Ford F-150 - 1997-2003 :: 2002 - Time Delay On Starting?
My 2002 Ford F-150 4x4 4.6L 5speed strangely has a time delay in starting now. A delay in TIME and not the usually chucking along waiting to start. Or simply I turn the key and a second or two passes before anything starts to happen and it fires right up. Was wondering a few months ago, if my clutch sensor was going out but then it cleared up once I put a new battery in it although at the same time the weather warmed also. Bad connection somewhere, bad ignition switch, or bad clutch position sensor – I could go in each of these directions. Thought maybe the security in the key was doing it too but both keys have the same problem. No codes also.
View 2 RepliesFord F-150 - 1997-2003 :: High Idle - Delay In Shift Intermittently?
So my F150 (with 4r70w) has a weird issue. If I jump on it (only briefly) and then drive normally it gets stuck in a high idle/late shift mode. Sometimes it won't even shift until 3500 - 4000 RPM. If I stop and restart it will usually go back to normal (depending on how warm the tranny is, the warmer it is, the less likely to fix on restart). Now I understand that if you give it a lot of gas it will shift later, but like I said, it get's stuck in this mode even if I have a light foot after. The really weird thing is that it does this after cruising on the highway for a while. Also, the OD light does not flash.
As I'm writing this, I just realized that a common thing is warm tranny fluid. I'm not sure if it's the tranny because the high idle and the fact that it will shift fine if babied. There are no codes.
Here's what I've done: Flushed tranny fluid and filter (full flush, not just the little bit with the filter change), replaced TPS, replaced PCV, replaced IAC valve, replaced a few vac lines, and cleaned entire throttle body (including EGR valve).
Ford F-150 - 1997-2003 :: Random Interval Engine Stops With Short Delay To Restart - Code PO231
I have got the most aggravating electrical gremlin possible. For over a year now, the truck intermittently just dies. Mostly it happens about 2-3 mins after start (every couple weeks or so), then takes a couple of key offs, then back ons to restart. But it does restart and then runs fine for a time.... 2 weeks ago I was rollin' down the road and hit a pothole, and whammo, she died, and wouldn't restart. I thought, "great it was the intertia cut-off going bad." I had it towed to the shop where they did some diagnosis and told me it threw a PO231 code.
The tech then said he was doing the diagnostic manual directed test, and swapped out the fuel pump relay, and it started right up. New relay, out the door. A few days later on the way to work about 2 - 3 minutes after start, she dies again. I hang my head, say a curse word, and key it a couple times, and it starts back up and runs fine. Presently speaking she's back at the shop, but the owner, who's a straight up dude was loath to take her back, because it was running fine at the time.... I've got to figure this thing out before I drive it off a cliff.
Truck -- 2001 7700 XLT 5.4L 88K miles
Symptoms -- Random interval engine stops with short delay to restart, 1 hard bump engine stop with no restart. PO231 code (after the hard bump no restart). Didn't check it previously (wasn't aware there were "soft" codes).
Troubleshooting to date -- 1 new fuel pump, 1 new fuel pump relay.
Only things left are the inertia cut-off switch (which apparently don't go bad that often), and the wiring itself/connections to the different components....
Ford F-150 - 1997-2003 :: How To Remove Starter
Starter Removal, The top bolt is a bugger.
View 5 RepliesFord F-150 - 1997-2003 :: New Starter Won't Disengage?
The starter on my kid's truck doesn't disengage and continues to turn over after the ignition is off. I have seen a few posts on this but have yet to find a clear troubleshooting path and it seems a lot of money wasted on new starters, solenoids and new ignitions.
View 4 RepliesFord F-150 - 1997-2003 :: 1999 - No Power Going To Starter
I have a '99 F-150 SC, 4x4, 4.6L, with 48,000 miles. I drove approximately 15 miles, then parked for 20 minutes. When I returned, the truck wouldn't do anything when the key was switched to start. It's as though there was no power going to the starter. Could it be a problem with the immobizer system, or just a freak incident with how I handled the key? The truck ended up starting after another 15 minutes and has consistantly started for the remainder of the day.
View 4 RepliesFord F-150 - 1997-2003 :: 1999 - New Starter Won't Disengage
Starter problem with my 1999 Ford 5.4 f150. Last few days I’ve had to cross the solenoid terminals in order to start up. After replacing the solenoid the starter would not disengage. Put the old solenoid back on, crossed term and the starter did the same thing. Bought new starter (what a job finding the upper bolt) replaced old one, and I’m still hearing the starter running along with the motor. What else?
View 11 RepliesFord F-150 - 1997-2003 :: Starter Engages With Key On In Park
1998 f250 4.6 4x4. In park the starter engages with key on . Ounce running the starter is still engaged in park and neutral. No engagement in the drive gears. Changed the ignition switch and neutral safety switch on the trans. When key is off instrument cluster is still on.
View 3 RepliesFord F-150 - 1997-2003 :: No Start Just A Click From Starter
I got a 1997 f150 4x4 4.6L had to replace fuel rail after a couple holes were rubbed in it and caused a fire, but now after two weeks of it sitting at the dealer, I wasn't gonna pay for a fuel rail to be put on so i had it towed home and I did it, however now when I go to start it, it just clicks. So I have the battery tested and its bad so it was still warrantied so it now has a new battery and i also replaced the starter solenoid while i was at it. But still just a click when i try to start it. I had the starter out and bench tested it and it went but went slow and looked very old and tired, I am thinking i need a starter now because its a click from the starter, like its trying to go but isn't strong enough.
View 3 RepliesFord F-150 - 1997-2003 :: New Starter Won't Turn / Motor Is Seized?
