Ford - Explorer :: 2002 - OD Light Start Flashing - Trans Bang In 4th Gear
It's a 2002 explorer, 4.0, 5R55W trans, all was fine then O/D light starts flashing, so I limp it home. Trans isn't slipping, every gear works, it does kinda bang into 4th but is otherwise normal. Took it to auto zone to have the code read, but no codes found. Disconnected battery to see if it just needed a reset maybe, let it sit for a few hours, reconnect, OD light still flashes. Borrow a different OBD2 tester, still shows no codes, still drives the same just bangs into 4th. I've read up on the solenoid pack replacement, just kind hesitant as I feel like I'm guessing at the problem and might be throwing money away.
View 2 RepliesFord Transmission :: 2001 - Trans Hesitates Going From 1st To Reverse And Vice Versa?
2001 7.3L I purchased used with 200K on it. Trans hesitates going from 1st to reverse and reverse to 1st. It seems more pronounced going from 1st to reverse. Fluid is clean.
View 2 RepliesFord Super Duty (1999-2016) :: 2005 F250 - When Engage Tow / Haul Button Transmission Doesn't Downshift Unless Feather The Pedal
I have a 2005 f250 super duty turbo diesel 6.0 automatic. The problem I'm having is, when I engage the tow/haul button the transmission doesn't down shift unless I feather the pedal. Also the engine will overheat at times. I've replaced the thermostat, but that's all so far.
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: 2002 - Transmission Work Slowly - Hesitates To Engage Drive After Reverse?
I have a 2002 7.3 e350 quigley 4x4 Sportsmobile with 312k miles. 2nd owner. Bought it with 295k miles 2 years ago. From what I gathered the tranny is original.
After reversing at a downhill angle, stopping, and shifting the lever to Drive, the tranny doesn't seem to put Drive in gear and depending on the angle of the slope, the van will roll back or barely creeps forward even with throttle. Put it in 1st gear, and the tranny engages that in gear and drives forward no issues, then I can shift to 2nd, then Drive and the tranny shifts fine after that.
No weird tranny noises or clunking. Noticed this issue about a month ago or about a couple thousand miles ago. Did tranny service (drain, filter, fill) at the ford dealership at 305k months ago.
I can only replicate this issue when Reversing on a down slope. On a flat surface van Reverses and engages Drive like normal.
Ford Transmission :: 2004 F450 - Transmission Will Not Engage In Any Gear
Just put the 6.0 back in the truck, engine working good now. Went to take it for a test drive and the transmission will not engage in any gear. I don't have any codes coming up on my scanner. Can not figure out why the transmission is not working from engine R&R.
- Fluid level is good
- Swapped wiring harness from my other truck and still nothing
Ford Brakes/Suspension :: Hub Locking - Bang From Front End When Engage 4WD
I have been having hub locking trouble and finally located a bad vacuum hose. Hose has been replaced. Now when I engage the 4WD and apply a little power, I get a terrible bang out of the front end, then the truck moves on. Sometimes there is a second bang, sometimes not. The chain appears tight in the transfer case and the ujoints look ok. I have turned the wheels with hubs locked one at a time and the joints are free.
View 9 RepliesTrans Sport :: 3T40 Automatic Transmission Suddenly Won't Engage Drive Or Reverse
This transmission shifted smooth and strong through all gears until today when it stopped all of a sudden to engage either Drive or Reverse. No previous signs of slippage, hesitation, stalling or lack of power whatsoever.
We checked the linkage to the transmission and it works as intended, nothing loose or broken, everything is in place. If there was something slightly different with it from other similar vans we have then it had a slightly delayed engagement in Drive (it took a second to engage it after you moved the lever) - on all other vans we have the transmission go into Drive almost instantly.
Van is a '92 Pontiac Trans Sport/Chevrolet Lumina APV with the 3.1L V6 Chevy TBI engine with the 3T40 automatic transaxle. Where we should start tackling this issue?
