Ford F-150 - 1997-2003 :: 1998 4X4 - Front Drive Shaft Won't Turn On
My t case will engage in 4 high and 4 low. so i know the switch and motor works because it go all the way to 4 low and i can feel the lower gears. BUT the front drive shaft is not turning because i know that the front diff is engaging just fine cus one I just fixed it and because when i put it in 4x4 the front drive shaft is locked in but when i take it out the drive shaft moves freely when i turn it by hand. But when I test it in gravel or mud the front wheels still ain't turning. So its gota be the t case. But what are the part that may be broken in the t case and if I can fix it wile its still on the truck.
View 4 RepliesFord F-150 - 1997-2003 :: Front U-Joint On Rear Drive Shaft Has Grease Fitting
I recently bought a 1997 F150 4wd 5sp manual. While changing the fluids, I noticed that the front u joint on the rear drive shaft has a grease fitting. No matter how I rotate that shaft, I cannot access that fitting with my grease gun, even when fitted with a flexible rubber hose.
View 14 RepliesFord Transmission :: 1997 F150 - Front Drive Shaft Installation - Bolt Size?
Bought a used 1997 Lariat Supercab 5.4L last week. It was missing its front drive shaft so I want to install one.
I just ordered a used front drive shaft online but I now need the bolts that connect everything together. New drive shaft has all the flanges, etc.
What is the pitch/length of these bolts? The part number for the bolts is N800594-S100 (AB-308-D). I believe there would be 8 of them, 4 on each side.
I thought it might be easier and cheaper to just buy bolts from an aftermarket supplier instead of OEM from Ford.
Ford Super Duty (1999-2016) :: Front Drive Shaft Spinning While In 2 Wheel Drive
I have a 1999 Ford F250 super duty 4wheel drive, lifted (really a leveling kit but had to lift rear to compensate), 5.4l. Im having a problem with my front shaft turning while in 2 wheel drive. Hubs aren't locked and its in 2 wheel not 4. I've taken hubs off and the bearing spins free soo I know its in auto. Why is the drive shaft still turning???????
View 5 RepliesFord F-150 - 1997-2003 :: 4x4 Front Axle Half Shaft Makes A Noise / Continuous Vibration
I thought that my front wheel bearing was bad but I removed it and it seems fine. The issue that I'm having is a continous vibration (noise) in the left front that gets worse with speed.The half shaft makes a noise at the point where the half shaft meets the steering knuckle and when I turn the shaft at the outer splines, the grinding noise is present. My question is, is the entire half shaft supposed to turn, even the outer diameter of it that would enter the steering knuckle, or is the shaft supposed to turn inside of that outer diameter? I hope I was able to explain my problem clearly/
View 6 RepliesFord - Aviator :: 2004 - Front Drive Shaft Removal?
I am wanting to remove my front drive shaft from my 2004 Aviator for a couple of month's while I save money to have my transfer case replaced. Are there any safety concerns with this? just need a couple of month's to get the money together....
View 5 RepliesFord F-150 - 1997-2003 :: Disconnect The Door Chime?
So on all of my trucks I disconnect the door dinger they drive me nuts. but how to do it on this new truck. any quick way of doing it ?
View 2 RepliesFord Super Duty (1999-2016) :: Front Drive Shaft Broken?
Not sure what caused it to break but my front driveshaft split in half. I had it in 4wd and was doing a K turn to back in my driveway in a snow storm.
I got underneath in the snow (miserable) and wasn't able to come close to getting it off. The bolts holding the shaft onto the t-case will not budge and the tiny 5/16" bolts stripped all my small 1/4" sockets. I'm guessing I need a 3/8" drive 5/16" for front and the rear just spins. Any tricks to getting this off the truck.
Ford Transmission :: Constant Clunk / Binding Noise From Front Drive Shaft Area
I bought this 2010 f150 from the company I work for, front diff was shot, front drive shaft was in the bed, that's all I knew about the truck so I bought a complete front diff from a used place, it only has 58000km on it, good diff... So I installed the diff and the old front drive shaft, which doesn't seem to be in the best condition, now when 4 wheel drive is engaged I'm getting a constant clunk/binding noise from the front driveshaft area. Where to start looking.
View 2 RepliesFord Super Duty (1999-2016) :: Front Drive Shaft Angle After Lift
I finally got my lift installed the other day from PMF. My question is how do I get my pinion angle corrected on the front drive shaft? I know Trevor sells a Tcase clocking adapter may have to go that route IDK Unlike the rear there's only so much pitch you can put on the front axle until it causes issues with steering. I was thinking of going with an aftermarket front drive shaft designed to handle harsher angles.
I live in the mountains and after installing the lift and pulling a trailer on some of theses steeper gravel roads I can feel a harshness or something coming from under to front of the truck. I'm unable to post pics since I'm back on the road but I can visually see the front drive shaft angle is definitely not in line like it was.
I'm currently running PMF 2.5 alpha with a 1'' spacer and 3 link kit up front and 5'' progressive leafs and traction bars out back. I was able to fix my rear shaft angle using shims on my carrier bearing ( not really a big fan having 1 1/2'' of stacked shims BTW ) ....
