Ford Excursion :: Cruise Control Not Working?
Have this problem?
View 2 RepliesFord Excursion :: Cruise Control Does Not Work
Just got my first X(and Ford) a couple days ago. Anyways, the cruise control doesn't work. I checked the CC switch on the master and it tested fine and I installed new switches on the steering wheel.
When I do the self diagnostic test with the steering wheel switches they all test fine, and on the last button(set) it lights up, but no other flashes. What does that mean? In 1 thread it stats that 0 flashes is the speed control servo.
Ford Excursion :: Cruise Control Not Working Intermittently?
I had had intermittent issues with the cruise control not working in my excursion. most of the time it was fine though. after a recent 150 mile trip it stopped working half way through. i didnt worry about it too much..got back into town and checked under the hood. i found brake fluid running down the inner fender well! all over everything under the master cylinder. finally tracked it down to the cruise control switch on the master cylinder leaking. I pulled the plug apart and it was full of brake fluid.
Meanwhile the master cylinder was about half full, so i replaced it with the same switch out of a '96 parts explorer which is the same part luckily. also yes i have had the cruise control recall done. So if you have lost CC and you have a leak replace the switch! seems it can leak..and at a pretty good rate..alittle scary! glad i figured it out before my 800+ mile trip later this week/weekend.
Ford Excursion :: 2001 - Cruise Control Won't Working?
Looking for any pointers on fixing my cruise control Have looked around under hood but what it looks like. I've got the air working again,put Warn hubs on and have ordered the Hellwig rear sway bar,adjusted steering box i/2 turn....
View 14 RepliesFord Excursion :: 2001 - Cruise Control Not Working
The cruise control in my recently purchased '01 Excursion isn't working. I've done a lot of searches and discovered there was a recall for a wiring harness: 2001 FORD EXCURSION Recalls
I called my local dealer and they stated there aren't any open recalls for this vehicle, so the previous owner must have taken care of it.
Is there any way I can verify that the warranty work was done? Can I visually inspect the harness? What else I can check to fix the cruise control? The lights on the steering wheel are illuminated.
Ford Excursion :: 2003 V10 - Cruise Control Not Working
I have a issue with my cruise control not working. The Ford dealer in my home town has had my truck for 3 days now and cannot figure out what the problem is. I finally went by the dealer and wanted to know what the deal is and how can this take so long to figure out when they have to of seen issue like this in the past. The tech that is working on my truck said he has traced wires,etc and think it has something to do with the after market JVC touch screen DVD/backup camera. My question is would this affect the cruise? I cannot find anything on the net that may point in that direction. The steering wheel controls work for the fan and temp controls but not the radio as its aftermarket. Radio adapter for the controls?
View 14 RepliesFord Excursion :: 2000 - Cruise Control Not Activating
The cruise control isn't activating on my 2000 X. The light will come on, on the dash but it never sets. Are there any common issues with this system and is there anything specific I can check?
View 14 RepliesFord Excursion :: No Cruise Control And Light On Steering?
I have no horn, no cruise. I have lights on the steering wheel switches fine. I measured all the resistances for the steering wheel switches, and checked the horn switch as it goes into the clockspring, everything checked out fine.
Replaced the clockspring, no joy. Cracked open the old one, not a hint of any problem.Checked voltages and resistances at the cruise/servo module, fine. Took the servo module thingy and swapped it with my truck. Works just fine in my truck. My trucks doesn't work in the X. If I try to get the module to go into its self test mode by turning it on/off while holding the off switch, I can get it to blink on the dash, but the next switch presses bring no more blinks. I have continuity and a dry master cylinder switch. I have a working top center brake light, fuse tests ok.
Ford Excursion :: Cruise Control Module Location On 6.0
My cruise control is out. I have checked the clock spring wiring and it is OK. Going to replace the brake switch today. Looked for the CC module but cannot locate. Where it is on the diesel X.
View 1 RepliesFord Excursion :: 2001 V10 - Cruise Control Not Working
I have a cruise control issue. I tried the self diagnostics test, and the "cruise" light would not come on. (Also read that 2001 did not have a self test, so maybe that's why it didn't work? Also, when I first start it, all the other lights turn on except for cruise.) I checked the brake master cylinder and it has the double fuse wiring with 2 good fuses. Not quite sure what else to test. I just bought the X knowing it had this problem, but didn't know how much I would miss cruise control until driving without for a week.
View 12 RepliesFord Excursion :: 2005 V10 - Cruise Control Inoperable
I have a 2005 Excursion Limited v10 with inoperable cruise control that I bought 2 years ago. Since I don't use the truck much, I'm just starting to track down the issue. I've read a lot of the threads here, and done the cruise control system test, and come out with a failed switch. The 2005 is NOT part of the master cylinder pressure switch recall.
