Ford - Explorer :: 2000 XLS Won't Engage Park Fully Or At All At Times
When putting vehicle into park, every so often it will barely enage or not at all. Can hear a clanking noise when rolling back or forward. Trans position sensor?
View 1 RepliesOldsmobile - Alero :: 2000 - Stalling And Security Light Beginning To Flash On Dashboard
I've been having a problem with my 2000 Alero recently where, periodically, attempting to start the car will end in the car stalling and the security light beginning to flash on the dashboard. Usually after about 10 minutes the light goes off and the car starts normally (well, insofar as feeling like it's going to shake itself apart the moment it hits idle is normal, but that's another topic for another post). This happens about 40% of the time when starting the car, and seems to be happening more and more frequently (which may be my imagination).
I took the car into the dealer (after my local mechanic told me he was familiar with the problem and wouldn't be able to fix it), and they told me I needed to replace the body control module and passlock sensor... Car info : 2000 Oldsmobile Alero~140,000 miles2.4L I-4.....
Ford - Explorer :: 2000 - Engine Continued Running Even When Key Is In Off Position
The other day I went to turn off my vehicle and it continued running even when key is in off position. I took the key out and it still continued running. I had to disconnect the battery and turn key in on position for vehicle to stall. I do not want to buy any unnecessary parts nor do I want to take apart any unnecessary components.
View 1 RepliesFord - Explorer :: 2000 XLT - Engine Making A Ticking Noise
Its getting worse. Noticed it a month or so ago, very slight ticking noise when the engine was cold. It would go away after a minute or two when the engine warmed up. Kinda sounded like a lifter ticking type noise when low on oil but I was not low on oil.
Now its getting more noticeable and it doesn't go away. Very noticeable when I take off or accelerate. less noticeable when I take my foot off the gas but its still there.
What it might be? I am pretty newbie about engines and I don't want some repair outfit telling me I need a rebuilt engine if all I need is to tighten my manifold or something. Because that would be my luck.
2000, XLT, 5 Liter V8, 178K miles.
Ford - Explorer :: 2000 - Engine Won't Shut Off / Running Even When Key Is In Off Position
The other day I went to turn off my vehicle and it continued running even when key is in off position. I took the key out and it still continued running. I had to disconnect the battery and turn key in on position for vehicle to stall. I do not want to buy any unnecessary parts nor do I want to take apart any unnecessary.
View 3 RepliesFord - Explorer :: 2000 XLS - Engine Hesitation - Constant Hiccup
I purchased my first Ford back in 2006 it was a 1999 Explorer Sport. Gave me a long line of problems from suspension to head gasket repair to rear main seal repair to ANOTHER head gasket repair. But sure enough, like I'm sure many of you have, I fell in love with her. She could do no wrong. Even now that I got her off the road she is still my baby. Now my recently purchased 2000 Explorer XLS which I've only had for about 5 months just yesterday started doing a strange hesitation. Perhaps a misfire. My initial instinct was dirty fuel injectors that hopefully if I'm lucky will be the easiest fix in Ford history. Another hypothesis is a bad plug. Either way, in my mind, that's best case scenario. I have yet to take it in and plan on buying some injector cleaner later on today. When I'm idling there's no problem. It's as soon I step on the gas that I feel the hesitation. Almost like a constant hiccup.
View 6 RepliesFord - Explorer :: 2000 Won't Idle When Cold / Hard To Start And Keep The Engine Running
I have a 2000 Explorer W/4.0 SOHC engine. With summer nearly over and fall on the way, I need to figure out what is going on with my engine. This problem has been going on for the past 2 years. As the outdoor temperatures get cooler, the harder it is to start and keep the engine running. This starts happening around 65 ambient temperature, and gets worse as the temps drop. By 30, I can barely keep the engine running.
Odd thing is, all I have to do if the engine starts is, keep my foot on the pedal to keep the engine around 2000RPM, put it in gear and start driving. After about a mile or two, the engine runs normally, and will do so the rest of the day. So far I have cleaned the air flow sensor, replaced the IAC, replaced all the injector "O" rings, and cussed a lot. I smoke tested the engine and the only vacuum leak is a very small one at the EGR valve.
Ford - Explorer :: 2000 - Consistent Knocking Noise Increases As Engine Speed Increase
I'm looking at a dirt cheap Explorer 4.0, has been sitting for 2 years. Runs nice, with a double "knock" noise but quieter than a rod knock. Idles smooth at 600 rpm, "knock" is consistent, but increases as engine increases speed. Has 2 year old oil, and 2 year old gas. Would a tune up support it, and revitalize it, or is the engine almost dead. Still drives, didn't push it to hard. Interior is 9/10, exterior is 10/10. I have him down to 600. 4x4 works, and feels good.
View 6 RepliesFord - Explorer :: 2000 - Cylinder 3 Misfire Persistently / Engine Stumbles And Has Poor Acceleration
I have a 2000 Explorer 4.0 SOHC that I'm having a persistent problem of cylinder 3 misfire. I've changed plugs with Motorcraft plugs set to the proper gap, put on new wires and have checked the resistance across the ignition module, both primary and secondary without change. I doubt that the problem could be the ignition control module as only cylinder 3 is affected. I have Auto Enginuity that I use to read the codes, attempt a repair and then clear the codes only to have P0303 appear again. Obviously the engine stumbles and has poor acceleration.
