Ford Wiring/Electrical :: 2003 - Instrument Panel / Interior Lights / Windows / Radio All Not Working
For about 3 months, my wife's 2003 explorer has had a bad door sensor (I'm guessing). The car claims a door is ajar and the alarm would go off randomly if it's locked. Yesterday the battery died because apparently the alarm had been going off for so long while she was at work. After having a stranger jump it, she has had major problems:
-She claimed the headlights didn't work in any setting except in the on position with high beams on, but now they seem to work.
-The instrument panel is totally out including all gauges and all lights
-the power windows don't work
-the radio won't turn on or show any display
-the interior lights won't turn on
All of the fuses are fine and my mechanic checked them as well. He did say that a few key fuses aren't getting any power to them on either side. But the battery is charging and drawing just fine. The car doesn't seem to have any other issues and all of the flashers work just fine.
What the problem could be? I have wondered if one of the relays is busted.
Ford - Explorer :: 2003 - Power Windows Stopped Working
I have a friend who has a 2003 Explorer and all his windows stopped working.
I checked all the fuses under dash and hood and found that none of them were shorted, even swapped my window circuit breaker off of my Ex and still could not get them to work. I took a test light to all the power wires in the door and noticed that he wasn't getting positive power and that he had negative to the switches. I ran a jumper wire from the battery and could get the windows to work. I removed the door panel and traced the wire all the way through the rubber boot at the door jam but could not get any juice. The circuit relay has power to it but don't know where else to look!
What else should I look for? Is there another place that he might've lost contact or another fuse/switch somewhere that I didn't see. Looking for a wire diagram for the power windows that would also kinda trace faults.
Ford Wiring/Electrical :: Radio / Gauges And Windows Not Working
My radio, all gauges and windows aren't working. Fuse 17 did not seem blown but I changed it anyway and still no luck.
View 2 RepliesFord Wiring/Electrical :: Power Windows And Door Locks Suddenly Quit Working
1997 Ford Expedition 4x4
When I push the switch for the drivers window I can hear the relay in the fuse block make a click but window doesn't move. If I push the switch for any other window (on the drivers door or any other door) no click at the relay and no window movement. I've swapped the relay with other relays in the fuse block but nothing changed.
I've tested the driver side window motor by running 12 volts directly and the motor works fine. When I press the PDL switch I hear a buzzing sound coming from the passenger floor area behind the glove box but the locks do not go up or down. I started the truck and when I put it in gear I can hear the PW relay in the fuse block clicking repeatedly. Put the truck in Park & the clicking stops.
I was told (on another forum) that the problem is most likely my GEM module. Bought a used 1 on eBay and installed it today but nothing changed.
Ford - Explorer :: 1997 - Power Windows And Locks Not Working
White 1997 Explorer XLT 4 door 4x4 4.0 sohc 220,000 miles. The power windows and locks don't work. I've tried all of them in the whole car and nothing. Replaced all fuses at the inside panel and replaced all fuses and relays under the hood. Replaced master control switch on the drivers side and still nothing.
View 1 RepliesFord - Explorer :: Windows And Interior Door Handles Not Working?
My windows wont work and my interior door handles ALL need replacing. How exactly can I do this? I had to replace one a while back when the windows worked but I am stumped as to how I am going to attempt this. The only way I can exit my truck is to get someone to open it from outside or climb out the rear window (I'm a thick female and this is annoying/embarrassing).
View 2 RepliesFord - Explorer :: 2001 XLT V8 - Power Windows And Interior Lights Stopped Working
I have a moonroof & there were no map light bulbs, so I tried putting them in place but the electric connection there wasn't so good (there is a plastic covered with wires) so the bulbs are in but it doesn't work. What worst is, that now all the interior lights (glove box & rear dome) don't work as well!! nor the power windows & moonroof don't work now (it worked before). I guess that I have touched something or a fuse broke... I don't know what to do...
View 2 RepliesFord - Explorer :: 1996 - All Power Windows And Door Lock Stopped Working?
My power windows and door lock controls on all doors have stopped working. No blown fuses and the local parts who says that locks and windows don't run on the same relay? I don't have a garage and cant really secure my vehicle?
View 3 RepliesFord - Explorer :: 1996 - Windows Switches Not Working / Locks Only Work From Driver Side
My brothers window won't work from any of the switches and the locks won't work they only work from the driver side no window action though from either side, checked the fuse and relay but nothing.... 1996 Ford Escape 4wd....
View 1 RepliesFord - Explorer :: 1997 - Windshield Wipers / Power Windows / Interior Lights Not Working?
I have a 1997 explorer 5.0 AWD. The problem is that when it is about 44 degrees and below, the windshield wipers, power windows, and interior lights don't and won't work. We will run the heater until it warms up the interior, then everything seems to work fine. I usually leave the wipers on so I know when it is warmed up enough. I have checked all of the fuses and all are fine. the only thing that I can think of is there is a crack in the back of the fuseblock that breaks contact when the metal is cold.
View 2 RepliesFord - Explorer :: 2003 XLS - Both Rear Door Windows Don't Work
Just purchased my first Explorer. It's a 2003 Explorer XLS. Only problem with it is that both rear door Windows don't work. The dealership where I purchased the vehicle immediately threw a new drivers side door switch in it to no avail. Now they want to throw two new window regulators in it. Before they do that though I am going to do some checking to see if they are getting power. Both front Windows work just fine.
View 6 RepliesFord - Explorer :: 2003 - Lean Codes P0171 And P0174
2003 Sport Trac. My car was not starting, told my fuel pump, replaced twice and nothing. Found out about inertia switch and changed it, now car runs.
