Prius (Gen 2) :: Shift Knob Making Click Every Time On Selecting A Gear
This morning the Shift Knob made a click every time I selected a gear, for about an hour, then it went away.
It was colder than almost ever here (Berkeley, CA) last nite, 30F. But there was no click back in '05 at 10F (in Prudhoe Bay, AK).
Mechanics (even the dealership!) say not to worry--probably a plastic part--just advised me to shift gently.
Ford Ranger / B-Series :: Long Time To Go Into Any Gear When At A Complete Stop
When ever i am at a complete stop, i have to hold down the clutch pedal for about 4 seconds before it will go into any gear. If i'm in motion it shifts flawlessly through all gears. But if i stop and put it into neutral and let off the clutch, the next time i push it down it will take about 4 seconds to slide in any gear including reverse. I just bought the truck a few days ago so i don't know its history but everything seems well maintained. What this is and if it will cause major issues down the line?
1995 Ranger XLT 2.3L SOHC 2WD 5spd 169,000 miles...
Ford - Explorer :: 2004 - Transmission Hesitate For A Long Time Between 2 - 3 Gear And RPM Went Higher Than Normal
04' Ford Explorer - 4.6l Automatic 4x4 - 138,000 miles... While driving today my transmission hesitated a long time between 2-3 gear and RPM went higher than normal. After coming to a stop a taking off again, long hesitation, slams into 3rd gear, check transmission warning came on and OD light on dash was blinking. I drive it home and pull the code: P0745. I drop the pan and find a piece of metal 1/4 wide x 1/2 long. Does this mean a complete trans rebuild?
View 5 RepliesFord Excursion :: Backup Alarm On All The Time In Reverse
The backup alarm sounds when I put the truck in reverse when there is nothing behind me. I found posts about people not getting any sound at all but none like mine. I'm guessing I have at least bad sensor that 'thinks' there's something in the way when there isn't.
View 5 RepliesFord Excursion :: Transmission Leak / Hard Time When Try To Reverse
I've seen this talked about before and it's happened to me before as well but now the tranny is leaking onto my Ypipe a couple times per week and it's giving me a hard time when I try to reverse. revs drop and it stalls if I don't give it enough gas.
So I know I have to change the seal but Ford is telling me the torque converter will need to be replaced but another transmission shop told me once the seal is changed and fluid level set appropriately I shouldn't have the reversing problem anymore?
Is this something I could attempt myself... looks almost like I'd have to move the exhaust to drop the tranny...
Ford Excursion :: Hard Time Getting Out Of Park And Into Gear
Lately (within the last couple of days) when we park the Excursion we have a difficult time getting it out of park and into gear whether it is going in to Reverse or Drive the gear shift does not want to move.
I have not forced anything at any time but eventually with some pumping of the brake pedal and some putting into park and out of park we can free it up. This is something that happened virtually overnight and once we are in gear everything is normal.
What is causing it? I am making an assumption that it has to be some switch in the steering column but I am no mechanic and only guessing.
Ford Excursion :: Trans Slipping / Changing 2 - 3 Gear Every Time?
So ever since I picked up the truck from getting the springs swapped out the tranny has started to slip more and more. It's about at the point now where it does it at the 1-2 and 2-3 gear change every time unless I give it a little throttle so it shifts harder. It's just the normal shifting pause and then the slight jerk when the next gear starts. Time to a new torque converter, or am I looking at getting my whole thing rebuilt? If it's the converter I can give that a shot myself but if I have to have it rebuilt it's going to have to wait until January or February.
View 14 RepliesFord Excursion :: Hesitates For A Few Seconds Then Goes Into Gear When Put It In Reverse
My transmission has started acting weird. When it's cold it seems to be not as bad. First thing is when I put it in reverse it hesitates for a few seconds then goes into gear. Second it will drive great then just out of no where start shifting very hard then go back to shifting smooth again. Third when pulling a load it won't always start in 1st gear when you come to a complete stop sometimes it tries to start off in 4th.
View 8 RepliesFord Excursion :: Reverse Lights And Back Up Alarm Will Not Engage - Gear Shifter Adjustment?
My reverse lights and back up alarm will not engage unless i hold up on the shifter while in reverse the only thing i found was a adjuster for the indicator....
View 14 RepliesFord - Taurus :: Run For Long Period Of Time And Then Won't Start
The problem I'm having with this vehicle is that, it will start up just fine most of the time if I just hop in my after and haven't drove it for a while, however after I drive lets say 20 min+ and then decide to turn the car off and go back to turn it on, it just wont, it will turn over and its getting power but it won't follow through to start the engine, took it to a place by my house for 3 days and they said its probably the fuel filter but they couldn't give me a straight answer, what it most likely is? Its a 2001 Ford Taurus...
View 6 RepliesFord - Explorer :: 2002 V6 - Long Crank Time Before Start
So my 2002 ford explorer with the 4.0 L V6, has been cranking along time before it starts. I thought i had this figured out already, i put a brand new fuel pump in it from the ford dealer. That seemed to work, but the problem came back.
Especially when it is cold, it cranks a lot longer than normal to start. and when it does start RMPS go way up briefly and come back down. Seems to only act up when its cold out, say 35 degrees and lower.
