Ford F-150 - 1997-2003 :: AC Compressor Clutch Engaging While Heater Is On
soo a friends 03 f-150 w/ the 4.6 has noticed the a/c compressor clutch engaging while heater is on. clutch engages for about 3 seconds or so and kicks back out consistently but only w/ the heater on. a/c dose function property when using a/c functions... Is this normal or does something need serviced???
View 3 RepliesFord Ranger / B-Series :: 2003 XLT - Compressor Making A Loud Click Noise Engaging Even Though Not Using Heat Or AC
I have a 2003 ford ranger xlt 4.0L and here recently my ac compressor has been making a loud click noise engaging even though i am not using heat or AC, so when it engages the rpms drop and almost wants to stall and it does this in about 10-15 sec. intervals, but when I am driving it acts fine. What is going on here, I recently had a vacuum leak and i found it and fixed it, and now this issue just started.
View 2 RepliesFord F-150 - 1997-2003 :: 1998 - 4WD Won't Engaging?
I am having a problem with my 1998 F150 4x4. The 4WD is not engaging. It is a manual shift. I have checked the transfer case by turning the drive shaft in 2WD it is free. When I shift into 4WD it is does not spin freely. So I believe that is OK. I have checked the vaccum diaphram. It will move the piston when I attach a hose and pull vacuum on the inboard hose barb. So I believe the diaphram it self is OK. I am not sure if the hoses and selenoids are OK. They look fine. However there is a constant vacuum on the inboard hose line (red/pink color) wether I am in 4WD or not. Is this OK? How can I check the selenoids. If all this is OK, the next thing I believ it could be is the shift fork in the differential. Is that a difficult job? Do you need to pull the whole axle out to replace it?
View 14 RepliesFord F-150 - 1997-2003 :: Auto Tranny Not Engaging
03 F150 2WD-I dropped tranny pan, changed filter, reassembled, put in 4 qts fluid. Checked dipstick, seemed to be overfilled, despite instructions to add 5 qts. Started truck, put it in reverse, went about 4 feet and then tranny wouldn't engage-ran it through all gears, just acts like in park or neutral. Over or Under filled???
View 4 RepliesFord F-150 - 1997-2003 :: 4wd Not Engaging / 2wd Solenoid Always Activated
Found out the hard way that the 4wd does not work on this new stupid truck. I've been troubleshooting the solenoids and confirmed that the 2wd solenoid gets grounded and will read ~12V when switched to 4wd; however, the 2wd solenoid always remains grounded and will always read 12V across the plug no matter if it's in 2wd,4hi,4lo. What would cause this? It seems that I would have vacuum going to the front differential from both the 2wd and 4wd solenoids at the same time, thus not allowing it to go into 4wd. BTW, this is on a '98, 4.6, turn dial 4wd
View 14 RepliesFord F-150 - 1997-2003 :: 2001 Screw - 4WD Not Engaging
I was out on the lake last night and after getting stuck in 6" of hard packed snow, I discovered that my 4WD is not engaging. When engaging 4WD, I do hear 2 clicks several seconds apart. I've checked the lines from the solenoids to the actuator and did not find any cracks. I have not checked the lines for vacuum yet but...
Last winter while engaging 4WD, I heard a load POP from the front end when I was turning the wheel and engaging 4WD. Ever since then, I haven't been sure if its been engaging but it was confirmed yesterday on the lake. Based on what I've read, I assume its either the actuator or the shift fork. Is it possible to remove the actuator and test it without disassembling the entire front end?
I went under the truck and had my wife engage and disengage the 4WD. The actuator was trying to move (maybe 1/16" inch) but the shift fork wasn't moving. Does this mean the shift fork is bad (frozen) or does this mean the actuator is bad (not enough power to move the fork)?
Ford A/C :: 2006 - Compressor Not Engaging?
I have an 06 F350 diesel, I had some work done on it that required the body to be raised on it. After I got it back the A/C didn't blow cold. I put it off for a while since I didn't need it. Anyways, the clutch isn't engaging so the compressor doesn't spin.
Things I have checked: Compressor rotates smoothly by hand. No blown fuses or bad relays (checked them all with meter). No results when jumpering the Hi/low press switches. Tried charging the system and the gage I got with the can goes to 80# and it maxed out. For the air gap on the clutch/shim idea, I tried pushing in on the clutch while it was running with a long extension to see if I could get it to engage, no luck
Ford F-150 - 1997-2003 :: 2000 - 4 Wheel Drive Isn't Engaging Properly?
I have a 2000 F-150 4x4 and the four wheel drive isn't working properly. It does work,but to get it to engage I had to drive in reverse for a couple feet then it locked it and everything was fine,pretty sure that isn't normal. What could be wrong with it? As soon as I turn the lights up on the dash,but the front tires don't spin.
View 1 RepliesFord F-150 - 1997-2003 :: 1999 - All Wheel Won't Engaging - Front End Is Not Pulling?
I just got a 99 Ford f150 with the 4.6. I am having problems getting the four wheel drive to engage. I turn the on the dash and the lights come on for four high and for four low. I have a 00 four by four and it works fine, so I know how to work it. In the 99 I can hear the transfer case engaging and everything clicks just fine just like it's going into fourwheel drive, but the front end is not pulling. The front drive shaft is turning but still the front end is not engaged. What the problem may be?
View 4 RepliesFord Ranger / B-Series :: 2003 - Repeated Serpentine Belt Replacement
2003 3.0 ranger... This will be my 3rd time replacing serpentine belt and if needed 2nd. time for idler, tension pulleys...NOT SURE WHAT TO DO, should i replace parts again?
