Ford F-150 - 1997-2003 :: Ignition Fuse Blows Every Time Turn The Key To On Position
97 F150 4.2 auto with Simple trans pan gasket change because it was leaking and now the ignition fuse blows every time I turn the key to the on position. Ran fine before now what? can't pull code with reader with key on or off.
View 4 RepliesFord F-150 - 1997-2003 :: 1998 - No Fuel Pump Buzzing Sound When Turn The Key To On Position
Ok I have recently bought a 1998 Ford F-150 V6 4.2L 2WD and when the guy sold it to me the check engine light was on and he told me that randomly when you turn the key to the on position you will not hear the fuel pump buzzing sound and he knew it wouldn't start, he said you would have to turn the key from the on and off position many times until you hear this sound and then the truck will start and run fine.
First off I got the codes read and there were three of them P0171, P0174, and P1537 some things to note are that the drivers air bag looks like it had deployed, the cover is loose and when I pulled it back the air bag looks duct taped up inside there that would cause the air bag light to continuously flash while driving. I noticed the battery leads were corroded so I replaced the battery and put new battery clamps on both wires, after that the problem did not happen for a week and I though it was over but it happened again.
Next is that the truck has the PATS system and it did not come with a remote which I have also read that the PATS system can cause the fuel pump not to turn on but not sure if this would cause it to not start randomly because sometimes it starts right up. When I started to look at the simple things to fix I noticed it did not have an air filter in the housing. so I thought the MAF sensor could be dirty so I cleaned it with the special cleaner, I put sea foam into the intake via a vacuum hose and also have put a fuel system cleaner in a full tank and have driven most of the gas out. After putting in an air filter, cleaning the MAF sensor, and sea foaming the intake, it seems to run a bit better but I am still having the random fuel pump issue.
I have checked the fuses and the and the fuel pump and ECM relays both are fine. Today I put new exhaust on it because it had some bad exhaust leaks and the truck did not start again, so the guy trying to put my exhaust on, hit the fuel tank with a hammer and it didn't work then hit it again and it finally worked. Im not sure if the hitting it did it or if it just randomly turned on like always from turning the key on and off. The new exhaust has made a huge difference in driving it feels and sounds much better.
Also to note is that when I am stopped at stop lights it will idle at about 1500 and then it drops down to 500 and back up and back down again and it does this at most stop lights, and it is not an abrupt drop it just slowly idles down and back up again. Again once the truck is started it runs perfectly fine with no issues, and there are no specific times when it has the problem it seems to be randomly. I know that many people will tell me to change the fuel pump out and I am already prepared for this but if there is any easy things I haven't thought of yet...
Ford F-150 - 1997-2003 :: CD Player Refuses To Eject Any Of The Discs - Error
I have an 03 F-150 XLT with the 6 disc changer, and I can't get the dang thing to eject. It plays most of the cds fine (sometimes it won't play a certain couple of the six that are in the changer, and reads "CD ERROR" after trying to play the disc for a moment) but it refuses to eject any of the discs. It pushes them out just a little bit and then errors. I've attempted to pull the disc out once its pushed itself out a little, but it won't release them.
I then have to mess with it for several minutes to get it to retake the disc and quit pushing it out again, and then a few more to quit erroring when I change it to disc. I've tried to disconnect the battery (I read in a forum that that sometimes works) but to no avail. I know its a frequent issue with these. I figure I can pull the stereo out and take it apart to get the discs, but how can I fix the issue for good?
Ford F-150 - 1997-2003 :: Throttle Body Whirring Noise
The Throttle Body on my 2001, 4.6 L is making a strange whirring noise, when you puy your hand on the intake pipe, you can feel a slight vibration. The Truck idles and runs okay, with no codes. Giving it a little gas and the noise goes away. The last thing I did was clean the IAC with Gum Out Carb cleaner, the second or third time I've done this over many years, with no problems. I'm a little perplexed at the cause.
View 6 RepliesFord F-150 - 1997-2003 :: Truck Horn Sounds Wimpy?
The one on my truck sounds pretty wimpy. I don't use it a lot but it's supposed to get your attention... Mine., Not so good.
View 13 RepliesFord F-150 - 1997-2003 :: Clunking Sounds Coming From The Rear End
Was having some clunking sounds coming from the rear end on the old F150. Bro in law said it was lack of gear lube and the rear diff grinding from the start. Wasn't the issue. U - joints are shot and causing the issue. My question is I marked the drive shashshaft and flange with a sharpie but it rubbed off on the flange from free spinning the rear end seeing if the issue was there. From the drive shashshaft to the rear diff flange does the flange need to be marked or no? I did scribe with a nail the transfer case and marked the drive shaft with sharpie. So is the flange being marked important or just the bracket with the u-joint? Would've used soap stone but don't have any on hand.
View 5 RepliesFord F-150 - 1997-2003 :: 2000 - Noise From The Left Side Of Car Sounds Like Air Being Let Out
2000 Ford f150 4.6 ... I am hearing two things one is a noise from the left side of the car it sounds like air being let out. The second I think I already figured out but its chirping I think its the harmonic balancer because it took so long until it started spinning and made a chirping noise because it sounds lower than the belt tensioner which I already replaced, along with the alternator, and the belt.
View 1 RepliesFord F-150 - 1997-2003 :: Driver Seat Not Staying In Position
1999 F-150. Driver's seat won't click firmly into place, it just moves freely backward and forward.
View 1 RepliesFord F-150 - 1997-2003 :: Seat Back Won't Stay In Up Position 1
I have a 2000 Regular Cab Work Truck with non power split bench seat. The passenger side back will not hook in the up position.
Before diving into it. Is the mechanism broken or is it something I can fix if I tear it apart? There is nothing stuck under or behind that I can tell.
