Ford Super Duty (1999-2016) :: F250 - Brake Slide Pins Removal
I have a 1999 F-250 SRW 4x2. Is there a post that explains how to remove the front brake slide pins?
View 3 RepliesJeep - Liberty :: 2012 - Squeaking From Under The Hood When Accelerating - Brake Caliper Slide?
I recently had a dealership mechanic check out a couple of annoying noises my 2012 Jeep Liberty had been making for a few months. The one that really bothers me is a squeak coming from under the hood. It squeaks pretty constantly when I'm accelerating at all, only stops when I brake. Now, I'm totally clueless about cars and I realize how easy it would be for me to be taken advantage of, but I don't want to be bitchy to the guys fixing my car. I was told this squeak is the brake caliper slide so I told them to go ahead and fix it. The guy comes back 3 hours later (had to order the part) and says he's replaced the part and did all he could but it still squeaks. Am I being jerked around? Should I just take it elsewhere for a second opinion?
View 11 RepliesCamry :: 2005 / 3.0 - Front Caliper Pins Mixed Up
Someone had worked on the car and front caliper pins got mixed up. Where the pin with the rubber piece goes into. The top or bottom of the caliper. and is it the same for both sides.
View 2 RepliesFord 6.0L Power Stroke Diesel :: 2006 F350 - Front Right Caliper Won't Slide Off Pads / Stuck
Replacing remaining three calipers on my 2006 F-350 2wd as a preventative measure after I had a drag on the left front. Passenger side front being difficult. Caliper won't slide off pads. I believe pins are stuck but it doesn't seem they've got the caliper stuck - appears that I can't get pistons to stay compressed enough to clear pads. Caliper has some wiggle on pads - just not enough.
I tried multiple C-clamp iterations but can't get there just yet. I'd rather not fool with the bracket and removal won't fix my problem, just allow me to work it on the bench. I do have a replacement caliper, so damaging it to get it off is an option. I have sprayed Kroil into the piston seals in a Hail Mary when I pick this up tomorrow.
Ford Excursion :: Rear Brake Caliper Line Installation?
Routine maintenance gone wrong.
Installing rear brake line and failed to put on the rear washer and stripped out the bolt hole mostly. Will still unscrew and screw back in but not enough to stop a slow drip. Is there an easy repair or time for a new caliper? Thread tape is not brake fluid resistent.
If no repair, what brand should I go with? Are they all similar or MC better? Can get Fenco for $50 and MC for $100. A1 Cardone and ACD for about $75.
Ford Excursion :: Rotors Rubbing On Caliper Bracket - Brake Rotors Too Thick?
I replaced my warped front brake rotors a couple thousand miles ago and all was fine but when I went to swap over to my snow tires, I can see that the outer part of the rotor has been rubbing on the caliper bracket. This is happening on both front rotors. Could my new rotors be too thick or something?
View 4 RepliesFord Excursion :: Top Bolt For The Caliper Is Frozen
I was replacing the brakes on the X, the threaded part that receives the top bolt for the caliper is frozen. I tried whacking it with a hammer and tried to free it up by turning it but no good. The bottom bolt assembly worked like it should but the top is frozen solid and makes the brakes rub, you can smell it. Do I need to replace the whole assembly or is there replacement parts for this?
View 6 RepliesFord Excursion :: Stuck Caliper - Squealing After Braking?
I think I have a stuck/sticky caliper. I am getting some squealing while under way after braking. It will fade away after a little while, but it it's bad enough where a friend left a message saying he could hear me coming...
I am also getting a shudder when braking at certain speeds (from @ 20-30 mph).
I replaced my front rotors @ 40k miles/4 yrs ago w/ PowerSlot Cryo's & Hawks LTS pads on all 4 wheels. I greased the pins at the time on the original calipers ('04 4wd 6.0 X w/ 105k miles now). The brakes have been great since, but the squealing/shudder started this spring.
Is it likely I need to replace the whole caliper, or can I get away with a pin kit? I want to order all the parts and be ready to do a weekend job.
Could the shudder be from the caliper, or is it likely i need to turn the front rotors? I'm planning to put new rear rotors on & new Hawk LTS pads all around again at the same time as dealing with the caliper. What rear rotors &/or calipers to get? I'd like to spend a bit less on the rear rotors vs the Powerslots.
Avalon 2005-12 :: Slight Rattle - Loose Right Front Caliper Bolt
My 2012 Avalon developed a slight rattle at 9000 miles that continued to get worse. I took off the right front wheel today and found the top caliper bolt partially loosened. I could turn it with my FINGERS! The other one was tight as were the ones on the left side.
