Ford F-150 - 1997-2003 :: New Starter Won't Disengage?
The starter on my kid's truck doesn't disengage and continues to turn over after the ignition is off. I have seen a few posts on this but have yet to find a clear troubleshooting path and it seems a lot of money wasted on new starters, solenoids and new ignitions.
View 4 RepliesFord F-150 - 1997-2003 :: Overdrive Switch Won't Disengage?
My father-in-law has a 01 F 150 4x4 with the 4.6 automatic and his overdrive button will not disengage. Is there a fuse or something on the tranny that he can look at to get it to work?
View 7 RepliesFord F-150 - 1997-2003 :: 1999 - New Starter Won't Disengage
Starter problem with my 1999 Ford 5.4 f150. Last few days I’ve had to cross the solenoid terminals in order to start up. After replacing the solenoid the starter would not disengage. Put the old solenoid back on, crossed term and the starter did the same thing. Bought new starter (what a job finding the upper bolt) replaced old one, and I’m still hearing the starter running along with the motor. What else?
View 11 RepliesFord F-150 - 1997-2003 :: 2000 - 4 Wheel Drive Will Not Disengage
I have a 2000 ford f-150 4 wheel drive that will not disengage, I am down here in south fla where and don't put it in 4 wheel drive much, but yesterday I put in 4 wheel drive and I heard the click click and it engaged I put it in drive and drove it about 5-10 miles parked it and turned the switch to 2 wheel high and got out , got back in the truck turn her back on and the 4 by 4 lamp came one went off then came back on and stayed on and it still in 4 wheel drive and wont disengage.
View 4 RepliesFord A/C :: Compressor Clutch Making Noise / Would Engage Or Disengage
The A/C in my truck stopped working last year, and this year I intend to fix it. I believe the problem is with the compressor clutch because it was making noise as it would engage or disengage. It was making this noise for a good year or so, and then one day the noise stopped and I have no A/C. So I am only assuming its the clutch.
View 4 RepliesFord Ranger / B-Series :: Clutch Start To Engage / Disengage At Half Way Point On The Pedal Travel?
So I just had my entire clutch replaced while another repair was taking place. What I've noticed is the "clutch engagement" has changed. Where as I would have the clutch start to engage/disengage at the 1/2 way point on the pedal travel is now the last 1/4 of the pedal. Is this a "normal reaction to a new clutch that just takes getting used to or is there an adjustment I can fine turn it with? Do I just have to wait for it to "break in"? When I replaced the clutch on my dearly departed 94 ranger, I replaced the bearings & disc only reusing the pressure plate and did not have this issue.
View 3 RepliesGolf IV / Jetta IV :: Intermittent AC - Compressor Would Engage Then Disengage
I have an 02' 2.0 Jetta Wagon, and the A/C is having some issues. Since I know close to nothing about A/C systems, I took it in to a few places to have it looked at. I've had the whole system Evac'd and recharged, and have had the low pressure fitting replaced (apparently there was a slight leak there), and the system is still not working.
The A/C worked fine when I first purchased the car a few months ago. Shortly after my 800 mile trek from Oregon, back to home, the A/C started to only work intermittently. The compressor would engage, then disengage, repeat...It seemed like a bad idea to keep trying to use it in its sad state so I stopped using it altogether. As I said, I had the system emptied and recharged, but it still only works intermittently. It sort of follows a pattern where upon start up it works longer, and switches on and off at shorter intervals, until it doesn't engage at all.
There are no strange noises from the compressor, and when it was hooked up to the machine, it proved to be performing its function well.
Passat (B6) :: 2007 - Parking Brake Won't Engage / Disengage?
owner of a 2007 Passat 2.0T wagon, 6 spd manual, 32k km's. (leased) I'm having repeated persistent parking brake failures (won't engage, or won't disengage).
-About two months ago the parking brake would not disengage, error message on the MFD, yellow warning light and warning tone. Called roadside, finally got it disengaged by removing one terminal from the battery. Took it straight to the dealership, they "fixed" it by resetting the computer.
