Ford 6.7L Power Stroke Diesel :: Starter Turned Over But Did Not Engage
With -37C and -50C with windchill today, I tried starting my truck after being plugged in all night, and it was a no-go. Sounded like the starter turned over but didnt engage. On another note, what is with the glow plug light? mine lights up for a few seconds, maybe, then nothing. Today was the first time it ever stayed on for 5 seconds, and that was only after i tried cranking it over twice. First two times it didnt stay on.
I think my block is still maybe too cold,maybe dead batteries too, and yes the block heater had power made sure to check that, I notice my passenger side battery has some corrosion ontop (1000watt amp hooked into drivers side) so maybe I am needing better batteries.
Usually fires right up, haven't noticed a problem lately either starting. Gonna let it warm up some more, and I put a charger on the truck too, gonna go check the battery voltages and see what it says. This is the coldest yet I have tried to start the truck.
Ford F-150 (2004-2008) :: Starter Not Engaging / Security Light Flash Slowly Even When Key Is Turned On
I just put a brand new engine in my 2004 f-150 4X4. Truck ran fine for two days. Yesterday I started the truck as usual put it in reverse. As I was backing up it just stopped running no warning nothing just stopped. All electrical still working fine gauges radio etc. When I turn the key I get nothing no starter nothing. The security light continues to flash slowly even when the key is turned on. Basically the best way I can describe it is. The truck is acting like it is in gear when I turn the key. And the odometer reads check gauges.
View 4 RepliesFord 6.0L Power Stroke Diesel :: 2003 F250 Not Starting - Starter Won't Engage
My 2003 Ford F250 superduty diesel wouldn't start. It was a cool morning and I suspected a problem with the glow plugs. I checked the GPCM ( new in the last year) and it was fine, than I tested both right and left harnesses...they showed two out of range. After further inspection I noticed both my buss bars were completely rotted off with the wire and top of the glow plugs exposed.
Since I cranked the truck over so much, I removed the ground terminals from the recently replaced batteries and put a charger on overnight, I also plugged in the block heater since the glow plug system is suspect. I went out the next morning, re attached the batteries, and turned the key. The fuel pump and injectors cycled as usual, than I turned the key to start....nothing....no click...no sound.
I disconnected the starter trigger wire and touched it to the positive post.... a few sparks but no click or engagement. I jumped the solenoid...again a few sparks...but no engagement. I removed the starter (less than a year old, and not a lot of use) and had it bench tested, it tested fine. I re installed the starter, and cleaned all the terminals and connectors through the the system, still nothing.
I checked the cable from the battery to the large terminal...12 volts, I had my wife try to start the truck and checked where the trigger disconnects on the fender and at the solenoid....12 volts when the key is turned to the start position. I used a jumper cable to run power from the battery to the solenoid...nothing, I ran the jumper cable from the ground terminal on the battery to the starter case...nothing. I checked all the fusible links and found a broken wire from chaffing, I repaired it ( but I think it was what was causing my battery light to come on for the last few months) even though the alternator, batteries and everything going else checked good.....nothing. I checked the starter relay...it checked out good, as well as the ignition fuse.
Pontiac - Grandprix :: 2008 V8 Won't Turn Over / Starter Does Not Engage
My neighbor has a 2008 Grand prix V8 that won't turn over. When the ignition is turn on the starter does not turn and then the horn honks once, you hear clicking sounds in the engine compartment and inside the car and the service display goes through each system indicating that it needs service. We unsuccessfully tried jumping the battery.
View 1 RepliesFord Super Duty (1999-2016) :: 2008 F250 Won't Engage Into 4x4 / Just Clicking
Basically I have a 2008 f250 (6.4l if that makes any difference) That wont engage into 4x4. When you go to turn the switch to engage the 4x4 all you get is a click click click click click. Is that a problem with the 4x4 shifting solenoid on the transfer case? Anything else to look for? The truck has 95k miles on it....
