Ford - Freestyle :: 2005 - Shaking If Drive Over 60 MPH
I took our 2005 Ford Freestyle to get an oil change this morning. It is now shaking violently if we drive it more than 60 mph.
View 2 RepliesFord 6.7L Power Stroke Diesel :: All Gauges Sweep Across And Then Go To Normal Position When Turn The Key
I had a '11 and when I turned the key on all the gauges would sweep across and then go to normal position. My '14 does not is that normal ?
View 1 RepliesFord :: 2005 Freestyle Stuck In 3rd Gear And Wouldn't Go Above 50
My freestyle has 239K on it and the it has been infrequently having periods of starting the car and having no drive and then turning it off and every thing is fine when you start again. The other day it stuck in 3rd gear and wouldn't go above 50. We stopped the car and started it and ran fine but the check engine and transmission light came on.
View 3 RepliesEngines - Repair :: 2005 Ford Freestyle - Lean Misfire
I have a 2005 SEL Freestyle with 114K miles. Cyl #3 missing. Has all the symptoms of a "lean misfire" - reading the code said #3. The indy mechanic already replaced the spark plug and the coil. Misfire still a problem. Tried to put some cleaner in there which did not work. He thinks the head needs to be replaced ....
The a/c is also busted. Needs a compressor. Not to mention I'm probably looking at brakes before much longer.
Ford - Freestyle :: 2005 - Loud Ticking Noise At Idle
I have a 2005 Ford Freestyle Limited AWD and there is a loud ticking noise at idle. It seems to quite a little when put in gear.
View 6 RepliesFord - Freestyle :: 2005 - Surging And Hesitation While In Cruise Control At 70 Mph
I have a 2005 Ford Freestyle with 59,xxx miles. My wife and I drive it less than 7,000 miles p/year. About six months ago it began to surge (we had already taken it back to the dealer for some work on a recall related to surges while idling). However, the surge that now occurs is not related to the recall--it can happen anytime, even when on the highway while in cruise control at 70 mph. It makes the driveability of the car questionable. We have had it back to the Ford deal repeatedly, only to be told a number of high dollar things that seem to be based on guesses rather than actual data. No codes have come up with computer diagnostics.
We have also taken to independent mechanics, only to be told there is nothing wrong. Only once did a mechanic say that he 'felt' the surging when he test drove the vehicle. But even then, the shop said that they would have to do a tune-up (which raised a red flag with me because tune-ups no longer seem to be the proper term to be used with modern engine maintenance). I did a lot of research and as a result I asked a mechanic to test the fuel pump. The result is that the low pressure was 39.5 lbs, and, the high pressure was also 39.5 lbs.
Ford F-150 - 1997-2003 :: 2002 V8 - Dashboard Gauges Always Stay In The Same Position
I have an F 150 2002 Trition V-8. I always thought I knew how to read an instrument panel on a vehicle but after being put down by my Ford, I have to rethink this knowledge.
I have noticed over the past 4 years that my volt meter guage on the instrument panel always stayed in the same place whether the motor was running or just the key in the on position. I noticed that a little battery icon kept coming on and going out yesterday. I read the owner's manual and it said something like this indicates your battery is not taking a charge correctly. Well why has the guage not told me anything. Well the alternator has quit but yet and still the guage is still showing me all is well.
I ask a Ford dealer service dept. about this and they do not have a clue. All they tell me is people do not pay attention to the guage but when the light comes on they need. They also said the gauge would work when everything shuts down, but man! I don't need it to work then. I know it's broken when that happens. It quits running.
What is the purpose of the gauge sitting there all shiny and pretty if it is not going to say anything other than "HEY MAN! I am just here looking pretty and taking up space".
I have looked at other trucks and they do the same thing. Nothing .. What is going on with this gauge which undoubtedly does nothing?
Ford F-150 - 1997-2003 :: 2000 - Starts Intermittently / Dash Gauges Spike To Max Levels For A Second Then Normal
Dad's 2000 F150 5.4 ltr will start intermittently, when it does fire it runs fine, but right after start up all the dash gauges "spike" to the max levels for a sec and then go back down to normal....
Put the Cen-Tec 98614 code reader on and it continues to say "Link error" and I can't communicate to the interface. P.S., I confirmed the Code reader is good by pulling a 420 O2 sensor code from my Toyota in just a few seconds....
I can hear the fuel pump kick in so I doubt that is the culprit. Because of the gauge spike at start up (every time) this problem screams grounding problem, but I don't know where to start. Could it be a faulty relay?
Ford Excursion :: 2003 V10 - Gauges Stopped Working
2003 Excursion 4x4 Limited v-10 gasoline engine powered
gauges stopped working
gauges dead
gauges not working
gauges
Coming home tonight, I lost all the instrument cluster gauges. Speedometer, tachometer, fuel, oil, temperature and transmission temperature.
So the logical thing to do was check both instrument cluster fuses, fuse 35 and fuse 41. They were both OK.
Kept looking and found fuse #45 blown, it's the "Ignition switch Run/ Start feed" fuse. It was blown.
Popped in a new one and gauges came back to life. I don't know why fuse #45 controls power to the instrument cluster gauges. Strange.
Ford Ranger / B-Series :: 1988 - Wiper Won't Roll Down To Normal Position And Not Working At Slow Setting?
1988 Bronco II 2.9L Issues:
- When I turn off the wiper switch the wipers immediately stop in place, they do not continue to their normal 'down' position.
- The switch's adjuster to slow the wipers isn't working, only the low and high settings work.
What I've done so far:
- Replaced wiper switch with used from spare parts.
