Ford Super Duty (1999-2016) :: 2 To 3 Seconds Delay Of Engagement When Putting Truck In Reverse
Ok I am getting a (6R140) transmission behaviour every morning drive or later in the day after the transmission cools down. I am experiencing a 2-3 second delay of engagement when putting truck in Reverse. This happens EVERY time whether transmission is cold or warmed up. I am also having very hard/harsh shift fares going into 3rd gear and 5th gear with the 3rd gear being the worse of the two. Also experiencing these hard/harsh shift when downshifting as well.
I took the truck to my local dealer and I let it sit over night in their lot so they could experience it at its worst after sitting all night. They definitely recognized the issue. But since it wasn't throwing and codes. I find this an unacceptable answer.
I brought to their attention that this issue is well documented online and a lot are having success with performing TSB 11-7-10 (replacing solenoids) They looked it up and said my truck doesn't apply to TSB because of the build date. My window sticker and VIN # implies the truck was built 10-11-2010. Which from my understanding, does fall under the required TSB. None the less, I insisted that I know I'm out of warranty and I will just pay to have this TSB performed. They refused.
What should I do? I know everyday I run my truck with this issue it is decreasing the reliability of this transmission and it will most likely end with a full transmission replacement.
Ford F-150 - 1997-2003 :: Truck Idles Very Rough - High Rpms Fine - Reason?
So my "farm truck" is idling very rough, to the point that sometimes that it stalls out. At high idle it runs fine but when its at a idle its very rough. Its been running fine until probably a month ago or so and its just getting worse. What it could be? I am thinking it might be that something is dirty but i just dont know where to start with figuring out what the problem is.
View 9 RepliesFord F-150 - 1997-2003 :: 1999 - Idling High Which Returns To Normal At A Stop After 3 - 5 Seconds
I have a 99 4.2L 5 speed reg. cab swb. It recently started idling high (which returns to normal at a stop after 3-5 seconds). While in neutral and in motion (coasting) the idle is around 1500-2k (idle=no throttle input from me). The first time it did this it took a while to start (7-10 seconds) and smoked like you wouldnt believe for about ten seconds. Smoke cleared, eyes returned to normal size, heart rate returned to "normal", but the high idle remains. Drives me nuts. No CEL, no codes, just a fat bald man scratching his head and a little nervousness.
View 5 RepliesFord F-150 - 1997-2003 :: When Engine Revs It Continue At High RPMs For About 10 Seconds After Letting Off The Throttle
2001 F150 5.4 4x4 148K... I recently replaced the intake manifold on this truck and when the engine revs it wants to continue at high RPMs for about 10 seconds after letting off the throttle. When driving, it almost wants to go faster and the gas mileage is really bad. Had some codes come up and took it to AZO and had them checked. P0171 & P0174. Guess I need to do some testing on the MAF and injectors.
View 2 RepliesToyota - Camry :: 1994 V6 Starts / Idles Very High And Within 15 Seconds Will Die
I've got a 1994 Camry V6 that I am swapping transmissions from automatic to manual. Before the swap, the engine ran fine and started first time every time. Now that I have everything back together, the car will take many times of 10 seconds or longer cranking to be able to start. Once it does start, it idles very high and within 15 seconds will die. If, during the time it is running, you touch the gas at all, the car instantly dies. I've got CEL's for CPS and TPS. I have replaced both sensors numerous times, checking with a voltmeter they are within spec as are the wires, I have replaced the ECU and wiring harness.
View 5 RepliesVolvo - 240 :: Engine Idles High For 3 To 5 Seconds And Then Immediately Dies On Cold Start
A minor but persistent (year-long) rough idle on my 1991 240 has quickly turned into a Cold Start Nightmare over the past month:
SITTING HOURS OVERNIGHT (50 to 60-degree temp. overnight) - When I attempt to start in the morning, the engine idles high for 3-5 seconds and then immediately dies. To successfully start, I must keep pressing the accelerator pedal at least half-way down for 2-3 minutes. The engine sputters, almost backfires, shakes, lopes, almost dies, etc. After 2-3 minutes, everything runs just fine.
WARM ENGINE SITTING - Once the engine is warmed up, it will consistently start without problems. Still a slightly rough idle, but OK. The car does not die.
I have changed the battery, coolant temp. sensor, and spark plug wires.
Elantra XD (2001-06) :: 2004 - Hard Jolt When Putting Into Reverse
My 04 elantra starting acting up yesterday. It has started jumping/ rocking entire car when putting in to reverse. What might cause this problem. It is hard to describe what it is doing being I know nothing about cars. It is a large jolt when going into reverse.
View 4 RepliesExplorer :: 2001 Ford Idles Very Low In Drive And Reverse Then Shuts Off
I have 2001 ford explorer sport.. it idles very low in drive and reverse and then shuts off.. What has been replaced:
1. Torque converter
2. All new plugs n wires
3. Map or mass sensor
4. Iac valve
5. O2 sensors
6. Fuel filter
7. Air filter
8. Throttle valve/sensor
It does not run bad only when u come to a red or stop light.. Had the vacuum tested and no vacuum leaks.. also no check engine light has come on and no codes have popped up when tested..
Ford Ranger / B-Series :: 1997 - Idles High And Accelerates On Its Own Sometimes
My ranger has a 3.0 v6 engine it idles high and accelerates on its own sometimes. Sometimes its more often then others. I turn my key about three times thinkin its reseting the computer and stop it and it does. But I keep hitting a dead end and don't know what to do about it.