View 5 RepliesFord A/C :: 1999 Expedition - Compressor Not Engaging
129k miles, first time ever noticed a/c compressor not engaging -- hadn't tried a/c in a few months, winter and all... Jumpered the cycle switch and determined it was low pressure situation -- took to dealer, who recharged/diagnosed leak situation. Compressor oil leak at front seal (needs replacement) and refrigerant leak at manifold hose assembly.
However - compressor running nice and quiet, after recharge, no problems, silent operation. Couple questions:
1. Ford manual says no need to replace accumulator unless there is evidence of compressor failure (which mine hasn't yet) -- is that 'evidence' trash in the orifice tube? If so, where precisely is it? I know it's in one of the tube assemblies, but can't visualize the location from the diagrams.
2. Since my compressor hadn't failed, still running quiet/smooth, can I just replace that and the leaky hose assembly and be done w/it?
3. Is this a job that's beyond the moderately skilled garage mechanic? I handle most of my own jobs with exception of heavy engine (i.e., heads, etc) but have never attempted a/c-related due to the refrigerant portion of this job. I'm sure I can obtain the proper vacuum equipment somehow, if it's something that's not too overly complicated...
Ford F-150 - 1997-2003 :: Selector Switch Does Not Light Up When Engaging Four Wheel Drive
My selector switch does not light up when engaging four wheel drive on my 98 f150,could this be my GEM module gone bad ?
View 6 RepliesFord F-150 - 1997-2003 :: 4 Wheel Drive Not Engaging / Indicator Lights Are Not Flashing
My 4 wheel drive is not engaging on a 2001 F150. The indicator lites on the dash illuminate to suggest that the truck is in 4 wheel drive but sigh...it stays in 2 wheel drive. No gross sounds and the indicator lights are not flashing. Could this be a fuse or a relay issue of some sort. What else should I try?
View 3 RepliesFord F-150 - 1997-2003 :: 1998 XLT - Starter Hitting And Engaging But Engine Not Starting
I Have a 1998 f150 4.6 XLT and recently it has been starting on and off. sometimes i will try and start it and wham! it starts right off. then other times I just here the starter hitting and engaging but nothing. Replaced the starter, solenoid and still nothing. It does have an alarm system but the alarm light doesn't come on, also had battery charged and its working fine. I am really fed up with this beautiful looking POS. Oh and the wiper motor needs replace.
View 5 RepliesFord Ranger / B-Series :: 2001 - AC Compressor Not Engaging
I have a 2001 ranger 4x4 4.0 L with what appears to be a unique a/c problem. Over the last week the compressor will not kick on immediately and seems to randomly decide when it is going to function. Once it starts, it runs properly and cools well, until I turn the engine off and it is back to square one. We have checked the coolant level and it is full. the problem seems to be getting progressively worse....At first it took about 15 minutes for it to decide to trip, then 30 minutes, and yesterday I drove for over an hour and the compressor never kicked on.
View 4 RepliesFord Super Duty (1999-2016) :: AC Compressor Is Not Engaging
2012 6.2 XLT 50,000 miles with manual single zone controls. I haven't had time to work on it yet, but it seems that my AC compressor is not engaging. The dash controls light up normal, fan comes on, etc. I am just looking to see if there are any common failure points. I know it COULD be low on charge, clutch could be bad, etc. I am just checking if there is a common failure with these trucks AC system.
View 10 RepliesToyota - Rav4 :: 1997 - After Replacement Of Timing Belt And Water Pump Noise Like Metal?
I had the timing belt, water pump and thermostat replaced on my '97 RAV4. The next morning while braking at a red light I heard a rapidly repeating sound that sounded like metal on metal. The car never made that sound again but now I'm hearing a noise coming from the passenger side of the engine (timing belt side). When the engine is cold I don't hear it. After driving a while its starts, then once the engine warms up it generally goes away (except for this morning which was the coldest morning since this started, temps in the 40s).
I was only hearing the noise when the car was stopped either in drive or reverse (reverse sounded louder) if I lightly let up on the brake pedal (there's no pulsing in the brake pedal). Once under way the sound goes away. This morning it was making the sound virtually every time I came to a stop (once the car warmed up) even with my foot firmly on the brake pedal. I recorded the sound Saturday while standing still with the car in drive and my foot slightly easing up on the brake pedal. The sound starts at the 20:30 mark, what it could be?
Ford F-150 - 1997-2003 :: AC Compressor Is Missing
So today, I planned on switching the belt, idler pulley and tensioner since at least two of them are making noises. After taking all of the stuff off, belt, idler pulley and tensioner... and since I always compare parts I buy to parts that were in, making sure they are identical and I didn't order the wrong one. So first up I checked my tensioner and the position of them or angles are different, completely different.
So Google it to view a few diagrams and bang! it hits me... the one I took out from my F150 is for a non-AC... so back into the truck and I'm looking. Didn't have to go far when I realized that my AC compressor is missing!!!!
I keep looking around and I see that yes, I did have AC in it before I got it; because the guts are there but sliced! Great, so the job went from easy and easy I mean buy compressor and install; but now since the guts were cut, the PO sliced the thing out simply put.
1.) What are the bolt sizes that hold the compressor in place?
2.) Is there a wire connector on the compressor? or no?
Ford F-150 - 1997-2003 :: AC Compressor Not Cycling After Replaced
My AC compressor failed so I replaced it.
I put in 1 can of R134, and I don't see the compressor cycling.
How do I remove the connector to the accumulator so I can jump it and force the AC to run.