Ford F-150 (2004-2008) :: Electrical Malfunctions - Blower / Turn Signals / Headlights Won't Working?
My truck is a 2004 F150 XLT, 4.6L 2 wheel drive extended cab
The truck starts fine. With no lights on, heater/ac blower turned off... my turn signals and hazards work as they should.
If I turn on my headlights, I have no turn signals and the indicators on the dash are slightly lit up along with my highbeam indicators. The actual dash lights do not come on.
The blower does not work at all regardless of whether the lights are on or off. Turning the blower on immediately creates the same issue as the lights. (no turn signals, slightly lit up indicators, etc). The blower does not work on any speed. I can hear the duct work changing direction behind the dash as I move the blower selector from dash to windshield to floor, etc. I can also hear the compressor kicking on for the AC.
What I have done: I have checked all the fuses. I have attempted to remove every one of them while running to see if anything shutting off would let the blower kick on. I have unplugged the blower entirely wondering if there was a dead short. I have removed and unplugged the resistor to see if that might be an issue. I have also removed the right side kick panel and checked the ground wire there that runs to the dash. Everything so far seems to be in good order.
Ford F-150 (2004-2008) :: 2005 - Electrical Malfunctions - Odometer Display Flashes On And Off - No Power Mirror?
I have a few issues with my 05 f150 that I need to know how to fix them
-the odometer display flashes on and off, the warmer it is outside the less it stays on
-heater blower doesn't work when the switch is on number one position, works fine on other positions
-power mirrors don't work neither side
Ford F-150 (2004-2008) :: 2006 - Installed Edge Evolution Gauges Now No Oil Temp Display?
I just installed my Edge Evolution from my 2006 F-150 5.4 into my 2008 F-150 5.4. It is not displaying oil temperature. It just shows 0 degrees. why?
View 1 RepliesFord - Taurus :: 1995 - Motor Swap And Now Fuel Electrical Malfunctions?
I have a 1995 Ford Taurus, and I just swapped in a new engine from a donor from 2000. The engine is a Flex Fuel 3.0L Vulcan OHV.I've got a wealth of background knowledge as a mechanic [5 years+] and an electrician [4 years+]I have swapped over everything required to make this work, in theory. I swapped exhaust, fuel system, and computer/harness and all the relays to go with it. I also made a custom gauge cluster from a 2000 Taurus as well.
Well everything works just peachy, all the wiring for the most part is correct minus a few buzzing relays that I just need to work out. The main issue this [now monster in my eyes] has is the PCM is not telling the FPDM to tell the Fuel Pump to start. Turn key, and no 3 second startup. I've checked the fuel pump, and it's fine. I replaced the PCM and that didn't solve it. I have the security system from the 2000 in there as well, thinking that was an issue. I also have the emission sensors and canisters installed, just like you would see in the 2000.
I'm at my wits end trying to figure out why the PCM isn't sending voltage out to the FPDM. I had to of missed something along the way but I double checked and still can't find anything. How to get this working properly.
Ford F-150 - 1997-2003 :: Electrical Malfunctions - Temp Gauge Pegs Without Getting Hot?
I just bought a 97 f-150 from my dad, there are some electrical issue's but the main one seems to be battery drain.
I have noticed with the truck off key in my pocket, the a/c doors keep trying to move and the a/c head has power to it.
I know the engine has been replaced, with about 20k on it.
The temp gauge pegs w/o getting hot, and it even turned over once while we were getting in the truck. Again key in pocket.
Ford Excursion :: Electrical Malfunctions - ABS Light On - No Radio / Gauges - Power Loss?
Today I was driving to my moms house. I had been on the road for about 2.5 hours. My ABS light came on, I didn't think anything about just figured a sensor was dirty or bad. About 30 min later the radio shut off then all the gauges bottomed out and the truck lost all power. I was able to coast/idle off the road. I called a local parts place and they had a replacement alternator for me. While I was at it I also replaced the battery. I started the truck up and hit the road again. I drove another 45min with no issues.
Does this sound right or am I missing something else?
