Golf/GTI VI :: How To Get Gauge Needles To Run A Cycle On Start Up
How do I get my gauge needles to run a cycle on start up? It is even possible?
View 2 RepliesGolf VI R :: Clicking Noise When Needles Sweep Back From Start Up
Hearing a definite (and quite annoying) clicking sound as the needles sweep back from the start up. Dealer says it is normal. How difficult is it to turn it off?
View 7 RepliesFord F-150 (2004-2008) :: Gauge Needles Vibrate When Truck Is Turned On
2004 F150 Supercrew
44400 miles
So I turned on my truck today and the needles acted as if they were possesed. The went under the "starting points" and vibrated there for about 5 seconds or so... Very strange. I also have been getting sluggish power from the truck. Mainly between 2000 and 3000 rpms.. Sound like a diesel at times.
Ford F-150 - 1997-2003 :: Electrical Malfunction - After Start Up No Gauge Moves / Temp / Oil / Battery?
I own a 1997 ford f150 V6 engine and I have problems with the electrics. I turn the key on and the engine starts up runs great but I then look at the gauges and not one moves at all the. No fuel when i have just filled up,no tep,no oil,no battery all read nil. I went a drive and the speedo reads 0 it does not move but the truck drives great. Could it be a fuse, does a fuse control the gauges, which one it could be. I have lifted the hood and under the hood on the drivers side there is a box with small and larger fuses.There is one that is very small and the colour is white that's blown. Would you no what that fuse is for.
View 1 RepliesFord F-150 - 1997-2003 :: Fuel Gauge Doesn't Go Past Half Tank And Won't Start
So my truck felt gutless somtimes, wouldn't start Every couple days , and Fuel gauge stops at half tank won't show full, so I went n bought a new fuel pump..... Well shoot nothing changed . I guess my next move is pull the dash off n fix gauge? It used to be a reliable truck . Now Im not comfortable to let wife drive it . I also pulled the chip to see if that had to do with not starting, also theft light blinks normal. I'm going to get some connector grease n redo all of my wires to c if there's just connection issues.
View 6 RepliesFord F-150 - 1997-2003 :: Truck Won't Start / Code P0174 Keeps Coming Back
I have a 2001 F150 XLT Supercab,4.2lt, automatic, 2WD.
I was able to start it about a month or so ago but it was really hard to start. I had to use starting fluid to get it started, and it was still tough to get it to start, but once started and warmed up it ran fine.
Now I tried to start it again and it kicks over and wont start. I tried the same with the starting fluid and it almost starts and dies. I think I used a little too much starting fluid because after a while of trying and spraying starting fluid, I got a hard backfire that sounded like a shotgun that was strong enough to pop off the MAF Sensor and throw it about 10 feet. I nearly crapped my pants! It looks clean and undamaged but I hope I didn't damage the MAF Sensor when if hit the ground.
The truck sounds like its starving for fuel, so I'm not sure if the fuel pump relay is going or has gone bad, or if its the fuel pump. How to check these items without making it a huge project to diagnose?
Once I can get it to start easily, I have a couple of questions about the trouble code that keeps coming back P0174. That was the original problem with it before the starting problem.The diagnostic says that it is lean in bank 2 but a mechanic friend of mine said something about a vacuum leak.
Ford F-150 - 1997-2003 :: 1999 V6 - Engine Will Miss In A Pull And Die Sometimes But Start Back
Engine will start and run but will miss in a pull and die sometimes but will start back, we hooked it to a scanner and it said (intake wiring) it wasn't a dealer hook up just a gas station garage, we have already done plugs and wires.
View 2 RepliesChrysler - Towncountry :: 2005 - Gauge Needles Move Up And Down When Car Started
I drive a 2005 Chrysler Town and Country with just over 47,000 miles. I noticed that during the last few days, when I start the car, the needles on the fuel, speedometer and temperature gauges go all the way up and then back down. After they finish moving, I then see the engine lights go on and off. Normally, when I start the car, just the engine lights go on and off. The movement of the needles on the gauges is new. This is now happening about every other time I start the car.
The car itself seems to be starting and running just fine. I haven’t noticed any drop off or change in performance. What could be causing this oddity? Is this a warning that something worse is about to happen?
