 67 to 86 to 92 back to 67..Temp was prob around 90 with high humidity and my a/c was on..So I got to where I was going and when I restarted my truck to go home the fuel gauge dropped to empty(I just fueled the day before) and fuel light came on and outside temp still wrong on the overhead digital display...Are these two things related???
Stopped the truck restarted it and fuel reads correctly again....Went out today and fuel light back on and on empty...Outside temp wrong again,a/c is on .....I disconnected the batteries when I got home to "reset the system"if there is such thing, fuel gauge working but outside temp wrong..?? Where is the outside temp sensor ?could condensation be running onto the sensor and throwing off my temp gauge? Just strange that both these things happened at the same time......I don't think its a fuse or they wouldn't work at all. I should mention all the other gauges work correctly...
Prius (Gen 2) :: Gas Gauge Is Not Giving Accurate Reading
I've been letting my wife drive the 2007 Prius since I've been cycling in to work. I got in the car last night and thought "Wow, almost a full tank". I then realized that only 1 pip was missing for 208 miles! The MFD was reading average mpg around 43, so this was bizarre. Usually the first pip drops around 110-120 miles.
By the time we got back home, I was around 220+ and 2 pips were gone. This is usually when half the pips are gone. Is this something I should be concerned about? Should I reset the gauge?
Cutlass - Supreme :: 1967 - Fuel Gauge Giving False Reading?
i own a 67 old cutlass supreme and the fuel gauge, as you turn off the car goes down to 3/4 of a tank, when you start it up it goes to full. But the car is really empty! That is the only reading I get, no matter how much gas I have. I replaced the sending unit and I cleaned the ground wire, it still does the same.
View 4 RepliesMustang :: 2001 - Gauge Reading 1/4 When Tank Is Empty
I changed the seal on the tank filler neck, now I run out of gas at 1/4 tank. How to "reset" the gauge?
2001 3.8 V-6 5-speed
5 Series :: Exterior Thermometer Giving Wrong Temperature
My digital exterior temp reads -40 degrees in May when it's toasty warm outside.
View 4 RepliesFord 7.3L Power Stroke (1999-2003) :: 2000 - EOT Reading Wrong?
2000 7.3 EOT read 272* with engine cold new Ford sensor only getting 3.95 volts at sensor plug and at the 42 pin connector from PCM should be 5 volts, dropping 1 Volt some where I disconnected all the sensors that share this voltage IAT, EBV, ICP, IPR, MAP no change. I left the EOT unplugged and the truck runs good I'll run it like this.
View 14 RepliesToyota - Matrix :: 2005 - Temp Gauge Won't Reading Correctly?
I have a 2005 Toyota Matrix with 250k on it. It has run like a champ so far, with the only problem being an ECM recall last year. I have noticed a few problems recently; the heat blows cold air for quite awhile, and the temperature gauge, while not reading hot, sort of fluctuates between normal and a little warm. When the ECM was being replaced, the dealer said the serpentine belt was overdue for replacement, and I know he's probably right about that. He also said the water pump needed replacing, although I have never seen any signs of leaking. This car has been a champ, and I'd like to try and get another 100k out of it if possible. I'm pretty handy around a car, I've replaced an alternator and radiator before, and I'm working on a limited budget, so if any of this is doable by me, I'm up for it.
View 11 RepliesPrius Plug-in 2012-15 :: Gas Gauge Is Wrong
Display says i have only used 5 gal of gas, but i only have two blips left on my gas gauge. Something has to be wrong.
Wonder if something is wrong with my tank.
Ford - Mustang :: 1999 - Gas Gauge Stuck On Full
1999 Ford Mustang coup gas gauge stuck on full. Just bought the car, it was a known condition been this way 2 years.
View 4 RepliesFord Aerostar :: 1994 - Temp Gauge Reading Low?
It is a garage queen 1994 4.0 AWD with 42,000 miles in nearly perfect shape. Except for the dent in the rear on the passenger side.
I have posted a picture of the dash when going down the road. As you see the engine light is on. It comes on intermittently, pulled the codes, indicated MAF, 02 sensor, running lean/rich. Runs like a champ, no hesitation, still gets up and goes, gets the appropriate gas mileage. I replaced the 02 sensor with the original Ford Part. Didn't cause the engine light to stop going on after about 20 to 60 minutes driving, sometimes it doesn't come on at all.
Could this thermostat be running too cool and causing the engine to throw those codes? Would gladly take it to a mechanic, but seems like it might be a fishing trip with my dollars for them. Next I was going to replace the MAS myself, easily done with the original remanufactured part at a cost of 150.00, 70 for the core, but don't want to chase my tail with these engine lights on when it runs nearly perfect.
Have sprayed the MAF. Checked for air leaks anywhere. Done all the things I could do by just lifting the hood.
So the picture shows the Temp gauge barely touching the N flying down the road at 70 on a level surface, outside temp about 60. Reading the posts says they all run in the cool section of the temp gauge.
So the question is, do they run this cool? Heater works fine and the gauge goes up past the N resting before the O when going up hills on the way to Tahoe. Is this a thermostat problem on a 20 year vehicle with low mileage, or am I going to have to bite the bullet and let the mechanic go wandering through the vehicle?
Ford - Mustang :: Fuel Gauge Started To Misread And Now It Doesn't Move At All - Code P0460
I have a 2005 v6 ford mustang with 134,300 miles on it. About three weeks ago the fuel gauge started to misread and now it doesn't move at all and it dose have gas. Two days ago the check light came on so I connected to to a code scanner and it gave me the code P0460. Under the code it gave a short discretion, (Fuel level sensor A circuit). What issue might be?