Ford Excursion :: Repairing Electrical Malfunctions - Power Door Lock Button Stopped Working
My power door lock switch in the drivers door stopped working (not the actuator problem, but the actual switch would unlock, but not lock the doors)
I started to research if it could just be simple corrosion and decided to spray the contacts with CRC electronics cleaner. It completely fixed it.
Next, my parking brake light sensor stopped working so I did the same and it fixed it.
I began to research cleaning contacts and found a number of people in the automotive forums who basically spray contact cleaner on every electrical connection they ever touch.
I will do this in the future. The only part I wonder about is if there is something better to spray on them to prevent further corrosion in the future. I used dielectric grease but it would be nice to just spray the thing down. However, CRC does say their electronic cleaner prevent future corrosion.
Passat (B5) :: 2000 - Electrical Malfunctions - A/C Won't Work
OK... My '00 GLX 4-motion 30v has started to really piss me off! It started about a month ago with the trunk latch. The light would come on in the dash and I'd check it and it would be open. I didn't open it! Then when I try to reclose it, no luck. Won't latch! So I look at the latch and it seems to be broken. But then I was driving down the road and the trunk just locked itself! I couldn't even get it to latch the day before and now it's locked! Next the rear view mirror decides to go all hazy and piss all over the dash! WTF! Now the autodimmer doesn't work! The rain sensing wipers quit and now the delay setting just does nothing! Then, as if that weren't enough, the A/C just decids to not work anymore! It won't turn on the compressor. It was working fine when I got to work and then when I got back in a few hours later, nothing! It has good system pressure, but it's like the controll unit isn't telling the compressor to kick! Up untill this point the only problems it's has giving me were the infamous tie rods and some wheel bearing noise from up front, oh and the camshaft seals. Starting to get pissed at the thing! Leaning toward the BMW side of things very quickly.
View 3 RepliesPhaeton :: Electrical Malfunctions After Installing Stop / Start Button
I did the installation of the start/stop button and it works. However, I have some unresolved issues. I have done a search in the FAQ thread but could not find anything referring to the following:
1- When I lock the car, either with the fob or with the door buttons, the alarm will sound when I enter the car if I unlock it using the door handle sensors. I can disarm the alarm with the fob, but it is not disarming with the door handles. How can I solve this issue so that the alarm is disarmed with the door handles? Can this be solved using a VAG-COM?
2- When I turn on the alarm, either with the fob or the door handle, the alarm indicating light blinks for a few seconds, then goes steady, and then blinks normally. I had not noticed this steady light state before. My alarm, I think, always went straight to blinking and stayed blinking
.
3- When they gave me the car back the adviser said that the seat would not move and the trunk would not open. However, I think they ran down the battery because the interior light was on. The dash displayed the "start the car now" message.
a) I had an almost two hour drive back home, do you think that the battery recharged in that time?
b) Was there any lasting damage done to the battery?
c) Is it safe to charge the battery with a trickle charger or do I need a special and specific charger?
The trunk now operates OK and the start/stop button also works. I wish the alarm also did.
Mini - Cooper :: 2005 - Electrical Malfunctions - Everything Went Out For Couple Of Seconds
I have a Mini Cooper 2005. Last month the battery died. The warning sign was that when I turned the key, there was a second or two pause where everything went dead. No lights at all in cabin and clock reset. Then it started up. It did that many times before the battery went dead. I got it charged and thought all was well but now the mini did the pause thing again and I fear that I am going to deal with a dead battery again.
View 5 RepliesGolf IV R32 :: Electrical Malfunctions - When Hit A Bump Or Pothole Radio Would Shut Off And Then Turn Back On
I have been having some electrical problems lately that seem to be getting worse. For the past few months sometimes when i hit a bump or pothole my radio would shut off and then turn back on. Well I never got around to looking at it cause i would forget about it until it did it again. so just a couple of days ago im coming into my driveway, hit the bump, and my car shuts off. Not like a stall, just no electricity. I was thinking i need a new battery because my lights flicker and dim when i hit my window button, or when I am just sitting at a light, sometimes my dash lights will flicker. But now I am thinking maybe I have a bad ground or something.
View 6 RepliesFord F-150 (2004-2008) :: 2006 - Electrical Malfunction - Back Light Works Intermittently - Blower Fan Stop Blowing?