Ford F-150 - 1997-2003 :: 2000 - Won't Start When Put The Ignition In On Position
Have 2000 Ford XLT Extended Cab 4x4 with 5.4. It will not start. Put the ignition in on position and can't hear the fuel pump running. Fuse Okay, Relay OK. Does this year have A Fuel Pump Driver Module? If so, where is it located? I know where they are located on 2004 and up but not mine. If I have to change out Fuel pump, is it easier to pull the tank or the Bed?
View 6 RepliesFord F-150 - 1997-2003 :: Code P0340 - Cam Position / Bank 1?
The p0340 code is the cam position right? Ready says bank 1.. Is there 2? Where the bank one is? And do I need to get on tdc on cyl one first or not?
View 3 RepliesFord F-150 - 1997-2003 :: 2002 V8 - Dashboard Gauges Always Stay In The Same Position
I have an F 150 2002 Trition V-8. I always thought I knew how to read an instrument panel on a vehicle but after being put down by my Ford, I have to rethink this knowledge.
I have noticed over the past 4 years that my volt meter guage on the instrument panel always stayed in the same place whether the motor was running or just the key in the on position. I noticed that a little battery icon kept coming on and going out yesterday. I read the owner's manual and it said something like this indicates your battery is not taking a charge correctly. Well why has the guage not told me anything. Well the alternator has quit but yet and still the guage is still showing me all is well.
I ask a Ford dealer service dept. about this and they do not have a clue. All they tell me is people do not pay attention to the guage but when the light comes on they need. They also said the gauge would work when everything shuts down, but man! I don't need it to work then. I know it's broken when that happens. It quits running.
What is the purpose of the gauge sitting there all shiny and pretty if it is not going to say anything other than "HEY MAN! I am just here looking pretty and taking up space".
I have looked at other trucks and they do the same thing. Nothing .. What is going on with this gauge which undoubtedly does nothing?
Ford F-150 - 1997-2003 :: Wipers Working Only With Steering Wheel In Up Position
Getting some rain here in az causing me to use my windshield wipers....which is rare. I can once and for all say I'm sick of the wipers working only with the steering wheel in the "up" position. Is it a big deal to tear into the column and replace that stinking multi-switch/harness? 378000 miles ....
View 1 RepliesFord F-150 - 1997-2003 :: 2002 V8 - Camshaft Position Sensor Harness
Just bought a 2002 4.6 v8. Check engine light was on and it pulls code po340 for the camshaft position sensor. I took a look at it and found its not plugged up. The plug is missing but the two wires are still there. I can replace the two wire plug but does it matter which wire goes to which side of the sensor?
View 3 RepliesFord F-150 - 1997-2003 :: 2001 - Truck Tries To Stall Almost Sounds Like Vacuum Leak And Really Bogs Down
So.... here's my issue. I have a 2001 supercrew 5.4 and runs great all day long, no problem starting or anything. After I have driven it for a while and turn the AC on it cools off very good then after about a 1/2hr. the truck tries to stall. It almost sounds like a vacuum leak and really bogs down. I can wait about 2hrs and then with the AC off the truck starts and drives like it should. I am steering to the IAC valve but would like to know if this is it.
View 9 RepliesFord F-150 - 1997-2003 :: Wheel Bearing Play / Clunking Or Sounds Like Something Mechanical Shifting
I have a 2002 Extended Cab F150 2WD 5.4L 3.55 Open. I have recently begun to notice a clunking or "sounds like something mechanical shifting" when I come to a stop or take my foot off the brake before accelerating (as in, when the light turns green.) The shocks are shot, so, some of the noise when I stop is likely due to bounce back, but the noise when I take my foot off the brake is clearly not related to suspension relaxation.
I jacked up the front, passenger corner and checked the wheel play. I immediately noticed wheel play in both 12/6 and 9/3 hand positions. First thought was obviously ball joints, but when I looked more closely I found that the steering knuckle itself was not moving at all. (I only had one corner jacked up, so, the torsion bar might have been stabilizing the steering knuckle to some degree, but...nonetheless, the wheel play is still there.)
So, the wheel play is between the wheel/rotor, and the steering knuckle. To me this suggests wheel bearings. But, I'm not sure how much play is allowable between the wheel and the spindle. Should the rotor/wheel move at all with respect to the spindle/steering knuckle? How much is okay? Does movement suggest I need to replace the wheel bearings? (I installed the rotor and wheel bearings myself last year.)
Ford F-150 - 1997-2003 :: Driver Side Rear Sounds Like Brakes Are Dragging Against The Rotor
Went and got new tires on the supercrew. Went going through parking lots or simply driving i hear a loud squeal like brake pad squeal. I put brand new wagner ceramics on the truck. Also if i turn to the left the driver side rear sounds like brakes are dragging against the rotor. Whats goin on with this. The squeal will happen between 10 mph to 20 mph and the grinding noise will happen if I am cruising or turning to the left. It goes away when i apply the brakes.
View 1 RepliesFord F-150 - 1997-2003 :: 2002 - Fan Selector Switch Actually Blow Any Air Only On High Position
2002 F150 XL... My heat & AC work fine, but the only position the fan selector switch will actually blow any air is on high. Bought an OEM replacement switch and installed it but the issue still exists.
View 4 RepliesFord F-150 - 1997-2003 :: Crunching Sounds From Front Passenger Side - Wheel Turns Hard
Had crunching sounds from front passenger side. Replaced CVJ shaft and hub bearing/assembly noise gone but tire turns hard by hand drivers side turns freely. Looked on line and guy had same thing going on said maybe 4x4 vacuum actuator might be bad and truck stuck in four wheel .does this sound right? I have manual trans and gear box so I don't understand why the actuator is even there.
View 4 Replies