Ford - Explorer :: Rear Springs Worn Out?
My rear springs are worn out
apparently ... it's not a pickup ...
seriously though ... they are worn out
Ford - Explorer :: 2002 - Changing Rear Coil Springs?
I have a 02 Explorer that has 2 cracked rear coil springs.
How hard are they to change ?
What brand to use ?
I was looking at the Monroe Quick-Strut.
Ford F-150 - 1997-2003 :: Replacing Rear Springs?
...So I think the time has come to replace the rear springs in my SuperCrew....They are starting to sag...nothings broken...spring perches look ok. Question is , Are the supercrew springs any different than a reg cab or supercab?
View 6 RepliesFord - Explorer :: 1993 - Rear Axle Replacement
The axle seal is bad on my 93 Explorer, manual, 4x4 both sides. The shocks and leaf springs are also shot. Instead of replacing the seals, was advised to just replace the entire axle and pick one up at the boneyard with springs.
I am wondering what axles from other vehicles will work? I have been able to find this before through RockAuto's website but there is no information concerning rear axle. Is there a source showing interchangeable parts between vehicles? Aside from the body, Explorer is basically rebuilt now, just needs the gearbox replaced.
Ford - Explorer :: 2001 - Rear Body Mount Bushing Replacement
2001 Ford Explorer Sport (not sport trac) 4.0l 5r55e 2wd.. Ok so I picked up a sweet deal of an explorer yesterday.
Sure enough I get her home and find out she needs both the rear body mount bushings replaced. Ok no sweat so I go to autozone...they cant find them... Ok I look in the book for replacement procedure... Nothing, To YouTube! ...nope nothing there either.
Ford F-150 - 1997-2003 :: Rear Differential Replacement?
Last week I broke the pinion and spider gears in in rear end. Well Im getting a used rear end rather than rebuidling mine. What is the gear ratio on the 97 F150 xlt 4.6l 4x4. I figured they would all be the same but my tag is missing on my diff and I was told by an auto parts store that there were a couple different ones.
View 14 RepliesFord F-150 - 1997-2003 :: 2002 2WD - Rear Shocks Replacement
What is the degree of difficulty in replacing the rear shocks on a 2WD 2002 F150?
View 14 RepliesFord - Explorer :: 1997 - Can't Get Upper Rear Bolt Out?
I can't get the upper rear bolt out the fuel lines are in the way and I have tried wiggling the arm in every direction possible. any tricks?
97 V8 AWD.
Ford F-150 - 1997-2003 :: Rear Axle Leak - Seal And Bearing Replacement?
Looking for a video, pictures, or steps that are in depth on how to replace my rear seals and bearings? They are leaking very badly and would like to see some other ways to get it done.
View 3 RepliesFord - Explorer :: 1997 V6 - Whole Rear Suspension (Shocks) Completely Destroyed
I Just bought a 1997 Ford Explorer V6 4WD and I noticed after the I bought the truck that the whole rear suspension (Shocks) were completely destroyed. I failed to notice this during inspection of the car because it was parked very close to a wall so i was unable to see the area. Now I do know a bit a about cars but I no professional, It seems as if this whole section of the car just rotted out which is surprising because the rest of the car seemed OK. So now my question what do I need to buy in order to fix this I am not sure it seems like there is some sort of cross member that bolts onto the frame that connects the two rear shocks. What it looks like?
View 8 RepliesFord - Explorer :: 1997 - Right Rear Window Motor Works In One Direction?
I have a 1997 ford explorer, the passenger side rear window only works in one direction, I have tested motor and it does work in both directions reversing the polarity, checked switch by checking voltage on each prong of plug (where motor plugs into harness), and does get 12 volts on each line as switch is being activated,I think there may be a ground problem on the one side that does not work, where to start looking??
