Ford F-150 - 1997-2003 :: Driver Side Brake Light And Turn Signal Doesn't Work
I have checked all wires for krosion and fuse's are good so confused! Just put brand new tail lights bulbs in! The top one comes on as a running light but nothing else works. I also checked under hood fuses too!
1.Only Hazard light that works is on the Right Front passenger side.
2 Drivers side Brake Light & Turn Signal Doesn't Work. But passenger works fine! Left turn signal is out and blinks really fast!
3.Passenger Side Overhead Outside Light on cab is out . Okay that's probably just a bulb!
Intrigue :: Passenger Side Turn Signal Does Not Work
My passehger side front turn signal does not work. I am not getting power to the turn signal part of the bulb everything else works running light cornering light ect. except no power at the plug for the turn signal that plugs into light bucket assy. The arrow in the dash blinks fast as if the bulb was blown, getting power to the rear but not the front....
View 5 RepliesFord - Explorer :: 2003 - Left Rear Turn Signal Brake Light Will Not Work
My wife's 2003 sportrac has developed a problem. The left rear turn signal brake light will not work. The tail light does. When you turn on the left turn signal the front bulb and the dash light flashes real fast. I have changed both, the front and rear bulbs with no luck. I've read on here about the tilt steering column deal. I have moved the steering column while operating the turn signal with no change.
View 4 RepliesFord F-150 - 1997-2003 :: Right Turn Signal / Brake Light Not Working - MFS?
I have a 1997 F150 5.4L 2wd long bed w/ tow package.
Right (passenger) turn signal/brake light is not illuminating. The tail light on the right side does illuminate when headlights are on. (Same Bulb) All other lights are functioning properly.
When the MFS is in the right turn position the right arrow on the dash flashes and clicks faster than normal.
This happened about a month ago and it turned out to be a blown fuse. The fuse was for the trailer lighting and right turn/stop light, found in the small fuse box under the hood that only holds 2 fuses. Problem solved temporarily...
Now the issue is back, Here are some things I've tried so far:
Replaced the fuse again; Turns out the fuse didn't blow this time, but I tried a new one anyway.
Cleaned the ground for the rear light wiring harness.
Replaced the bulb.
Replaced the relay.
Checked continuity on multi-function switch, right turn position reads 2.8 ohms IIRC
Repaired pin #5 on the multi-function switch wiring connector (wire backed out, right turn related)
Replaced the bulb socket.
Inspected the wiring for broken insulation/exposed wires from that socket to under the hood, didn't find anything exposed. All wires are still in the loom.
I replaced this wiring harness and wiring looms about 6 months ago because the previous owner had done a hideous splice job for unknown reasons, so it should be ok. Should I get a new multi-function switch, or try something else? If the switch doesn't work what's the next step?
Kia - Rio :: 2003 - Passenger Side Rear Turn Signal Stopped Working
This passenger side rear turn signal stopped working two weeks ago after a period of intermittent operation. All other lights work. I replaced the bulb and fuses. I am not an expert about auto electrical. The relay box is under the hood on the driver side. There is another fuse box under the driver side dash left of the steering column. Auto parts stores want to sell me a "flasher" that, well, I can't figure out where it goes. The "TNS relay" in the relay box is smaller than the flasher the parts stores are selling me. My little owner manual is not useful. Any theories about what is wrong? Wiring? Relay? Where does that flasher go? Somewhere under the dash?
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Signal Light Will Not Work Occasionally While Making A Right Hand Turn
On the final stages of prepping my truck for sale. I noticed today that occasionally while making a right hand turn the signal light will not work when you put the lever in the locked position (no dashboard arrow to the right and no front/rear light). I can pull the stalk upward, but not lock it, and it always works correctly. I am thinking a bit of corrosion on a switch, but I thought I would check and see if others have run into this.
View 1 RepliesFord F-150 - 1997-2003 :: No Brake Lights But Turn Signals Work
This has been driving nuts for 2 days.... Brake lights dont work. Either pushing pedal or turning on lights. Turn signals work just fine.
Cab/cargo/3rd brake light on back of cab doesn't work either. I have checked/done the following:
- Checked Brake pedal switch for continuity. Tested fine.