To diagnose this rattle, find a bumpy road that makes it rattle. Put your foot lightly on the brake (to load the caliper). If the noise goes away, it is probably a loose caliper bolt.
Ford F-150 (2004-2008) :: No Brakes After Caliper / Brake Pad Change
After a routine brake pad replacement the brake pedal hits the floor when applied with normal force. The pedal feels like a badly leaking master cylinder, but prior to the pad replacement the brake pedal was firm as a rock with no drop at all. If I pump the brakes the pedal will come up to normal height, but if I then maintain light pressure the pedal will again sink to the floor.
1. Truck was braking fine, however pad 3/4 worn
2. Replaced front calipers, rotors and pads
3. Replaced front brake feed hoses
4. Replaced rear pads
5. Started engine
6. Started bleeding from furthest point from MC a) passenger rear, b) Driver Rear, c) passenger front, d)driver front. Did it two times...
Still, brake travels all the way to the fire wall and never develops tension. Moreover, sometimes, when person pumping brake puts pressure and i open bleed, no fluid comes out. Could it be a failed master cylinder??? I tend to think it's not because 24hrs ago, the pedal felt fine and the truck was braking ok.... So much for preventive maintenance.
Ford F-150 - 1997-2003 :: Front Right Brake Caliper Locking Up
My buddy has been having a strange problem with his 275,000 mile 2003 F150 2wd. The right side caliper will lock up out of the blue and will not release for anything. We put 3 news calipers on it within a 4 week period thinking that we had a defective one but no change. I am thinking either a bad brake line or, more likely, the front abs block...
View 1 RepliesFord - Explorer :: Left Front Brake Caliper Locked Up
My teenage son just bought his first car, a 1991 Ford Explorer XLT 2-wheel drive. I had it checked out by our mechanic before I let him shell out the money, and everything seemed OK. It's the prototypical low-mileage car (127k actual, confirmed by Carfax) owned by a little old man who took good care of it (stack of service records a foot high) and didn't drive it very much.
Earlier this week ... he'd driven it for about two weeks with no issues ... the left front brake caliper locked up on it, to the point where it heated up enormously, the pads and rotors got so hot they were discolored and some transmission fluid got blown out by the strain.
He took it to our regular mechanic, great guy who we've used for years and has worked magic with our cars, he got into it and he diagnosed the problem as ... I hope I'm explaining it right ... a little pin or piston or something in the caliper was upside down. He put it back in the right way, and everything seemed to be OK, although he said my son would probably end up needing a brake job sooner than later because of the way the pad got ground down.
FYI, master cylinder is full of fluid, our mechanic couldn't see any leaks anywhere. Although when we took the car to the mechanic, my son tried to back it up to get a better angle at getting into the service bay, and the pedal went to the floor.
Fast forward two days, and danged if the same thing didn't happen with the right front caliper, seized up although he didn't get it as hot as the other time, parked it a lot quicker. And of course it happens on Friday going into the weekend, when our mechanic isn't working, he won't be able to do anything until Monday, which leaves us scrambling trying to get everyone to work, etc., down one car.
Doing a little online homework ... which we probably should've done before my son made this purchase ... I'm seeing a lot of brake issues with '91 Explorers. I asked my mechanic if he thought there was some ABS-related problem here and he said he didn't think so.
I will say that the car apparently sat undriven for a long time, which I know can unleash a lot of issues. What might be going on here? Do we just need to go ahead and replace the calipers, any hoses, etc., as preventive maintenance?
Ford Ranger / B-Series :: Front Brake Caliper Seems To Be Sticking?
Yesterday, I noticed that my right front brake caliper seemed to be sticking. This morning I jacked up the front end, and could barely turn the right front wheel when it was off the ground. So, I have concluded that that caliper is sticking. So, here is the question(s): what is the best way to repair this (new caliper, rebuilt caliper, or rebuild it myself), do I need to do both sides the same or can I just do the one that is acting up, and should I expect to pay. I have some mechanical ability, but that Haynes manual doesn't make too much sense to me. Getting it professionally repaired is extremely inconvenient, I need to be back at school (300 miles away) Tuesday evening, and probably couldn't get it in to get it done before then.
View 12 RepliesFord Brakes/Suspension :: Brake Caliper Bracket Stripped - Options?