I have 98 f150 with 4.6 starter went so I put a new one on wich was a hassle and it tries to turn but just wont as if the motor is seized. I had been hear a loud howling sound from what I think is the ac unit and the ac line burst after trying to start. Would a bearing or something with the AC be enough to stop the engine from turning over? Or could it maybe be a wire connection problem? To me it sounds like a starter trying to start a seized motor but I cant see that my motor would be out it only has 190 000km and the oil looks good. but we couldn't turn the motor over with a ratchet? The truck had been getting gutless. I am stuck...
View 4 RepliesFord F-150 - 1997-2003 :: Grinding And Starter Won't Engage The Flywheel
I just bought a 2000 f150 4x4 ex cab with the 5.4. Once in a while when starting, there is a grinding and the starter won't engage the flywheel. The truck has only had 17000 miles put on it in the past 4 years, and has sat quite a bit. Could the starter gear be gummed up and not engaging all the way, or should the starter be replaced? Or could poor contact on the cables cause this? Or is this a flywheel issue?
View 14 RepliesFord F-150 - 1997-2003 :: 2000 - Bad Starter Solenoid Relay?
My truck has started fine every time I've turned the key except for last night after work. I got in had all the lights on the dash and dome lights. I turned the key and nothing. Not even a click. Hooked it up to a company truck and it fired right up and ran fine. Drove home shut off and then started it a little later and it started fine. Then this morning it wouldn't start. I hooked up the jump pack and still nothing. I drove my fusion to work and when I got home I went out and it fired right up like nothing happened. Does the work sometimes not work other times sound like the solenoid on the firewall? 2000 4x4 4.6 auto 253k miles
View 4 RepliesFord F-150 - 1997-2003 :: Starter Stays Engaged Until Put In Gear
I might have a chance to pick up an 1997 F150 with a 4.6 pretty cheap. He has replaced the ignition switch and lock cylinder, Says it keeps turning over until you put in in gear. In my experience a solenoid that is sticking wont stop until you disconnect the battery, just wondering what people think it might be? I am thinking I will just put a push button stater to make it work if its a wiring issue.
View 3 RepliesEscort :: 95 - Starter Delay In Cold Weather / Dash Lights Dimmed
95 1.9L 5 speed. 142K Runs like a champ but over the last few colder mornings, low 40's high 30's, the starter is slow to get turning. This morning it was really slow, as I held the switch to the crank position for a good 10-15 seconds before it started. To the point that the dash lights dimmed, like a larger load was on the battery. Once it starts its fine. Later in the day it starts just like it should. Just wondering if I may have a starter about to go south on me.
View 5 RepliesFord F-150 - 1997-2003 :: Rebuilt Starter Fires When Battery Connected
My husband's starter went, so he took it in to be rebuilt. After my husband reinstalled it, as soon as he connects the battery up, the starter engages without the ignition on (not even a key in the ignition). Did the guy who rebuilt it screw up, or is there something my s/o might have done wrong when putting it back in?
View 11 RepliesFord F-150 - 1997-2003 :: Freezing Temps - Multiple Starter Failures
2004 F-150 heritage : 12 degrees F yesterday. clicked (firewall solenoid) but starter was not pulling amps. After putting a jumper pack on it, after about 30-40 clicks it took off, never to work again.....towed it home with a rope.
2000 F-250 Super Duty : 7 degrees F today, did the same except you could tell the starter was pulling amps. Took a lot of clicks and engaged but I let off too quick, another bunch of clicks and it started. Once I moved it, I tried it a bunch more and it seemed to work, however I do not trust it.
2001 Crown Victoria : 7 degrees F today, the first turn of the key was nothing but a click, and the 2nd turn it worked fine. After moving it worked a bunch more times.
Whats up with the cold temps and the starters?
Ford F-150 - 1997-2003 :: 2002 - Starter Did Not Turn Or Crank The Engine
I have an 02 f150 5.4 4x4, drowned it a while back, thought i had hydro lock, crank can be turned by hand though as far as i can with a wrench, so internals seem to be fine, no bent or broken rods that i could tell, ripped everything apart cleaned it up put it back together, new fuses, new ignition relay, new starter, alternator and battery as well, turned the key to on and got all my electronic stuff back up, turned to start and it all goes dark, which i assume is because at that point its sending power to the starter, but the starter didn't turn or crank the engine...
So question being when i put my new starter on is it possible that i might have crossed a wire or something that would cause it to not crank? and due to the fact that I had water in it, and had hydro locked it, all my plugs are out, now I know that spark is needed for the engine to run, but shouldn't be needed just for the crank to turn right? question being is that once i fix the wires on my starter, I am looking for initial crank before start up, so do i need to put a plug or two back in and hook them up to make it crank? or will it crank without them? and yes I did replace all my fluids as well.
Ford F-150 - 1997-2003 :: Starter Engage The Flywheel But Couldn't Turn It Over At All
After getting the oil changed in my 1997 Ford F-150 4.6L with 150K miles at a local quick lube, I made one stop and my truck wouldn't start. I could hear the starter engage the flywheel, but couldn't turn it over at all. Oil was clean and full. I bench tested the starter and it tests good. I put a breaker bar on the crankcase nut and I could barely move it. Oil level was about 2 quarts low before oil change.
View 10 RepliesFord F-150 - 1997-2003 :: 2000 - Remote Starter Keyless Entry
I'm putting in a remote starter keyless entry in my 2000 f150 I have all the wires figured out except for the remote start part. Where the wires listed in the photo go? I do have the module required.....
View 3 Replies