Ford F-150 (2009-2014) :: Repeated Front Wheel Hub Failures
I'm new to the site and I've got a 2012 F-150 SuperCrew EcoBoost that has had the front wheel hubs replaced twice. Both hubs two winters ago and one hub last winter. I'm taking it in again tomorrow because the wheels are growling again when turning slightly at low speeds and sometimes without turning. I'm running in 2H, so the hubs should not be engaged. Previous years it was when running in 4H or 4A.
When I took it in, the service manager said it was common this time of year because of the temperature. Always seems to be cold, but not frigid, days here in SD. I asked why I should tolerate having hubs replaced every year, but he can't answer that.
I'm at 36,450 miles/29 months. I'm not beating on it or running in 4wd on dry pavement. Just normal highway miles. I should know more tomorrow after it comes out of the shop.
Bmw - 325 :: 2004 - Repeated DMTL Pump Failures
The dealer has replaced the DMTL pump 4 times on my 2004 BMW325. The last time the dealer checked the gas cap and smoke tested the fuel system - all OK. I do not overfill the tank. The pump has failed again and I am getting tired of taking it to the dealer for a new pump. Fortunately it is under warranty but I am sure that there is something else causing these pump failures.
View 5 RepliesFord F-150 (2004-2008) :: Left Front Wheel Bearing Keep Going Bad
What is causing the right front wheel bearing to keep going bad on my 06 f-150 2 wheel drive....
View 1 RepliesFord F-150 (2004-2008) :: Grinding From Front Wheel Area At 20 KPH And Above
I am getting a grinding sound from the left front wheel while driving straight.. The sound stays the same when brakes are applied and does not change when selecting 4wd or 2wd.. I pulled the wheel off and had a look, but saw nothing unusual.. What are the steps to diagnose/repair the issue? 2004 F-150 5.4 4x4
View 6 RepliesFord F-150 (2004-2008) :: 2006 - Grinding Or Whirring Noise Coming From Front Passenger Side Wheel
I owned a 99 f250 a little while ago. Just bought a 2006 crewcab F150 xlt about 2 months ago, and for the past month there has been this unusual grinding or whirring like noise coming from the front passenger side wheel.
I took it to the mechanic and he found a bad wheel bearing on drivers side and replaced it but that wasn't the issue. He could hear the noise but wasn't able to figure out what the actual issue was.
The noise only happens when my foot is on the throttle. (not when coasting) and i also just discovered that it doesn't make any noise at all when put in 4x4.
Ford F-150 (2004-2008) :: Bearing Noise - Constant Grinding / Whine
We've had a lot of rain here in pa lately and i hit a few big puddles the other day and now i have a growl slash wine in the front of my motor,now i narrowed it down to something driven by the bely because I removed the belt and no noise all pulleys feel good and smooth except the ac compressor if you spin it by hand it has a rough/dry feeling and sound to it but the noise doesn't change with the ac on or off its just constant grinding/whine. Replace the ac compressor pulley bearing that what I am thinking it is and don't really want to change out the whole compressor..
View 1 RepliesFord Super Duty (1999-2016) :: 2008 F250 - Little Bit Of Movement In Front Wheel Bearing And Hub Assemblies
I have a 2008 F250 5.4 4x4 supercab long box (68,000 miles) that has a little bit of movement in the front wheel bearing and hub assemblies. Made it through inspection OK but it will need to be changed soon. Just asking for everyone's thoughts on brands they prefer. I have had great luck with Moog brand products in the past. I put SKF hubs on my wife's 2010 Explorer and they I would say are top quality also. Not interested in a conversion kit or cheap junk. I want a good quality unit. What brand has everyone had good results with? Are Moog or SKF the way to go?
View 8 RepliesFord F-150 (2004-2008) :: Wheel Bearing - Hard To Turn One Direction
Have a wheel bearing going south can it make the car hard to turn one direction. I dont really have any humming like a wheel bearing does. But i feel a little resistance every now and then when turning the steering right. I have sprayed the steering shaft joints and i can see that they are moving free like they should. And i have a less than 2 yr old steering rack. My truck has 103k miles on the original (to my knowledge) bearings. i didn't know if sometimes a wheel bearing could cause a hard to turn in one direction feel.
View 14 RepliesFord F-150 (2004-2008) :: Driver Side Wheel Bearing Squealing Pretty Bad
I just replaced my drivers side wheel bearing that was squealing pretty bad. After replacing it I now have the same noise only consistent where before it was only when I turned the wheel to the right. I noticed the teeth in the cv shaft where a little warn down when I changed the hub. Now also along with that noise I'm getting a clunking sound. Should I just change the cv shaft or is there something else I need to be looking at?
View 1 RepliesFord F-150 (2004-2008) :: Steering Wheel Occasionally Clicks When Turning - Bad Bearing?
I have a 2004 F150 SCrew 4x4 with the 4.6 (260K)... My steering wheel occasionally 'clicks' when turning - It sounds and feels like a bearing is bad in the steering column.
When it happens, it feels like one in the bearing is binding- the steering wheel slightly binds, then there's a 'pop' like the ball snapped back into place. This only happens occasionally. Sometimes it will pop with every revolution of the steering wheel, other times not at all.
