Ford F-150 - 1997-2003 :: Whine Coming From Engine Bay
I've got a 2003 f150 supercrew with a 5.4 in it. I have a whine coming from the engine bay. I thought it was the power steering pump and changed that and that wasn't it. I'm thinking its the idler or tensioner pully. I've ruled out the alternator by wrapping rags around it and it didn't dampen the sound any.
View 5 RepliesFord F-150 - 1997-2003 :: Low Whine Noise Between 45 To 55 Mph Only When Gas Pedal Is Being Engaged
I have a 2003 F150 4x4. There is a whining noise when going 45 to 55 mph (at least that's the only time I can hear it), but only when the gas pedal is engaged. I thought I'd work back to front and I took off the rear differential cover, cleaned it out and changed the rear differential fluid. That did not reduce the whining, but I think those spin when the wheels spin anyway. The whine only happens when the gas pedal is engaged.
View 2 RepliesFord F-150 - 1997-2003 :: Vacuum Leak When Engine Is Under Load
It has been since the 80's that I have attempted to do any work on a vehicle. How do I find a vacuum leak and where is my vacuum canister. I am assuming that it is a vacuum leak for anytime my engine has a load on it the air stops coming out of the dash vents and goes to the defrost vents. I have an 2000 F150 with the large engine with about 112,000 miles.
View 11 RepliesFord F-150 - 1997-2003 :: 1999 - Engine Stumble At Load
1999 4.6 (106K miles) will stumble / miss when at 35-50 mph under a mid throttle load (just before reaching the downshift point). Has been doing this since I bought the truck at 70K miles.
Computer has no codes, engine runs fine under all other circumstances, and gets a decent ~20 MPG on the highway.
Done the standard tune up items (plugs / motocraft) and cleaned MAF, replaced TPS, tranny flush/ filter. Replaced the left O2 sensor 2 months ago, but it dumped a code and was really noticeable when it went out.
I am about ready to dive off and replace the MAF, but at $100 a shot would like other alternatives to try first. I am really convinced the engine is leaning out and misfiring under this load.
Ford F-150 (2004-2008) :: Engine Whine At 1800 - 2100 RPM When Under Load
My truck has 57k miles on it. At 1800-2100 RPM it whines under or over it is just fine. it has a new air filter in it as well, still makes the noise, it doesn't matter what gear i am in, it only does this under load. if i free rev it , it will not do it.
View 2 RepliesFord F-150 - 1997-2003 :: Misfire And Flashing MIL When Engine Was Under A Load Doing About 3000 RPM
I have a 2002 Ford F-150 with a 5.4 Triton. 212,xxx miles. I replaced the cops and the plugs about 6 months ago. I was pulling a trailer up hill last week and the engine was under a load doing about 3000rpm. It began to misfire and give me a flashing mil. However, before I went very far the engine began to run fine. It happened 3-4 different times. However, there is no code recorded. I've driven the truck nearly 100 miles with no problems, but I'm going to be pulling that trailer uphill again next week.
View 8 RepliesFord F-150 - 1997-2003 :: Piston Slap Under Load
A friend from work is having what he says is piston slap, but only under a load. I feel it could be the timing set since it's never been changed and at least 160k miles. Odometer quit working at least 5 years ago. Other than that, motor runs great. 1997 F150 4.6....
View 4 RepliesFord F-150 - 1997-2003 :: 2000 - Whine Whilst Deceleration?
I have a 2000 5.4 4x2 with about 118k. the pinion seal was leaking. I replaced the seal and added proper amount of 75/140 diff fluid as listed on the tag. I marked the pinion nut, flange and housing, so I could count the number of turns it took to remove nut. I put back the same but now I have a whine at low speed on deceleration. under normal throttle and at higher speeds it sounds just fine. Its just on deceleration and at 5mph or less. The sound was not there before I did the new seal.