View 3 RepliesFord A/C :: 1977 F100 - Temp Gauge Reading Higher
I have a 77 F100 2wd 302/c4. I recently replaced the rear plate to my gauge cluster after it crumbled to pieces. I swapped all the gauges to the new plate minus the fuel gauge since it decided it couldn't live if livin was without the old plate. I have a gauge cluster out of my 75 and decided to swap in my fuel gauge from that one. I put the cluster in the truck and fire it up for 10 mins or so and everything is working great except the temp gauge isn't moving. I figure it romeo and Juliet with the fuel gauge so I just swap all gauges from the 75 into the 77 cluster except the speedo. Same result.
So I figure its the sending unit now and maybe both gauges were fine to begin with. I put in a new sending unit and now the gauges works but the needle sits on the P in the word TEMP on the gauge which makes me uncomfortable. That's about 1/4 inch or so from being past the end of the gauge. I don't believe the truck is running that hot. The gauge was more or less straight vertical before the swap sitting right at the end of the E on TEMP. Did I get a bad sending unit? Is it a bad ground on the gauge? Was I supposed to take off the teflon tape that came on the threads of the sending unit? I'm gonna try removing that first and see if it lowers the needle.
Ford Excursion :: No Reading At Oil Gauge And Temp Light Is On When Very Cold
I have a 2001 Excursion Limited V10. 146000 miles 2 wheel drive. I have had it about a year and this is my first winter to really have experience with her.
When the outside temperature is very cold and the engine is cold from sitting all night, at start up, the oil pressure gauge reads nothing and the oil pressure/temp idiot light is on. Only does this during the first very cold start up or after sitting and engine getting very cold again.
I can drive just a short distance (2 blocks) and both gauge and light go to normal and stay there for the rest of my drive. I am using a quality 5/20 oil and filter and the level is good. Warmer days it has never happened. Truck runs fine, smooth idle, no "limp mode". She has not had any recent work done. All the other dash gauges read fine.
There is something about really cold temperatures that have to be causing the issue , I think. ??
Ford Ranger / B-Series :: 2002 V6 - Low Oil Pressure / False Reading On Gauge?
I have a 2002 Ranger V6 3000 with 100K miles. Can I add a higher viscosity oil since my pressure gauge is acting up. I changed the sending switch twice but the gauge still acts up occasionally. I was thinking of adding 10/ 30 on my next oil change. I do live in the area where the air temp is quite high in the summer. The truck runs well except for the oil gauge, in my opinion, is giving false readings.
View 14 RepliesFord Ranger / B-Series :: 2001 - Oil Pressure Gauge Does Not Show Reading
I have a 2001 Ranger 4.0, 4x4 that just hit 100k and the oil pressure gauge doesn't show a reading for about 1 minute after startup. Also, the check gauge light comes on. What do I replace to fix this and is it something I can do myself? I am mildly handy. Would you worry about fixing it or just let it go because it's obviously getting oil pressure.
View 2 RepliesFord Excursion :: A/C Gauge Reading - Leak In Low And High Pressure Valve?
These are my gauge readings at 70 degrees Fahrenheit. According to an AC conversion for gauges calibrated in Pascals, 35-40F converts to 241-276 KPa, 140-160F converts to 1000-1103Kpa. The gauges are in Mpa which by conversion is 3 decimal points to the left so .241-.276 and 1-1.103 Mpa. Here are my gauge readings at 68 degrees ambient temp. Rear air is same as an ambient temp on max ac and the front is pictured. There seem to be virtually no pressure differences which I would interpret as a novice that there is ) freon flow.
There is freon in the system with the high pressure being approx correct but the low side is too high if I understand correctly. Basically when at highway speeds at 75 degrees yesterday the front AC was cold and the rear was outside vent temp only. There are slight leaks in the low and high-pressure valves. I have a Mastercool replacement tool but they did not send a fitting for the high-pressure valve. What these readings mean as far as what may be wrong?
Ford Excursion :: Fuel Gauge Giving A Low Fuel Light
Today I noticed my fuel gauge giving a low fuel light. I had just fill up 50 miles earlier. Stop fr fuel anyway and could only put 1 3/4 gallons in so the tank is full.
After fueling the gauge went up off the low fuel mark about what I had put in. The only other consideration was the batteries were down and charged last night.
Question. What do I look at first?
Ford Excursion :: Oil Pressure Gauge Not Reading Intermittently / Battery Light Coming On
I have been having an intermittent (2 times in the past 2000 miles) oil pressure gauge not reading. As I own a 6.0L I understand that this is just a pressure switch in reality and if the engine was starved of oil the HPOP system would kill the engine. The first time the oil gauge went out it was raining out. The second time was after going through a carwash and getting the underbody wash. At this time my battery light also came on for a few seconds.
Both problems seemed to go away after an engine restart. Today it is snowing lightly and my battery light came on again. I happened to be monitoring the battery voltage and FICM voltage via OBD II using Torque app. At no time while the battery light was on today did the battery voltage drop below 13.5V. The FICM was also stable at 48.5+/-.5V.
As the battery voltage read by the PCM is not actually dropping and the previous oil pressure gauge and the fact that my left blinker indicator is out I am thinking I may have electrical issues with the gauge cluster. I have never had these issues while driving in dry weather. Where do I start troubleshooting this? Also I am going out of town for the next two weeks and my girlfriend was going to use the vehicle. Is it OK for her to drive?
Ford 7.3L Power Stroke (1999-2003) :: Not Starting - No RPM Reading On Gauge While Cranking
Just bought this 1999 7.3 drove it a couple days now and got to walmart today. shut it off to go inside and came back out. turned on key waited for wait to start to go off. cranked the motor over but it didnt fire. i tried it again and nothing. oil is full, oil pressure is good while cranking. no rpm reading on gauge while cranking. no check engine light. batteries are literally brand new two weeks ago. Cam sensor?
View 4 Replies