- put multi meter on wiring all the way back to brake lights. No drop in voltage.
- changed bulbs. #3157 dual filament.
- positioned steering wheel all the way up and all the way down as suggested on here. No change.
- checked multi function switch (turn signal switch) for wiring issues. None found.
- kicked rear quarter panel for caveman adjustment out of frustration. No change.
What am I missing?
Ford Excursion :: Right Turn Signal / Hazard / Brake Lights Do Not Work
I have a 2003 V10 Excursion with an electrical problem. The right turn, right brake and right hazard light do not work but the flasher makes the clicking noise. When the right turn signal is on, the right front turn signal light works but is at double speed. The right rear light does not work. Same when brake and hazard are applied.
I checked the bulb socket with a multi meter and have no current. I also checked my trailer plug and have all functions work. Fuses were checked also for the brake circuit and were all ok.
Ford F-150 - 1997-2003 :: No Brake / Turn Signal Or Hazard Lights When Trailer Lights Plugged In
I've got a 2001 f150 supercrew 4x4 with the 4.6. I plugged in trailer lights and now I have no brake, turn signal, or hazard lights. I've checked fuses and none are blown.
View 8 RepliesYukon :: 1999 Denali - Rear Brake And Turn Signal On Driver Side Not Working
As the says I have a 1999 Yukon Denali that the Rear Brake and Turn signal on Drivers side are not working. Also brake light on trailer DOES work but not the turn signal on that side.
I tested the Tail light circuit by plugging it into the passenger side and it works so that rules out that. What wires to test under the dash to test the combo / multi switch?
Also the tail lights or park light do work (both top and middle bulb lights up when the vehicle is running) its just brighter filament does not light up when breaks are pressed or turn signal is on.
Ford F-150 - 1997-2003 :: Passenger Side Brake Started Making A Grinding Noise
I have a 1997 F150 (truck in signature). In December my passenger side parking brake cable broke so I replaced both rear cables (front cable appears in good condition).
This past Friday the passenger side brake started making a grinding noise so I pulled the drum to find the self adjuster cable broken and the ratchet jammed between the shoe and the drum. I pulled everything apart and put new shoes (the pin the ratchet pivots on was broken off the rear shoe)and all new adjusting hardware (adjuster screw, ratchet, cable, and cable guide). The rest of the hardware looks in good condition (still paint on the springs and retainers). I got everything put together and took it for a test drive, it had a nice firm brake pedal (it's been a while since this truck has had a firm pedal) and great stopping power.
Took it to work today, and on the way back I stopped to pickup a package from the UPS store. I set the parking brake and put the truck in 1st like I always do. When I got back out to the truck to drive home, I released the parking brake but there was still obvious drag as I drove home (no good place to stop during rush hour), got out of the truck and it reeks of burning brakes. I pulled the driver side drum off (after it cooled), which was rather difficult, and everything looks to be in order except the rear shoe was not touching the post at the top of the backing plate. I checked and the adjuster was still all the way in, so that isn't the issue.
I pulled the parking brake cable out to slack the drum side of it (with the pedal released there is some spring tension from the pedal mechanism) and clamped it with vice grips so the cable was slacked and the shoes were then touching the post, and the drum could be installed and turned relatively easily, I then removed the vice grips and let the spring pull the tension out of the cable and the brake held firmly (requiring considerable effort to turn the drum). Is there anyway to adjust the spring tension on the parking brake cable when the parking brake is released?
Additional notes: when setting the parking brake, the pedal will only go down an inch or 2 before the brakes are locked up tight and the pedal won't move, it used to go down several inches before. also I noticed that the feral on the end of the drivers side cable (that locks into the lever attached to the rear shoe) is deformed, like the cable has too much tension on it. The cables are the correct ones for my wheel base according to Autozone but I'm starting to wonder if they are too short. Spring tension on the parking brake cable (when the brake is not set) causes the parking brake to drag. How do I get the parking brake to stop dragging? ("star" adjusters are new and adjusted all the way in).
Ford Wiring/Electrical :: 2005 F250 - Rear Turn Signal Signals And Brake Lights Don't Work
I just bought an 05 F250 XLT. I noticed tonight that the rear turn signals and brake lights don't work.