View 2 RepliesFord F-150 - 1997-2003 :: 2001 - Truck Stalls Under Load
I have 2001 F-150 with 4.6L. Truck runs fine until under load and runs fine until I slow down to a stop sign. Once truck sits for a few moments it fires up again and will run for a short while then will do it again. Each time i let it sit for a few minutes, it will start again.
I pull a small travel trailer and seems to happen more frequently when pulling or climbing hill, but not under full power, just when slowing down. Could this be cause of catalytic converters? MAF sensor, or fuel starving.
Check engine light is on, will codes identify if it is a plugged cat?
Ford F-150 - 1997-2003 :: 4.2L - Suddenly Started Missing Under Load
My 4.2 liter F150 suddenly started missing under load. A little background: It is a late 2003 and has 75k miles. It has been in my family since new, and I have had it for the last 4 years. This truck is as stock as they come, and has been well maintained.
On my way to work yesterday, it began missing. Not bad at first, but got worse. It misses while under load and under acceleration. The "check engine light" never came on. I have not put fuel in in several days, and it ran fine until now, so I doubt it is bad fuel. I started the engine after dark and looked for arcing. None visible, and I even sprayed the wires with a mist of water. I pulled the plugs and they all look normal. The gaps were all way too large, so I regapped the plugs to .054". I pulled the coil pack and it checks within range with my VOM. Can the coil pack be the problem even though it checks out on the bench? Can the large plug gaps have contributed to a coil pack failure?
Where to start. I HATE just throwing parts at this thing, and I don't like wasting money... If I let one of the auto parts stores run a scan, will it show a code even though I have no check engine light? I used to think of myself as a pretty good diagnostician, but then again, when I used to spend a lot of time under the hood, those cars had points, condensers and carburetors...
Ford F-150 - 1997-2003 :: 2010 - Rough Idle Under Load
My daughter has a 2010 F150 with 5.4, when pulling her horse trailer or extended idling her truck starts running rough, so far her husband has changed the fuel pump and 2 coil packs, no luck.
View 3 RepliesFord F-150 - 1997-2003 :: Engine Running Rough During Idle And Driving
I am having a problem with my 1997 f150 4.2 v6. The engine is running rough at idle and while driving. It's running so rough that it vibrates the entire cab of the truck. I found water in the oil when I was trying to fix the problem. I have since had the heads redone and replaced all of the gaskets thinking this was the reason for the rough idling and rough driving. It wasn't; doing this fixed the water in the oil but still I have the rough running engine at idle and driving.
I have replaced the EGR valve, plugs and wires, pcv valve, replaced the coil pack, fuel filter and air filter (everything has been replaced with ford recommended parts because I have read that the engine I have doesn't like after market parts). While driving the engine vibrates and sound as if it's going in a cycle in a rhythmic sort of way (like a washing machine goes in a cycle), best way I can explain it. I have come to the end of what I think it is?
Ford F-150 - 1997-2003 :: Slow Shifting Into Reverse / Shudder Under Load
I have a 03 f150 2wd with the 4.6l. Recently it has been slow shifting into reverse(about 2 full seconds) and when it finally gets in reverse it shudders when it comes under load. The fluid is full and not burnt...
View 1 RepliesFord F-150 - 1997-2003 :: P0401 Code / Occasionally Missing Under Load
Have a p0401 code which I need to diagnose and solve. However, I don't believe the symptoms are indicative of the EGR system. Its a 1999 4.6L auto approximately 200k miles. Truck runs fine until it warms up, and then occasionally it begins to act like its missing under load. steady state on the freeway it may have an occasional miss, but put a load on the motor and the miss becomes real bad. This doesn't seem to me to be symptomatic of a P0401 code, but I don't really understand the EGR system enough to be sure. Searching on the forums for other p0401 codes doesn't seem to have the same symptoms.