So the remote start wont work because it only cranks for a few seconds and then stops. it tries this three times and it gives up. i go out there to start it and cranks for 10 seconds it seems like, sometimes i have to feather the fuel pedal.
Ford Ranger / B-Series :: 1991 - Take Very Long Time To Start?
Grandson 1991 Ranger 3.0 v6 69,000 miles We have a long start issue after it has sat for 30 mins. plus. If you open the throttle part way while cranking it will start fairly easily. Fuel pressure comes up instantly when you turn on the key. It runs at 39 psi pull the vac line off regulator it jumps to 49 psi. Fuel pressure does drop to about 30 psi after setting an hour. It kinda acts like it is flooded when it starts. so far we have done a complete tune up plugs wires cap and rotor. The ignition module has been replaced twice last one a real Motorcraft. New fuel pump and filter. Cleaned the fuel injectors with Ford cleaning system. I will replace the coil next and maybe clean the iac.
View 14 RepliesFord A/C :: 2006 F350 - Long Time To Start Cooling
A/C takes a long time to start cooling, but after it starts it gets as cold as it should. Seems to do okay while highway driving after it starts cooling. Is this a low refrig problem or do I have bigger issues?
View 3 RepliesFord - Escape :: 2001 - At Start Up Idles While Sat For Long Periods Of Time
I have a 2001 Ford Escape XLT V6 4X4. About 3 months ago I started to experience rough idle in the morning. It went a away for a month or so, but it is back now. I noticed that it occurs primarily after the vehicle has sat for long periods of time. More than 10 hours, give or take, and it happens, less than 10 and it generally doesn't. When the issue does occur it sometimes almost stalls. I can tell the computer attempts to make up for it usually. The check engine light came on originally but hasn't since, a mechanic could not pull any code and could not reproduce. The issue disappears within 3 to 5 minutes usually after everything seems to warm up. I'm had regular maintenance and I am an 75k. I've even tried using gas additives and tried a high grade of gasoline to no avail.
View 17 RepliesFord Escape / Hybrid :: 2012 - Long Time Between Shifts When Cold
My 12 Escape with the 3.0, shifts fine in warm weather or in cold weather when warmed up. But first thing on a cold morning she's a bit of a screamer getting into the next gear. Is this a signal of something about to go wrong? Is there an easy adjustment? Or this is the way of it and it is fine......
View 14 RepliesFord 6.0L Power Stroke Diesel :: How Long Is Extended Crank Time
So how long does one have to crank until it is considered an extended crank? 2 seconds, 5 seconds, 10 seconds.....?
The reason I ask is after all the motor work I did on my truck sometimes she fires up in less than 1 second of cranking and other times it take maybe 2 seconds of cranking. I do not think 2 seconds is considered and extended crank time but was just curious about what is considered extended cranking.
Ford - F150 :: 2003 - Condensation Inside When Running AC For Long Periods Of Time
My 2003 f150 v6 occassionally leaks a little inside when running the AC for long periods of time. Its only a little bit, and Ive noticed it after several road trips with the AC on the whole time. I am aware of a service bulletin fix on this. Essentially the problem is the two drain holes are horizontal through the firewall so air blows water back in, and the fix is to fit two L shaped hoses to block the wind and allow the water to drain downward in the engine compartment. I have done this months ago and it has largely solved the problem, when the water was more of an issue. My question is, is some condensation to be expected or is something clogged up? From time to time the heater core area makes a faint rhythmic rattling that goes away eventually.
View 2 RepliesFord - Windstar - Gasoline - Filters - Pump :: 2002 SEL - Long Crank Time
I have a 2002 Ford Windstar that only in the fall and winter it has a longer crank time of at least 10 seconds. In the summer it starts as it should within 3-4 seconds. I did notice that the times it did start normally in the colder air is when I turned the key on and listened to the fuel pump prime the system. All other times it doesn't do that and that's when I get the long crank time. Once it is started it runs as normal. Am I looking at a possible fuel filter or pump? I am due to replace the filter as the van has 83,000 miles on it. If this is the possible culprit, is this something that is easily replaced at home?
View 4 RepliesFord 6.0L Power Stroke Diesel :: Long Cranking Time When Sitting For Over 5 Hours
2005 Ex with 6.0. It has been bulletproofed. But has had a long crank after sitting for over 5 hours. I was starting to think glowplugs but no codes, Then thinking FICM, nope voltage has always been good. After I run the truck for a few miles if I kill it. It would crank right up. No issues. Only happened after it sat for awhile. I knew it had to do with HPOP system since it took about 5 to 8 seconds to show over 500PSI.
The passenger side does not have a leak since the oil is to the top of ICP sensor. When I was going to remove it. So I took off the drivers side. I inspected the dummy plug. No issues there "they are the 12mm with teflon plugs" I inspected the stand pipe. No issues there either. I inspected the small test port on the top of the rail. No issues there either. So I decided to air test it. So I used my auto-ingenuity to close the IPR valve after I heard all the oil blow out.
Then after sitting with 120 psi of air for about 10 minutes. I hear a bubbling sound coming from the Drivers side Rail. It was a plug I have never seen mentioned here. It is at the back of the rail. I removed it and sure enough the oring is split in 2. I went to ford and picked up a new Oring it was like $4. It also looks like its a different material. I am still in the process of putting the truck back together so i have not started it back up. But I am pretty sure this was my problem.