Ford Super Duty (1999-2016) :: Inertia Switch Sensitive?
As I pulled in to park I slid only 3 or 4 inches and just kissed a snow bank, didn't even think anything of it. An hour later truck wouldn't start until I reset the inertia switch. Man that thing is sensitive!
View 13 RepliesFord Super Duty (1999-2016) :: 2001 F250 - No Voltage At Either Window Switch
Just picked up a 2001 Gas F250 4X4 XLT. Everything seems to work except for the electric windows and ABS. I pulled both window switches and cannot find any voltage on the Blue/black cables. I jumped 12v to the drivers side switch and the windows work up and down even in auto. I have voltage at the 30a circuit breaker in the PDB but nothing at fuse #7 in the PCFP. I've checked for voltage at another connector with a Blue/black cable and found nothing. I'm thinking bad cable or GEM. I have noticed that the bell system doesn't sound when you have the key in the off position with the door open if that matters.
View 14 RepliesFord F-150 - 1997-2003 :: 1999 F250 - Rear Door Won't Open / Ajar Switch Is Out
It was working fine then I drove on a 2 hour highway trip and now it will not open. This is the Xtra cab where you open the front door and then the rear from the inside. The door ajar switch is out. I suspect one of the latches is stuck. There is one on the top and one on the bottom of the door.
View 2 RepliesFord Ranger / B-Series :: 1985 - Fuel Pump Wires Heating Up Intermittently At Inertia Switch
1985 2.3L... New fuel pump And fuel pump relay, problem was happening before new parts. the wires at inertia switch continue to get hot switch has been removed. The heat continues to under the hood where there is some so rt of connecting link and heat stops.what the is this link for, it doesn't look like A fusible link?? Saw a similar post here about a fuel pump shutting down and wires getting hot. Same problem.
View 9 RepliesFord F-150 - 1997-2003 :: 1999 F250 Will Not Start After It Gets Hot And Sits Fir A Bit
I just got this truck. 1999 F250 4X4 with the 5.4L. It will start great when its cold but after you get it hot and it sits for a bit it will not start (will crank) again till it cools off. Its has new MAF coil packs and plugs, air filter tranny flush and oil change.
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Truck Won't Start - Battery Voltage Will Keep Falling If Cranking Continues
So when its cold and im talking below 55 degrees, and the truck hadn't been started that day, it will turn over 3 or 4 times before the voltmeter takes a dive down to 10 volts or so and doesn't start. The voltage will keep falling if cranking continues. I took the batteries out and had them tested. They are both above the rated cca. So im thinking it could be the starter windings?
I did replace an injector recently so all the cranking to get it going again may have ruined the starter? But when I hook up the battery charger and jump the truck it starts. And after it has been started it will continue to start easily the rest of the day.
Ford 7.3L Power Stroke (1999-2003) :: 2000 E450 - Low Voltage On Gauge With Good Battery - No Start Condition
2000 Ford 7.3 E450 120,000 miles...
I have changed the CPS twice
I have checked the resistance of the injectors at the IDM connector with a volt meter and the harness reports back good.
The truck will run with ether for a few seconds
I have changed the fuel filter.
The fuel bowl fills quickly
I have unplugged the ICP.
The truck is showing low voltage on the gauge with a good battery. Around 10v
I have connected my 200amp car starter and I never see over 10v. I plan to check the grounds, but I am at a loss.
Everything is difficult because this is a van body so space is limited. I have also plugged in the block heater for an hour and that hasn't made any difference. Where can I get the best price on an AE scanner.
Ford F-150 - 1997-2003 :: 2001 - Replaced Blinker Switch Now It Won't Start
This is a truck at work, I had my student workers put in a new blinker switch, and when they were done it won't start anymore. The "theft" light is flashing on the dash, so I guess the PATS system thinks it was tampered with. How could you trigger this by changing the blinker switch? Does this have to be reset by a dealer?
View 3 RepliesFord F-150 - 1997-2003 :: 1999 - PCV Switch And Sensor?
1999 f150 4.2L V6. I have found the valve, and ot checked out okay, but i need to find the pressure switch and sensor.
View 6 RepliesFord F-150 - 1997-2003 :: Low Presser AC Switch Died / Start Solenoid Just Clicks Sometimes
On my 97, just had a new engine installed. Suddenly the Lo presser AC switch died. Now the Start Solenoid (I think) just clicks sometimes. Is this Solenoid on the Firewall the Start Solenoid?
