Ford F-150 (2004-2008) :: 2005 - Torsion Bar Adjustment To Lift Front End

I wanted to put bigger tires on my truck, something more agressive. Is there a torsion bar? Can it be adjusted? How? If not what is the biggest tire i can put on with my stock 17" rims? 2wd 2005 f150...

View 2 Replies

Ford F-150 (2009-2014) :: Gas And Brake Pedal Adjustment

I just purchased a 2011 F-150 XTR and i noticed the pedals very close to me and i know it does not have electric positioning and it appears that looking at it, it can be adjusted manually..

View 10 Replies

Ford F-150 (2009-2014) :: Automatic Headlights Sensitivity Adjustment?

I have a 2009 f150 is there any way to adjust the sensitivity of when the automatic head lights come on?

View 9 Replies

Ford F-150 (2009-2014) :: Steering Wheel Highest Adjustment?

Is there a way to move the wheel higher than the highest setting? I like to keep the seat at its highest and its difficult getting in and out of the truck.

View 9 Replies

Ford F-150 (2009-2014) :: Changing Tire Size And Speedo Adjustment?

Been looking at a level for my truck and some new wheels and tires. If I change sizes, can the dealership recalibrate my Speedo and transmission shift points for me?

View 14 Replies

Ford F-150 (2009-2014) :: 2010 - Passenger Side Door Adjustment

2010 Ford F-150 Lariat crew cab ... Is there any way to adjust the door on the passenger side? It is not close all the way. When it rains hard it gets in the cab.

View 1 Replies

Ford F-150 (2009-2014) :: Truck Not Level Left To Right In Back

I recently bought a 09 F150 Screw short box. I just hooked it up to my camper for the first time and was measuring height on the corners of the truck to check my WD hitch. I noticed that the driver's side was higher than the passenger's side in the back of my truck. I checked again without the camper on some level ground and found the same thing - approximately 1 1/4" difference at the wheel wells and about 3/4" at the frame. I can't believe that this would be normal, so trying to figure out what happened here - maybe it got rear-ended?

View 6 Replies

Ford F-150 (2009-2014) :: Oil Level Rising Up To 1 Quarter Over Full

2012 F-150 ecoboost oil level rising up to 1 qt over full. Took it to the dealer, They are installing a block heater and a new vent line. Cannot see what a block heater is going to do for me in a warm climate. I will let them do there thing and see what happens. 24,000 mils on the truck and warranty runs out in Dec 2015.

View 14 Replies

Ford F-150 (2009-2014) :: Oil Level Slightly High After Change

2014 F150 3.5 Ecoboost...

I recently got my oil changed at the dealership and yesterday when I did my periodic oil check, I noticed that the oil level is slightly higher than the "high" mark on the dipstick. Its about 4mm above the high line, maybe 5mm at most. I do not smell gas in the oil, and given that its been about a month since the change, I simply think that slightly too much oil was added.

My question is will a slight overfill like that affect this engine? I'm particularly worried about "frothing" of the oil by the crankshaft. I don't think that oil level is nowhere near to be "pushed" by pistons and affect my seals. Correct me if I'm wrong here. I drive on very flat terrain. So the question to those that have knowledge on how much clearance there is between the crankshaft and oil level in that engine is, do I leave as is or go back to the dealer to adjust. (Reason I ask is because I'm particularly busy with a project at work, and if I don't have to burn time to correct this I would rather not given my busy schedule.)

View 1 Replies

Ford F-150 (2009-2014) :: 2013 XLT - Checking Level Of Power Steering Fluid

Is there any way to check your level of the power steering fluid on a 2013 xlt 5.0,

View 4 Replies

Ford F-150 (2009-2014) :: 2010 6 Speed - Checking Trans Fluid Level - No Dipstick In Engine Compartment?

OK; I give up. How do I check the trans. fluid level on my 2010 F150 6 spd. auto trans????? I see that there is NOT a dipstick in the engine compartment.