Ford 6.7L Power Stroke Diesel :: 2000 - Front Drive Shaft And Axle Locked In?
I am a new 6.7 owner and had/ have a 7.3 As I have been getting to know the truck I have been under it and noticed that the front drive shaft and axle are locked in. My hubs are switched to auto but I know on my 2000 7.3 when my hubs are on auto my front axle and driveshaft are disengaged... I'm wondering if the new 4x4 system is different. I know that can save on MPG
View 6 RepliesFord F-150 - 1997-2003 :: Drive Without Front Driveshaft Will Cause Damage?
Can I do this without damage to anything?
'97 Expedition (but the F150 forum seems more mechanically incline, no offense to the Expedition forum).
I'm trying to find the cause of a vibration in what I think is the front drivetrain. I was almost positive that it was the front driveshaft universal joints. I jacked the truck up off all fours and took her for a spin. The noise seemed to be coming from the from u-joint.
I took the u-joints off and they were still nicely lubricated (after 230,000 miles). My heart sank since this probably not the root of my problem.
I'm surely going to put new u-joints in but think I'll get them from the dealer tomorrow (if the OEM stuff lasted this long, why buy aftermarket, even though it's the same stuff? I dunno, just my OCD kicking in.)
So, I thought I would take the truck for a drive without the front driveshaft today (in 2wd of course) to see if the vibration was gone. Can I do this?
Dodge - Ram :: 1997 - Drive Shaft Fell Off?
I've got a 1997 Dodge Ram with 150k miles. I was driving down the Parkway today and the drive shaft fell out of the rear differential. Is this a major problem? Can this be easily bolted back on or is this the end of my truck? Or something in between? I have no clue where I stand.
View 19 RepliesFord Super Duty (1999-2016) :: Front Drive Shaft Hits The Catalytic Converter
After installing the lift on my 6.2 F250 I ran into the well known issue where the front drive shaft hits the catalytic converter. The two options I was told that I had was to weld in a slight jog into the exhaust guts to go around the cat or to get a smaller diameter drive shaft... I had the truck down at my local exhaust shop to have a new cat back system installed and I had the exhaust guy throw in his .02 about what to do.
He came up with a super easy/obvious fix. When the left and right exhaust meet up before the collector there is a welded brace that secures both sides together. He cut about .5" out of it and loosened the flanges and shifted the exhaust over. Welded the brace back up... Works perfect.
Ford Super Duty (1999-2016) :: 2004 - F350 Front Drive Shaft Metallic Squeal
I have a 2004 F350 Crew Cab DRW 4WD 6.0L.
The front drive shaft is making a high pitched metallic squeal while the truck is in motion. I thought it might be the universal joints but after lubricating the joints, I can still hear the squeal and it sounds like it is coming from inside the drive shaft. I also hear this squeal when I spin the drive shaft by hand.
I have quite a few questions about these drive shafts:
- What would cause a squeal from within the drive shaft?
- Are there any replaceable parts or do I have to get a new drive shaft?
- How do I identify the correct drive shaft part for my truck? Seems like there are a LOT of different models on the web.
- Are any of the aftermarket drive shafts any good? Any to avoid?
- Is this a DIY job or will I need to take it in to the shop?
Ford Super Duty (1999-2016) :: 2000 F350 - How To Correctly Install Front Drive Shaft
I want to install a new front drive shaft in my 2000 F350. I have the new one, and it has a big nut and it is threaded for length adjustment. My old one has a rubber boot which is missing from the new one. I plan on using red locktite but I do not know the torque specs on the front universal caps. Should I take it to my mechanic? I've never owned a 4x4 before.
View 3 RepliesFord F-150 - 1997-2003 :: Front End Rattle When Drive Over Rough Places On The Road
I have a 97 F-150 4wd and when I drive over rough places on the road you can hear a rattling noise. It also causes my truck to thud loudly. But also as I just coast at about 10 mph with the window down you can hear that rattling noise. Almost sounds like a washer sliding on a shaft or something. You can definitely tell something is loose in the front end when i hit rough places. We've jacked it up and tried to move the wheel and the bearings and ball joints seem tight.
View 6 RepliesJimmy :: 2001 - Strong Vibration When In 4WD / Front Drive Shaft?
2001 Jimmy 4wd, 115,000 miles; Recently I noticed a strong vibration when in 4WD, no vibration in 2wd. I found that the rear joint (at the transfer case) of the front drive shaft has play in it. I am assuming that this is the problem. It has the appearance of a CV joint. Is that joint rebuildable or do I need to replace the shaft?
View 1 RepliesChevrolet - Suburban :: 1994 - Won't Engage The Front Drive Shaft
My 1994 Chevy Suburban will not engage the front drive shaft. It has an electric actuator and it will not engage. the transfer case engages but not the front axal. When I shift the transfer case into 4Hi or 4Low it will shift itself but the light will not turn on. I have heared rumors that you might have to manualy connect it to the battery and have a kill switch in the cab. What is the problem and should I connect it manualy?
View 6 Replies