View 2 RepliesFord Super Duty (1999-2016) :: 2008 F250 Won't Start - Replaced Battery And Starter?
I have a 2008 f 250 super duty gas v10 i have never had problems with it start always starts right up and strong. After coming out of the story today I tried the remote start and it tried to turn for a couple seconds and stopped. I replaced the battery and starter and still nothing. i hear the relay when trying to start with both keys or remote start but nothing from the starter all lights are working .
View 1 RepliesFord Super Duty (1999-2016) :: 2004 F250 - 4x4 Will Not Engage
I have a 04 ford f250 superduty... I tried to use my 4x4 today and the front wheels would not engage using the ESOF. The light comes on in the dash saying its in 4x4. i do not believe i have a vacuum leak because it doesn't switch over to the automatic setting for defrost. what else could it possibly be I'm stumped at this point.
View 14 RepliesFord Super Duty (1999-2016) :: 2004 F250 V10 - 4x4 Will Not Engage
4x4 will not engage. 4x4 light on dash does not come on. Can not hear motor switching into 4x4. Check fuses under dash all looked good.
Truck is a 2004 F250SD V10 ....
Ford F-150 (2004-2008) :: 4X4 Won't Engage - Hub Spinning
2008 5.4L triton. When I'm in the snow or mud and engage the 4 wheel drive I hit the gas and I can hear what I think it is the hub spinning but it will not turn the wheel. Hoping it is not my transfer case...
View 3 RepliesFord F-150 (2004-2008) :: Front Hubs Won't Engage
2004 fx4, transfer case engages, but front wheels won't engage. I assume the vacuum solenoid is stuck, any other thoughts?
View 1 RepliesFord F-150 (2004-2008) :: Starts To Engage 4x4 Randomly On Its Own
Truck shifts great from 2 to 4h to 4l and back to 2. However, at random times - any speed - usually when slowing down - I hear/feel something engage and there is usually a ratchet sound. I figured out its the 4x4 - if I switch to 4h then back to 2 quick, it stops. What the heck.
View 1 RepliesFord Super Duty (1999-2016) :: 2004 F250 - Front Hubs Do Not Engage Automatically
About a month ago I bought a 2004 F-250 160xxx from a reputable Ford dealer here in town. The dealer performed a safety and emissions inspection, and spent about a grand on other repairs, as a condition of my purchase. Today I had it in the shop for an instrument cluster issue (at a different Ford dealer, closer to my house), and was told the vacuum lines were all messed up. Their write up is below:
"Check 4x4 operation. Transfer case shifts to 4x4 and 4x4 low. Front hubs do not engage automatically. Check vacuum at the hubs. No vacuum. Check the vacuum at the solenoid. No vacuum. Perform visual of the engine vacuum lines. There is no vacuum to the reservoir. Vacuum line is routed wrong from the fuel pressure regulator to the vapor management valve. There is other vacuum concerns. All of the vacuum line routing needs to be inspected and corrected."
The service rep told me it is questionable whether the 4x4 ever worked, although during the few weeks I've owned it, I could hear gears or other mechanical parts making noise which seemed to me to be in response to me turning the 4x4 electronic switch. She also said there was a vacuum line dangling loose with a screw in the end of it.
Before I contact the dealer where I bought the truck, I am planning my going-in position. But I wanted to get a sense of a) how serious of a problem this might be? and b) how reasonable it is that the dealer didn't catch this issue before I bought the truck while they were in their fixing other things?
The dealer who sold me the truck made it very clear that the sale was as-is, and I took it to my mechanic prior to purchase, though unfortunately he only had time for a cursory look at the engine. Obviously he didn't look closely enough to find this issue.
I'm not sure if I should ask the dealer who sold it to me to fix it, or ask them to allow me to return it, or sell it back to them, or if I should eat the cost of fixing it. How wrong would it be to try to trade it in for something else?