Golf IV / Jetta IV :: Transmission Hesitates When Going From 2nd To 3rd Gear
I have a 2007 Volkswagen Jetta MKIV with an automatic 4 speed transmission (m01), and the car has only 100,000 kms on it, was always maintained either by myself or at the dealer, and never abused...ever!. Recently, I noticed that the transmission, going from 2nd to 3rd gear (and only 2nd to 3rd gear) will only sometimes hesitate...meaning the engine either revs a little bit (about 100rpm...yes one hundred) right before it changes gear, or if I'm going up-hill and it happens, it struggles to find the gear from 2nd to 3rd. However, this does not happen all the time, in fact, if someone who may not be as informed about cars, drove the car, the may never notice it. I checked with VCDS and no fault codes for transmission, only 2 fault codes from the engine misfiring because I sprayed the engine bay with water a while ago, and water accumulated in the dizzy.
View 24 RepliesChevrolet - Equinox :: Transmission Hesitates When Shifting From 2nd To 3rd Gear
I have a 2007 Chevy Equinox with 104,500 mi. For the past 20,000 miles (2-1/2 yrs.) or so the transmission hesitates when shifting from 2nd to 3rd gear. When this happens, the engine revs and the wheels lose power for a second or two, and then the shift completes.It happens anywhere from once or twice a week, to once a month.It never produces a "Check Engine Light" nor a "Code" when scoped the same day.It is more of a nuisance, although doing it while pulling into traffic could cause a nasty safety issue.I have had it checked by independent mechanics and a local Chevy Dealership and nobody has an answer.
View 5 RepliesFord Transmission :: 1987 - Trans Won't Even Come Out Of 1st Gear
This is in an 87 crown vic( 5.0), the shop that rebuilt it is closed today. Before the rebuild, the trans would go from 1st to 2nd and that was it.
After rebuild, trans wont even come out of 1st. new torque converter was also put in. I've spent some time adjusting the TV cable and no matter where i have it adjusted, it doesn't make a difference. I am thinking its internal like stuck governor or shift valve.
Ford Transmission :: No Clutch / Truck Will Not Engage A Gear While Running
I have a 2001 m5r2 ford f-150 standard transmission. i have replaced the slave cyl., the entire clutch assy., the master cyl. pilot bearing. the trans. will engage all five gears plus reverse while truck is off but will not engage a gear while running. i have bled and bled and bled and still will not engage.
View 1 RepliesFord F-150 - 1997-2003 :: 2001 5.4L With 4R70W Transmission Won't Engage Any Gear
The problem started with a front seal leak a few months ago which I had no choice but to continue driving with because of low funds. I don't drive much so a couple of quarts of ATF was usually enough to get me out and about for what little driving I had to do. I know.. a front seal is cheap, but I'm partially disabled and unable to work on anything that is not under the hood.
I finally scraped up enough money to hire a friend to replace the seal, but he had a life crisis before completing the work, so I had to get another friend to reinstall the trany... still had the leak, but I could get around by adding ATF as before.
So we tried again... dropped everything and put another new seal on. This stopped the leak, but we got some grinding/squealing noises and could not get the trany to engage any gear.
From reading forum posts and other sources, we decided to replace the TC which we just completed this evening. We got some more of the grinding / squealing noise like before, except that it only occurred the first time we tried cranking the engine, the 2nd time we got no noises, but again no gears engaging.
What to check/replace next assuming there is something we can look at other than a total trany rebuild or replacement. I personally find it hard to believe we could have gone from a tolerably functional trany to scrap metal just replacing a seal and the TC. Its gotta be something simple we overlooked !!
Accent MC (2006-11) :: Transmission Hesitates For 4 Or 5 Seconds Before It Engages Forward Gear
When cold starting the transmission shifts into reverse perfectly, then after backing up the car and shifting into drive it hesitates for 4 or 5 seconds before it engages the forward gear.