I pulled a brake caliper off for inspection, and when I reinstalled it, I managed to strip one of the holes on the caliper bracket when putting one of the 7mm bolts back in - haste makes waste, ya? So, I am trying to find out my options, is it possible to get it re-threaded, helicoiled, or is it toast and I need to buy a new one?
View 2 RepliesFord Super Duty (1999-2016) :: Rear Brake Caliper Locked Up?
About a year ago, I had my right rear brake caliper lock up on my F350 dually. The shop said it can happen and replaced both rear calipers. Last week I started to hear something from the rear and within less than a a few days, before I could get to a shop the noise increased and when I looked the rotor had been gouged on the right rear.
I cannot see the left rear rotor to compare as the wheels don't line up on that side to see through. So my question is this. Could it be the caliper failure was a symptom and not the cause. Maybe a proportion valve or something that could affect the pressure on that one wheel.
Ford Super Duty (1999-2016) :: F250 - Brake Caliper Won't Release
My 1999 F250 right rear brake caliper will not release. I replaced the caliper, caliper mounting hardware, pads, rotor, emergency brake pads, and I bled the system. For some reason the right rear remains activated when my foot is not on the brake pedal. The other three wheels appear to be functioning normal.
View 6 RepliesFord 6.7L Power Stroke Diesel :: 2011 - Disc Brake Caliper Sticking?
Have 50,000 mile on my 2011 F350 6.7 and up until today the truck has been flawless. This is my weekend vehicle and sees very light duty hauling fishing gear to my boat (100 miles hwy) and pulling my 7x12 enclose trailer with goose decoys. On a couple of occasions pulling my 29 CC from marina to my home and back. Took truck in for oil change and tire rotation, service advisor informs me I have 2mm on rear brakes and 3mm on fronts. Not sure why rears have more wear than fronts. Schedule to have brakes done for today and now find out that front right caliper is sticky and they want to replace both front calipers. I cannot believe that a 2011 SD F350 with 50,000 miles and of that mostly highway needs brakes let a lone calipers are going bad. Service manger tried to tell me that brake fluid should be replaced every 2 years, to which I responded that I have Ford perform all scheduled maintenance. He went on to say that this is not scheduled maintenance, wtf bs is he telling me, if it is necessary then it would be scheduled maintenance. Truck gave zero indication of stuck caliper, no sound and no excessive brake dust on wheel.
View 14 RepliesFord F-150 (2009-2014) :: MPG Dragging - Caliper Locking Up - Replace Whole Brake System?
I was uber excited to buy my first brand new truck in 09..... Amount numerous issues, defective rear window (fought with ford for 3 years never replaced under warranty), sync issues draining my battery, multiple O2 sensors replaced, multiple lights replaced and a blown drive shaft all under warranty. Now my warranty literally just ended, years not miles, just rolled 36k yesterday, ran out 3 years in November 12, now I'm having break issues.
A few weeks ago while driving, I released the gas and truck seem to slow faster than normal. Seemed kind of unusual but also began to noticed a drag on my mpg, about 2-4 mpg difference, depending on highway or in town. Now 3 weeks later, I feel grinding under breaking. Now it's beginning to make sense. I figure probably a stuck caliper. While driving with head out the window , freezing in IL, by the way, seems to be the drivers front. Checked rotors, outsides only as there are the guards preventing me from checking the back side. No visual or touch grooves ground into the rotors from the pads being worn out. Best bet is its the back side of the caliper that is locked.
Question 1, does this make sense, only one side of the caliper locking up? I had a caliper lock on my old GTP but the whole thing locked up.
Question 2, do I just suck it up and replace the breaks my self, gf's dad is a manager at O'rylies so I can get anything I want at cost, or do I go back to the dealer and bitch about mechanical problems being constant with my new now only weeks out of warranty truck? I read some horror stories about clogged lines and numerous other issues causing calipers to lock. I don't feel like replacing my whole break system, lines, calipers and all just to make sure the problem is fixed. At 3 years this seems ludicrous.
Ford 7.3L Power Stroke (1999-2003) :: New Caliper Now Loose Brake Pedal?
Ive had plenty of brake issues with this truck since I've owned it and I finally got to inspect a brake i knew was having issues. The outside pad was metal on metal. The inside pad was gone and the one piston was extended completely open while the other one was closed. So to the question. Ive bled it like i do any other caliper and no luck. I went an bled all the other calipers and still no luck. The brakes seem to be working ok even though i never really tested them super hard but the pedal is far lower then it was before.
View 9 Replies