Touareg :: 2004 - Hesitates When Taking Off Lightly?
I have a gasoline V-6 2004 Touareg. It hesitates a little when taking off lightly or heavily from a start. I took it in and just told dealer to fix it. They replaced the (electronic accelerator connection)?? It made it maybe 25% better. What to do. Mileage is at 60K. MPG is about 13.5 in town. 18 on highway.
View 1 RepliesCamry 2012+ :: Transmission Shaking / Jerking When Accelerate Lightly
When I accelerate lightly and when the Eco light is on, u can feel a shaking or jerking in the gas pedal? But when I accelerate harder it stops. It seems to happen under light acceleration through most of the gears?
View 2 RepliesFord Excursion :: Hesitates For A Few Seconds Then Goes Into Gear When Put It In Reverse
My transmission has started acting weird. When it's cold it seems to be not as bad. First thing is when I put it in reverse it hesitates for a few seconds then goes into gear. Second it will drive great then just out of no where start shifting very hard then go back to shifting smooth again. Third when pulling a load it won't always start in 1st gear when you come to a complete stop sometimes it tries to start off in 4th.
View 8 RepliesFord Transmission :: 4R100 Hesitates Until Throttle Up To 1500 RPM Or So
I have a 2000 F350 7.3 with 308657 miles on it. After changing the trans fluid, filter and checking the center support bolts for proper torque I'm still having the same problem as before. When put in drive it doesn't seem to want to pull itself much until I throttle up to 1500rpm or so, then it grabs and goes. It acts similar in reverse but the rpms aren't as high. There was a coating of something inside the pan and on most of the parts along with the magnet being covered. What to look at to narrow down my problem?
View 4 RepliesFord Transmission :: 2001 - Trans Hesitates Going From 1st To Reverse And Vice Versa?
2001 7.3L I purchased used with 200K on it. Trans hesitates going from 1st to reverse and reverse to 1st. It seems more pronounced going from 1st to reverse. Fluid is clean.
View 2 RepliesFord Ranger / B-Series :: 1997 - Transmission Hesitates / Struggling To Shift Into Gears?
1997 2.3 5 Speed. My poor truck is having a hard time shifting into gears. I have bled the master off the truck with the correct method, bled it on the truck with the hose on the slave method while pushing the pedal and multiple times with no bubbles coming out at all, no leaks, etc.
Here's the breakdown -
- Clutch, slave cylinder and shifter bushings replaced about 3 years ago (everything has less than 7000 miles on it)
- While driving and pushing in the clutch, it clearly disengages, although quite a ways down.
- Only shifts hard while running. If I sit with it off with the clutch in, I can shift through all the gears with no effort whatsoever. At times while driving, it gets so hard to shift that it may become dangerous.
- Only things I haven't replaced are the master cylinder and the flywheel.
Should I just assume a bad master and just replace it? It's the original with 188,200 miles on it.
Forgot to mention there are times that when I am at a standstill trying to go into reverse, it grinds like the transmission is still engaged.
Ford Super Duty (1999-2016) :: 2014 F359 - Transmission Hesitates When Cold
I have a 14 f350, 6.2... Takes a few seconds to go into gear when cold, trans is fine otherwise, and I don't want to waste the dealers time if this is the way these things are:
When its warm and I put it in drive it goes right in .. .
When cold and only sometimes, it takes up to three seconds to go in gear .. .
It has 7000 miles on it .. .
Ford Transmission :: 2005 F250 - Trans Hesitates - If Engage Then Bang Into Gear Solid?
I have an 05 F 250 super duty with the Triton in it. When I shift either into overdrive or reverse the transmission hesitates (does not go into either gear for about 5 to 10 seconds). After that it engages and it's fine. It does not appear to be slipping or acting up regardless of temperature or speed. Sometimes it will sort of engage and than bang into gear solid. I do not have any check engine lights. Not sure if the PCM has any codes. So I'm trying to figure out if I need to have a complete rebuild or if I have a valve / solenoid body problem Where do I start?
View 4 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 - Transmission Work Slowly - Hesitates To Engage Drive After Reverse?
I have a 2002 7.3 e350 quigley 4x4 Sportsmobile with 312k miles. 2nd owner. Bought it with 295k miles 2 years ago. From what I gathered the tranny is original.
After reversing at a downhill angle, stopping, and shifting the lever to Drive, the tranny doesn't seem to put Drive in gear and depending on the angle of the slope, the van will roll back or barely creeps forward even with throttle. Put it in 1st gear, and the tranny engages that in gear and drives forward no issues, then I can shift to 2nd, then Drive and the tranny shifts fine after that.
No weird tranny noises or clunking. Noticed this issue about a month ago or about a couple thousand miles ago. Did tranny service (drain, filter, fill) at the ford dealership at 305k months ago.
I can only replicate this issue when Reversing on a down slope. On a flat surface van Reverses and engages Drive like normal.
Golf IV / Jetta IV :: Transmission Hesitates When Going From 2nd To 3rd Gear
I have a 2007 Volkswagen Jetta MKIV with an automatic 4 speed transmission (m01), and the car has only 100,000 kms on it, was always maintained either by myself or at the dealer, and never abused...ever!. Recently, I noticed that the transmission, going from 2nd to 3rd gear (and only 2nd to 3rd gear) will only sometimes hesitate...meaning the engine either revs a little bit (about 100rpm...yes one hundred) right before it changes gear, or if I'm going up-hill and it happens, it struggles to find the gear from 2nd to 3rd. However, this does not happen all the time, in fact, if someone who may not be as informed about cars, drove the car, the may never notice it. I checked with VCDS and no fault codes for transmission, only 2 fault codes from the engine misfiring because I sprayed the engine bay with water a while ago, and water accumulated in the dizzy.