View 10 RepliesFord F-150 - 1997-2003 :: 2001 - Blows Fuse Touching Gas In Reverse
Got a 2001 F150 XLT 4x4,4.6L, When you start the vehicle it seems to run a little rough you can drive around with it OK. Soon as you put it in reverse,It starts to really run rough..touch the gas pedal and fuse position #30 blows.
This fuse is for : Passive Anti theft Transceiver, Cluster Ignition Coils, Powertrain Control Module, Relay Coil on Plugs, Radio noise Capacitor, ECC Diode.
I have checked cables and connections, all seem ok...Relays are fine. Nothing seems burnt on the cable running from the engine to the exhaust. I don't see any wire breakage in the tilt Column.
Cant find a short if it is one.. Even removed the aftermarket Remote starter from the circuit ... still blowing that darn fuse.... What to check now, or what it could be?
Elantra XD (2001-06) :: 2004 - Transmission Making Slight Grinding Noise When Putting Into Reverse Only
No codes, transmission makes a slight grinding noise when putting it into reverse only. Has a slight bump from 1st to 2nd. I flushed 16 quarts of the sp3 through it. Been researching and see a lot of talk about the output and input sensors. Not my car but my sisters. Needs axles, timing belt water pump, ps return hose, plus have champions in there and old ass hyundai wires.... thing does idle rough, motor mounts are new.
View 1 RepliesFord F-150 - 1997-2003 :: 2001 - High Output On Takeoff
I have a 2001 5.4 4x4 supercrew with 300,000 miles.. This truck is my baby. Recently when I start it up and after putting it in gear and begin taking off my engine is loud as if I am revving the engine without any indication in the rpms. I want to say it starts out on the trip a tad sluggish. Is there anything I can do to eliminate?
View 1 RepliesFord F-150 - 1997-2003 :: Misfire On Cylinder 3 And 8 After Putting New Trans
I've got a 1997 f150, 4.6. It sat for year and a half, trans went out and it wasn't my primary vehicle so wasn't to worried about fixing it. Until now, well got a new trans put in it, fired it up. And had a misfire, #3 and #8. Changed plugs and wires, same thing. Getting spark at the plug. So I changed both injectors, still nothing! I'm kind of stumped now.
View 4 RepliesFord Super Duty (1999-2016) :: 2003 F350 - 4x4 High Not Working / 4x4 Low Putting The Truck In Neutral
I recently bought a 2003 F350 super duty dually automatic transmission 6.0 deisel 4x4. The 4x4 is not working. with the hubs in auto when i flip the switch to 4x4 high nothing happens.The same with 4x4 low putting the truck in neutral. I can only find 2 fuses using the owners manual that says anything about 4x4 and both of them check out good. Also the owners manual says when i turn on the key I should see a 4x4 light and a low range light momentarily. Neither of these lights are showing up. I don't hear any clicking or any noise of any kind when trying the 4x4.It acts like an electrical issue but not sure where to start.
View 7 RepliesFord F-150 - 1997-2003 :: Brake Bleeding After Putting In A New Master Cylinder?
...Is there anything special that needs to be done for brake bleeding after putting in a new master cylinder? I decided today to flush my system with my vacuum bleeder and now my pedal slowly falls to the floor at a light...No problems in a panic stop or otherwise, just falls to the floor slowly when braking...no leaks, so I'm assuming a master cylinder is an order....
View 14 RepliesFord F-150 - 1997-2003 :: New Clutch - Grinding Noise When Putting It Into 1st Gear
2000 Ford F250 crew cab 4 x 4 with 7.3. 6 speed transmission. I just had a new clutch installed and now I am have a grinding noise when putting it into 1st gear and when I change from granny to first it will grind also. I did not have this issue before having the clutch replaced. I have also just had a new hydraulic clutch kit installed.......
View 1 RepliesFord F-150 - 1997-2003 :: 2001 - Rear Differential High Gear Noise
I just came back from a long trip and during the 400 miles drive I started to hear noise coming from my differential - kind of like a constant high gear loud noise. I will hear this noise when I start to accelerate and it will only gets louder and louder as I go faster and faster. I had a pinion seal leaked fixed last week and I checked the fluid and it is full.
View 9 RepliesElantra XD (2001-06) :: Idles Really High For A While After Start
So, among other things my 06 Limited is acting a little weird when I start it up. If it's cold, as in hasn't run in a few hours, not so much temp, it idles really high for a while. I wait for it to come down under 1000 before rolling out. It makes a funny noise too. Sort of a tick-tick-tick with a little whine behind it. What it could be? How much it'd be to get it fixed? I'm past my 100,000, 107,000 to be exact. Of course the issues pop up after the warranty is up!
View 3 RepliesPrius (2001-03) :: Engine Idles High When Drive For About 20 Minutes
I've read a lot on hear but can't seem to find what I need. I just replaced one of the battery cells. Now when I drive for about 20 min the engine idles high and the energy read out stops charging the hybrid battery. The AC recirculation turns off on its own. I have a few codes. the O2 sensor and cat code. The p3006. I had one cell that i didn't replace that was reading 6.9 volts. I thought that it would charge back up on its own. We went of vacation for 2 weeks and the car didn't get driven. I found out that's not good for an older prius.
View 5 Replies