Ford Fuel System :: Hiccup And Stumble When Get On It Real Hard From A Standing Start
My 302 runs pretty good when all warmed up. It has some cold start issues every now and then, but is easily dealt with. My question is how to best "tune" the carb. It's a 600 cfm 4150/60 style Holley single pump, vac secondaries and electric choke. About as basic as you can get. I think I have the fuel level set correctly. I also think I have the "idle mixture" set right. I used a vacuum gauge and moved back and forth between screws till I got the highest vacuum. Is there a better way than that? I have the idle set correctly. the fast idle is a little high, but I can fix that.
Now, my real question is how to fix the hiccup and stumble I get many times when I step into it pretty good. I assume that this is the point the carb is going from idle circuit to main circuit. It stumbles when I get on it real hard from a standing start. I can roll slowly and step into it and it stumbles as well. I also like to blip the throttle when I down shift (it has a manual tranny by the way), and many times I'll blip it and get nothing. Now, it runs fine after the stumble all through the rpm range. That's the only time it stumbles. so, do I need more accel. pump shot?? To compensate on the transfer of circuits.
I also notice when I on it real hard, during the shift right when I jump on it, under the heaviest load, I hear a bit of spark knock. It's not running hot, and the timing is good. Do I need a bit bigger jets? I'm thinking it's going a bit lead during that time, but I don't have any real way to measure it.
Ford Fuel System :: Engine Shakes The Vehicle So Much / Hard To Set The Floats
4150 Holley 532BBF float adj issue . I think i have it close, but its so hard to tell because the engine shakes the vehicle so much its hard to set the floats so that it just trickles out of the float holes. (532 kasse P51 heads, big roller cam) Is there an easier way to do it say on the bench?
View 1 RepliesLincoln - Gasoline - Ls :: 2001 - Hard Start / Fuel System?
I have a 2001 Lincoln LS V8 that runs rich and no one can solve the problem that's been going on for close to a year. The fuel sys pressure tests fine. The fuel regulator sensor has been replaced. First start in morning is normal but after that I need to give it gas to get it to turn over. Also, car has a fuel smell.
View 8 RepliesFord Fuel System :: 1989 F250 5.8L Runs Great Then Dies After Warm
I just purchased a 1989 F250 with a 5.8 motor. Great truck for its age. Ive owned other Ford trucks in the past and my Dad had them as a kid. Love them.
When I bought the truck from the 2nd owner it had a problem so I bought this truck with the problem figuring with my past knowledge I could fix it. Not the case. When I got the truck it would start fine and run really great but when it got warm it seems it would die and I would have to wait till it was cooled down to start back up and again it would run fine. Well the problem got worse and worse and now it wont run at all.
It will run on starter fluid so that leads me immediately to the fuel pumps. I say that plural because none of them will run it seems. I did a fuel pressure test at the shrader valve at the top of the motor on the fuel rail and I get no pressure at all when I turn the key. The relay in the engine compartment seems to be working to as I can hear it. I put a new on of those on to to be sure. Leads me back to the pumps again. I replaced the external pump on the fuel rail and I know thats working. I replaced the fuel filter to while I was there.
Is it possible to have BOTH fuel pumps in the front and rear tanks go at once? Seems unusual. My other F150 with dual tanks worked great and when the back tank pump went I could just switch it over to the front tank.
Ford Excursion :: 2004 - Hard Start When Warm?
I got a new to me 2004 4x4 Excursion v10. 98,000 miles but why it is hard to start when the engine is warm. Starts right up when cold, engine not ambient air temp, idles great once started. In park idles at 1,000 until normal op temp is reach, then down to 750ish. In gear idles right at 650. Drives great. Plenty of power, does not surge, averaging 13.7 mpg over two tanks (70% hwy, 30% city) and no codes. Since it is new to me, and I don't trust people to do maintenance I have:
Replaced spark plugs
Replace downstream o2 sensor (the two upstream were not in stock)
Replaced fuel filter
Replaced belt
Replaced crank sensor (because the belt was already off)
Changed oil (mobile 1 5w20) and filter.