My 2006 F150 was purchased by me in early 2009 with about 28,000 miles on it. It's an XLT crew cab 4X4 with the 5.4. Stock except for a leveling kit and an aftermarket head unit. It currently has about 59,000 miles and has been babied since I purchased it. About 3 years ago I started noting some issues:
A. Oil pressure dummy gauge is all over the place. Some times it will show no oil pressure. Other times it is all the way to the highest mark. Other times the needle has gone 180 degrees past where normal is and is actualy pointing straight down towards the floor.
B. Recently my alternator dummy gauge has started doing the same thing as my oil pressure gauge.
C. The backlight behind my odometer works intermittently, but mostly not at all.
D. My dome light will flicker when first turned on. It doesn't matter which door is opened or if the override switch it turned on. It takes several seconds to come on and will flicker like there is a poor connection somewhere, but stays on once its on.
E. Blower fan will occasionally stop blowing. Once the climate control switch is turned to off, then back to on it resumes working. This doesn't happen often, but does occasionally.
Fortunately, the truck has not left me stranded and I want to keep it that way. We are getting ready to sale my wife's Toyota and this will become her daily driver. I want to take care of any issues before she starts driving it. Are these all separate issues or is there one common issue which could be causing them all?
Dodge - Grandcaravan :: 1997 - Electrical Malfunctions / Wipers Work Only In Spray And Wipe Mode
Problem 1: Headlight switch occasionally needs to be jiggled to get headlights on.
Problem 2: Wipers only work in the "spray and wipe" mode.
My Solution: Removed dash, installed new switches, replaced dash.Result: Now the right headlight does not come on at all. Wipers STILL only work in the "Spray and wipe" mode.
Question: Where do I go from here?
Ford Excursion :: 2000 - Electrical Malfunctions - Dome Light Stays On - Battery Dead In Morning - OD Light Flashes?
i have a 2000 ex,6.8 4x4.every now and then the dome light stays on.theres also a problem where theres a buzzing sound coming under dash while driving and makes the dome light flicker.these are seprate problems.lol.when the buzzing sound is present ,it stops when i open the door,running or not.but starts up again when i close it,even happens occasionaly when ignition is off and no key in ignition.electrical problems are my worst night mare!!!!!!!! My battery is dead in the morning when this is happening .oh yea,and the o.d.light flashes occasionaly as well.im totally lost.
View 6 RepliesFord F-150 (2004-2008) :: With New Tip Installed Now Exhaust Popping?
All I did was cut off the straight section of tailpipe and install a 2.5" inlet, 4" outlet exhaust tip. It sounds a bit deeper at idle and a little louder when I rev it, but when I let off the gas it pops pretty loud.
I remember hearing popping on decel on videos of trucks where aftermarket exhaust/mufflers were installed, but not just from a new tip.
Ford F-150 (2004-2008) :: A/C Not Working After Control Panel Installed?
I just installed a Heater AC Control panel that was broken when things shifted in my truck. Now, air blows, but I get no AC. I'm wondering if something deeper in the dash was broken.
View 1 RepliesFord F-150 (2004-2008) :: 2006 - Misfiring And Then Stalling When Stopping At Lights
I have an 2006 f-150 King Ranch with 103k miles and it was misfiring and then stalling when stopping at lights. Both cam shaft sensors and all coil packs were relaced then it was still misfiring. The head was recently replaced and now they are waiting on a new computer. When it starts misfiring it vibrates the whole truck and the engine light flashes. If you turn the truck off then back on it will run fine for about 50 miles. Im worried that replacing the computer is not going to fix it, what else could it be?
View 14 RepliesFord F-150 (2004-2008) :: 2006 - Right Tail And Brake Lights Don't Work
I have a 2006 King Ranch and right tail and brake lights don't work. The bulb is good. The fuse diagram in the owners manual is not the fuse box I have, so I cannot id the correct fuse to see if its bad.
View 4 RepliesFord F-150 (2004-2008) :: 2006 - Adding Reverse Lights To 7 Pin Connector
For our new pontoon with surge brakes I need to add reverse lights to the wiring harness to deactivate the surge brakes while backing up. What is the proper way of doing this? BTW this is on an 06 F150 XLT with factory 7 pin harness.
View 4 Replies