Ford - Mustang :: 2011 - Knocking Noise On Cold Starts
I have a 2011 Mustang base with the V-6 engine and 6 speed transmission. It is my summer car, getting fewer than 3,000 miles on it per year. I take very good care of it. My question is what is the mechanical knocking noise I am hearing on cold starts? It continues for about 5 minutes until the engine is fully warm, then stops. The noise comes from the valve cover area. It clearly is a noise that cycles with the movement of internal parts. Is it normal or could be something serious. The car only has 10,000 miles on it (it was sold in 2010 as a 2011 model, so it is 5 years old now).
View 11 RepliesLand Cruiser :: 1995 - Air Conditioner Starts Cold Then Blows Hot
95 Land Cruiser, air conditioner starts out cold, it has freon and then blows hot after the engine gets hot.
View 3 RepliesFord - Mustang :: 1989 GT Starts Without Key
I noticed something strange the other day that my 89 GT can be started without the key ! Everything works as it should but you do not have to put the key in the ignition lock switch. I did have the ignition switch replaced many years ago when Ford had the recall due to a possible fire.. I believe the switch that was replaced is located down under the base of the steering column and activated with a rod from the column key lock.. Is it hard to replace this column lock switch ?
I would rather do it myself instead of paying a locksmith to do it..I do have an anti-start security system on it and when you enable it it locks out the ignition. To start it you have to enter a certain 5 number code for it to crank. I had this car since new and only 117k on the clock and runs like new. Where can I obtain a replacement "key lock assembly " ? This is the original key lock on the column..Just worn out I guess . Only thing I replaced on this car was a new clutch due to a bad throw out bearing making noise at 80k and a water pump and serpentine belt at 90k and a noisy fuel pump. Still has the original prone to failure ignition control module.
Ford - Mustang :: 1995 - Engine Is Making Rattling Noise
I have a 1995 Ford Mustang GT. I've had it for 4 years now, and the engine rattles mostly when the RPMs are between 1500 and 2000, just after pressing the gas. Sometimes it does it when the RPMs are higher, around 2500, and sometimes it does it regardless of RPM after I've been driving it for a long duration. It's done this since I bought it, so it's not a pressing issue, but I'd still like to get it fixed.
View 10 RepliesFord - Mustang :: 1995 - Electrical And Shifter / Ignition Malfunction
I have a 1995 ford mustang with a 3.8 v6, and have recently discovered an electrical problem. First I thought it was just the headlight switch. We replaced it, but looking at the old one, we found that it had gotten so hot, it melted all the plastic off the wires, and that this caused the switch to burn out. I replaced the old one with a new one but it still gets super hot. I'm afraid to drive my car at night for the reason that my lights might fail me in the dark.
Another problem, I'm unsure if they are associated, but it did appear around the same time I replaced the headlight switch. When my car is running, it is impossible to shift it from the park. The button on the shifter (its an automatic transmission) refuses to give, and the result is that my car can only be shifted into gear by turning the key to turn on the ignition position while pressing in the button on the shifter, and then starting my car and driving off. Another thing that i'm sure is associated with this problem is that the cruise control will not be turned off by the brake. It will disengage the cruise when braking but re-engages after my foot leaves the brake. These last two problems began at the same time.
Mustang :: 1995 - AC Compressor Turns On Then Cuts Off
I have a 95 stang that I just had refilled with Freon and oil at Ice Cold Air. The compressor turns on then cuts off as if its low on Freon but its not. Last night the ac started blowing cold and was this morning then started back on the compressor turning on then off. I know it has Freon in it and is full. Could it be that the orifice tube is clogged or maybe even the drier? is this something that I could take off and try to clean out?