GTI 337/20th Anniversary :: Gauge Cluster Needles Don't Move As Soon As Car Turns On
I have a 2005 mkiv GLI and my gas gauge, temp gauge, and information display stopped working when the car is running. They work when the car is on auxiliary but not while it's running. The lights all work on the cluster all the time but the needles don't move as soon as the car turns on.
View 3 RepliesFord F-150 - 1997-2003 :: 1998 - Suddenly Died / Cranks But Won't Start - Back Link Error Code
My 4.2L died all of a sudden, it cranks but won't start. Checked the harness side to coil packs, pos. signal but no neg. Tried a code reader keeps coming back link error. Does this mean PCM is fried?
View 4 RepliesGolf/GTI VI :: Clicking Noise When Needles Sweep Back
Hearing a clicking noise as the needles sleep back after their start up dance. Dealer claiming it is normal ..
View 2 RepliesGolf/GTI VI :: Gauge Needles Sweeping - Heads Up Display Resets During Driving
I am going down the highway at 70-75 mph listening to music I look down and see my gauge needles sweeping across the faces of the gauges. The heads up display resets. Nothing else in the car changes radio keeps playing, speed doesn't change. Nothing else changed.
Mods that have affected electrical system:
Interior LEDs (front dome, rear dome, footwell lights, glove box and trunk)
1 JL 10 inch sub with JL 900/5 amp
Honda - Accord :: Instrument Panel Temp Gauge / Thumping Makes Needles Bounce Around
98 accord v6, when we first got it about a year ago the temp gauge was a little erratic. Sometimes it would stay all the way down (cold) after driving for awhile. You can take your finger and thump the plastic and it would jump up to normal. At first it was only temp, but now all gauges including gas level are not working. Odometer still works right but the speedo goes to about 45 and stays there. Thumping still makes the needles bounce around.
View 10 RepliesFord F-150 (2004-2008) :: 2005 - All Needles Shake For 5 Seconds At Start Up Then Ok?
I have a 05 f150, on initial startup ALL of my needles shake for about 5 seconds and then return to normal operation. What is wrong.
View 2 RepliesFord Escape / Hybrid :: 2003 V6 Pegs Needles On Acceleration
Not always & seemingly at random. Just like at startup after battery reconnect.
Most searches come back only with incidents at startup only. Recommendations say battery &/or alternator. Battery is Optima Red that's been in there maybe 6-7 years and all connections are clean & reads 12.48 at rest.
Alt is a AC Delco new unit replaced 20k or so ago & reading 14.24 at idle with or with out any accessory drain on the system or RPM.
Troubling thing is a code for coil misfire on # 5 which put it into limp mode (I erased & so far hasn't returned) & some comm issues with the Inova 1403 that I'm using.
Nissan - Pickup :: 1997 - Gas Gauge Drop To All Most Empty After Hitting Bump Then Go Back To Normal?
1997 Nissan pickup 2.4 liter auto.gas gauge drop to all most empty when driving.then i can hit a bump in the road and it will go back to normal.
View 2 RepliesFord F-150 - 1997-2003 :: Cannot Get The Oil Gauge To Read Pressure
I changed the sending unit and replace the oil filter with a motorcraft unit and still can't get the oil gauge to read pressure. Since it is a gear oil pump I don't believe it is the pump.
View 2 RepliesFord F-150 - 1997-2003 :: Oil Pressure Gauge Drops To Zero
I have an 01 F150 Lariat Supercrew 4x4 with the 5.4 Triton. The truck has 222,000 miles on it. Recently, I have noticed that when I am stopped at a stop light/stop sign while in gear, the oil pressure gauge drops to zero and the light comes on. As soon as I let off the brake and give it gas, it pops back up to normal. While driving, the needle never moves and stays consistent until I stop again, and back down to zero it goes.
If I put the truck in Park, the pressure goes back to normal. Same with neutral. It seems it is hit or miss and does not do this all the time, but I just wanted to see what your thoughts are. After doing some research I am leaning towards an oil pressure sensor/sending unit.... The truck runs perfectly fine, I just want to make sure it is not something more serious.
Ford F-150 - 1997-2003 :: Gauge Cluster Dead?
My dad has a 97 f150 ext cab and the gauges are dead.... What would cause this? I've checked the faq but didn't see anything.
View 3 Replies