- The next day I have auto hold engaged, parking brake did not disengage when I turned the car back on. Had to turn engine on/off several times before it disengaged.
- Took it to the dealership again, had to get a rental car over a weekend while they diagnosed the problem. This time they changed some wiring and replaced the parking brake button.
- Next day the parking brake engaged ok but wouldn't disengage. Same routine on/off/on/off to get it to disengage.
- Back to the dealership again, they decided to replace the brake control module but didnt have stock.
- Last week I took the car back in (4th trip for this issue), they replaced the module and said it was fixed. Next day my wife got stuck in a parking lot with the parking brake stuck on.
- Called the dealership last friday and asked them to come pick it up this time, as my wife and I are sick of the inconvenience of this issue. (we share the car, both work, and also have a child's daycare to schedule around)
The problem is intermittent but not difficult to cause a fault. Can be caused when engaging, disengaging, or when the PB kicks in from auto hold when turning the car off. I try not to use it, but sometimes is necessary (parking on hills etc).
The dealership doesnt seem to know the problem and are just throwing parts at it. What recourse do I have for repeated problems? The manual recommends using this parking brake EVERY time the car is parked, so I don't think it's too much to ask to have it working properly.
Ford F-150 - 1997-2003 :: 2003 4x4 - Tranny Doesn't Engage
I have a 03 4x4 5.4lt supcab with 154k miles. I replaced the shift motor about 40,000 ago but it has always been tempormental like I had to engage it in 4lo in N and then shift to 4hi to keep it in 4hi. Now fast forward to today. Went to shift to 4lo in N and it didn't shift. I only heard the relays click once and then it wouldn't shift into any gear even though the indicator was on PRND123. Didn't matter.
Also, Park didn't engage and the speedometer acted like it was engaged in RN and D. No movement what so ever. I think it might be the shift motor that shifted part way and is stuck in between gears. Is this possible? I drove fine to the dirt road and I haven't had problems other then the shift motor being touchy. I don't want to pay for a new tranny if it might be the shift motor.
Ford F-150 - 1997-2003 :: Cannot Get 4x4 To Engage
I have a 2003 F150 5.4liter 4x4 and when it is cold I can not get the 4x4 to engage. It is a manual shift for the transfer case not electronic. It shifts but does not activate the 4x4 when it is cold. The 4x4 does work when the temp is about 30 degrees or better. Where to start?
View 1 RepliesFord F-150 - 1997-2003 :: 4x4 Won't Engage When Cold
I've got a problem with my 4x4 not engaging. I've been ready and re-reading all the related posts and threads and am still confused. Here goes. Early in the fall I had no problem shifting in or out of 4wd. Then when it got well below freezing up here, it stopped working. I had it in a warm shop and all of a sudden it worked fine. After sitting outside again it wouldn't work.
When it was warm, I had no problem shifting in and out of 4x4, dash lights functioning as normal. As it got colder it only seemed to work if I really pulled quite hard on the stick and the 4Low indicator didn't work but 4Low was obviously engaged. Now after another day or two outside, nothing happens at all. When the diff does engage, shifting out of 4x4 is never a problem.
Transfer case seems fine as the front drive shaft turns when I shift into 4H and drive forward. After researching a bit, I crawled under and pulled the blue line off the actuator and had someone shift into 4H, I couldn't feel any vacuum so figured it must be the engage solenoid especially since, shifting out of 4x4 is never a problem.
My question now is, shouldn't the lights on the dash be on even if the solenoid isn't working? I am now starting to wonder if its the sensor switch on the transfer case but I don't see how freezing should affect the switch and would think I'd have issues shifting out of 4x4 as well as in. If I put it in 4X4 and test for current at the solenoid and it is there, can I assume that the switch is fine and the problem is in fact the solenoid?
Ford F-150 - 1997-2003 :: 4x4 Slightly Trying To Engage?