Ford F-150 (2004-2008) :: No Power To The Starter Solenoid
Yesterday after work, i got in my truck and it started right up, no problem. my stereo has been giving me some fits the past few days, looks like everything is on but no sound, and was thinking it might be a fuse so i proceeded to shut off my truck and take a quick look at the fuse box. didn't find anything quickly fuse wise, so i got back in the truck to go home and turned the key and nothing. no whine from the starter, no click click click like a dead battery, but i do here a single click from the relay switch as i left the case off to do a more thorough investigation on the stereo when i got home. anyway.. here is all i have ran through.
1. Made sure the battery is good, even tried jumping it for good measure..took cables off and made sure they had clean connections.
2. Switched out the relay, and fuses related to the starter in fuse box.
3. Put the truck in Neutral, thinking safety switch.. wiggled it around while trying to start it as well
4. Crawled under the truck, took a screw driver and bypassed the switch all together to make sure it wasn't the starter, starter kicked in like it was new, but no truck start. (key was in the on position)
5. Checked the solenoid post with a test light to see if it had power on key turn, nothing.
6. Checked the fuse box and surrounding wires to make sure i didn't bump anything when taking off the cover..
From all of this it sounds like some safety switch that isn't giving power, otherwise i would have thought the truck would have started when i bypassed the switch on the solenoid. Just seems very odd the timing of it and i have not had any previous issues like this.. just out of the blue, literally less than 5 minutes from starting the truck without issue.
Ford F-150 (2004-2008) :: 5.4 4x4 - Replacing Starter On Truck?
I may have to replace the starter on my truck. Have heard it is difficult especially on the top bolt. Any stickys/bulletins on how to do this.
View 1 RepliesFord - F150 :: Starter Will Spin But Not Engage The Flywheel
I have a 2000 Ford F150 lariat with the 5.4 liter engine. At least once or twice a day, its like the starter hits a bad spot and will spin but not engage the flywheel. It has a new starter, battery, and solenoid. What this might be?
View 1 RepliesFord F-150 (2004-2008) :: 4WD Not Working - Front Wheels Don't Engage
I have a 2006 XLT w/ the 5.4L engine. Manual transfer case, I'm wondering where to start looking for problems w/ the 4x4...the front wheels don't engage.
View 3 RepliesFord F-150 (2004-2008) :: 2006 - 4x4 Quit Working / Won't Engage
I have a 2006 F-150 4x4 and the 4x4 quit working, it gives me a P1867 & P1891 code but my scanner don't tell me possible causes. Where to start looking?
View 3 RepliesFord F-150 (2004-2008) :: Intermittent 4wd - Sometimes It Would Engage And Other Times It Wouldn't
For the last little while I have been having an issue with the 4wd in my 2006 F-150 with about 93k on the clock. Sometimes it would engage when I switched to 4H/4L and other times it wouldn't. A friend of mine works at a Ford dealership and said it could be the vacuum solenoid on the firewall going bad. So I bought a new one and as I removed the old one, noticed debris in one of the inlets. So I cleaned that out and neither old or new solved the problem. Then I went through ALL of the vacuum lines and found some debris in parts of them....
Cleaned them all out and still nothing. Then I got to thinking it may be the ESOF motor on the transfer case. Checked to make sure there was power to the plug, which there was. Removed the motor and turned switch, and the motor seemed to be working. Reattached the motor and the 4wd would engage/disengage without problem. Pretty much everywhere I went I would check it and it worked fine . Then all of a sudden it didn't . So I took the motor off, turned selector and it worked fine. No issues yesterday at all.
So, I am not sure if it is the motor going bad or not. Could there be a contact problem? I talked to a mechanic this morning and he told me to drive around with it in 4H for a while because more times than not it doesn't get used enough. I'm just not sure what could be going on...am I missing something?
Ford F-150 (2004-2008) :: 2007 - 4wd Will Not Engage At All - Code C1979
I have a 2007 ford f150 and the 4wd will not engage at all checked vacuum lines they all look intact wondering if it could be the IWE solenoid and is there any way to test the IWE solenoid ...
View 5 Replies