Ford F-150 - 1997-2003 :: P0401 Code - Vacuum Lines?
So here's the background. I recently bought this truck. It's a 97 Ford f150 4x4 4.6l 99w vin code. Anyway Driving it home got a p0401. No problem. I Applied vacuum from other vacuum source to EGR engine stalls. So to me passages are clean in the throttle body. I checked to verify and indeed passages are clean. No while doing so I noticed no vacuum was making its way to the dose valve thing. Strange.... So took the line that runs to the passenger fender to dose off and it was impossible to blow air through.
So I cut out the clogged section found solder in the line. I filled the gap I now created using some 5/32 vacuum line reconnected to test and to my anvil still not vacuum. So I disconnected it again. Went directly to where the yellow/orange dose vacuum line connects to at the passenger fender and to my surprise no vacuum there either. No my question is. Am i suppose to have constant vacuum to the dpse or I'm I just being an idiot. And two if I am suppose to when the vacuum line runs into the passange fender where does it go from there and could I have a major issue in my hands?
Ford F-150 - 1997-2003 :: Check Engine Keeps Going Off And On - P0401 Code
On my 98' f250 4.6L 4x4 .. My check engine keeps going off and on, I finally pulled the code and its the P0401. The truck pings and knocks now and than and idles a tiny bit rough sometimes but overall runs good and gets the same mpg it always gets.....is this a bad egr valve?
View 2 RepliesFord F-150 - 1997-2003 :: P0401 OBD2 Code / Vacuum Leaks
I've had a 0401 code on my truck for the last two years. I've replaced the EGR valve and the dpfe sensor a couple of times, with fomoco parts. Ive also cleaned out the egr tube that comes off the exhaust manifold. In this time I also discovered a couple of vacuum leaks and replaced those. I changed the pcv valve, tried running 93 octane gas, and had a mechanic friend run a special smoke through the vacuum lines to find more leaks. Also put a brand new gas cap. I have an obd computer and cleared the code repeatedly but the light always returns.
View 14 RepliesFord F-150 - 1997-2003 :: Diagnostic Code P0401 - Insufficient EGR Flow
My 2001 F-150 came up with this code and I changed the EGR valve cleared the code and it returned 15 miles later. The truck only has 30K miles and the warranty expired 24 May.
View 14 RepliesFord F-150 - 1997-2003 :: P0401 Code / Occasionally Missing Under Load
Have a p0401 code which I need to diagnose and solve. However, I don't believe the symptoms are indicative of the EGR system. Its a 1999 4.6L auto approximately 200k miles. Truck runs fine until it warms up, and then occasionally it begins to act like its missing under load. steady state on the freeway it may have an occasional miss, but put a load on the motor and the miss becomes real bad. This doesn't seem to me to be symptomatic of a P0401 code, but I don't really understand the EGR system enough to be sure. Searching on the forums for other p0401 codes doesn't seem to have the same symptoms.
View 10 RepliesFord F-150 - 1997-2003 :: 1999 V6 - Code P0401 / Insufficient EGR Flow
Dreaded insufficient EGR flow. I've read I should clean the EGR ports.
I can't really find where these are? I took the throttle body off.
What I should do with this thing? I also get a hesitation on initial take off.
1999 F150 4.2 V6 ... 160k miles on it. Runs good otherwise.
Ford F-150 - 1997-2003 :: P0401 - EGR Insufficient Flow / P0455 Code
Has a P0401 code EGR unSufficient flow. Ive read several things that it could be, from a DPFE sensor to the EGR valve it's self our that the port going into the TB could be plugged. Truck drives fine does not have a miss or anything noticeable when driving other than the CEL, trucks a 4.6 with 200k on it. Forgot to mention it sometimes gets a P0455 code but i assumed that is gas cap. or could it be related?
View 7 RepliesFord F-150 - 1997-2003 :: Got Error Code P1000 - Idle Rough - CEL On?