View 14 RepliesFord - Mustang :: A/C Is Cold Until The Fan Is On High Then Warm Air Comes Out
When the a/c fan is on any setting other than the highest setting the air comes out cold. When the fan is set to the highest setting, it only comes out warm. This happens regardless of a/c or max a/c setting, regardless of fresh or recirculated air, and regardless of car speed. (2005 Mustang GT)
View 9 RepliesFord - Mustang :: 2005 - AC Not Blowing Cold Anymore
So roughly 2 months ago my ac wasnt blowing cold anymore and it was the evaporator, so i got a new one put in and recharged and it blows 50 degrees or colder now and it still blew that cold today. But today i heard a noise coming from the engine, so i inspected it and saw the compressor was turning on and off which it was doing right before i got it fixed 2 months ago, so I know its not the compressor but i know that's probably gonna go soon to. now its getting to winter so I don't need the ac.
Everything else is working perfect never had any problems with the car other then the ac, it does get used a lot cause but it never gets pushed passed level 2 out of 4. it has 90k on it and i was wondering if this is a major repair to just let it go and sell it for a reasonable price and pick up another car? or just fix it and hope another problem does not arise in 2 months. Like i said ive never had any problems with it before other then the ac. it still runs great and i can still floor it and she responds almost like new.
Ford - Mustang :: 1998 - Hard Start At Cold?
Simple question: Is it possible that battery problem/corrosion in battery cables would allow car to crank but not start on first try when cold? (Car normally starts on 2nd or 3rd try). I've read some places that if car cranks its not a battery problem but I'm not convinced.
Background:I have a 98 Ford Mustang (approx 140,000 miles) that occasionally has trouble starting. Car normally takes 2 to 3 tries to start first thing in the morning or if it has been sitting for a while. It always cranks but doesn't turn over. I had it in the auto repair shop, they said it had to do with IAC valve being stuck open. They recommended to replace throttle air by-pass valve. The repair was done and when I came to pick up the car I heard it take three tries to start before they brought it to me from the back. I asked about it, so the service advisor said he would go and talk to the tech, he said he talked to the tech and that there was a lot of carbon that he had cleaned out and maybe remaining carbon in the system caused problem, I got the idea that they seemed to think everything was fine if I had any problems I could bring it back. The car became even harder to start, now taking up to 8 tries. I brought it back and they said that the new IAC had to be adjusted to allow more air. I picked up the car, they said it was fine, but now it still takes 2 to 3 tries to start it first thing in the morning.
In the past, I have had trouble with battery and battery terminal corrosion, have had new terminal ends put on my battery a few times, last time was probably about 6 months ago. Terminal ends look very corroded again. I'm thinking about just asking them to replace the battery cables and see what happens.
Ford - Mustang :: 2006 V6 - AC Blowing Cool Air But Not Cold
AC works, but only drops temp by 15 degrees. Pressures 40/150 after adding some 134a.
Compressor runs continuously at idle. (I don't know if this is correct or not.)
Not sure what the issue is.
Mustang :: 1995 3.8 Severe Shaking When Started At Idle And Push The Accelerator
I have a 1995 Mustang convertible 3.8. Shakes when its started at an idle and as u push the accelerator, the shaking gets worse, in park, neutral, drive, doesn't matter. I have replaced plugs, wires, coil, torque convertor. I took it to precision auto tune and they said everything checked out computer wise but there is deffinately something wrong. Car shakes so bad its insane.
View 2 RepliesFord - Mustang :: Coolant Spill Out When Take Off The Radiator Cap On Cold Engine
I got a 2002 mustang v6 and I hadn't flushed the coolant since 5 years ago so I decided to take off the radiator cap off too check the status of the coolant. As I took the cap off, coolant started to slowly spill out of it so I quickly put the cap right on. What causing this? My car was already cooled down and it can't be a head gasket problem cause I don't see white smoke. And I don't see any leaks from hoses and water pump . I park my car outside could it be the sun heating it up and making the coolant flowing out when I take the cap off? What causing this?
View 12 RepliesFord - Explorer :: 1995 - OD Off Light Starts Flashing By Itself?
The OD OFF light starts flashing by itself and I can't get it to go out. Everytime it does this, the car is sluggish, won't pull very good at stop signs and kicks hard when down shifts. Thought it was weather related but it doesn't matter what the temp. is. Eventually it will go out by itself and everything is fine.
