Stalling - Toyota - Rough - Celica :: 2001 - Idle Roughly / Shakes A Bit
I have a 2001 Toyota celica GT auto. It has 120k miles. I seem to have an issue that really is not causing a problem except for annoyance. After coming to a stop the car seems to exhibit the signs of stalling (car idles rough, shakes a bit) however the car never stalls. Once I start driving all is well. Now I took it to the dealer and they replaced the Idle Air Control Valve which is under the throttle body. They said it was getting stuck and due to the higher mileage possible. It was replaced and the problem is still there. The funny thing is even though the car exhibits these stalling symptoms the idle does not drop below 500 rpm (both dealer and I have verified this).
View 3 RepliesDodge - Ram - 1500 :: 1997 - Idle Roughly At Warm / Accelerating
I have a 1997 dodge ram 1500 4x4 with the 318ci engine. 140,000 miles. Fall 2009 I replaced the CAT (old one had broken loose and was rattling around inside) and both o2 sensors. A few months later, when I'd start the truck cold it would idle fine then as it warmed at idle it would run rough almost quit then idle up and run fine all by itself. When started warm it would idle fine then hesitate while acclerating a few times then run fine. No check engine light. Now, about 10 months later check engine light is on (P0138 o2 circuit high voltage bank 1 sensor 2). I have put about 5,000 miles on the new CAT. I checked the wires and connections for damage and found none. Also, new cap,rotor,plugs and wires.
View 3 RepliesFord - Explorer :: 1997 XLT - Shakes A Lot On Idle When Put In Drive
I have a 1997 explorer xlt 2 wheel drive 4 door. It's got 189,000 miles on it. It's shakes a lot on idle when put in drive. I've replaced a lot of stuff. I've also lost a lot of power. I can put the gas pedal to the floor and still not get enough power. The shaking feels like it's about the stall out but it doesn't. Oh and there a rear main leak if that works.
View 2 RepliesFord F-150 - 1997-2003 :: 1999 - Timed Engine Now Hard Start - Idles Roughly?
I have a 1999 F150 4x4 5.4, I pulled the heads due to blown head gasket. Prior to pulling heads truck started and run fine other than miss on #1 cylinder. I timed the engine according to Haynes manual and posts on this site. Truck is now hard to start and idles very rough. I does seem to smooth out when reving the engine and seems to have plenty of power. Cant find any vacuum leaks or unplugged wires.
View 1 RepliesMalibu :: 2003 - High Idle At Roughly 2500 RPM
I have a 2003 Malibu with 57000 on it. It recently started to high idle at roughly 2500 RPM. Could the throttle position sensor have gone bad? It will do this after it warms up.
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: Idle Roughly - No Power - Got Codes P1280 And P1316?
Started my truck yesterday and drove about 1/4 of mile and all of a sudden I lost all power but was lucky enough to creep back home. Had a friend put it on a scanner and it spit out P1280 and P1316 codes. My truck will start and idle rough but has no throttle response and no power. I changed out the CPS and ICP and the problem still exists. I got an infrared thermometer and checked the heat coming off each manifold and the driver side was reading about 200 while the passenger side was reading about 75 while at idle. Pulled valve pan cover off the passenger side to check and see if the harness came loose and everything looked fine. So my question is do you think this could lead to a bad IDM?
View 9 RepliesFord F-150 - 1997-2003 :: Truck Shakes When Accelerating Hard
Its not the tires/wheels. I just had them balanced. It only shakes when hard accelerating. If I am easy on it, then smooth as can be. It gets worse with the RPM of the engine. I am thinking its in the tranny.
It still shifts smooth and I have been pulling 17 mpg on the interstate with it. So I know its acting correctly? Could I have blown something in the trans or ballooned the torque converter?
It just started the other day, I drove about 350 miles on vacation and noticed it when I went to come home. Like i said it only shakes when you lay in to the throttle, and it gets kinda violent.
Ford F-150 - 1997-2003 :: Shakes When Foot On The Brake Idling
I've owned the truck for 8 months, did a fair bit of maintenance in the first two months (plugs, tranny fluid change, maf cleaned, o2s replaced), 320,000km runs very well, no codes.