What that means? The check engine light is NOT on but I looked for a code because my truck is idling rough, and when driving, when the overdrive kicks in, it vibrates really bad. As if a bad U-joint on your drive shaft. The truck has been in a field for about 5 months broke down so any clue? Haynes manual says nothing about P1000.
View 13 RepliesFord F-150 - 1997-2003 :: 2001 - Got Code P0401 - Replace DPFE Sensor?
I have a p0401 generic exhaust gas recirculation flow insufficant detected code on my truck I was wondering what would be the first thing to check to get ride of this code? my truck hesitates from a stop while excelerating to several thousand rpm. should I try replacing the dpfe sensor? what does dpfe stand for? do they sell this sensor at oreilys or do you half to get this a the dealership?
View 9 RepliesFord 7.3L Power Stroke (1999-2003) :: 2001 - Rough Idle - Poor Fuel Mileage?
My7.3 is idling rough till I pull the fuse for the fuel pump them it will smoothen out I ran a by pass switch to us my truck but the fuel mileage is bad why
View 13 RepliesAccent RB (2012+) :: Poor Performance Under Load
This is a accent 2015 Sr poor performance under load and when I have passengers. This car is 1 month old. 1.6 lt.
View 4 RepliesAlero :: 2000 2.4 - Skipping And Rough Idle - Poor Gas Mileage
I have a 2000 Alero w/ 2.4 103,000 miles auto. I have been trying to fix a problem for about 3 months. It all started one night when i got stuck in my backyard in about a foot if mud. I thought i could drive it out, but when the wheels would spin and traction control would limit the rpms. After getting out the car would skip every now and then going up an incline at highway speeds in 4th gear (drive) then it would skip while idling. I could get it to run smooth if i hit the pedal and made it shift to 3rd. I drive this car daily and the problem has got worse slowly. Now its hard to crank and when it does there is a small amount of white smoke with strong gas smell while the motor spudders for about 10 secs.
It will finally "clear" up and still misfire every few secs or just cut off. Gas mileage is terrible between 15-18mpg. The engine light and trac off light has only been on twice. Both times the code was for random misfire of multiple cylinders. I have put plugs, boots (wires), distributor, 2 fuel processor regulator, seafoam, all octanes of gas, pulled injectors (looked ok a little dirty but still could be one) and I have ordered ignition control module. Its getting hard to drive and even harder to sell. It has just started the white smoke and gas smell and i think its that's the pressure regulator, but the skipping and rough idle....
Ford F-150 - 1997-2003 :: Rough Idle At Start Up
I just acquired a 2003 with 5.4 L. Did all new plugs and coils, cleaned MAF sensor, changed air filter, oil, transfluid and filter (obviously not related).
Upon start up and idle the truck has is rough, enough that it will vibrate the whole truck SLIGHTLY. Once in gear and warm, it smooths out and is fine. Unit the next stop and start.
Ford F-150 - 1997-2003 :: Idle Very Rough Like A Misfire
I got a 97 f150 4.2l from my neighbor. he takes good care of his vehicles. he sold it to me cuz it started to idle very rough like a misfire. it is hard to start when cold spits sputters and pops. once started idles like it wants to stall, then will idle normally then back to rough. back and forth like that. runs like a champ when going down the road . check engine light was on took it to auto store they checked codes . said bad o2 sensors so i changed them. still same issue. neighbor changed coil packs checked spark plugs and wire. every thing fires good. i changed iac. still didn't fix problem. could this be a bad egr valve or sensor? if so how can i diagnose this? he also thought was a clogged cat and bored it out. tight budget can't afford to take it to a mechanic. Was told spray carb cleaner spray around engine to check for leaks that did nothing at all...
View 14 RepliesFord F-150 - 1997-2003 :: Rough Idle When In Drive
I bought this truck used and when it's in drive the engine idles rough and seems about to stall when the ac is on at a stop sign or red light.. I've tried it w/o the ac on and it seems a little better but not as smooth. Idle in park is fine.