However, in digging around, I have no wiring harness attached to the master cylinder pressure switch. I also don't have any loose wiring harnesses or obvious signs of any wiring just being cut off. Talking about wiring, where to look, where it should be connected or what I might need to purchase? No wiring harness..
Ford Excursion :: 2002 - Cruise Control Would Come On Intermittently
2002 Ford Excursion cruise control inoperable. Problem began when cruise would come on intermittently. I would push the on button then set, at which point the green cruise icon light would either come on and the cruise would set or she would flash and not set. Sometimes holding the switch down worked, other times not. Now no matter what I do the cruise will not engage.
I have had the recall done for the cruise control by the dealership.
I have checked the fuse on the recall module, the 2.5 is in good shape and not blown.
I also found this guide to a self test (copied below). I used the test, turning the key on with the off button depressed yields a green speed icon light. Letting go and pressing on yields a green flash as well. But when I move on to pressing resume I get no lights at all, same if I continue through the other switches, no more lights.
Here is the self test guide -
*cruise control self test
Enter self-test diagnostics by depressing the speed control OFF switch while turning the ignition key ON, making sure the engine does not start and is not running. The speed control indicator on the instrument panel will flash once to indicate that speed control module entered the diagnostic mode. Five additional flashes at this point indicate a defective speed control servo.
Release the OFF switch.
Press the remaining switches in this sequence: ON, RESUME, COAST and SET/ACCEL. If the ON switch is not depressed within five seconds after entering the diagnostics mode, the module times out and the procedure must be started over.
The speed control indicator lamp will flash as each switch is depressed. Press each switch in the sequence immediately after the indicator light goes out for the previous switch. NOTE: There will be a slight delay when the last button is pressed and the lamp flashes.
A lamp flash with the last button (SET/ACCEL) indicates that the static test passed. If the lamp does not flash with the last button and there are no additional flashes of the lamp, the switch is defective. If the lamp does not flash with the last button, and additional flashes occur, follow the chart below for trouble codes:
2 flashes - BPP defective, circuit is defective, brake applied, CPP switch or jumper (if equipped).
3 flashes - deactivator switch is open or circuit defective.
4 flashes - vehicle speed signal is out of range or circuit is defective.
Immediately (.25 second delay) after the static test, the speed control servo does a dynamic test by automatically actuating the throttle lever from 8 mm (0.315 in) to 12 mm (0.472 in) of travel from the idle position. During the dynamic throttle pull, observe throttle movement to witness any binding or sticking of the speed control cable and correct connection of speed control cable to throttle lever. Make sure the throttle returns to the idle position.
Ford Excursion :: Fuel Gauge Is Not Working / No Cruise Control?
My fuel gauge is not working, nor is the cruise control, Had the truck looked at, was told the cruise was not working due to the fuel gauge not working?
Also when he hooked it up was told the dash gauge worked fine and the computer showed 60% which would have been about right based on mileage on the tank. My guess is that I need a sending unit?
Ford Excursion :: 2000 - Cruise Control Just Quit Working
I have a question on my '00 7.3. Cruise control just quit working. From reading the threads/forums I have gotten some ideas, but how about no dash light when turning the key to on? Nothing with the self test also. How can I troubleshoot the switch in the steering wheel? I could also have a bulb out in the cluster, but either way- no cruise function.
View 4 RepliesFord Excursion :: 2002 6.8L V10 - No Cruise Control / Indicator Light Comes On
I just bought my 2002 Excursion about a month ago, and the cruise control doesn't work. When I'm driving, I press "ON", then "SET", the CC indicator light comes on, but when I take my foot off the gas, it doesn't maintain speed.
I've done the self test, and all the lights blink once. Just to be sure, I've replaced the CC switch on the master cylinder, and the Brake switch mounted above the brake pedal. Still no joy.
Ford Excursion :: 2001 - Cruise Control Stopped Working
One day it work and the next day it didn't. I checked the 15a fuse and it was good. What else should I be looking at?
View 12 RepliesFord Excursion :: 2003 2WD - Cruise Control Working Intermittently
2003 X limited 2wd 6.0L ... My cruise control was working intermittently. Could it be the buttons on the steering wheel itself? there is a cluster that I see. Does it pop off to expose the connectors/switches? Can these go bad? Can I buy new switches for the steering wheel?
View 2 RepliesFord Excursion :: 2002 - Cruise Control Quit Working?
The ruck is a 2002 Ex limited v10 4x4. The cruise worked fine till my wife drove the truck! the green cruise light blinked a few times, now, there is nothing.I'm no good at electrical issues.
View 3 RepliesFord Excursion :: 2005 - Cruise Control Module Location
Discovering where my cruise control module is located on my 05 Excursion. . . I've looked at all of the pictures showing that it should be right in front of the a/c unit, underneath the vacuum pump, but on both my 04 and my 05 Excursions, there is nothing to be found on that location. Where the bugger can be located.
View 2 Replies