View 10 RepliesFord F-150 - 1997-2003 :: Rattle Under Load / Hard Knock In The Bottom End
I've got a 97 truck, broke the crank, swapped in a motor from an 07. Heads down is 07, intake up is 97. had heads planed and a valve job with new seals done. Left it alone from the rings down. Got it in this weekend, running today. Ran it in the driveway with no load for about 30 minutes, top end was noisy for about 5 minutes till the top end got good and oily (I'm assuming). Purred like a kitten, sounded real smooth. Took it for a drive around the block, heard the clatter in the video below. It's almost always there when driving. Brought it back, turned it off to check oil, it was a quart low. Added oil, startup was VERY labored with a real hard knock in the bottom end. Ran like poo till I gave it some throttle for a couple seconds, then it cleaned up and idled well. Let it run for a couple minutes, turned off and let it sit for a couple minutes then started back up, same thing. Very labored with hard knocking.
View 2 RepliesFord F-150 - 1997-2003 :: Whine When Turning From Rear End / Shutter When Takeoff Or Back Up
I've got a 2003 F150 4x4 supercrew that's got a 9.75" rear end with 3.73 gears. I just replaced clutch packs and spider gear set 2 weeks ago. The last day or two I have noticed that when I make sharp turns that it get a whining like spinning noise. It sounds to me like the spider gears are spinning. It only does it when making sharp turns. There is no noise going down the highway or normal driver. I have noticed at times I get a little shutter when I go to take off or back up. Kinda feels like a brake is hanging. I put friction modifier in when I did the clutch packs and everything. Maybe not enough?
View 5 RepliesFord F-150 - 1997-2003 :: 5.4L Engine Stutter While Turning - Misfire At Idle Or While Driving
My 2003 f150 5.4l has developed a slight stutter when I turn from a stop or go from reverse to drive or vise versa. I had thought it was the IAC so I replaced it but the issue is still there. There are no engine codes and it does not miss fire at idle or while driving. The problem appears to be happening only when the a/c is on. Could the belt be the cause?
View 4 RepliesFord F-150 - 1997-2003 :: Constant Whine - Rear Axle Pinion Bearing Replacement
I have a constant whine going down the road with foot on the gas. Back off and it quiets up. At 2-3 MPH i think i can here a " tick- tick". Took the drive shaft off, wheels off ground, cover off and oil out. Spin wheel and i can hear a tick - tick, I think around the pinion bearing. No play up and down or in and out, but it appears to have 2-3 times the backlash i would expect. I used the screw driver- stethoscope--- still think its the bearing. This is a 9.75 axle. What kind of luck would I have pulling the yoke off and going in from the front without removing axles halves and ring gear? I thought I had read that here before. Never done one that way .
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Smokes While Driving Under Load And Shuddering At 2k RPMs
Ill start off with my mods and recent maintenance things I have done before fully describing the issue.
E99 7.3l with 190k on the clock
Full 5" turbo back
TS-6 chip
EGT, Boost and trans temp gauge
New ford glow plugs
Re-orings injectors
new valve cover gaskets
new fuel filter and fuel lines
new turbo with a ww2
Newer trans and oil pan
I think that should do it, now for my problem. The truck starts good cranks over once and is running with no hesitation, the engine run a little rough, more than normal vibration at idle almost like a small miss. No smoke at idle.
While driving with no/little load on the engine runs great , but under load there is a good amount of white smoke/ oil smell. The turbo is new and is not leaking oil I have already checked over that and the exhaust is new but there is some oil that is at the tail pipe in liquid form. The exhaust up pipe that goes to the turbo is not covered in oil either
The truck cruising in OD or in 3rd with O/D off around 2k rpms it shudders real bad almost like the truck is going to shake its self apart. but at like 2400 rpms and above its fine. Where is a good place to start the diagnosis as I am pretty new to the Diesel world. From what I've read it looks to be either rings are junk or maybe I have some bad injectors (thats what it feels like to me) but would that cause it to smoke like crazy?