Ford Super Duty (1999-2016) :: 2000 F250 - Making Ticking / Knocking Noise
I have a 2000 F250 5.4 that has a ticking/knocking noise. After about 30-60 seconds of first starting the truck in the morning, the ticking/knocking noise appears. It sounds like its coming through the exhaust system and seems to be louder under the front passenger side wheel well. When I rev the engine up, it seems to go away. Does this engine have a cam phaser? Could it be timing chain slap?
View 11 RepliesCamry :: 2007 V6 - Ticking / Knocking Sound When Engine Is Cold
When the engine of my 2007 Camry LE V6 is cold, it makes a ticking/knocking sound. The engine has 100,000 kms on it (60k miles). The frequency of the sound varies with the speed of the engine, not with the speed of the car.
When engine is cold: The sound happens roughly twice a second when the engine idles (at 700-800 rpm).
When engine is warm: The noise is less audible. It can be heard when idled at a stop, but you have to listen for it. The noise cannot be heard on the highway.
The car doesn't burn oil, and the oil level is ok. I had the oil changed 3000 kms ago, and it is still very clean (clear). The was the same before and after the oil change.
I am wondering if it could be the lifters, bad plug, or maybe a timing issue.
Ford - Mountaineer :: 2008 - Exhaust Ticking When Cold?
The wife's 08 Mountaineer has an exhaust tick when it's cold. Goes away after it warms up. EGR valve sticking or something? Is there an easy fix?
View 5 RepliesFord - Mountaineer :: 2004 - Running Rough - CEL On - Ticking?
Mountaineer started running rough couple of weeks ago with engine flashing. Had codes read, got codes P0306 and P0316. I changed the coil pack of cylinder 6, engine light went away but still running rough. Decided to change all plugs. Found cylinders 2 and 3 filled with oil so I changed the valve cover gasket. Put back together, still running rough and ticking. Pulled every coil pack and metered them.
Every one reads .6 ohms across terminals and 5.6k from each terminal to spring. I'm assuming this indicates a good coil pack. I also metered the one that I took out and it reads the same. I've also looked for vacuum line leaks and listened but found none. The engine is rocking pretty bad and the exhaust comes out in the pattern of the "misfiring". Went to see if Autozone could read a code without the engine light on but they read "no codes".
Ford - Mountaineer :: 2006 - Ticking At Startup Stops After About 30 Seconds
My 2006 Mountaineer 4.6 is ticking at start up, and it gets quieter after about 30 seconds. Does this sounds like the cam phaser?
View 3 RepliesTaurus :: P0193 - Can't Find Port On Fuel Rail To Get Fuel Pressure
I cant find the port on fuel rail to get a fuel pressure reading.it is nothing like my tarus.saw astem sticking up on front right of rail but it has some kind of covering over it. It is a 2005 freestar with the 3.9 motor.
View 5 RepliesVolvo :: Lost Metal Clip Connecting Fuel Line To Fuel Rail - What It Is Called
I have a 1994 volvo 850 turbo wagon. While replacing the pcv breather system, I dropped a little metal clip that attaches the fuel line to the fuel rail with a t25 torx screw. I can't find the clip. What the part is called or where it can be found?
View 1 RepliesJeep - Cherokee :: 1987 - Starts Immediately If Relieve Fuel Pressure At Fuel Rail
I have a 1987 jeep cherokee with inline 6 and multi port injection.
Sometimes this vehicle only starts when hot
Some times only when it cold
I have recently fixed the fuel leak.
When its hot or cold and not starting if i relieve the fuel pressure at the fuel rail, in most cases it will start immediately. However if fuel pressure relief does not work. I disconnect the vacuum line at the what looks to be the EGR valve or the pressure regulator at the front end of the rail, then usually starts right away.
I have not tested at this time to see if the fuel pump is failing nor have i tested fuel pressure. I am trying to narrow down the problem to one specific part. There is no problems with cranking. There is spark - coil, plug, dist cap have been replaced.
It seems the problem is with fuel delivery of sorts. It was mentioned that sometimes the heat from the engine could be heating the fuel rail to a point which turns the fuel into a gas not allowing it to atomize.
Ford Excursion :: 2000 - Ticking Sound Coming From Underside / U-Joints?
Yesterday morning taking off out of my driveway I heard a ticking sound. Kinda metal on metal sounding. It sounds like middle of truck underside. Only on acceleration. It does also clunk at times or ping when I put it in gear.is this u joints? Hopefully not rear end. Its a 2000 limited ex. with the v10.
View 7 RepliesFord F-150 - 1997-2003 :: 2000 V6 - Ticking Sound At Idle But Not When Moving
2000 f150 v6... I just got the truck and was fine went to instant oil change and changed the oil used 5w30 and there filter unknown brand? now I'm getting a ticking kinda like a lifter tick?? you can hear it at idle not when moving.. Would the thicker oil be causing this? or the cheap filter is so filter should I go to? Motorcraft? bk to factory oil?