Ok, have a 2003 fx4 auto trans with manual 4x4 ...I notice more and more that say at intersections, when I start out either turning left or right it feels like the 4x4 is slightly trying to engage, or a chuttering feeling..best that I can describe it. any thoughts, I have 106 K and do need to change out the diffential oils etc.
View 9 RepliesFord F-150 - 1997-2003 :: 1998 - 4wd Won't Engage?
I have a 98 f150 4wd with manual shift on floor (msof) and the 4wd will not engage. I've done research and I've learned quite a bit but still have an issue. In All the research I've done I have learned about
View 3 RepliesCorolla / Matrix 2009-13 :: Clutch Creaks Like Old School Bus When Engage And Disengage
I think this is just poor dealer service, but I need a sanity check.
I have 93k miles on my Corolla. My clutch creaks like an old school bus when I engage and disengage. It's done this pretty much all along and I think I had another dealer successfully lube the linkage to quiet it down -- it was miles and years ago so I may be misremembering that.
My current dealer says all they can do for it now is REPLACE THE WHOLE FREAKING CLUTCH assembly to the tune of $1,300. Clearly, I'm not doing this. As long as it works, I ain't replacin' the clutch, but, REALLY?
Golf IV R32 :: Inconsistent Clutch Force - Can Engage / Disengage The Pedal With Little To No Effort
I went driving today and for a moment I could engage/disengage the clutch pedal with little to no effort. It goes back to the normal force after 3-4 shifts.
It's the exact opposite of what's happening in this thread. [URL] ....
Ford F-150 - 1997-2003 :: 1999 - Key Won't Engage Lock?
1999 F-150 Sport 4x4
So the deal is I had to use a slim jim to open up my truck door the other day. Door still locks/unlocks fine, only not with the key. Key will still fit & turn the barrel without any prob. just doesn't engage the lock. Took the door panel off and it looks as if the Rod that connects the inside of the key barrel to the lower (part)? not familiar w/name. has come loose.
Looking for a diagram/picture of how it should look to get everything put back together so the key'll work again. Sucks unlocking passenger side and climbing over to open driver door.
Ford F-150 - 1997-2003 :: 4x4 Won't Engage / No Lights Coming On
Just tried to engage my 4x4 today to see if it was working and nothing. It is the electronic shift on the fly. I started checking the vacuum hoses and found one that looked like a mouse chewed threw part of it and repaired that line. Still no 4x4. So...there are no lights coming on, no sound from the transfer case shift motor and no noise of any kind when cycling the shift ....
I pulled the connection apart at the shift motor to test for voltage with 2hi and truck running and no 12volt. I tested all the pins but not sure if i did it correctly. Also the shift motor itself is rusty on the outside casing. What pin to test for voltage?
Ford F-150 - 1997-2003 :: 4 Lo Sometimes Will Not Engage Or Shifting Rough
I have 1999, F150 5.4L with electric 4wd shift. I put it in 4high just fine and smooth. Now 4lo on other hand rough shift if it goes in 4lo, sometimes won't engage but 4 high works fine. What's the cause
View 2 RepliesSubaru - Legacy - Sensors - Starters :: 2005 - Starter Engage / Disengage At Start Up?
This past monday morning I got in my 05 Legacy GT w/ 82,000 miles. When I turned the key it acted as if the starter engaged for a second then disengaged and made the typical motor winding sound. I tried it several more times with the same result. So I reluctantly called my local repair shop and had it hauled over for what I thought was possibly a bad starter. The mechanic went out to check it to see what it was doing and when he did, it started right up…..!! He said that when it started it ran as if it had been flooded for a minute or two then cleared up. Throughout the day he drove it around and started it about 20 times and said it “appears” to be ok. It’s a small shop that I trust with my other cars but they don’t have the tech to pull codes on a subaru. So my question is, what was the cause of this issue? Neutral Switch? Cam Sensor? or a Fluke?
View 1 Replies