Ford F-150 (2004-2008) :: Loud Bang And Truck Quits
Just a hour ago, driving along about 45, then I hear a loud bang and my truck quits. I get off the road and it won't even turn over. I had a friend tow it back to the barracks and put a socket and breaker bar on the crank and can't move it. All the fluids are fine. Possible seized up? The thing was running great as always then boom. Nothing! It's a 06' F150, 5.4, 97K on it.
View 6 RepliesFord Excursion :: 2002 - Loud Bang When Applying Emergency Brake
2002 Excursion 4x4. While applying my emergency brake today I heard a loud bang. Now, the parking brake won't come up when I pull the parking brake release. Also, the noise is driving me crazy. Is there a way to release the pedal until I can get the cable replaced?
View 1 RepliesFord F-150 (2009-2014) :: Big Bang / Puff Noise - Truck Runs Like It Is On 2 Or 3 Cylinders
I have a 2011 eco boost 3.5. well I was driving it made a big bang/ puff noise then the no oil psi came on and runs like its on 2 or 3 cly. oil is leaking heavily on the passenger side of engine looks like by the turbo but to hard to see past engine mount. pulled the plugs and did compression check passenger side front cly 0 next cly 110 last 110, drivers side front 135 next 125 and last 120. Deep down I know the engine is nfg . was this a turbo fail . are engine swaps hard to do on the f150 .
View 14 RepliesAccent RB (2012+) :: 2013 - Transmission Noise / Loud Bang
Ive got a 2013 Accent with 16,000km on it. It has an automatic transmission. The noise is when i pass from R to D, or P to D. It is an intermittent noise, so it does not do it all the time. But when it does, it makes a loud "bang" that can be easily heard and felt in the floor. Ive had it checked by the dealer, but it never does it when its in the shop.
I always let the idle go down before shifting into gear and even if i hold the brake hard to change gears it does it anyway. It doesnt matter if the trans is cold or hot. And no, i never change gears when the car is still rolling, always when i have stopped completely.
Mercury - Mountaineer :: Transmission Makes A Loud Bang Noise When Slowing Down To Stop
I have a '06 Mercury Mountaineer, right over 100,000 miles. For the past few months the car has started to make a sound and even produce an "clunk" that I can feel when I am slowing down to come to a stop. It only happens when I slow down to around 3-4mph or slower. The transmission has only around 10,000 miles on it. What could be causing this?
View 9 RepliesFord Excursion :: Change Gearing In Rear Differential To Make Truck Go Faster At Lower RPMs?
I have a 7.3 2003 Excursion. Should I change the gearing in the rear differential to make the truck go faster at lower RPMs? I know that will decrease my towing capability.
View 12 RepliesFord F-150 :: 2001 - Loud Bang Sound Like A Shotgun Going Off On Highway
2001 Ford F-150 Supercrew Lariat 4x4
I was driving last winter when something bad happened. I was on the highway in 4H doing about 45mph (Really bad weather). Suddenly there was a loud bang, like a shotgun going off. The truck continued to run but it sounded like someone was beating my driveshaft with a metal pipe. There is no apparent damage but it grinds and bangs when it drives. The engine runs just fine. I limped it back home with the noises being constant only when its moving.
Ford 6.7L Power Stroke Diesel :: Loud Clunk / Bang When Downshifting Under Load
38k and 15 months old. Runs fine except...
Can be in cruise or not, tow/haul or not, but need to be pulling a decent hill with 7k+ trailer. Running level with air bags. Regardless of speed, cruising at 50, 58, or 65, beginning incline and turbo boost builds normally to maintain speed to the point when it needs to downshift. BAM!!, not just a clunk, 90% of the time- scares the hell out of me. I can make it do it on an incline empty, but it it difficult. If because initial speed is 50ish, a second downshift to 4th may be needed. A bang only 50% of the time.
No codes.