2008 Accent 4 door automatic 77,000 KM
Ford Super Duty (1999-2016) :: 2005 F250 - 4x4 Would Not Engage
2005 F-250 King Ranch Diesel ... My truck when I got it the 4x4 wouldn't engage. I replace the front inner seals, and the lock outs. Still wouldn't work. Took the shift motor off and freed it up and it worked fin till today. Changed the shift motor and still nothing. This truck has been nothing but problems since I have had it and now this ... Truck is going on the market soon and would sell better if the 4x4 worked ...
View 13 RepliesFord Super Duty (1999-2016) :: 2005 F250 XLT - 4X4 Won't Engage
F-250 2005 XLT 5.4L 4X4. Had ford for a few years now (Escape as a personal vehicle and econoline as business vehicle). Now I'm having a little problem with 4x4. It wont engage. Worked fine last week and now nothing! I did check all the fuses and when i switch to either 4Lo or 4Hi I can hear a clicking sound behind the switch but feel like it's getting blocked or something. Tries a few time then stop...
View 14 RepliesFord Transmission :: 1979 F250 - Clunking Noise In The Trans
I swapped in a manual trans in my 79 f250 4x4 about a year ago. i had the trans gone through before i put it in. I installed a new luk clutch, resurfaced the flywheel, new throw out bearing, etc.
Ever since i installed it there was always a clunking noise in the trans. I drove it and didn't think much about it until recently where im just fed up with it. the trans always shifted nice and tight with no grinding.
In the past few weeks i picked up a parts truck for the trans thinking that's what my problem was. I drove the truck before i pulled it and it mad no noises whatsoever. I had it gone through and reasealed it before i installed it. I pulled my old trans and it still looked good with no slop on the input shaft(which i thought that was the problem). I installed the new one and once again same noise.
I decided to pull the trans again this time pulling the bellhousing and checking the clutch. It looked like new to me still and i saw nothing abnormal. Put it back together and still the same. I swapped the transfer case too, checked both driveshafts all is good. I am thinking its coming from the bellhousing(maybe the clutch is bad)
So here is a video and you can hear what I am talking about it happens mostly when I engage the clutch and i am coasting. it is much louder now with no carpet and the trans hump cover off.
Np 435 transmission clunk - YouTube
Ford Transmission :: 2000 F250 7.3 - Trans Slipping - Torque Converter?
I was driving my 7.3 down the road and it started acting like the trans was slipping, it revved up and tried kicking down a couple times and when I slowed down and went to speed back up it just had no power coming through the trans to the wheels it just revved. I put it in neutral and it idled up for about 5 seconds. I put it in park n shut it down. I fired it back up after looking everything over and it moved about half mile down the road and no power to the wheels again. The trans is full of fluid, is there a sensor that could of went bad or just the torque converter or the entire thing shot? Only owned my truck 6 months has a trans and motor swap already from previous owner. 180k on current motor n Trans. 382k on my truck. t6 4" turbo back banks exhaust only mods I know of.
View 11 RepliesFord Transmission :: 1991 F250 - Truck Is Slow To Engage In Reverse Taking About 5 - 10 Seconds
1991 4x4 f250 idi w e4od w 3:55 ratio... The truck is slow to engage in reverse, about 5-10 sec. It also has a very hard shift 1-2. All other shift points are good. Drop down is good, and TC lock up happens at all the right points (feels like anyway).
I've had the truck for about 2 years now, replaced several sensors an harnesses and a full fluid change to solve other problems but this still remains.
Sometimes when I start it in the morning if I let it sit and idle for a few min it will engage reverse much quicker AND shifts way smoother and constant. Shifts smoothly thro all gears, holding a constant 1800-2000 rpms with no drop or lug. Or do I need a rebuild?
Ford Super Duty (1999-2016) :: 2004 F250 - Trans Never Shifts From First Gear
I recently purchased a 04 f250 with the 6.0l powerstroke. I drove it for about 3 weeks now, Ive put my trailer behind it with small loads and just today tried to use the tow/haul button. When you go to pull out the tranny never shifts from first gear?? Its pulls and runs fine until you push the buttan and no shifting........
View 6 Replies