2008 Renault Clio Making Small Grinding Noise When Starting Up
Just bought a 2008 Clio dynamique 1.2 16v when starting the car up it would make a small grinding noise. Thinking it was a starting motor issue I went and took it apart cleaned and greased it up then put it back in, went to start the car up and got nothing no turning over or anything.
View 2 RepliesAcura - Tsx :: 2008 - Making Noise When Driving / Braking?
My 2008 Acura with 80k+ miles seems to be making a noise when I drive, when I brake. Speed doesn't seem to make a difference although it doesn't start until after I have been driving for a few minutes. Sounds like it is coming from the rear passenger side. I have no clue as to what it could be.
View 4 RepliesCamry :: 2008 V6 Making Noise When First Driving And Engine Is Cold
My 2008 Camry V6 has a noise that happens when I first start driving forward right after the transmission shifts from 1st to 2nd gear, from inside the car it sounds like it's coming from the engine compartment on the driver side. I've figured out that the noise happens only when the engine is completely cooled down and it happens only once until the engine is cooled down again. It doesn't do it when in reverse, however if I reverse first it will still occur when I start pulling forward and the transmission shifts.
I brought my car into the Toyota dealer and they say that they don't hear anything wrong. They ended up replacing an axle because a boot was torn so I was hoping that it would end up fixing the issue but it made the noise right away when I picked up the car.
I have a video of the noise happening... turn your sound up and you'll hear it right at the 0:14 second mark of the video: [URL] ....
I have literally 89 miles left on my extended warranty so I really need to get this fixed. Back to Toyota...
Ford F-150 (2009-2014) :: Grinding Noise When Making Turns Only
There is a grinding noise when i make a turn,when i straighten out it's fine,when i bought the truck in 09 i had a shudder problem but that was repaired by greasing the spline in the drive shaft. Truck has 59,000 and is coming up on the 60,000....
View 1 RepliesFord 6.7L Power Stroke Diesel :: Making Grinding Noise While Turning On Hill
a few times when making a tight turn on hilly terrain or a hill on a road, I've noticed a grinding sound in the front of the truck and a vibration in the steering wheel. I've so far chalked this up to the hill assist feature, but today I was on relatively flat ground in a parking lot with a dip in it. While crossing the dip in a tight turn, I noticed the same thing again.
I've checked the tires/wheel wells and there is no rubbing, etc.
Ford Super Duty (1999-2016) :: F350 Making Grinding Noise Every Once In A While
My 1999 Ford F350 Dually 4x4 started making a grinding noise every once in a while about 3 weeks ago. Now it is doing it quite often, randomly as I am driving. I do notice the noise stops when I stop the truck, or when I flip the switch to 4x4 and back while driving.
View 1 RepliesFord F-150 - 1997-2003 :: Passenger Side Brake Started Making A Grinding Noise
I have a 1997 F150 (truck in signature). In December my passenger side parking brake cable broke so I replaced both rear cables (front cable appears in good condition).
This past Friday the passenger side brake started making a grinding noise so I pulled the drum to find the self adjuster cable broken and the ratchet jammed between the shoe and the drum. I pulled everything apart and put new shoes (the pin the ratchet pivots on was broken off the rear shoe)and all new adjusting hardware (adjuster screw, ratchet, cable, and cable guide). The rest of the hardware looks in good condition (still paint on the springs and retainers). I got everything put together and took it for a test drive, it had a nice firm brake pedal (it's been a while since this truck has had a firm pedal) and great stopping power.
Took it to work today, and on the way back I stopped to pickup a package from the UPS store. I set the parking brake and put the truck in 1st like I always do. When I got back out to the truck to drive home, I released the parking brake but there was still obvious drag as I drove home (no good place to stop during rush hour), got out of the truck and it reeks of burning brakes. I pulled the driver side drum off (after it cooled), which was rather difficult, and everything looks to be in order except the rear shoe was not touching the post at the top of the backing plate. I checked and the adjuster was still all the way in, so that isn't the issue.
I pulled the parking brake cable out to slack the drum side of it (with the pedal released there is some spring tension from the pedal mechanism) and clamped it with vice grips so the cable was slacked and the shoes were then touching the post, and the drum could be installed and turned relatively easily, I then removed the vice grips and let the spring pull the tension out of the cable and the brake held firmly (requiring considerable effort to turn the drum). Is there anyway to adjust the spring tension on the parking brake cable when the parking brake is released?
Additional notes: when setting the parking brake, the pedal will only go down an inch or 2 before the brakes are locked up tight and the pedal won't move, it used to go down several inches before. also I noticed that the feral on the end of the drivers side cable (that locks into the lever attached to the rear shoe) is deformed, like the cable has too much tension on it. The cables are the correct ones for my wheel base according to Autozone but I'm starting to wonder if they are too short. Spring tension on the parking brake cable (when the brake is not set) causes the parking brake to drag. How do I get the parking brake to stop dragging? ("star" adjusters are new and adjusted all the way in).
