Ford F-150 (2009-2014) :: Back Up Warning Alarm Starts Beeping Constantly
My 2012 F-150 has the back up camera, and the warning system that beeps with increasing frequency when you're backing into something.
It's worked flawlessly, however the last few times I've started and put it in reverse, it starts beeping constantly although there is absolutely nothing back there. Having been on this forum for probably 3 years, I don't recall this system ever being discussed.
So, where is the sensor located? I looked all around the obvious places, like under the rear bumper, and don't see anything. Is it part of the camera
system?
Secondly, what could make it beep when there is nothing there? Yes, the tailgate is up, and there is nothing in the hitch that might trick it. I'm thinking
dirt on a senor.
Ford Excursion :: 2003 - Back Up Sensors Went Out?
Outside backup sensors both went out on my03' Excursion, but the inside ones are still working.
View 3 RepliesFord Excursion :: Off Lit Up On Back Up Sensor Cancel Button - No Beeping
So the other day, I noted the OFF was lit up on the sensor cancel button. I can't do anything to get it to quit, and the sensors don't react to objects with a beep. I looked around but couldn't find anything with the terms I used.
View 5 RepliesCorolla :: 2008 Toyota - Seatbelt Warning Keeps Beeping Constantly
I've a 2008 Toyota Corolla ever since I bought it back in 2007. I don't have any problem with the seat belt warning before but recently for the past months the seat belt warning keeps beeping constantly, even when I'm wearing my seat belt. I fastened every belts in the car to make it stop but it just keep going. How to get it working properly?
View 1 RepliesGolf IV / Jetta IV :: Brake Light In Cluster Constantly On With Beeping
I started the car one morning after it snowed. the red "BRAKE" light is constantly on and while the car is moving it beeps which is extremely annoying.. I have tried:
-Topping off brake fluid
- another ebrake sensor (under the center console)
- brake pads have plenty of meat on them
- brake light are working
Golf/GTI VII :: System Error - Parking Sensors Beeping And Button Flashing
I am owner of brand new Golf Sportsvan 1.4 92kw petrol, 6 speed manual. Since day two ive been noticeing that something might be wrong with my car. Second day of ownership i was greeted by TPMS, ESC, Auto hold and Stop start system error all at once, and parking sensors were beeping and button was flashing. Ive been reading about it and its not new for MK7 owners as i can understand. But what worries me most is the revs when the engine is cold and i start it up first time. Did a video and uploaded it. [URL] .....
Weird thing is i only get errors when its cold start, i mean for example yesterday and today it was cold here (-5 degrees celcsius) and car started up with no errors, but the revs where bouncing up and down like seen on video. Sometimes i get those 4 errors aswell and rev problem, sometimes only rev problem, but when the engine is at the working temperature i get no errors, no shakey revs.
Otherwise love the car. Solid build quality, Spacious, Like the pyramid gold color, lovely car, beside those gremlins.
Ford Excursion :: Misfiring - O2 Sensors Out?
So Wife did this nice "How-To" for the site and then we celebrated with a trip to Steak N' Shake. Halfway there I could feel it running a little off so I pulled up the app on the phone and connected it. I pulled up the codes and this is what I got.
So am I looking at an O2 sensor you think? It's shifting early and chugging a little as well. When driving it sounds a little like I have dual exhaust or a flowmaster. When sitting still at a light there is a small bump like bass turned WAY low coming from the exhaust as well. I turned around halfway there and went home and we took the wife's Highlander
Ford Excursion :: O2 Sensors Not Ready
Recently smogged my excursion, passed the emissions but failed self test. O2 sensors not ready. Drive it 40 miles everyday and still wont pass.
View 10 RepliesFord 6.7L Power Stroke Diesel :: Check Back Up Sensors Message
Nothing mechanical, fuel filter change and coolant check. While its there I am going to have them look at a few things:
1. Back up sensors - they work intermittently with a message that comes up saying "check back up sensors" or something to that affect on the display. The icon on the display that lets you check off or on will not let you put a check mark next to "on" after you push the "OK" button to get out of the check message. There is nothing coating the bumper/sensors (mud or anything).
2. Blinkers - sometimes, out of the blue, my left turn signal comes on and it doesn't like to go off. I have to push the blinker wand down to the second full position then back, or repeat if it comes back on. It is almost always the left blinker. It also happens sometimes when I start the truck.
3. Windshield wipers - sometimes if I go from the remote start to key power in the morning I get the windshield wipers going. So I will turn them on with the dial and back off. This is pretty rare.
4. The Ford emblems are starting to corrode.
5. I might have them look at the cruse control - sometimes I can get the light to come on the dash and go to green when I push the + button, but it doesn't hold the speed. I have to shut the truck off and restart all the electronics for it to start working again.
How to check the back up sensors? My gut tells me with the rest of the issues that unless they can repeat and verify my "complaints" they won't be able to do anything. There probably isn't a code thrown for the blinkers going on at will. Is there anything I might be able to do to fix it? Or do these issues require parts being replaced - which we're back to square 1 with being able to verify what it's doing at the dealer?