When I should start looking? Spark-plugs? spark plugs wires, disturber cap, fuel filter etc...
Lexus IS 2014+ :: Poor Acceleration Performance After Driven For 30+ Minutes
Our car's don't have as great acceleration performance when hot / after having been driven for 30+ minutes?
View 6 RepliesToyota - Corolla :: 2000 - Poor Performance When Load Placed On Engine
I have a 2000 Toyota Corolla LE that ran very well until about a month ago. It has about 146,000 miles on it. A month ago it started hesitating from a standstill and the engine ran extremely roughly when trying to move the car. But when I put it in low gear it did much better, although not great! When in Drive it barely moved the car at all and would frequently stop running completely.
When I took it to an auto parts store they hooked it up to their computer and it read out that I needed either spark pugs, spark plug wires, or a new coil. I have replaced the plugs, but that made little difference. I then took it to another auto repair place that told me that it was either a problems with valves, or a 'problems in the lower engine'. I don't know what that latter problems means but either way it sounds like it will be very expensive to fix.
Chevy - K1500 :: 1997 - Code P0300 Rough Idle
97 chevy k1500 with 305, engine rebuilt by shop 60k ago, last few months only drove truck 4-5 times, last time driving gave p0306, new plugs, wires, cap, rotor, cleared code, now gives p0300, took intake apart removed spider, sprayed/scrubbed each injector and poppet with cleaner, but no way of cleaning the line between the injector and poppets. No change after cleaning. Also ran injector cleaner through tank. All vacuum hoses look in good order, sprayed carb cleaner around intake to check for leaks at intake/throttle body, no leaks.
Checked TPS, IAC, MAF, Coil and fuel pressure, all good except fuel pressure was 52-54 while idle, replaced fuel pump, screen filter and main filter, cleared code, rough start and rough idle still gives p0300. Checked coil with ohmmeter, between posts A & C, Chilton says 0.1 ohms, i got 0.5 ohms, went to autozone and had them check a new coil, it have 0.5 ohms......? Can drive at higher speeds and runs smooth, but idle is poor almost dies.Checked fuel pressure after pump replacement, still ~54 psi. Stumped and don't want to throw more parts at it without a proper diagnosis. Have a OBDII pocket scan tool, but can't find manual, will try to find manual and see if I can pinpoint the misfiring cylinders.
Passat (B5) :: 2001 VW - Rough Idle / Loss Of Power And Poor Gas Mileage
I have a 2001 VW Passat Wagon 1.8t AUG. A couple of months ago, I took it into my shop for a check engine light. The did the following work on the vehicle:
Replaced MAF sensor
Replaced broken oil level sensor
Replaced outer CV boots
Resealed my transmission pan (it was leaking)
Replaced bad vacuum hoses
When I got the car back, it was idling really rough, and one time it even stalled. Just after starting it, when I hit the gas it wouldn't respond immediately and sputtered for a little while. Once I got going it was usually OK, unless I was going uphill...where it wouldn't perform as well and the engine noise kinda wavered. I also noticed that my gas mileage wasn't nearly as good as it used to be. (I never experienced any problems like this before they did this work) So I took it back to the shop and they replaced both the front and rear 02 sensors. I still had the same problem, so I took it back, and they replaced the fuel filter. Still has the same problem.
The light came on after a month, so I took it back and it was the random cylinder misfire code...and they said that didn't really know what to do about it. So I decided to take matters into my own hands. I cleaned the MAF sensor they installed (took it out and sprayed it with cleaner) nothing. I replaced the spark plugs and while doing so found that one of my ignition coils was bad, and I replaced that as well. Turns out the AutoLite plugs that a local parts store sold me are crap for this engine (actually caused misfires) so I went and got Denso double platinum plugs the next day and put those in. And finally I changed my air filter. Still having problems.