Ford Excursion :: No Air On Passenger Side - Blend Door?
Went into town earlier and the a/c was not blowing out the 2 passenger side vents. Could switch to defrost and it would blow correctly. The rear is working as well. The drivers side vents blow good and if you cover those with your hands to block them off its like it forces air to blow out the passenger vents. Could this be a blend door issue?
View 2 RepliesFord F-150 (2009-2014) :: 2013 - Clicking Under Dash - Heater Blend Door Motor?
I have a 2013 Lariat with 135K miles. Yesterday started a loud and consistent clicking under the center dash. When I turn the heater up to 77 degrees or above it stops. I have dual AC controls and the passenger side will now occasionally blow hot compared to the driver side when I have them on the same temperature.
Based on what I have researched I need to replace my heater blend door. Need to confirm if this sounds correct? Are there different blend doors for driver vs. passenger side repair?
As importantly I am looking for a good set of instructions on how to gain access to the heater blend door motor in order to take care of the replacement myself. My understanding is it is a $40 part buy may be heavy on services due to access. My 2013 is stocked with the sync touch screen / navigation option .....
Ford Ranger / B-Series :: 1999 - Blend Door That Channels Air To Dash Vents Is Opening And Closing
Started the other day. Seems like the blend door that channels air to the dash vents is opening and closing as it feels like it. Sometimes open for awhile, sometimes closed. The defrost vents keep blowing cold and normal while doing this.
View 9 RepliesExplorer :: Clicking From Under The Dash - Blend Door Stuck
Recently when I adjust the temperature, there is a clicking from under the dash. It sounds like the Blend door is stuck.
View 7 RepliesSaab - Heating - 9-5 :: Blend Door Motor Not Opening To Allow System To Switch From Air To Heat
I have a SAAB 2000 95, and the heat isn't working. I was told by a local shop that the blend door motor isn't opening to allow the system to switch from air to heat. He said that the heating system was working, but that the hot air can't exit the dash. He said it would have to be repaired at a dealership.
View 3 RepliesFord Excursion :: A/C Seems To Only Blow Out The Front Windshield Defroster
I'm having with my Ex. When I have the A/C (or heat) on, it seems to only blow out the front windshield defroster. Once in a while it'll blow out where it should, but 99% of the time it only comes out the defrost. This is when I have it on face, face/feet and feet.
View 6 RepliesFord Excursion :: 2003 - Windshield Front Wiper And Sprayer Quit Working
I'm working on a 2003 that the front wiper and sprayer quit working on. The rear wiper and sprayer still work fine. We replaced the multifunction switch and no change. I would like to test the motor before we keep throwing parts at it.
View 5 RepliesFord A/C :: Blend Door Actuator - Clicking
What is the difference between :
Part # XF2H-19E616-FA and
Part # YL5Z-19E616-AA?
The middle numbers are the same. And they look the same? the first one is mine. Blend door actuator out of a 2000 ford windstar. Will another part # work? If the connection is the same?
Ford A/C :: 1999 - New Blend Door Actuator Won't Working?
I have a 99 EB Expedition 5.4 with EATC climate control. I replaced the heater core that had been leaking severely. When I got the dash back on I adjusted the controls with the engine running while watching the blend door actuator under the dash. it moved but not as much as I thought it should. So I drilled an "inspection" hole behind the glove box and into the plenum cover. I watched the blend door open and close when the hot/cold buttons were adjusted, but the movement was intermittent.
I'd checked the blend door for cracks prior to installing the heater core and found none. I left things alone for a day while I drove as normal. When I had time to work on it again, the actuator quit working. I figured it was damaged from the coolant leaking into the cab so I decided to replace it. It was indeed full of coolant. I bought a Dorman actuator (part #604-216) and plugged it into the wiring harness to test it before installing it. I adjusted the controls with the ignition in the "run" position and nothing happened. I'm at a loss as to what could be the problem. I've searched for this problem, but the only threads I find are incomplete or deal with the "manual" controls. I checked all my fuses and they are all good.
My questions are:
Could I have bought the wrong actuator? Would the harness fit the "manual" actuator? The part number was identified as being for the main blend door for "automatic" controls. Is there a possibility the EATC head unit is bad? It still sends air to the panel, floor and defrost when adjusted.
