Ford F-150 (2009-2014) :: Loud Knocking Noise When Truck Warmed Up In Drive And RPM Up To About 800
Just had my 2010 F150 in for a loud knocking noise when the truck has warmed up in drive and rpm up to about 800. I can't hear the noise when I disconnect the passenger side vtc selonoid. The Tech who worked on it has recommended replacing the motor. His troubleshooting on the ticket says he removed the coil from the number 4 cylinder and the noise he hears goes away. I just can't see that the motor is bad.
View 8 RepliesIS F (2008-2014) :: Metallic Click Sound Coming From Left Rear Axle Area When Shift Into Reverse
This has going on for a few months now off and on. Whenever drive my F hard I notice this metallic click when i go to shift hard into second. The metallic click seems to be coming from the front of the car. I also get it if I'm around 3600rpm in and stomp on the pedal in first or second. It also happens when I shift into reverse. What it could be??
It also happens when i floor it and let off and do not change gears mainly in first and second. Sometimes i get a double click also.
At first I thought something could have gotten trapped in the engine bay and it only accelerated to a high enough speed to cause an audible noise but seeing as it been 3 or 4 months I don't think its the problem. It does not seem to effect spend and it does not make the click all the time.
Ford F-150 (2009-2014) :: Rear End On Truck Feels Slippery / Slosh From A Stop
The rear end on my truck feels slippery when starting to drive from a stop sometimes, and also when you drop the hammer to pass vehicles on the highway. Had the clutch packs replaced last year and did not solve the issue but found that maybe they were tightened too much. Also, who builds the differential that they would have put in that truck?
View 12 RepliesAzera TG (2006-11) :: Click Noise When Putting Car In Drive Or Reverse
I have a 2006 Hyundai Azera Limited, 3.8 with 5 speed automatic; car has 139K miles. I am noticing a small 'click' noise when putting the transmission in Drive or Reverse, and sometimes when accelerating from a dead stop. Car otherwise drives beautifully - the 'click' doesn't seem to affect driving it. The CV's don't make a clatter if accelerating at full wheel lock, which is usually the tell-tale for bad CV's. Is this something simple? My thoughts are:
1.) Somehow it's a CV joint. Grayson Hyundai said they're 'shot' but I think I would notice more than a brief click? They said a whole bunch of other things were wrong on their 'inspection', said the brakes were 'shot' because the rotors had rust on them... I don't trust that opinion.
2.) A motor mount or transmission mount. Seems more likely since would be most noticeable with torque.
3.) Something in the suspension. The car has new tie rod ends, but there may be something else worn/loose that I'm not aware of.
4.) Maybe I am just being too picky. The car drives awesome!
Maybe I'm overreacting, I just don't want some sort of catastrophic failure to occur.. The car still feels very robust, solid, and overall quite healthy..
Ford F-150 - 1997-2003 :: Truck Will Go In Reverse But Will Not Go In To Drive
I have a buddy that has a 1998 f150 4x4 with 4.6l and 332836 km on it. It will go in to reverse but will not go in to drive at all. Is his transmission shot? Or is there anyway to test it to find out what the problem is.
View 4 RepliesFord Transmission :: Truck Stuck In Drive No Reverse
My truck does not go into reverse but thinks all positions of shifter are drive. I had some slippage and changed the filter and oil great for awhile then blame no reverse just forward I was told my torque converter was out I just don't know....
View 1 RepliesFord Transmission :: RPMs Drop And Truck Dies As Soon As Put It In Drive Or Reverse
Just finished putting a fresh 460 backed by a (1977) c6 in my '68 ranger and now I'm having (what I believe is) transmission problems. The truck will idle and rev properly in gear but as soon as I put it in drive or reverse the RPM's drop and it dies. I jacked the back end up and put it in both drive and reverse and the tire's spin, but if I try and apply the brake to stop them the truck will die. My suspicion is that the torque converter is locked up all the time. I have managed to get it in gear and give it gas and it'll drive and shift fine, until I come to a stop. My question, what would cause the converter to do this? It's the same transmission and converter that I pulled out a month ago and I never had any issues before...
View 4 RepliesFord Escape / Hybrid :: 2003 - Truck Will Not Move When Put It In Drive Or Reverse And Press The Gas
I have an 03 Escape that is very difficult to start after it rains, if I open the hood and let it dry out for a few days it starts fine, however if I put it in drive or reverse and press the gas it will not move... if I hold the brake while it is in gear and give it gas it does not rev up, however if I put it back in neutral or park it revs up. I normally cover the hood with a tarp to prevent this from happening however I was shutting the tarp in the door and a lot of water got in the floor board of the truck I sucked it all out, that night the radio started playing all on its own, I came out to the truck turned the radio off it stop went back in came back a while later and it was on again, so I pulled the fuse... but there are two buttons that stay lit on the radio the preset button 1 and 2 stay on all the time and I can not figure it out either. This is my beach truck I only use it for that purpose..however it is fall fishing time and I really want to go...
View 4 RepliesFord Ranger / B-Series :: 1988 Truck Will Not Pull In Reverse / Overdrive / Drive / Second Or First
I have a 1988 FORD Ranger with the 2.9 liter engine with the four speed automatic overdrive transmission. Several days ago the transmission went out. The truck will not pull in reverse, overdrive, drive, second or first. Usually most vehicles will usually have at least the reverse, A first or second when the drive and overdrive stops working altogether. What the problem could be?