Ford F-150 - 1997-2003 :: 2002 - Hard To Start When Warm
I have a 2002 F-150 4.2L that is hard to start when warm. Cold starts are no problem, except in the below 0 F stretch last winter. Also when it is a hot start it is not an issue. Only when it has sat for a few hours does it have an issue. The following is the list of things that have been done.
- New Plugs,
- New Plug Wires,
- New Coil Pack,
- New Fuel Filter,
- Clean Throttle Body,
- Clean Mass Air Sensor,
- Clean Idle Bypass,
- Replace EGR Vacuum Control Switch,
- Manifold Leak Repair (Ford Dealer),
- Throttle Body Stop Adjusted for more idle speed,
- Check fuel pressure (40 psi key on, drops to 35 psi static).
Ford Fuel System :: Changed Fuel Filter Now Just Cranks But Won't Fire / Start
2002 E-250 with the 4.6 V-6. Pulled the 30 amp fuse, replaced the fuel filter, replaced the fuse, now the truck wont start. Checked the fuse and the kill switch under the passenger kick cover, all ok. Cranks and cranks but wont fire. No problem prior to changing the filter. Even swithed out the relay with another, no luck.
View 4 RepliesFord Fuel System :: 1994 F150 Won't Start - No Fuel Comes Out Of The Valve
1994 150 300 6. parked truck after lunch finished work and it wont start no fuel comes out of the valve. Can't get the pump to work even when jumping the 6 pin. heard the relay click still nothing. Checked the inertia switch it wasn't popped. Took the pump out jumped it straight from the battery pump works . I know there has to be something i am missing...
View 7 RepliesFord Fuel System :: 1978 - Sputtering And Smoking - Getting Too Much Fuel In Engine?
I have a holley 390 cfm carb on a 78 F250, 300 I6 with headers and an offy dp intake. Somewhere i am getting way too much fuel to the engine and it is sputtering and smoking bad. I have checked the float level, needle and seat, and power valve. All seemed ok but i replaced the power valve and needle and seat on the primary side just to be sure. Even with the float level adjusted way low and the idle mixture screws turned way in the truck would still sputter and spew out black smoke at idle and all throttle positions. I can't figure out where the gas is coming from. I checked to make sure the butterflies were closed and they were. I looked down the throat of the carb when it was running and didn't see any gas rushing in. When i take the carb off the bottom is soaked and the gasket and spacer is all soaked and theres gas sitting in the bottom of my intake. Where is this gas coming from?
View 14 RepliesFord Fuel System :: Fuel Filter Is Clogged When Turn Over The Engine
Is it fair to assume that my filter is clogged when I turn over the engine and fuel does NOT come out of the filter with the uphill line disconnected. I was able to disconnect the rear line from filter and fuel DID pump out of line when I cranked it over. Been dealing with a crank no start, I'm in the process of trying to test my CPS properly but not sure if I'm testing it right.
2000 f 150 4.2 v6 232,000 miles....
Ford Fuel System :: No Fuel From Tank To Engine In Normal Operation
I am unable to get fuel delivery from tanks to engine in normal operation. I can however get pumps working with jumper wire to them. It will start with ether but not stay running on it's own. Could this be a relay or something in tfi thing ?
View 14 RepliesFord Fuel System :: Leak / Dripping On Top Of Engine At The Fuel Filter
I'm dripping fuel on top of the engine at the fuel filter . Where the line ties into the filter canister, there is a small plate that's attached with small Allen screws its dripping between this plate and the canister .... I assume there is a gasket/oring that is causing it ...... What is the part number or correct description so I can go to ford dealer and get one. It's a 2007 Ford 4x4 6.0 diesel.
View 2 RepliesGmc - Sierra :: At Warm Hard Start?
I recenty replaced the upper intake manifold gasket on my gmc sierra 1500 350 motor. In the process I did plugs and wires and power steering pump. I went through everything and cleaned it to perfection and put it together. It started like a dream and took it for a test burn out in the country. About 15 miles down the road I shut it down and went through all the fluids and upon starting I noticed it was really hard starting. Kinda like it had alot of compression. I just replaced the battery 2 month ago with the best Interstate battery they had and it still checks out good.