Regardless of the degree incline, (toughest in the NC/KY areas is 6-7% grade, can avoid harsh shift by backing off on throttle and manually downshifting to 5th or 4th, depending upon speed.
Can "make" it do it on level terrain with 7k trailer if I slowly back off throttle and slow from 65 to 50 or so and punch it, but not too hard. Too hard and it goes to 4th, usually with just a modest clunk. Just right and I get 5th with a loud, and I mean loud BAM. Even the tech was impressed.
Afraid to hook up my 17k 5er and take off for the next 3 months, which is the reason I bought the truck to replace my 11...
Carrier bearing has grease coming out of it (400k on various duallies and never seen this), but dealer says not an issue.
Ford told dealer that it had no idea, and advised tech to do a lot of pin point electrical testing and everything checks out. Next stop is the inner workings of transmission.
I have been without it and work for 3 days because of backlog. Running two day load tomorrow, then back in for tranny work.
Ford Super Duty (1999-2016) :: Loud Bang And Brake Pedal Went All The Way To The Floor
I was driving, Iput the brakes on then suddenly I heard a loud bang and brake pedal went all the way to the floor. I knew there was something wrong with the brakes, parked went and checked the passenger side rear brake caliper was ripped off which made a hole through my rim and also ripped off the brake lines. I need to get the part but I don't know what its called. See the pictures....
View 12 RepliesFord Ranger / B-Series :: 2002 4X4 - Loud Bang / Pop Comes From Driver Side Front Tire
Bought a 2002 ranger with a four liter in it. Didn't notice until actually going off-road there is something wrong with the four wheel drive. In 4 high it will drive good for a random distance then a loud bang, pop, comes from what feels like it's the driver front tire. The faster you're moving the worse it is. It's not consistent at all.
Replaced the transfer case shift motor and both CV axles. Still does it. Walked next to the truck while it's moving and the front tires look like something is in a bind and it's causing the bang. Beating my head against the wall at this point.
On a side note it has something wrong with the tranny. Taking off it feels like someone bumped the rear, and after about twenty minutes of driving od light starts blinking and it shifts hard from first to second. Kill it, cures that specific problem just not the takeoff problem. Not sure if this is all related. Pulled the pan and refilled with as much fluid as came out. Which was a dark red. Still having same issues.
Ford Super Duty (1999-2016) :: 2001 - One Loud Bang / Thud In Front Axle Area When In 4 Low
We were using my 2001 7.3 4x4 (automatic, manual lock outs) in 4 low yesterday on dry pavement in an attempt to pull out the remainder of a 6x6 post in concrete. We were working her pretty hard alternating directions of pulling. At one point we heard a loud bang (see also: thud; pop; etc). It seemed at that point that the front axle was no longer functioning in 4wd. We still had the low gearing feel, but at one point I noticed my rear tires trying to slip on the driveway, but fronts didn't appear to be pulling anymore.
Long story short, came in, went to bed, went out this morning and thought I'd jack up the front end and roll the tires in both 'free' and 'lock' to see if the universal joints (yokes?) behind each wheel were spinning or not, depending on whether free or locked in. I noticed on the passenger side a few drops of a clear/light colored fluid that had dripped from behind the dust cover that isn't functioning any longer. The joints worked as they should, based on if it was locked in or not.
I decided to go ahead and put the back axle on jackstands as well and see how it was working when "driving". When in 2wd, rear worked, front was stationary, as it should be. when in 4high, rear spun, front driver spun erratically, nothing from passenger front (where I had seen drip). 4low was same thing - erratic on driver side, at best.
So I know I have front axle/transfer case issues. The question is, with the drip (smells like grease, so I'm assuming its gear oil?) would I be safe to drive it a few days with hubs in free position? I don't want all of the fluid leaking out when I'm driving down the road. I use the truck for work and wouldn't be able to be without it until later in the week or next week. But I also don't want to drive it if it will just make my predicament worse.
Gmc - Yukon :: 2003 - Loud Bang After Backing Up Often?