Originally, I thought it was a U-joint, but it seems like the noise is coming from the bottom of the column...
Ford F-150 (2004-2008) :: 2007 - Speed Related Ticking Sound / Wheel Bearing?
The front driver's side wheel of my 2007 Ext. Cab makes a speed-related "ticking" sound. It's usually audible but not always there. I look for rocks in the tread of my BFG All-Terrains and sometimes I find some, sometimes not. The noise seems to be independent although some of the rocks really get up in there. Sometimes its really loud and it sounds like a rock. Bearing? 4WD CV or U-Joints or whatever?
View 6 RepliesFord Super Duty (1999-2016) :: 2004 F250 4WD - Front Wheel Bearing Replacement
So I have to replace the front unit bearings on my 2004 f250 4wd. My question is, which thread pattern I have, fine or coarse? I have read that the early models, 99-02 have coarse threads. Afterwards they are fine. I am going to order online as they are cheaper than the local parts store. I have the Timken part numbers for either thread pattern.
View 4 RepliesPrius (2004-09) :: Noise In The Right Front Wheel - Bearing Failed
I devloped a noise in the right front wheel. I thought it was a tire going bad so I rotated the tires & still had the noise. I was told by shop it is a wheel bearing. If that is the problem is that a DIY repair ?
View 5 RepliesFord - Explorer :: 2003 - Grinding Sound Like Wheel Bearing Noise
I have a 2003 Sport Trac 4wd with 299,000 miles. There is what sounds like wheel bearing noise (grinding) that was noticed after returning from a trip where I flat towed it behind my rv. I did not notice the noise the last time I drove it - before towing it about 450 miles. I have towed this vehicle for many years and miles this way - transmission and transfer case in neutral with key in on position to unlock steering. I stated this part about the towing because the noise may have gone unnoticed for many miles. About 20,000 miles ago, I changed front wheel bearings, brake calipers, upper and lower ball joints, shocks and outer tie rod ends. Also rear brake pads.
I put the vehicle on jack stands and in drive mode couldn't hear anything in either 2wd or 4wd. I held one wheel at a time so the other side would spin. After checking for wobbling wheel bearings, I took off the wheels and did a push / pull on everything - all seems good. I changed driver's side wheel bearing anyway because I thought it to be a little rough. I removed the front drive shaft and took it out on the road. Noise was still there. This makes me think front differential but before entering unknown territory (for me) is there something else I can do to narrow down the problem? At this point, I'm not even convinced it is from the front end - maybe the sound is radiating through the truck.
Prius (2004-09) :: Scraping Sound From Right Front Side - Wheel Bearing Went Out
For several days I could hear a scraping sound from the right front side. I thought it was snow packed in the wheel well at first, until there wasn't any snow there. Today I was driving on the Xway and the scraping became a buzz like a Cessna airplane. On the way back home I turned the steering wheel back and forth and sure enough the buzz came and went. That made it sure to me the wheel bearing was bad.
View 19 RepliesPrius (2004-09) :: Faint Whup Between 35 And 50 MPH On Front Driver Side Area / Bad Wheel Bearing At 30K
At about 20k on my 07 I started hearing a faint whup whup whup between 35 and 50 mph's on the front driver's side area. At 60+ pretty quiet. It has gotten real loud at the present 30K. I suspected the tirers as I know the Integrities are complete junk but as a test I did a rotation and exact same noise.
I thought thats not good but found it hard to believe something else was bad as I had no vibration and no pull whatsoever in steering. Long story short I bought a new set of tires Kumho KR21's at stock size and oh crap exact same noise.
Ford F-150 (2004-2008) :: Grinding And Popping From Under The Floorboard On Front End
2004 F150 SCREW Lariat 4x4. Experiencing some odd noises. When driving down the road and turning the wheel slightly left will produce some grinding and popping from under the floorboard. I'm suspecting a CV axle as the boot is ripped on that side. Would this have anything to do with the IWE system or solenoid??
View 1 RepliesFord F-150 (2004-2008) :: Grinding Noise From Front Passenger Side
2005 ford f150 Fx4 So last Friday I started hearing a grinding noise from the passenger side front of my truck. sounded like metal on metal. So I started rooting around and noticed that bottom ball joints were shot. so replaced bottom ball joints on both side. I aslo replaced wheel bearing hub assembly on both sides, still heard the grinding. So I noticed that both axles were slinging grease, so I replaced them on both sides.
Still heard the grinding noise. So then I removed everything from the passenger side and noticed that the locking hub actuator was grinding both axle and the wheel bearing hub. So I just got done replacing that on the passenger side, put it all back together, and still grinding noise ringtones free. Also replaced the 4wd solenoid that they said gets water in it, and I replaced the check valve. And I put new Rotors and breaks. What it could be?
Ford F-150 (2004-2008) :: 2006 - Grinding Noise On Both Sides In Front End
I just bought 2006 f150 4wd . It make a grinding sound on both sides in the front end..it seems to be independent and when I slow and come to a stop, I makes a clanking noise like its locking something in.
View 4 Replies