The front turn signals work fine, although they flash fast. I know that usually means a light on its way out. neither taillight flashes though, which puzzles me.
My second issue is that, of the 3 brake lights, only the high mounted light illuminates when I hit the brakes.
Malibu - Chevrolet :: 2004 - Turn Signal Does Not Work When Brake On
My daughter recently bought a 2004 chevy malibu. she had it checked by a mechanic, who said it was a decent car for the price. the turn signal does not work when she has the brake on.
View 4 RepliesFord Super Duty (1999-2016) :: 2003 F250 - Unlock On Passenger Side Does Not Work
I recently purchased a 2003 F-250. The door locks don't work properly, the passenger side will lock the entire truck all 4 door locks actually lock. The unlock on the passenger side does not work and neither does the entire switch in the driver side. I attempted to switch the actual switches from the driver to passenger side thinking that it could be a switch that is broken.
After doing that still only the passenger side would lock and the rest of lock unlock buttons did nothing. I have checked all the fuses in my truck and actually took the door panels off today thinking I might find an obvious problem. I know the actuators are a common problem but because all the locks lock in the vehicle I was thinking it might be something else.
Ford F-150 (2004-2008) :: 2006 - Rear Passenger Side Turn Signal Not Working
My rear passengers side turn signal is not working. The bulb is lit up when i have my parking lights on so i know that th bulb is good. So my guess is that there is a voltage issue. I have searched the web for a wiring diagram and have come up empty handed.
View 2 RepliesFord F-150 (2004-2008) :: Turn Signal Indicator On Passenger Side Mirror Is Not Working
I just picked up a 2004 F150 FX4 Supercab, I had a safety inspection done and am working through some of the issues.
The turn signal indicator on the passenger side mirror is not working (front and rear indicators work). I took the mirror apart and get no voltage to the led array, next I pulled the rubber boot off of the harness in the door jam and probed the wires while with a test light and found one of the wires would blink the test lest light but the colour didn't match the the turn signal array, it matched the heated mirror wire. I probed at the heated mirror connector at the mirror and sure enough it blinks! Then I notice that the heated mirror indicator light on the center dash is blinking? I push the heated mirror button below the indicator light and ALL turn signals (front and rear) stop.
I searched the forum for mirror turn signal issues and found a thread about corroded wire splice below the fuse panel. I checked and have no splice all look ok so I thought I would post and see if I can get some direction or a schematic.
The symptoms are :
- Passenger side mirror turn signal(right turn) indicator does not work
- front and rear turn signal indicators work
- power seat works
- fuses are good
- drivers side all turn signals work fine
- heated mirror indicator light on the dash blinks with the passenger side turn signal
- pushing the heated mirror button when turn signals are flashing (right turn) results in a solid heated mirror indicator light but all other right turn signal indicator stop blinking (off)
It seems to me that there must be a short between the two circuits but where?
Buick - Rendezvous :: 2004 - Turn Signal And Brake Lights Don't Work / No Clicking Sound
I turned the car on this morning and my turn signals don't work, there is no clicking sound when I flip the left or right signal and when I step on the brakes the brake lights don't illuminate. Needless to say the cars behind me don't like it when I slow down to make a turn. Can't be the bulbs and the symptoms make me think it is more than a fuse.
View 3 RepliesFord Aerostar :: 1997 - Brake Lights / Turn Signal / Emergency Flasher Stopped Working?
I have a '97 AWD and my brake light, turn signals and emergency flasher have stopped working. I've checked all the bulbs, checked all the fuses (under the dash) replaced the flasher just in front of the fuse box...nothing. All the running lights work, and the 3rd brake light above the rear door window works.
View 3 RepliesFord 6.0L Power Stroke Diesel :: Driver Side Turn Signal Freezes When Brake Applied
2004 F250 6.0L!!
An issue I noticed right off the bat was that whenever I had the driver side turn signal on, and the brake was applied, the turn signal freezes.
I took apart the tail light and found a concoction of wires...I posted a diagram illustrating what it looks like.
There is this pesky Red wire that is spliced into the tail light bulb socket wire (specifically the green wire).
There is a trailer brake installed...if this means anything. I've tried disconnecting that with no luck on fixing the issue.
How to further troubleshoot would be great...electrical work is not my forte!