View 4 RepliesFord Ranger / B-Series :: 1995 - After Warm Up Starts Idling - MAF?
I have a 95 4.0 EFI inside of my 83 Ranger. Once the motor warms up, it starts to have an idle issue. I have to press the gas, in order for it not to cut off. Here is a video I posted a while back. A person suggested that it could be the MAF needed to be cleaned. I did that, and it did not work.
View 9 RepliesFord A/C :: 1995 F150 - Clutch Never Cycles Just Starts Spinning
How often should my A/C clutch be cycling when the compressor is being used. (i.e defrost, mix, a/c and max a/c). My clutch never cycles, it starts spinning when I turn something on and it does not shut off until I shut off the a/c. The truck is a 95 F-150 4.9L 5 speed...
View 14 RepliesFord - Mustang :: 1971 - Cold Engine Start Fine But Will Not Start When Warmed Up / Sluggish Crank
A cold engine crank will turnover and start normally. But stop to run and errand or grab lunch...and the warm 302 2 barrel engine will turn over very sluggishly, lke the battery is dying. If you wait until the engine is cool, an easy start is assured but that takes hours! A local repair shop has rebuilt the carb, the battery & cables are new, and the starter works fine when engine is cold. My local repair shop is out of suggestions. It seems to work a little to hold the gas pedal down on the floor for a warm engine start....but engine still turns over sluggishly when trying to start when warm. Now If I drive it.....I just drive it around town a bit then back home ...unless I stay several hours somewhere while the engine cools....but that's not fun. It is a convertible, fun to drive...and this problem needs to be solved.
View 14 RepliesFord - F250 :: 1995 - CEL Starts Blinking And Then Stays On / Power Drops Off Drastically
I have a 1995 F250 SuperDuty pickup with a 5.8L FI Engine and an automatic Transmission with Overdrive. The truck runs great except when I am towing a trailer up a grade. When I start the grade climb after a few minutes, the Check Engine Light starts blinking and then stays On, and the power drops off drastically. Sometimes I am just going 30 mph up the grade. Doesn't matter if I am towing a 1500 Lb or a 6000 LB trailer, the behavior is the same. I might mention that when I am towing I turn OFF the overdrive via the button on the end of the transmission shifter. When I reach the summit, of if I am going downhill, or on flat ground the Check Engine light goes OFF and power returns. I understand that the 1995 F250's computer does not store codes, so I am up the creek on this one. I don't know how I can simulate the condition at a mechanics shop.
View 5 RepliesFord - Ranger :: 1995 - Clutch Does Not Engage / Pedal Starts To Feel A Little Spongy
I have a 1995 Ford Ranger 4 cyl w/ hydraulic clutch, about 95k miles, and an intermittent problem. Normally, my clutch works fine, but a few times a year, normally during the summer, and normally only after driving for a half hour or more, it starts to act up. First, the pedal starts to feel a little spongy. Then, I'll depress the clutch, and when I release it, the peddle comes up, but the clutch does not engage; a few seconds later, the clutch engages fully instantaneously, which usually stalls the engine if I am stopped.
Then, when I try to reengage the clutch so that I can restart the engine, the clutch is very stiff, and I have to pump it a few times, at which time it will depress easily, and then I am usually back to the original problem where the peddle comes up but the clutch does not engage. When I finally make it home and the truck sits for awhile, the clutch then works fine again. I think it is the orig clutch. I have talked to several mechanics about this problem (including the Ford garage!), and they are mystified. One mechanic thinks that it is a problem with the master and slave cylinder combo, and can replace them.
Ford - Explorer :: 1995 - Heater Only Blows Out Cold Air
My 95 explorer heater only blows out cold air. I have topped off the antifreeze and just replaced the thermostat. The engine operating temperature is very cold, it won't even come up to the first mark. It is very cold here in Utah but I still can't imagine why the engine won't heat up.
View 9 Replies