View 1 RepliesFord F-150 - 1997-2003 :: Constant Whine - Rear Axle Pinion Bearing Replacement
I have a constant whine going down the road with foot on the gas. Back off and it quiets up. At 2-3 MPH i think i can here a " tick- tick". Took the drive shaft off, wheels off ground, cover off and oil out. Spin wheel and i can hear a tick - tick, I think around the pinion bearing. No play up and down or in and out, but it appears to have 2-3 times the backlash i would expect. I used the screw driver- stethoscope--- still think its the bearing. This is a 9.75 axle. What kind of luck would I have pulling the yoke off and going in from the front without removing axles halves and ring gear? I thought I had read that here before. Never done one that way .
View 2 RepliesFord Excursion :: Rear Springs Basically The Same On 4X2 As 4X4?
Here's a pic of rear springs off a 4X2 Ex.
They look the same to me with the exception of not having the bottom overload spring with the rubber snubber on it for the axle wrap.
I need a pair of stock rear springs so I can pull the bottom two leaves off in order to do a modded B-code, and these are available for me to use if they will work.
Ford - Explorer :: 1997 4x4 - No Running - Shudder In Rear Tire - Front Never Spin?
My Explorer is a 1997 with the control trac 4x4 system. It's only purpose in life at the moment is to plow snow and its been doing that quite well. I typically leave it in 4lo all the time. Every once in a while, I will switch it to the other modes to ensure they are all working.
Today I was plowing and it looks like I'm getting nothing, or next to nothing to the front wheels. There is some shudder if the rear tires begin to spin, but the front never spin, or lock up. I can feel/hear the transfer case shift when I change modes between auto/4hi/4lo as I usually do, but the front wheels just are not doing their job. All three modes are not driving the front wheels.
The transmission was rebuilt a few years ago, and it's shifting fine. I'm suspecting the transfer case. Only my OD light is flashing, but it only does that once in a blue moon. I plugged my code reader in and it could not read those codes. I was able to clear the light though.
Ford Aerostar :: How To Replace Rear Coil Springs
Have been the owner of a 96 4.0 AWD for 10 yrs and if they still made this van I would get one in a heartbeat. Been doing a search on how to replace the rear coil springs with no luck... is there special tools or procedures involved?
View 8 RepliesFord Excursion :: Rear Springs Versus Blocks?
I'm going to be installing a 4" lift on my truck and was wondering what the pros and cons are using springs or blocks. I have the option of going with either the pro comp 22210/22415 springs or 22210 with a 5" block. With the block I'd be saving around $200 but I guess my main concern is ride quality. Dont know if the stock rear springs have issues like the front do. I'm probably going to go all spring but it would be nice to save a few bucks.
View 14 RepliesFord F-150 - 1997-2003 :: 2000 - Leaf Springs Rattles - Fix?
My wife's 2000 SCAB 4x4 has been rattling for a while now. I have been able to figure out that the culprit(s) are the metal bands on the leaf springs, which are somewhat loose and causing the rattle. I have squeezed them with a large c-clamp on a couple of occasions, which seems to have provided a temporary fix, but as soon as the suspension cycles fully they stretch out again, and begin making noise. How to tighten them permanently? Or is there a replacement/upgrade to fix it?
View 2 RepliesFord F-150 - 1997-2003 :: New Leaf Springs Have Slightly Different Arch?
I bought some new leaf springs for my 2000 F150XL and noticed one is different only slightly, it being in the arch one is 7 15/16 which is correct, but the other is 8 1/8. how much variable do they allow, will it make that big of a difference or will i be able to notice it after there on. I am happy with them but don't want to put them on and then the truck set uneven??? the reason for replacing the ones still on the truck is they are twisted and apparently broke they are 2/1 springs and having the new ones i can tell the #2 spring on the truck now are shorter like the ends are broke off and the clips moved around allowing for them to twist, so i really needed new ones.should i put the taller arch on a particular side or should i just put them on....
View 2 RepliesFord Excursion :: 2004 - Rear Springs Worn Out And Sagging
My Ex has a ProComp 6" lift that was installed in 2004 (it's an 03) and it seems that the rear springs are worn out and sagging. I'm assuming the lift used the stock springs and blocks. I haven't measured but I'd say the rear is 1" - 2"s lower in the back. Question is should I replace the springs with stock ones? Maybe get springs that'll give me some lift and remove the blocks? Airbag it?
View 14 Replies