Before this switch blew out my car was running perfectly, no check engine, nothing. Now i have changed my fuel pump twice and put a brand new fuel filter in and soon after i get lean codes P0171 and P0174. My fuel pressure is 60psi at idle and drops to 0 after about 30 seconds when the car is shut off.
A lot of my intake is new since i did have a vacuum leak before, so i do not suspect that is it, especially since this happened after the new fuel pump. I am completely stuck as to what i should do. And i get hesitation when trying to accelerate sometimes
Ford Excursion :: 2003 - Power Windows And Radio Not Working
All my power windows aren't working along with my after market radio. All the fuses are good
View 10 RepliesFord - Explorer :: 2003 - Idling Rough With P2196 And P0174 Codes
I've got an '03 Explorer with the 4.0L SOHC that I got for a deal on craigslist as it needed timing chain tensioners. I got that all done and it runs and drives relatively well, but it idles a little bit rough - especially when it's sitting in gear at a stop light. My go-to first attempt for idling issues is to squirt off the MAF sensor, throttle body, and squirt some starter fluid around the vacuum lines to check for vacuum leaks (though it's possible I may have missed a line or two). Neither seemed to work much. I cleared the codes, dumped some Sea Foam and fresh fuel in it and drove it around a little bit and it threw the CEL light, got about 10 mpg, and generally just didn't seem to have as much power as it should (though I have no experience with the 4.0 in a explorer, soI'm not counting that as a hard fact).
I pulled the codes and I've got a:
P2196 (O2 sensor stuck rich - bank 1 sensor 1)
(and)
P0174 (system too lean - bank 2)
That seems kinda weird to me. Bank 1 is rich and bank 2 is lean? That would make it idle and run weird, for sure, but I'm having a bit of a hard time figuring out what would cause that. I think my next step would be to check/replace the plugs, but that's more of a shot in the dark than a proper diagnosis.
Ford - Explorer :: 2003 - Sputter - Got Codes P2196 And P0405 - O2 Sensor?
I have a 2003 Explorer 4.6, about 2 weeks ago the CEL kicked on but I didn't notice any problem. Last week I stopped at a red light and felt it shacking a little, I took off everything seem ok. At the next light I felt it again and that time it started sputtering, I drove it for a few more days and it would sputter now and then as I was driving and every time when I would stop when it was in drive. I had the codes pulled and it came back with P2196 & P0405 (o2 & EGR).
I was going to buy a new 02 sensor & EGR but I was told that a bad EGR could be causing the o2 code also. I put the new EGR on yesterday and had the codes cleared. I test drove it for about 10 miles with no problems. Today while driving I felt it start doing it again and about 5 mins. later the CEL was back on. I got the codes and again its P2196 & P0405, Should I have changed the 02 sensor instead or what I should do next?
Ford - Explorer :: 2003 - P0171 And P0174 Codes - Rubber Elbow Begin To Collapse
2003 Ford Explorer, with P0171 and P0174 codes, common problem, as I have read. I pulled the cover over the engine off, and I immediately found the likely problem. There is a hose/connection that runs from the valve cover on the right side, about 6 inches behind the oil fill tube across and looks like it comes into the Carb. Where it turns to come into the carb is a rubber elbow. This elbow has a hole in it. Temporarily I have used electrical tape, but when I run the vehicle, I see the elbow begin to collapse. I believe the elbow is getting weak with age, plus the hole/tear doesn't work. Anyway, what i the part number, or what this is called. Hoping Advance Auto, or Napa will have it, just don't know what it is called, and can't figure out the part number. Otherwise I will pull it off tomorrow and take to advance and see if they can match it.
View 5 RepliesFord Super Duty (1999-2016) :: 2003 - Windows / Radio Not Working 30 - 60 Seconds?
'03 F250 V10 SuperDuty.
Ok...I hadn't driven my SD for over a week...maybe like 7 days. Get in...and turn the key to the 'On' position. Wait for the computer to cycle on (I just like to hear it)...and then fire up the V10. It's a HOT day...so I try and open the electric windows, but nothing happens. Then...I notice the radio is not on either. What the heck??? Ok...about 30sec or 1min passes and the windows are now working and the stereo is on. Some kind of weird time delay...???
So...here is the catch of it all. I drive to the local hardware store and all seems fine. Do my business in the store...and jump back into my SD. Fire it up...and everything is working. The windows or radio did not have that "time delay". Now...I am really confused.
Ford F-150 - 1997-2003 :: F250 - Power Windows Not Working - No Door Chime - GEM Module?
My 97 f250 light duty has give me fits. The power windows do not work up or down either side, no door chime or pdl either.i think this is related to the gem module cause I have run a 12 v to the motor itself in the door and it goes up and down.checked all fuses and switched relays.I don't even hear any clicking relays.I have spliced into the orang/white wire at the 2pin connector to the motor and have hooked it to a purple wire on the back of the window switch and now have pdl,and door chime,and hear clicking under dash but still no windows.What am I missing is there another wire to splice into?
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 - Radio / Windows Stop Working Occasionally?
I have a 02 PSD, and sometimes after I start it up my radio and power windows do not work. I have a red "security" light on my Kenwood radio that turns on when the truck is off. That light keeps flashing after I turned on the truck so I know it's still getting power, but for some reason it thinks the truck is off, and the windows don't go down. Other days it works perfectly fine, sometimes the radio and windows will stop working after driving normal.
At first it was a routine where I knew they'd start working shortly. But today was the last straw, I drove into work with no radio and windows not rolling down for 30 miles. Of course after I park, I turn off the truck, turn it back on and everything comes on like nothing ever happened. What can be causing this, I have checked all the wiring, no kinks, cuts, nothing. I remember reading something about a relay that can cause this but can't find that info.