Every time I went to start it cold it started normal but when warm it had the same hard starting issue. Well a week later I stopped at the store before work and it did the same but then just rested to a stop and now the starter just clicks every time I turn the key. I can turn the motor over by hand with a wrench and all battery connection are good. I just put a new starter in today thinking that may have been a fluke of a deal but nothing still. I did see when I first tried the new starter that the pulley on the alternator was trying to spin over ever so slowly tell it quit again.
Intrigue :: 1998 - Hard To Start When Warm?
I am having a problems with my intrigue... Hard to start when warm i checked the pressure reg vac hose found no fuel so im not sure if that is the problem. I have the 3800S11 engine. sometimes it will start when warm other times i need to push the gas a little to get it to start.
View 4 RepliesFord 6.0L Power Stroke Diesel :: 2007 F250 - Engine Gets Warm / Hard To Restart
I have s 2007 f250 superduty with a 6.0. Recently after the engine gets warm I have a problem restarting it. I have to turn the key to the run position until all sounds have stopped then I have to pump the accelerator to get it to start. Sometimes I have to repeat this three or four times before it starts. I have had the fuel pump rebuild and installed two new batteries. What I should be looking at.
View 14 RepliesCamry :: Hard To Start When Warm At Operating Temperature
My Camry has 185,809 miles on the 4 cylinder, it has recently started to be hard to start when it's at operating temperature, has code P0301 and p0302 replaced spark plugs at 185,000 miles no change, possibly ignition coils?
View 1 RepliesCamry :: 2010 LE I4 - Hard / Hesitant Start When Warm
I have a 2010 Toyota Camry LE V4 version, it has about 47k miles on it and about 4.5 yrs old. I have developed a problem over the past few months where the car will crank fine in the morning or when cold (sitting around for several hours or overnight) However if the car is Warm when driven for about 10 miles or more, then parked and then started again in 15-20 minutes it will feel hesitant to start, seems like it takes several cranks before starting and literally feels like it will die while cranking but it will eventually start.
i have the original stock battery, i got it checked at O'Reilly and they confirmed that battery, stater, alternator looked good and cold cranking amps looked good and other items checked out as well fine.
I am not sure what the issue might be at this time, However since the problem is at random and only when outside is like a 100F (which it is not now) and it is warm/hot (driven after 10+ miles), i am not sure what is wrong with the car. I have been using Top Tier gas for the most part, however i had used Arco for about 3-4 months during the Spring/Summer of 2013.
Elantra HD (2006-10) :: Hard To Start When Weather Is Warm
This has been going on for 3 or 4 months can someone tell me where the ETC sensor is located on 4 cylinder 2008 Elantra ?
View 5 RepliesGolf IV / Jetta IV :: Random Hard Start After Car Is Warm / No CEL
I have a 99.5 golf gls with an 02' engine in it. 5 Speed, neuspeed supercharged with a bunch of other stuff done to it.
I've had this issue as long as I've owned the car (3-4 years). Starting the car cold, it usually fires right up and can drive it e, no problem. However, when I get the car up to operating temp and turn the car off, if I immediately try and restart the car it either :
A.) chokes but will fire or
B.) will have a long crank and usually starts hard.
Another thing I noticed is that at low RPM right after the clutch has been engaged, the car seems to almost hesitate like something is holding it back, even if I give it more gas. I have checked my codes with Vag com and the only CEL I have it for not having a post cat o2 sensor (picks up that the heater circuit is unplugged). I also have run some diagnostics on my fuel trim and both long and short term fuel trim are within spec. I tested two different mafs and both were around 2.5g/s at idle. Checked for vac leaks and didn't have any.
I have read that a dead/dying crank sensor can give me the symptoms I have, but I seem to be lacking a symptom where the CEL is on for the sensor, and my car doesn't randomly die when driving. So my question is, have any of you had the same symptoms but no CEL?