Ford Excursion :: Backup Sensors Turned Off?
Is it possible to turn off the backup sensors on my X ?
When I am towing these things drive me nuts!
Ford 6.0L Power Stroke Diesel :: No Back-up Sensors After Remote Start Install
I have read countless threads and have done research and can't figure out my issue. Had remote start installed in the truck a month ago. The day it was installed sensors were working. I left the shop and went to back in and noticed they didn't work and the light popped when in reverse and sometime it will the random beeping. I did the check and found the inner right sensor was not buzzing. So ordered four from eBay and it still doesn't work. I even switched one of the others out thinking it was the eBay special issue. It didnt work so it's just that sensor. Now what? I have checked the wiring under the truck and it all looks good. What's my next step? Could the remote start have taken just one sensor out?
View 2 RepliesFord Excursion :: Backup Sensors Turn Off When Put In Reverse
Just started doing this. Sometimes I can get them to turn on in I hit the button enough. Switch going bad?
View 12 RepliesFord Excursion :: Backup Sensors Not Working - Light Always On
I can't find any info about this "always on" reverse light issue. My searches show that most people with the problem only have it when they put it in to revers. Mine's broken but the light is on all of the time indicating it's not working.
I can go through the sensors, but I think the system only recognizes sensor failures when the car is in reverse. What's my first/next step?
Ford Excursion :: Water-in-fuel Light Has Been On Constantly
My water-in-fuel light has been on constantly since I bought my 6.0L X about 3 weeks ago. Replaced fuel filters immediately; used DieselKleen in fuel; drained the HFCM multiple times... no water (upgraded the HFCM plug too). Sprayed some carb cleaner through drain hole and out runs red goo. Finally had time to clean out the HFCM this weekend. Raised front-end on ramps, chocked wheels.
Attempted to remove front drive shaft to 4x4. Couldn't free one of the bolts on the front U-joint. Rats. Since I couldn't remove the drive shaft, there wasn't enough room to remove the entire HFCM, so I removed only the cover.
Disconnect battery.
Unplug WIF sensor and fuel heater.
Drain HFCM (again) to make sure it's empty...it wasn't.
Disconnect 4 fuel lines. Wipe fuel from running down arms. I should mention that I had less than 1/4 tank of fuel to try and minimize spillage.
Remove 4 cover screws (7mm, though my 5/16" SAE socket fit better.)
Clean cover and HFCM with carb cleaner.
Replace HFCM gasket.
Replace HFCM cover; screws were hand-tightened.
Reconnect fuel lines and sensors.
Cycle Key-On, Engine Off (KOEO) about 4-5 times.
Crank 'er up....no more WIF light.
Here are some before and after pics.
BEFORE:
AFTER:
Ford Excursion :: Removal Of Backup Sensors In Rear Bumper?
My Excursion had a mangled rear bumper when I bought it recently. I just bought a salvage one to replace it. I had it installed today. I want to salvage the backup sensors in the old bumper along with the license plate lights. How do these come out? They seem locked in there to me.
View 3 RepliesFord Excursion :: Backup Sensors - Fast Ticking From Only One Sensor
Ok, so it seems I have 3 bad backup sensors on the 2002 Ex. Background information for those considering a repair:
I put the Ex in reverse, key in run and can hear "fast ticking" from only one sensor. Sensor removal is easy (at lease on the two outside sensors). Two tabs on the black housing in the bumper hold the cylindrical sensor in place. Release the two tabs and work the sensor out. I haven't tried to remove the bad inside sensor yet as there is a lot less room to work there.
Once removed, a single tab on the wiring harness connector holds the sensor in place.
Here is the problem I have. I can't get the sensor to LOCK back into the connector. I have backed the connector against the bumper and pushed on the sensor with all my strength and I cannot get it to lock back into the single tab on the connector.
Is there a trick I am missing? I am ready to try vice grips but I fear I will damage the connector.
Ford Excursion :: 2000 V10 - Sway Bar Link Rattles Constantly
I recently replaced Sway Bar Links on my 2000 X (V10, 4x4, 155k). They were only a year and half old but the bushings had gave way. Mechanic went with an OEM part with a new design from NAPA. This new design added grease fittings. Now the truck rattles constantly and seems to have more sway. Shocks are probably originals, but I don't think they are the main cause. I can tell the rattle is coming through the frame. All my suspension is stock.
View 14 RepliesFord Excursion :: Addition Of Backup Sensors On Chrome Bumper Without Drilling
I'd really like to add these to The Beast, but don't want to drill through chrome. My bumper has some plastic running along the top (see pic). Just looking for info for the same bumper mounted the sensors there with success.
View 9 RepliesPrius V :: How To Turn Off Beeping When Back Up In Reverse
When I put my new Prius v in reverse and back it up, there's this infernal beeping *smile*. How can I turn that off?
View 2 Replies