When the truck is in gear and I put my foot on the brake after a second or so idling, the engine shakes. Releasing the brake, the shake stops, but it does it every time. Also, the belt or one of the pulleys will squeak a bit at the same time, but only idling with the brake on.
It doesn't seem like it is a serious problem, but what and why? My instincts are telling me it may be transmission related.
Ford F-150 - 1997-2003 :: 2001 - Misfire / Shakes The Cab When It Goes To Lowest RPM For That Gear
Have an 01 f250 superduty with a 5.4 triton ... Plugs done 1500 miles ago along with boots just tested and put in 4 new coils.
I have developed a miss and i feel like I am parts chasing. The miss only shakes the cab when it goes to the lowest rpm for that gear. It is very subtle when it is in idle.
Ford F-150 - 1997-2003 :: 2001 - Shakes Violently At Consistent Speed?
2001 F150 4x4 harsh shaking. When driving at consistent speeds the truck begins to shutter and shake, begins as a light shake and becomes extremely harsh fast. This is not like a vibration that can be felt, but a really harsh shaking of the entire truck.
The truck continues to shake after taking foot off gas and braking. It will shake harshly even when braking and slowed down to 5mph, but instantly goes away once at a complete stop. Accelerate immediately after coming to a complete stop and it completely goes away and drives normal for a day.
Check Engine light has not come on. Tachometer stays consistent RPM. Shift into neutral does not stop shaking. Only coming to a complete stop ether in drive or neutral does the shaking stop. It happens driving at consistent speeds going 35mph & 65mph, etc. Any thoughts on what the issue could be?
Ford F-150 - 1997-2003 :: 1999 - Runs But Shudders - Shakes - White Smoke
For over a year, the truck took 5-6 seconds of cranking to start, but always started. This morning it started, but shakes, coughs, and vibrates like hell. It revs up but still sounds like its hitting only on a few. replaced ciols many times over the years, but this sounds different.
View 6 RepliesYaris/Scion & Vitz :: 2003 Toyota Echo - Engine Shakes On Idle
I am buying a Toyota Echo that the engine shakes on Idle and the shaking increase a bit when the AC is On ....
View 2 RepliesFord Super Duty (1999-2016) :: Idle Roughly At 60 To 75 MPH?
Truck runs and rids smooth up to about 60 MPH between 60 and 75 it gets bouncy really bouncy. Feels like the right front is whats bouncing. The not as bad on a good smooth highway but still bouncy.
I've replaced the Ujoints, Center Support Bearing on the rear drive shaft and had hit balanced. I had the front drive shaft completely rebuilt and balanced. I have new tires.
Shop said suspension needed done. Could that be the cause of the bounce or is it a CVJ on the front (feels like the front bouncing)
Side note, when the hubs are locked in there's a knocking when i turn hard right.
Ford - Explorer :: 2005 - Idle Roughly - Hard Start?
I have a 2005 Ford Explorer 4wd with 4.0 SOHC 6 cyl Flex Fuel. For months the vehicle has idle rough and increasingly becoming difficult to start. I decicded to replace the spark plugs and wires hoping to solve this issue! gap set to 052. When I started the vehicle it went into engine fail safe mode and wrench light came on. I then replaced the TPS on the throttle body and had no diference (I may have installed incorrectly! when I put it on the armature felt like it broke free inside the sensor). DTC codes read P0223, P2106, P2110 and with P0122 pending, P0223 pdg, P2106 pdg, & 2110 pdg.
With the old tps installed and wiring harness disconnected the truck will start in fail safe mode, but will not start at all with wire harness connected. A volt meter reads at computer end of wire plug 3.69 volts at pin one (gray/red wire +) and pin three (gray/white wire -) with key to on but not running.
Ford Ranger / B-Series :: 2007 - Idle Roughly In Park And Drive?
The trucks seems to Idle Rough in Park and Drive, Cold or Hot. It mellows out as soon as I give it gas but at stop lights or in park it goes back to a seemingly rough idle.