Ford - Explorer :: 2010 - Compressor Started Making A Grinding Noise When Turn The Defrost On
My wife has a 2010 Explorer 4.0 with 46000 miles on it. Yesterday the compressor started making a grinding noise when you turn the defrost on. It's only when the clutch kicks in. I'm hoping its something simple but, I fear its not.
View 8 RepliesFord Super Duty (1999-2016) :: 2011 F450 - Front End Making Grinding Noise?
I've had the 450 a little over two years. Its used 95% of the time for hauling trailers, including the toy hauler. Has not given me a single problem since day one and now has around 21,000 on the odometer.
Lately I've noticed a "grinding" sound coming from the front end somewhere. It is most apparent when I'm turning at slow speeds; especially left. To describe it would be similar to worn out brake pads or maybe a wheel bearing going bad. It does it whether I'm on the brakes or not.
Ford Super Duty (1999-2016) :: Starter Making A Grinding Noise And Bolts Backed Out
2002 Ford 7.3L 2WD 200K miles ....My starter was making a grinding noise and the bolts had backed out. Wound up replacing the starter all together. Seemed to work for a little while and then went back to making the grinding noise again. I took the starter back and got a warranty replacement and took it to the shop last week to have it installed with lock-tite. It worked perfectly for a few days and then went back to grinding again yesterday afternoon. Why it is still doing it? I bought a new Duralast Gold 5154 starter from Autozone.
View 1 RepliesHyundai :: New Rear Brakes Making A Grinding Noise Around 15 - 25 Mph
My car came back from the shop yesterday with new brakes and pads and seems to be making some odd noises, both at low speeds and while breaking. I called the shop this morning and they said that this sound was normal for awhile but to come back in a week if it persists. Is this sound advice, or should I be driving my car right back to the shop?
2005 Hyundai Tucson 122,000 miles
Tiguan :: Brakes Making Grinding Noise When Applied
Is it just me or is this an ABS thing? during a snow storm i was going about 25mph and had applied the breaks and started making a grinding noise... if it is the abs how are you suppose to work with the response time for a quicker stop.
View 2 RepliesLexus GX 2004-09 :: AC Clutch Shot - Making Grinding Noise
My 04 GX has about 113k on it and the A/C clutch is shot, making a ton of grinding noise when its engaged (when the A/C is on).
Need to repair or replace there unit because of this? I see online the ability to buy just the clutch pack for the A/C compressor. However Lexus and other sites want to sell me the whole A/C compressor.
Question being, can I get away with buying the clutch pack and installing it onto my OEM a/c compressor? Or do I buy a new compressor?
Regal :: 1989 Buick Making Grinding Noise When Accelerate
My 1989 Buick Regal is making a grinding sound when I accelerate. It makes the sound slightly when it's just idling as well, but it definitely gets worse when I start going. It's been dying a bunch too. The engine will just shut off. The scariest part though, is when I pop the hood and have a look, there are shards of metal that I can only assume have been ground off, thus the grinding noise. It's near the belt, but that's all I really know because I'm not car smart at all.
View 2 RepliesTiguan :: Steering Making Grinding / Rubbing Noise At Low Speeds
The steering on my wife's 2010 Tiguan makes a bit of a grinding/rubbing noise at low speeds? Something isn't right, it sounds the same way my X5 did when the Rack needed to be replaced. It would be strange to have 2 cars needing new racks within the same year....especially since they are both 2010 model.
View 9 RepliesToyota - Rav4 :: 2010 - Brakes Making Grinding Noise
Just bought a 2010 Toyota Rav4 about 2 weeks ago. It rained the other day and the brakes made a grinding noise the first time I braked after starting the car but didn't make it after that. Did it again the same day, still raining, but only the first time I braked after starting the car. I have a 30 day guarantee on the vehicle and need to know quickly if the brakes are bad or not.
View 7 RepliesGolf IV / Jetta IV :: Passenger Window Making Grinding Noise
This just started on me not even an hour ago. I hit my switch and the window will go down all the way and the motor will continue running making a grinding noise until I hit the switch again. Same as when it goes up all the way. It stops at halfway and makes the grinding noise until I release and press the switch up again. Is this just the motor teeth going bad or are the cables getting frayed out possibly? Haven't had time to tear down and inspect yet.
View 4 RepliesPrizm - Chevrolet :: AC Making Metallic-sounding Grinding Noise When Off
About 5 years ago, my air conditioner started making a metallic-sounding grinding noise, when it is turned OFF. This noise goes away if the A/C is on. My mechanic said some part was slightly bent, bent it back, and this fixed it for a while. Eventually the noise came back but was intermittent. I drove the car for years hoping it would go away, leaving the A/C on most of the time. The noise is no longer intermittent, and my new mechanic says that it seems louder than before and if I don't get it fixed, it might cause the car to stall out. He offered to bypass it with a belt or replace the unit. What this could be? I drive with the A/C on now. 1998 geo prizm
View 3 RepliesPrius (2010-12) :: 2013 - Grinding Noise When Making U Turn
What might be causing this symptom?
View 14 Replies