- Replaced wiper switch with new from spare parts.
- Replaced wiper motor with remanufactured from Autozone.
- Thoroughly cleaned wiper motor ground terminals.
- Replaced interval wiper governor with used from spare parts.
The problem occurred after the truck sat in my garage for 6 months while I removed and reinstalled the engine to replace some gaskets & seals.
Ford - Explorer :: 1997 - Shaking From Inside When Car Is On Position D And Apply Brakes
I just got my first car: 1997 Ford Explorer XLT 130k miles, drives great and I drove like 1200 miles already, got balljoints changed but still have a problem: when car is on position D and i apply brakes it starts shaking from inside: seats, main console and steering wheel vibrating (kind of tough when i drive a lot). And one more question: how can i increase MPG i got 4.0L but it consumes a lot: 9MPG CITY and 16MPG HIGHWAY.....
View 8 RepliesFord Wiring/Electrical :: 1999 F350 - Alternator Over Charging And Gauges Stopped Working
We have a 1999 F-350 V10 super duty. The alt was over charging and the gauges stopped working. Replacing the alt, the guages still don't work, and the new thing is the charge light and selt belt light comes on. The fuses 29 (5amp)and 30(30Amp) which are supposed to be key on hot only are hot at the same time. With these on, it causes a drain killing the battery. Also if the truck is started, the lights go out, but when you try to turn the vehicle off, it stays running, one with the battery disconnected. The only way to shut it down is pull the fuse box power fuse, 50(amp)Some one had been in the dash before we got this vehicle and busted, burned out or removed the check engine light. I can read codes and their vehicle runs fair and does operate. Could this be a dash board? Also this problem appears when the truck is sitting, and the key removed nothing on. No fuses are blown either.
View 3 RepliesFord F-150 - 1997-2003 :: Gauges And Tach Stopped Working While Driving - Wiring Diagram?
I am working on my son's 1997 F-150, 2 wheel drive, 4/6L truck. He was driving it when the gauges and the tach stopped working. I replaced the cluster and it still blows the fuses. The five amp fuse that is specifically for the cluster doesn't blow. It is a twenty five amp fuse that also power the overdrive circuit, etc.
After replacing the gauge cluster I installed a new fuse and the overdrive button on the shifter started smoking. Where I could get a wiring diagram of this circuit so I can see how it is wired.
Ford Excursion :: 2004 - Dash Lights / Gauges Stopped Working After 30 Minutes Of Driving
2004 Excursion 4x4 6.0. I just had the fuel injectors & wiring harness replaced and it runs great, but after 30 minutes of driving the complete dash lights/gauges stopped working. I found that the #45 10amp fuse had blown so replaced it and after 20 minutes the same thing happened. While it was working all of the lights & gauges seemed to be working okay. This doesn't effect anything else, still starts & runs okay, turn signals work, head lights work, but the head light auto on/off doesn't.
View 4 RepliesFord Wiring/Electrical :: All Gauges Stopped Working / Strong Burning Smell Inside Cabin
My father in-law gave us a 1996 explorer AWD with a 5.0 for my son who is 16. A couple of weeks later he's out learning with my wife and a very strong electrical smell took over the cabin. They came right home and when I got in I found all of the gauges not working. The instrument lights work, blinkers work, but all gauges do nothing. Pulled cluster and wires look O.K. behind it from what I can see. They saw no smoke, just smell, fuses look O.K.. What could cook on this vehicle that would wipe out just the gauges?
View 5 RepliesFord Super Duty (1999-2016) :: 2000 F350 - Gauges / Speedometer And Tach Stopped Working
I have a 2000 F350 4x4 with 7.3L diesel and a manual transmission. While driving home yesterday my gauges (fuel, temp, volts, oil pres) stopped working. Within a couple min the speedometer and the tach also stopped working, but the truck was still running fine. Within a couple miles the engine stopped running, just like I had turned the engine off.
After having it towed home I checked all the fuses, none are blown, but there is no power to fuse #16 (15A, instrument cluster, high beam head lamp). Also in the fuse box under the hood, again, no fuses are blown, but fuse #9 (left head lamp low beam) and #11 (right head lamp low beam) have no power to them.
Bmw - 318 :: Gauges Flipping Back And Forth When Driving Or Stopped
I have a 1995 BMW 318i and my gauges freak out when I drive or when I am stopped. All of them, not just one or two, like flip back and forth over and over and then eventually will return to their accurate readings. Then they do it again and again. It's not always the same how long they do it for and sometime they will go a whole day without doing it and then other days like today they just dont stop.
View 3 RepliesGolf/GTI VII :: Trunk Won't Open While Car Is Locked From A Normal Standing Position
I can't get the trunk to open while the car is locked from a normal standing position. I used to be able to, but now I have to rub up against my car to open it. gotta hump the back of my gti to open trunk... its been 3 months. is the key already dead?
View 6 RepliesFord Super Duty (1999-2016) :: 2008 F250 - Gauges Stopped Working / No Crank / Security Light Flashing
My father-in-law has a 2008 f-250 with the 5.4. as he was driving a while back all the gauges of the dash quit. The engine still kept running without any noticeable difference but when he shut the engine off and tried to restart, it wouldn't even crank but the security light was flashing. He tried starting it again a few hours later and it started just like normal and ran fine.
He has had this problem occur several times in the last few months, but the other day it repeated the problem again and would not restart for about 5 days. He has tried charging the batteries, changing relays, checking all fuses and finding none blown, scanned it with his code reader, and checked the steering column for bare or rubbed wires.