This is my first Ford Ranger and dont know if its normal. No code or dummy lights.
2007 2WD 4cyl
Ford - Windstar :: 1999 - Blown Head Gasket - Idle Roughly - Now Won't Start
On July 18 my 1999 Ford Windstar van was towed and diagnosed with a blown head gasket. I FINALLY got it back on Sept 4th and was told it was idling a little rough, but it was probably due to water that got in the catalytic converter and would work itself out. The next day we drove it about an hour away it was idling VERY rough and started to stall every time we came to a stop or tried to slowly pull into a parking spot. The following Monday September 8th it wouldn't start and the shop came and towed it back in. It's still there and they are saying they aren't sure what's wrong with it, but are assuring me the problem is unrelated to their repairs. Every time I call they continue to say they are working on it. Where do I go from here?!?!
View 10 RepliesFord Super Duty (1999-2016) :: Hard To Start Sometimes - Stumble And Idle Roughly Then Cut Off
06 F250 6.0 with only 65,xxx miles on it. This has happened twice and both times the engine was warm and had been cut off for less than 10 min.. When I tried to crank it back up it stumbled and idle roughly then cut off. After several attempts to re-crank it still would idle rough and I tried to give it fuel but no change, even with pedal fully depressed. Then it would die.
After sitting a few minutes it starts normal. Both times I didn't have my obd2 adapter for my torque pro. The last time it happened I went home and hooked it up and got no codes. Everything looked fine. What could it be, where should I start looking. Batteries are1.5 years old. Oil, oil filter, and both fuel filter changed about 1000 miles back. I have had the truck for 1.5 years and the oil has been changed twice.
Ford 6.0L Power Stroke Diesel :: Runs And Idle Roughly - Stalls When Coasting / Parking
but 2nd time 6.0 psd owner. 2 weeks ago we picked up an '03 Excursion and were thrilled because it's been running like a dream and getting great mileage. However, according to my wife just yesterday, and after me driving it today, we have a big problem.
The engine starts, momentarily runs smooth, but then quickly becomes very rough. When trying to drive, it will make decent power, but it has an "off" feel to it, like it doesn't quite make as much power as it did, and it has a slight vibration to it.
Then when you coast to come to a stop, or pull in our driveway, it runs REALLY rough and badly, and usually stalls. I have begun the troubleshooting process. Here's what I know: Ficm tests good - 7 pin w/key on only gives ~46V (only tested w/voltmeter) Had an oil change done today and added a bottle of Hot Shot, will add the fuel treatment when we put more diesel in Believe ICP sensor to be OK. I unplugged it and no change Appears all injectors are firing since it ran down the highway decently, AND you can hear all injectors 'triggering' in a uniform manner with key on Turbo probably isn't sticking because made great power before, and decent power even with the problem NO Check engine lights / codes thrown
Details about the truck:Early '03 w/ 189,000 miles EGR delete done in a previous life w/ IPD kit Turbocharger replaced, in a previous life Headgaskets done, in a previous life (no ARPs though )
Questions & next steps:Even if there was no change w/ ICP unplugged, does that truly rule the ICP out completely? Could the IPR be the culprit?
Others? I have ordered a Scangage 2 and it will be here Tuesday. What's the first thing I should check? To me, this very much seems like an electrical problem; my gut tells me it's some kind of sensor or electrical signal error. What's the best way to investigate this path?
The engine turns over very well, and sounds very uniform so I don't think compression is the issue. Head gaskets have been done, although not with ARP studs. Batteries are very fresh and turn it over very fast. I have already learned a ton reading through these forums and just need some additional direction & brainstorming!
Ford F-150 (2004-2008) :: 2005 - Changed Fuel Filter / Spark Plugs / Battery Now Idle Roughly?
I have rough idle problem after changing spark plugs, fuel filter and battery. There was no rough idle problem before this work was done. What could be wrong. Once the speed is above 20 mph it seem to run fine but at stops it vibrates and seem like it may stall!
View 6 Replies