Ford Super Duty (1999-2016) :: Code P0001 - Fuel Volume Regulator Control Circuit Open
My scanner reads P0001 Fuel Volume Regulator Control Circuit Open. My truck shuts down without warning, runs great otherwise. I've changed 2 grey CPS units and now have the Black IH one installed. What the Fuel Volume Reg.is? Is it the IPR on the HPOP?F250SD 7.3 225,000 miles.
View 10 RepliesFord Super Duty (1999-2016) :: Fuel Volume Regulator Control - Code P0001
My 1999 6.8 has developed a miss at low rpm lugging, so I checked on my code reader and it says the Fuel Volume Regulator Control has open circuit.
Well, I can't find anything on these forums or in my shop manual on a fuel volume regulator. Is my reader just using the wrong name?
Prius (2001-03) :: Error Code P0001 - Fuel Volume Regulator Stuck Opened
Got a P0001 error , Fuel volume regulator stuck opened....where is the fuel volume regulator is located on a first Gen. Prius?
View 8 RepliesFord F-150 - 1997-2003 :: Code PO443 / Purge Control Valve Circuit
I need the PCM pinout for a 2002 F150 4.6 For the Purge Control Valve Circuit. If possible the wire schematic would be nice also. Getting code PO443 (( hard code )) I have checked battery voltage at valve connector with key on (( 12.2 volts )) valve resistance is at be 35 ohms so I'm thinking I may have a bad wire or a bad PCM .
View 2 RepliesFord F-150 - 1997-2003 :: High Idle - OBD2 Code With 1506?
corrected vaccum leak. Still high idle and obd2 code 1506???
View 14 RepliesFord F-150 - 1997-2003 :: P0401 OBD2 Code / Vacuum Leaks
I've had a 0401 code on my truck for the last two years. I've replaced the EGR valve and the dpfe sensor a couple of times, with fomoco parts. Ive also cleaned out the egr tube that comes off the exhaust manifold. In this time I also discovered a couple of vacuum leaks and replaced those. I changed the pcv valve, tried running 93 octane gas, and had a mechanic friend run a special smoke through the vacuum lines to find more leaks. Also put a brand new gas cap. I have an obd computer and cleared the code repeatedly but the light always returns.
View 14 RepliesFord F-150 - 1997-2003 :: Truck Won't Start - Fuel Pump Regulator?
How do you test the fuel pump regulator, the truck wont start. I tested the schrader valve and it does have pressure but didn't seem like much. (need a gauge) I replaced fuel pump a few years ago so was wondering about the regulator. Is there a test procedure?
View 7 RepliesFord Fuel System :: Vacuum Control On EFI Regulator
I have an Accel Gen vll EFI setup on a 59AB and plan on using a pressure regulator but it has a vacuum inlet fitting. I'm assuming it's to allow for more pressure on acceleration. When the vacum drops more fuel will be allowed into the fuel rail is my guess.
View 3 RepliesFord Fuel System :: Fuel Pump Circuit Open
Pulled codes awhile ago...got a 96. Says "Fuel Pump Circuit Open"-Battery to ECA (1988 On). What is an ECA maybe the Pump Relay? And does this thing have a fuse for the fuel pump in the panel. Fuel Pumps not getting any juice.
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: Codes For Exhaust Pressure Circuit Valve / Intake Air Heater Control Circuit
I have an emissions test coming up. I have 3 P codes that I'd like to eliminate before then. I don't want to "fix" the issues they are telling me about. Just make the codes go away. I know why they're there I just need to get rid of them.
What I have coming up is:
P0475 Exhaust Pressure Circuit Valve (result of EBPV delete)
P0541 Intake air heater A circuit low (result of aih delete)
P0640 Intake air heater control circuit (also result of aih delete)
What resistors I'll need and where to put them in?
Ford F-150 - 1997-2003 :: Code P0161 Came Up - 2nd Bank Downstream Heater Circuit Fault
Just started the truck after not running for a few weeks and drove around fine. Looked down and suddenly a CEL was indicated. Checked it with my Edge Evolution diagnostic mode and Code P0161 came up 2nd bank downstream heater circuit fault. I've also have an exhaust leak in the right passenger side exhaust manifold for about the last year. I've been waiting to install my newer 03' used engine when time and funds permit.