View 6 RepliesFord F-150 - 1997-2003 :: 1999 - Door Lock Switch Malfunction
The power door lock switches, on both driver and passenger doors, only functions to lock the door but will not unlock. When either switch is depressed to lock, both function with no problem. But when depressing either side button to unlock, there is absolutely no activity at all. Like there is no current reaching either one. This happened once about a week ago, but my son came along and just kept pressing the passenger side button and it came back to life after 5 or 6 tries. But now the same problem has recurred and it will not resolve.
View 14 RepliesFord Super Duty (1999-2016) :: 2003 F250 - No Headlights When Ignition Switch Is On / Wheezing Sound For A Second
Headlights work well w/ ignition switch off. High/low/passing all ok. When I turn the ignition switch on, there's a strange wheezing sound for a second.
When the ignition switch is on, there are no headlights.
What's the wheezing sound? Why does the power to the switch quit with the key on? The more I work on modern trucks, the more I like my 1968 f-250.
Ford F-150 - 1997-2003 :: Fuel Pump Not Working / Not Getting Voltage To Contacts On PCM And Relays
New to this site, my problem is on my 2003 4.6L fuel pump not working.My problem is that I am not getting voltage to contacts on pcm and fuel pump relays.
Getting volts to #30 fuse 30amps ok, voltage to pcm diode ok. Voltage on #30 on both relays(pcm & fuel) but I am loosing voltage across coils contacts #85 & #86, these makes hot #30 & #87 to make pump work. Inertia sw ok, Don't know if PCM is bad, ck fuse #2 ok 5 amps.
Ford F-150 - 1997-2003 :: 1998 Truck Not Starting / Not Getting Voltage At Fuel Pump
I have a 1998 Ford F150 with 4.2.. Started off a intermittent problem of not starting acct no fuel. Now will not start at all. Checked all fuses and relays.. Am not getting voltage at fuel pump. Changed ECM thinking that was the problem.. Have checked all multi wire connectors for corrosion and tightness. Am at a lost what to try next.
Also, not sure if its related or not. The turn signals and hazard flashers do not work. When I turn on the hazard flashers, nothing happens. If I leave the flashers switch on, the turn signal work. Checked all fuses and relays and they appear good.
Ford F-150 - 1997-2003 :: F250 - Accelerator Hangs Up At Start Up?
I have a 97 F250, 4x4, 5.4 Triton with a bunch of mile on it. The problem I'm having is when first starting, the accelerator hangs up. Can't just push down slowly to start off - have to tap it to get it to free up. Problem doesn't seem to be with the pedal or cable - they move freely. What to look at or try?
View 1 RepliesFord Super Duty (1999-2016) :: 2004 F250 - FICM Voltage Low - Starter Broke Away
Truck would have a miss that went away when warmed up past 180. Ficm voltage was low so I got a new one from diesel tech ron. After I installed it The truck would crank for maybe 5-6 turns then lock up and kick the starter out. The starter broke away from the motor from the kickback. I got a new starter in and set up my scangauge 2. In the few turns of the motor i can do before it kicks out, ficm is at 48.5 koeo and cranking, ipr at 14.4, and the icp shoots up to 1100. The ficm sync wont come on and I m stumped what to do next. Dont want to start throwing new sensors at it. 2004 f250 6.0 ...
View 1 RepliesFord F-150 - 1997-2003 :: 1999 F250 - Shift Very Hardly?
99 F-250 with the manual shift 4x4, feels like I'm arm wrestling with King Kong to get it to work, this is my first 4x4 but I'm inclined to think this is not normal. This used to be a PA truck so it is rusty, the cursory look I gave it showed me massive amount of rust on the 4x4 shift mechanism. Should I just replace it or can it be rebuilt? Also should I replace the manual shift cover on the transfer case also?
View 3 RepliesFord F-150 - 1997-2003 :: 1998 F250 - Service Engine Soon Light And Truck Will Not Start
I have a little more detail on when the truck starts and does not . I have gone out the past two days and put the key in the ignition and turn it to the on position and all the lights come on except Service Engine Soon light and truck will not start. I bought a ceramic electric heater and placed it on the floor directing the heat under the dash. after ten to fifteen minutes I go out and put the key in the ignition turn the key to the on position and the service engine soon light is on and the truck starts right up. I let it warm up for about a half hour and then shut it off. I then try to start it right back up and the service engine soon light comes on momentarily then goes off and the truck does not start?
View 5 RepliesFord 7.3L Power Stroke (1999-2003) :: Won't Turn Over Voltage Above 12v
Batteries are a year old. Drove to work. Now won't turn over even with a diesel truck jumping. Voltage above 12 and slowly drops when cranking.
View 14 Replies