View 14 Replies

Sierra :: Leveling The Front - Torsion Bars Need To Be Released?

I want to level the front of my truck. 1999 GMC Serria 2500 4x4. Wondering what is involved. Do the cams on the torsion bars need to be released and rotated or can I just turn the bolts in?

View 2 Replies

Ford F-150 (2009-2014) :: Shroud Under The Front Of Truck

So my truck hit 1,000 miles. I decided to change the oil to get the factory oil out and remove any material that may be in there from the break in. I know the motor hasn't fully broken in. My question is what is the purpose of that shroud under the front of the truck? It seems like it can almost get caught on parking bumpers. It also makes it very difficult to get under there and change the oil. I had to go from the side. Need to remove it? It seems to be held by 2 good size bolts by the frame.

View 14 Replies

Ford F-150 (2009-2014) :: FX4 - No Front Turn Signals

Ok so I have a 2014 F-150 Screw fX4 with the projector headlights. 13356.0 km as I sit in it. I had turn signals the other day, but now none. I had the dealer disable the lamp outage to remove the hyper flash issue with led's. Sockets don't look burnt or anything everything is new. So here is what is working.

- mirrors turn indicators
- rear turn signals
- dash turn signals.

I have reinstalled my OEM bulbs and still have the issue, only my running lights are on the front. So it has power.

View 6 Replies

Ford F-150 (2009-2014) :: Front Windows Won't Roll Down Sometimes

Anyway, just bought an 09 Expedition EL Limited. I ran through every button and function I could find at the dealership and it all worked great.

The next morning I went to roll the driver's window down and it makes a noise like it's going to start, but barely moves - if at all, then stops. Same with the front passenger. Rear windows worked fine. It was freezing and snow-covered at the time.

Yesterday (warmer and sunnier), all windows worked perfectly fine - just like they did at the dealership. The only thing that changed was the temperature.

View 2 Replies

Ford F-150 (2009-2014) :: Vibrates When Braking - Front Rotors?

Ever since day 1 when I make a hard stop i had a vibration when braking - heard i need to put bigger rotors on also change calipers - asked FORD about this and they said it would have to be aftermarket rotors and calipers ???

View 9 Replies

Ford F-150 (2009-2014) :: Repeated Front Wheel Hub Failures

I'm new to the site and I've got a 2012 F-150 SuperCrew EcoBoost that has had the front wheel hubs replaced twice. Both hubs two winters ago and one hub last winter. I'm taking it in again tomorrow because the wheels are growling again when turning slightly at low speeds and sometimes without turning. I'm running in 2H, so the hubs should not be engaged. Previous years it was when running in 4H or 4A.

When I took it in, the service manager said it was common this time of year because of the temperature. Always seems to be cold, but not frigid, days here in SD. I asked why I should tolerate having hubs replaced every year, but he can't answer that.

I'm at 36,450 miles/29 months. I'm not beating on it or running in 4wd on dry pavement. Just normal highway miles. I should know more tomorrow after it comes out of the shop.

View 14 Replies

Ford F-150 (2009-2014) :: Front End Single Clunk / Pop During Turning

When making turns and occasionally during slowing and accelerating, a klunk or pop sound comes from the front of the vehicle. It is a F-150 STX 2011 2WD shortbed with 16,000 miles. Engine is 5.0 with 6 speed auto. Previos owner had (before returning to stock) put a lowering kit in, headers back exhaust, intake, tuner, etc. Truck is butchered a bit from pos previous owner. Front end components have all been checked, bolts torqued. Even the cab mounts have been checked. The only thing that can be seen that might contribute is the cat crossover supports have been hacked off.

View 1 Replies

Ford F-150 (2009-2014) :: Clicking Noise From Front Hubs

Front hubs are making a clicking noise pull in 4x4 and it quits also when pulling camper or boat quits make noise when you let off the gas could this be a vacuum line issue or automatic hub issue?

View 2 Replies