How do I test the voltage at the connector? I just bought a multimeter but I'm not sure which wires in the harness deliver power to the actuator. I know there are a lot of people on this site who've gone through the heater core/blend door ordeal and have lived to tell about it. What I should do next.
Ford Aerostar :: Blend Door Actuator Location
Where is the Blend Door Actuator on the ford Aerostar?
View 14 RepliesFord Excursion :: Door Ajar Little Red Light Illuminated On Dash
The "Door Ajar" light on my Ex has apparently decided that I would enjoy having the little red light on the dash illuminated. Normally, I'd consider this just a nuisance, but it's convinced the interior and running board lights to play along so that they don't go out until they time out. I'm pretty sure that it's in the rear door somewhere. Where the sensor(s) are for the rear doors and how to test them?
View 14 RepliesFord F-150 (2009-2014) :: Blend Door Actuator Re-Calibration Before Using?
Time for me to replace the actuator. I just have one. I've watched many videos on it but none say anything about re-calibration before using. A few posts say this is needed. Is it? if so how is it done?
View 6 RepliesFord A/C :: Blend Door Actuator Broke (Gear Inside)
I have an Explorer with automatic A/C. The blend door actuator broke (a gear inside) so I replace it with a Dorman part (could not find the Ford ones anywhere). Part #604-202, looks identical and fits. But... doesn't work.
If I do the EATC test (OFF+FLOOR, then AUTOMATIC), the display shows error coded 024, 025, 052. What is the meaning of those?
Ford - Mountaineer :: 2003 - Very Little Heat In Cabin But Not Blend Door?
My 2003 mountaineer 4.6L has front and rear heat. The issue is the heat in the front is barely warm and the heat in the back is poor. I have replaced the blend doors front and back and I'm sure they work as I can go from cold to barely warm and back again when I change the temperature setting.
I can feel hot fluid going from the engine to the front heater core and also down under the vehicle to the rear when the vehicle is warm. The return on the front is almost cold - so heat is being given up by the heater core in front, but it seems to me that if the return is almost cold, there's not enough hot coolant delivery. The overall heat is very poor in the cabin.
The coolant temperature gauge is steady and just below 1/2 with no erratic movements. I flushed the front heater core a couple years ago. Coolant has also been flushed last year. I know that the heat is underpowered in this vehicle, but it's a far cry from when it was new.
Ford A/C :: 1997 F150 - Blend Door Stuck In Hot Position
Dad has a 97 F150 with some heater issues. He put a new potentiometer in and it didn't work. We he turns the dial to cold, it still blows hot air. Defrost =hot, vent=hot, a/c=warm etc.....
The dealership told him that the blend door might be stuck. My question is, how hard is this to fix? Is it something that I can just stop by after work and quickly fix. What is involved in fixing this and where it is?
Ford F-150 - 1997-2003 :: Replace Blend Door Actuator?
Whenever my A/C is turned on, it blows nice cold air. As long as the blower is on "1", "2", and sometimes ", it blows cold air. If I turn it to "4" I can hear a small "thud" behind the dash. It sounds like the blend door is shutting. All my functions work like they should. I think the actuator is goin out and isn't pushing the door all the way closed, and when I turn it to "4" it pushes it te other way.
View 5 RepliesFord Ranger / B-Series :: A/C Works Occasionally - Blend Door?
Compressor clutch engages, lines are cold, when it works air is cold. A/C guy thinks the blend door isn't working right, is it vacuum operated or electric?
View 3 RepliesFord Excursion :: 2002 - Dash Light For Door Ajar Stays On
I own a 2002 excursion and my dash light for door ajar stays on, I pulled all of the contacts off the rear doors and hatch and found that there are no electric hook up to what I thought would be the contacts i needed to be looking at. So what relays the signal to my dash that the doors are in fact closed?
View 14 RepliesFord Ranger / B-Series :: 1998 - Replace Blend Door Actuator?
I purchased a 6.7 Diesel 2014 F250 Super Duty Crew Cab about 3 months ago. Yesterday I started my truck using the remote starter from inside my house. Seconds after I heard a loud noise. Looked outside, saw nothing and thought nothing of it till I went to open my door and realized that the driver door window shattered! I live in a quiet area, it wasn't a rock thrown at my truck or anything like that, it just Blew!!!!
I'm wondering if the truck might have some sort of pressure or torque if you wish on that window to make it just pop! My mirrors were folded in however I can't see that playing a role......