I have a 2003 GMC Yukon XL 1500 4 WD. Ive been getting a loud bang ( like a hammer strike on the front frame) on occasion only after backing up and it happens after the truck moves forward a bit. You can almost feel the truck loading up and then it gives with a loud hammer like bang. Ive had a tech check the front end and do an alignment. I had thought it might be a brake hanging up.
View 2 RepliesFord Excursion :: Big Bang In Front Suspension - Jerk When Turning Steering Wheel To Center
Starting having a problem with the front suspension on my 01 excursion. When you go over a incline I am getting a big bang in the front suspension also when you turn the steering wheel to the middle it has a jerk right before its in the straight position.
I have new wheel bearings and new locking hubs coming, this problem still happens without the hubs in. Could it be a front axle or U joint but it happens with the 4x4 disengaged.
Ford Super Duty (1999-2016) :: 2004 F450 - Loud Click Almost A Bang When Cruise Control Shut Off
I've got a 2004 F450 that I'm loving, but suddenly having an issue getting it into gear. To get it out of park and into another gear I've got to turn the key a little father towards start (somewhere in between normal after start position and actually engaging the starter) and then the column shifter will actually let me get out of park and into another gear. Once I've done this there is no problem moving between gears. Last, this has to be related since it started at the same time - when I'm in cruise control it takes a greater amount of force on the brake to get the cruise control to shut off. When it finally does, it makes a loud click, almost a bang. If I only lightly push on the brake it won't kick off the cruise control and the engine will increase power to keep the speed and fight me on the brake.
View 1 RepliesVolkswagen - Beetle :: Backfire - Heard A Loud Pop / Bang
I have a 2002 bettle with about 150k on it. was running fine and one day while the wife was driving it she heard a loud pop/bang and it started missing and has low power. Starts fine just dosent have much power and is missing on one cylinder.
View 1 RepliesPhaeton :: Loud Bang Or Clunk Underneath The Pedal
2005 V8 Phaeton,82,000 miles.
If I ease on the brakes ,no problem but if I hit the pedal there is a loud bang or clunk from underneath,sometimes front and sometimes in the back. It's as if the wheels stopped but the chassis went forward and back slightly. As long as I put the brakes on gradually there is no problem stopping.
When I come off the Interstate and leave the off ramp, the low side of the front end sounds as if there is no shock absorber ,doesn't matter which side is low,they both do it on the low side.
Intermittent problems.
Steering wheel turns and grinding,groaning noises from under the hood, not all the time.
Going over a speed bump in a parking lot causes the same noise I get exiting the Interstate.
Prius (2004-09) :: Loud Bang And Rattling - Oil Leakage
Was driving down the highway when I heard a loud explosion.
View 9 RepliesPhaeton :: Loud And Aggressive Bang When Gearing Down After Accelerating
My phaeton's gearbox has progressively gotten worse.. When gearing down after accelerating I am regularly getting a very loud and aggressive bang rather than a smooth gear change, I believe the torque converter is on its way out or the transmission fluid is low.
What transmission fluid I should have in the Phaeton is it the 75w90? I want to try and top up the transmission fluid rather than getting the gearbox serviced as the waiting list in Dortsmund is too long and there is nobody nearby that I am aware of.
Ford Transmission :: Loud Grinding Noise When Put Truck In Reverse
Chasing down a grinding noise. I have done a lot of research but nothing quit matches up with what I am hearing.
I have a 1979 F250 4x4. A few days ago I put the truck in reverse and as I was backing up it was like the drivetrain locked up. After that I put the truck in gear and started on my way. As I got up in speed a pretty loud grinding noise was coming from the tranny. 2nd and 3rd gear aren't bad but when I get up to 40+mph it sounds like crap. If I push in the clutch the grinding is still there. While driving I also put the transfer case in neutral, kept the tranny in gear, pushed in the clutch and the grinding stopped.
I also took the lid off, inspected the forks and thoroughly cleaned the inside but noise still continues.