View 1 RepliesFord - Explorer :: 2000 4.0 - Sputtering Almost Knocking Sound That Gets Worse When Put Into Gear Or AC Turned On
I have a 2000 Explorer with the 4.0 OHV. 104,000 miles. Has always ran great. The last few days it has had a sputtering almost knocking sound that gets worse when put into gear or the ac turned on. I changed the oil and checked all fluids. Looks good. Only thing I had done was fill it up this past monday after a storm. My mother in law told me afterwards that the particular station always has complaints after rain and has leaks in their tanks. I'm assuming I may have gotten water into the system. Would this cause these problems? And is it ok to drive it out or should it be flushed. I've added a can of Iso Heat and am now down to 1/4 tank. I had planned on getting a little lower on fuel and filling up with Premium. I've never had a problem like this before so not really sure the best way to track the problem or fix it. Or it may be something else all together.
View 3 RepliesFord F-150 - 1997-2003 :: Truck Won't Start - Fluid At Fuel Rail?
I bought the truck now it won't start has to fuel at the fuel rail cranks but won't start when I spray starting fluid it starts but won't stay running....
View 1 RepliesFord Ranger / B-Series :: 1986 - No Fuel To Rail / Truck Quit On The Way
I have a 86 ranger 2.9 5 speed. A few days a go I replaced the front fuel filter and all seemed ok. Last night on my way home the truck quit and I had to have it towed home. Now I find both pumps don't seem to be working. What would make me loose both pumps??
View 11 RepliesFord Super Duty (1999-2016) :: Turning Over Fine Just No Start / No Fuel At Rail
I have a 99 f350 super duty with a v10. I drove it Friday night, but it wouldn't start Saturday morning. It is turning over fine, just no start. I have no pressure at the fuel rail. The pump does its little key on run. I can hot wire the pump at the tank, and it pumps. It builds up pressure after the fuel filter. I found that out when I changed the fuel filter. Will the pressure regulator shut off the fuel to the rail?
View 9 RepliesFord 7.3L Power Stroke (1999-2003) :: Fuel Rail And High Pressure Oil Cross Over
Next mods are for the fuel rail cross over and the high pressure oil cross over. I see the unused ports will come in handy.
Fuel delivery? any specialty mods to run the fuel lines? I see it's a #4 ORB fitting. Anyone ever use a "T" or a splitter off the fuel bowl to have a quad line set up?
Saw the FRx from RiffRaff .... not sure how it eliminates air from the system 7.3L Diesel Fuel Rail Crossover? (FRx) 99-03 Powerstroke
Ford F-150 (2009-2014) :: Dirt Fell In Injector Hole After Fuel Rail Removal?
I thought id tackle installing my new boss intake this morning and didn't think to clean everything up enough and after i removed the fuel rail some dirt and small stones one was about a quarter of in inch round fell into the injector hole. I no that all will be in the engine now and I feel awful about it.
View 14 RepliesMercury - Mountaineer :: 2007 - Ticking Under The Hood Increases And Decreases With RPM
My parents have a 2007 Mercury Mountaineer, 100,845 miles. They change oil like a religion. It has under the hood ticking that increases and decreases with RPM. The ticking (tickity-tickity) sounds like when there is low oil. People have said,"You better put oil in there..."The oil is full. I can't tell if the sound is coming from inside the engine, or if something on the engine might be loose that is causing the ticking as the engine RPM changes. From what I can remember from auto shop in the 80's...it kind of sounds like valves/lifters.
Also, it has a strange road noise that I think is coming from the tires. It sounds and sort of feels like riding on knobby off road tires. I can put it in neutral and turn off the engine, and the noise remains and decreases as the speed does, so it is not from the engine.
Accent LC (2000-05) :: Ticking Sound Form The Engine When Idle
I bought a 2005 Hyundai Accent about 5-6 months ago, GS 2 Dr model, 52,000kms (69,000 on her now), and lately she has been making a weird ticking sound form the engine when idle, if you give her some gas it slowly goes away as your RPMS increase. I had my father look at it, he said it seems fine, i also had a garage look at it and they also said its fine, but too me the engine sounds different then it did when i got it, maybe the cold from the winter could be doing this? when the engine is heated up it still makes the noise.
View 4 RepliesToyota - Tundra :: 2000 - Ticking Sound When Turn On The Ignition
We own a 2000 Toyota Tundra--90,000 miles--obviously not used hard. When we turn on the ignition, we hear a ticking sound--sounds like it might be coming from underneath car passenger side. The sound seems to disappear as we drive it. What it might be? Toyota service person told us it might be exhaust manifold and estimated maybe 2K to fix it.
View 1 Replies