View 1 RepliesFord - F250 :: Loud Whining Sound / Truck Refused To Go On When Shifted From Drive To Reverse
I am not the sharpest tool in the box. I was driving my 1979 f250 with a full load of fire wood going about 45mph when I shifted it from drive to reverse (I thought I was in 1st) the truck mad a loud whining sound then refused to go on. Now when I shift it in gear it feels like it wants to move and if I revved up high it will rock back and forth. A friend jacked up the rear end with the wheels off the ground the tiers spun in all gears including park and I was told they could stop the wheels by hand with the car in drive. He then took the cover off the rear end and found it to be low on fluid but no signs of damage. What I broke?
View 9 RepliesFord F-150 (2009-2014) :: Click In Steering On Left Hand Turns At About 1/4 Revolution
I have noticed on our 2009 F-150 there is an audible "click" (and you can feel it in the steering wheel) in left hand turns at about 1/4 revolution. You can also hear/feel the same thing coming out of right hand turns. It doesn't happen EVERY time, but pretty often. My wife had the service guy drive it when it was in for an oil change, and of course he didn't experience the same thing. What it might be or where to start?
View 8 RepliesFord F-150 (2009-2014) :: Hi And Lo Lights Went Out / Click Noise Coming From Fuse Block
The other day my left light went out. I ended up taking out the sockets and realizing that it was the green wire that goes into the socket. I fixed it and it worked for a while and now both my lights went out. Hi and low. Every time I turn my light on I hear a weird click noise coming from the fuse block. It sounds like a bad relay. What it is?
View 2 RepliesFord F-150 (2009-2014) :: How Does 4x4 Engage - Click Sound Coming From Front Axle
Curious, how does the 4x4 engage in the new F-150's? When I put the truck in 4WD I can here the click sound coming from the front axle, where as it comes from the t-case on my Ranger. Just wondering how it's set-up.
View 5 RepliesIS F (2008-2014) :: Light Click Pop Noise From Passenger Front Area When Reverse Or Go Forward
When I reverse on flat surface no bumps or anything like that... when I proceed to go forward I get a light click pop noise from my passenger front area I don't know what it might be I will be putting it on a lift to check if anything is loose ...suspension mods are usrs bushing and bc coilovers ...What I should look at would be great. When turning or going over bumps I get no noise what so ever its only when I proceed so go forward after reversing
View 2 RepliesFord F-150 (2009-2014) :: 2012- Driver Side Door Click While Opening / Closing?
My drivers side door just started clicking when opening or shutting ...
View 9 RepliesCorolla / Matrix 2009-13 :: Front Brakes Click / Clunk Noise When In Reverse?
I have a 2009 Corolla S and the symptoms are as follows:
1. Normal forward driving, brakes work fine (and as expected without sound).
2. In reverse, when I apply the brakes I hear a click (clunk) sound from the front brakes. It only makes the sound when I'm going from moving to stopping (IE: I cant just keep pressing the brake once stopped to generate the noise). But if I let myself continue in reverse and press pedal again, it will make the same sound (very repeatable). I don't need to go forward to replicate the sound, I can just stay in reverse, stop (CLICK), continue in reverse, stop (CLICK), etc.
3. The it's noticable in the pedal. I can feel it on the brake with my foot when the noise happens.
4. It happens when I depress the brake pedal about 1/4 down, a gentle stop. And usually happens every time when I back out of my driveway or parking spot.
5. GF's sister's 2009 corolla CE does NOT make this noise in reverse.
6. 20,000 miles, Orig tires/brakes, didn't happen 4ish months ago.
I plan on putting winter tires on next month. Perhaps I'll take a look at the pads to make sure they aren't moving around, but wouldn't I also hear the noise in forward motion? Or when I switch from forward to reverse?
Dodge - Dakota - Transmissions :: 1991 Truck Will Go Into Reverse But Will Not Go Into Drive Or Any Of Other Gears
The truck will go into reverse, but will not go into drive or any of the other gears. When shifted into one of those gears, it just idles as though in neutral. This started as I was driving down the highway at approximate 70mph. The speedometer jumped up then fell to zero as the car slowed to a stop. There was no noise except the sound of rapid fuel intake and then it went to idling. I have been told it may be a speed sensor, but I was wondering if there was anyway to confirm that before I have the truck towed down to a mechanic and find out its more than I want to pay to fix it.
View 1 RepliesFord F-150 (2009-2014) :: Reverse Sensors Stays On?
It's abnormally cold here in the Northern Va area single digits with windchills in the negatives. I ran through the car wash, one of those that hand dries it afterwards to get the salt off my truck. After running the roads I went to back in to a spot and the sensors are going off. Nothing is blocking them so I'm thinking water got inside and froze?
View 4 RepliesSubaru - Impreza :: 2009 Going In Reverse When Put The Car In Drive
I bought (in November 2012) a 2009 Subaru Impreza. On a couple of occasions, when I put the car in Drive, it started going in reverse (in a flat parking lot). Each time, I put the car back in Park, turned the ignition off, started up again and it seemed fine - till yesterday. I was in a parking lot again, tried putting the car in drive and it went in reverse! A few times in a row, till I got so close to the vehicle behind me that I had to call roadside assistance... What's going on??
View 4 Replies