View 24 RepliesChevrolet - Equinox :: Transmission Hesitates When Shifting From 2nd To 3rd Gear
I have a 2007 Chevy Equinox with 104,500 mi. For the past 20,000 miles (2-1/2 yrs.) or so the transmission hesitates when shifting from 2nd to 3rd gear. When this happens, the engine revs and the wheels lose power for a second or two, and then the shift completes.It happens anywhere from once or twice a week, to once a month.It never produces a "Check Engine Light" nor a "Code" when scoped the same day.It is more of a nuisance, although doing it while pulling into traffic could cause a nasty safety issue.I have had it checked by independent mechanics and a local Chevy Dealership and nobody has an answer.
View 5 RepliesInfiniti - G35 :: 2006 - Transmission Hesitates To Downshift When Lugging At 35 Mph
My daughters 2006 Infinity G 35 transmission hesitates to downshift when lugging at 35mph. Is this a trait of this vehicle or a problem with the tranny or anything else?
View 2 RepliesCamry :: 2007 V6 LE Transmission Hesitates To Shift / Holds When Cold
I notice on cold days my transmission hesitates to shift and holds 2nd - 3rd for a long time before finally shifting. Once the car warms , all is fine. Will and what could the dealer do for this? I would like it looked after before my warranty runs out.
View 11 RepliesVolvo - 240 :: 1986 - Transmission Malfunction - Hesitates And Lurches Forward?
I have a 1986 Volvo 240. It has a button to push on the stick shift to put it in 5th gear. It drives and works fine except when I downshift from 5th gear. ..then it seems confused and has a hard time getting back into gear, it kind of hesitates and lurches forward. It will not go into reverse after it has been in 5th gear until I turn off the ignition, and start it again.
View 2 RepliesAccent MC (2006-11) :: Transmission Hesitates For 4 Or 5 Seconds Before It Engages Forward Gear
When cold starting the transmission shifts into reverse perfectly, then after backing up the car and shifting into drive it hesitates for 4 or 5 seconds before it engages the forward gear.
2008 Accent 4 door automatic 77,000 KM
Ford Excursion :: Passenger Window Down By Itself But Won't Go Back?
My wife took my '05 Excursion diesel to work today with temps near zero. Got the sticky doors open for her and sprayed the seals with silicone so they won't freeze shut again. I don't think the spray has anything to do with this problem, but thought I'd mention it since I used it this morning.
At lunchtime she got in the truck, started it, and the electric passenger window behind the driver went down by itself and now won't go back up. All the other windows (and door locks) continue to operate properly. Thinking that perhaps some ice/water might be shorting out the circuit, I tried banging on and slamming the door, as well as "futzing" with both switches (drivers door and the switch on the problem door) with no change.
Also, I haven't had the door panels off the X, so if there are any tricks to popping the electric panel out without breaking retaining hardware....
Ford Excursion :: Back Right Passenger Window Won't Go Up
Rolled all the windows down(for the first time) to play some tunes. All of them went down like they should and all came back up but the back right passenger window. hit the switch...nothing, not even a tick like its trying to do something, it went down fine and dandy but is now totally dead. Figured it was the master switch on drivers door, spent the last two hours taking that apart, got down to the switch connections, cleaned connections and put back together...still nothing. At this point a really need to get it back up somehow(rain moving in), me and my brother tried jumping the connector, made some sparks fly but never got it up. mashing it hard, taking other switches from other doors, have tried all that and it still wont go up..er know.
View 13 RepliesFord Excursion :: Slap Back Going Over Bumps?
I've noticed that my Ex has an odd noise when driving over minor bumps like repaired potholes. It doesn't do it over larger bumps. Hard to describe, but it's like a "slap-back" after hitting the bump. Sounds like a dull thud that's apparently coming from the right front. Sounds like the wheel is hitting the bump twice.
Anyhow, after working underneath...and checking for things that are loose, worn, etc...I found nothing. The truck has just under 41,000 miles. The only thing that seemed to be a bit off was the right front shock. I pulled them all while painting/cleaning up...and of course, each one expanded immediately. This one didn't. Once it was compressed fully..it did expand but not as quickly as the others. (In order to get back on the road, I put it back.)
So, before I start throwing parts at this truck. My initial thought is that this one shock is weak and isn't keeping the front wheel planted.
All that being said, I could swap the shocks side to side and see if the noise moves. But....it's difficult to move gas shocks around so if it's thought that shocks could be the case..I'd just put new ones on. (Any recommendation?)
Ford Excursion :: 4WD - Could Not Get 4Hi Or 4Lo To Engage With Rocking Back And Forth
I had to make a few trips up and down the snow covered driveway. I moved the dash switch to 4wd high for each trip and then back to 2wd when I was turning around at each end. On my final trip back, I got stuck while turning around in 2wd. I tried switching to 4wd high and low but could not get either to engage with rocking back and forth.
The dash light did not come on and only the rear right wheel was spinning. Shifting to park or neutral and turning the switch to 4wd did not change the results. When I finally got myself unstuck, the 4wd still wouldn't engage when driving in a straight line.
What could have broke or stopped working? Bad vacuum line? Bad fuse? Could I have still initiated 4wd by manually locking the hubs? If so, is the process with the dash switch still the same even when manually locking the hubs?