View 3 RepliesFord Excursion :: Cruise Control Will Not Work / Deactivator Switch Is Open Or Circuit Defective
I bought a 2002 Excursion 2wd V10 at an auction with 105,000 miles. I've been working through the little problems and I'm down to one last small item.
The cruise control will not work. I found a thread to diagnose the problem. My diagnosis is:
After doing the self test I received: 3 flashes - deactivator switch is open or circuit defective.
What does this represent and what shall I do to correct it?
Ford 6.0L Power Stroke Diesel :: Code P2623 For The ICP Circuit Open
Over the past weekend I had to replace all of the egr gaskets and seals, due to it failing smog. I removed all of the harnesses over the motor, intake manifold, turbo, and oil filter housing. I also replaced the oil/oil filter and also the fuel filters. The truck ran great before I decided to replace all of the seals. When I went to start the truck, it would just crank and not fire. One thing I noticed was that my wait to start light only stays on for a few seconds, where before it would stay on for a while. After cranking on it for a while I got a code P2623 for the ICP circuit open. I have tried unplugging the ICP sensor to see if it would start, but it just cranks over. The truck sounds like it wants to fire, but wont. Should I pull the ipr and ICP sensor?
View 4 RepliesPhaeton :: Thermostat Heating Control Circuit Open, Message Came On
My Phaeton has been running perfect since I got it. Yesterday I took it to the dealership to get fluids topped off and a wash. We have had a break in the weather the last couple of days, so I took my w12 on 465 and got it up to 120 before I chickened out. It continued to ride perfectly. This morning when I went out to start my honey do list the service engine soon light was on, it is still running perfect, but when I stopped by local auto store and had them pull the code it says "thermostat heating control circuit open". My middle temp stays at 200, when sitting still the left temp gauge goes almost to 200 however when driving it falls to under 160.
View 24 RepliesFord F-150 - 1997-2003 :: 1999 - No OBD2 Port And Good Fuse?
I just picked up a 99 F150 for a song because it has an issue with the PATS system and the po doesn't have a clue on what to do with it. I bought a new ignition cylinder and Auto Enginuity to program the PATS. The problem I'm having is that I'm not getting anything from the OBD2 port and the #3 fuse is good. What else would cause the port not to have signal?
View 4 RepliesFord F-150 - 1997-2003 :: OBD2 Port Stopped Working - Fuse Not Blown
My 03 5.4 the obd2 port isnt working i have tried 4 bluetooth adapters and a snap on scanner and nothing will connect to the ecm. im having problems and trying to read codes my check engine light isnt on but that don't mean anything. my truck is running really rich and blows a little bit black smoke when i rev it up after its been idling a few min and getting horrible gas mileage again. yesterday i went to start it and i had to crank on it 4 time before it finally started and then when i reved it up it almost died on the way back down but it caught itself. then today i go out and it starts right up and runs fine but its still running rich but i still cant get an obd2 adapter to connect to the ecm. I checked the fuse and its not blown my cigarette plug and the power port both work. i really dont know where to start in trying to figure out this problem. Right now iI don't really want to take it to a shop right now.
View 4 RepliesFord 6.7L Power Stroke Diesel :: 2013 - CEL On With P206 Code / Fault Inj 6 Open Circuit?
On a family vacation in our 2013 6.7 pulling a 41ft trailer to the Seattle area from Alberta Canada. Made it to destination yesterday. Woke up this morning started truck and cel on. Bought a code reader at the local napa store and read P206 fault inj 6 open circuit. Any thoughts on driving the truck around with a inj fault? Thought I had read here some where that 6 was the regen cylinder.
View 14 RepliesGolf VI R :: Code P2293 - Fuel Pressure Regulator 2 Performance
I've been having this code come up for a couple weeks now off and on. Currently I am stage 2 Giac. I have the autotech HPFP upgrade and was installed a couple months ago. Recently It threw the code and lasted for a couple days then went away. I notice that if i get on it pretty hard for a while the code will come back, im guessing due to lack of fuel. I pulled the fuel pump and checked the cam follower and it looks almost good as new still. Thought it would be the sensor but doesn't seem like it as the CEL turns off after a while of not getting on it.
View 10 RepliesPassat (B6) :: Code P2293 - Fuel Pressure Regulator Performance
My car is throwing this p2293 code which means fuel pressure regulator performance 1 had towed twice this week my mechanic replace the fuel pump in the tank but yesterday I died again with the same symptom ...
View 6 Replies