View 14 RepliesExplorer :: 2000 OHV 4.0 Engine Turns Over But Never Catches When Cold Outside
My wife's 2000 explorer with the ohv 4.0 has trouble starting when cold outside. No problem in summer. The engine turns over but never catches. Eventually, after 5-10 min, it will catch. Sometimes we have to trun the key all the way off, not just acc, to make it start. Had battery checked, and was on the "low" end for cold cranking amps, but the engine doesn't lag like a dead battery would. Last winter we replaced a gasket on the upper part of the engine thinking that it wasn't flexible enough when cold outside and was getting the air/fuel mixture wrong. No check engine light. I think that covers everything.
View 7 RepliesFord - Explorer :: 2000 - Heavy Oil Leak / Steady Dripping From Inspection Plate Area Where Engine Meets Trans
Question about my dads 2000 explorer with the 4.0, he just noticed it was leaking oil heavily. Added 2quarts and drove it home. I looked under it and the oil is dripping very steadily from what appears to be the inspection plate area where engine meets trans. Have y'all ever seen a rear main seal fall out or cause a leak this heavy? I know we will have to clean it and re check but this is all I have seen at this point. Is there any other seal or issue that could cause this from inside the bell housing area or nearby?
View 2 RepliesSilverado :: 2000 / 5.3L Engine - Vibration At Highway Speeds Between 40 And 65mph
I recently got a used 2000 silverado 1500 ext. cab with a short bed. Has a 5.3L engine. I noticed it has vibrations at highway speeds. I thought it was the crappy tires on it so I had all the tires replaced and balanced. Now it has all new tires and does the same thing. Runs really smooth all the way up to 40mph and then the vibrations begins. It is mostly felt in the steering/dash and pedals. A little more pronounced on accel. but vibrates if your on the gas on not.
Once your reach 65mph, the vibrations stop. I have also noticed that asphalt makes it vibrates more. When I go over concrete overpasses in the problem area of 40 to 65mph it smooths out. I took a look under the truck and saw nothing obvious. U joints feel tight and no play, seen it had weights which appeared welded onto the one piece drive shaft.
Accord :: 2000 - Bad Vibration At Idle - Revving The Engine Smooths It Out At Certain RPM
I have a 2000 Accord with a 2.3L 4 cylinder and manual transmission. I just changed the timing belt, balancer belt, water pump, tensioner wheels and other external belts. I now get a bad engine vibration at idle and when backing up and pulling forward. The vibration is quite noticeable in the steering wheel. Revving the engine smooths it out at certain RPM's. I know this isn't right and its got to be limited to something I just did. I followed the instructions in the Honda service manual and thought that everything went back to gather correctly. I double checked the timing and balancer alignments. The motor mount on the drivers side is simple and all went back together correctly. Is there a way to verify correct timing belt and balancer belt alignments without tearing it all down again?
View 13 RepliesGolf IV / Jetta IV :: 2000 - Constant Engine Vibration When Car Is In Gear
I have a 2000 Jetta with the 2.0 automatic and just like the title states, I have recently developed a engine vibration that is felt at all times. It is much worse when the car is in gear. I only seem to feel it in the gas and brake pedals. It does not seem to depend on speed nor does it only occur at certain rpms. It feels like someone zip tied a vibrating back messager to my pedals. I want to find out what it is because on long commutes my foot begins to feel like its falling asleep. I can visually see the engine vibrating with the car in gear. I am leaning towards motor mounts.
View 1 RepliesGolf IV / Jetta IV :: Vibration At 2000 - 2500 Rpm From Inside / Under Engine Bay
I am hearing a vibrating sound only between 2000 - 2500 rpm while accelerating from inside/under engine bay. No impact on ride quality and no engine harshness is felt. Only it sounds like some metal sheet is vibrating for a while. After crossing 2500 rpm it simply disappears.
Checked inside the engine compartment by revving the engine while stationery and I don't get that sound. What could it be? Some shield of the exhaust? cat?
Camry 2012+ :: Drone / Vibration Which Occurs When Engine At 1600 - 2000 Rpm?
2012 Camry SE 4 cyl, 56K miles ... Happens in all gears, in normal and sport mode “under light acceleration” at 1600-2000 rpm.
Sitting in driver’s seat I hear a drone which sounds similar to the engine lugging we hear briefly at around 1000 RPM. In the 1600-2000 RPM range it is very annoying because this is the cruising range on highways. Sometime when going up a slight incline it can be felt through the accelerator.
When seating in back seat on passenger’s side, it sounds similar to a bad muffler/resonator and is very audible. Spring loaded exhaust couplings in front of muffler and between front pipe and converter are not seized. All rubber hangers are there. Installed “B-quiet” sound absorber in trunk going from spare tire well over top of muffler and up rear quarter panel which did not work. Nothing is touching the exhaust under the car.
When idling the exhaust produces a noticeable putt-putt sound. Toyota rep (not dealer) went for a ride with me and feels it is typical of a car “for this mileage” (same as dealer told me). I stated it did not do it before and was told cars wear in and after a while characteristics change.
Corolla / Matrix 2009-13 :: 2011 LE Engine Vibration Right Between 2000 - 3000 RPM
I am getting a engine vibration on a new 2011 corolla LE. The vibration is right between 2000-3000 RPM. Also the muffler kinda sounds louder at that RPM. I have only 300 miles on this car ...
View 14 RepliesWindstar :: 2000 Ford - How To Put It Into Park By Hand To Start The Van
I a 2002 ford windstar 3.8 engine. I need to put a new shift cable on it. And reconnect it to the transaxel range sensor or the netural safety switch. Not sure what i have on my van. But what i need to know is how to put it into park by hand to start the van, then how to put it into drive to drive the van. I need to get the van running the right way. Next month, I'll get them. but need to get around now. so how to shift the gears by hand.
View 2 RepliesFord Excursion :: 2000 - Coming Out Of Park A Few Times?
My excursion has come out of park a few times. Not good at the boat ramp.....
View 3 Replies